Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.     

Some happy,others sad: exploring environmental justice in solid waste management in Kinshasa,The Democratic Republic of Congo

This paper explores the concept of environmental justice (EJ) in solid waste management (SWM) in Kinshasa, the Democratic Republic of Congo (DRC). It evaluates the extent to which EJ occurs in SWM and discusses the factors accounting for this state of affairs. The paper examines the relevant theoretical framework(s) and mechanisms that would facilitate the attainment of EJ in Kinshasa. It is argued that solid waste (SW) often ends up in the poorest and least powerful communities in the cities of the DRC. A qualitative research methodology, which includes exhaustive critical review of the literature, system analysis, reflections from best practices through case studies and discussion with stakeholders, was used for this study. Findings revealed that SWM in Kinshasa is a duty entrusted to publicly-funded municipal authorities. There are evidences of a clear divide between the rich and poor neighbourhoods in the manner SW is managed. This is an inequality that has only recently begun to be recognised as injustice practices in SWM. It is argued that a politico-cultural mechanism on remedying SWM inequities could enable changes that will address EJ in Kinshasa. Such a solution will go directly against the prevailing notion “some happy, others sad”.     

Green algae of the genus Spirogyra: A potential absorbent for heavy metal from coal mine water

Algae have considerable capability for absorbing heavy metals from wastewaters and are considered an effective treatment technology. Heavy metal absorption from coal mine water from the Bhowra Abandoned mine (open cast mine) and the Sudamdih Shaft mine (underground mine waters), both located in Dhanbad, India, by cells of Spirogyra was studied at different dilutions (100 percent, 80 percent, 60 percent, 40 percent, and 20 percent). In the present study, the following 18 metals were selected for analysis: aluminium (Al), arsenic (As), silver (Ag), barium (Ba), beryllium (Be), bismuth (Bi), cadmium (Cd), cobalt (Co), chromium (Cr), cesium (Cs), copper (Cu), iron (Fe), gallium (Ga), indium (In), potassium (K), manganese (Mn), nickel (Ni), and vanadium (V). Accordingly, Al and K were found to be higher in concentration with respect to selected metals for both mine waters. The biosorption study revealed that higher amounts of Al, Bi, Co, Cs, Fe, Ga, Mn, Ni, and V were absorbed by algal biomass at 100 percent concentration from both mine waters. The maximum uptake of Cu, As, and Cd was measured at 60 percent, 40 percent, and 20 percent, respectively, for the Bhowra Abandoned mine water. The biosorption equilibrium study revealed that Ag, Al, Ba, Be, Bi, Co, Cr, Cs, Fe, Ga, In, K, Mn, Ni, and V were maximally absorbed by algal biomass at 100 percent concentration from Bhowra mine water, while the maximum uptake by the algal biomass measured for the Sudamidh coal mine water was for Al, As, Bi, Cu, Fe, and Mn at 100 percent concentration. The different physicochemical characteristics of mine water and drinking water standards was also studied. Accordingly, total dissolved solid and chemical oxygen demand concentrations exceeded the drinking water standards for water samples collected from both mines.     

An analytical model for crosswind integrated concentrations released from a continuous source in a finite atmospheric boundary layer

An analytical model for the crosswind integrated concentrations released from a continuous source in a finite atmospheric boundary layer is formulated by considering the wind speed as a power law profile of vertical height above the ground and eddy diffusivity as an explicit function of downwind distance from the source and vertical height. A closed form analytical solution of the resulting advection–diffusion equation for these profiles of wind speed and eddy diffusivity with the physically relevant boundary conditions is derived using the separation of variables technique that leads to a Sturm–Liouville eigen value problem. Various particular cases of the model are deduced.The model is evaluated with the observations obtained from Prairie Grass experiment in various stability classes varying from very unstable to neutral and stable conditions and Hanford diffusion experiment in stable conditions. The agreement is found to be good between the computed and observed concentrations in both the diffusion experiments. For Prairie Grass experiment, the model is predicting 78% cases with in a factor of two and gives a value of NMSE as 0.075. On the other hand, for Hanford observations in stable conditions, it predicts 70% cases with in factor of two. An extensive analysis of statistical measures with the downwind distances from the source reveals that the model is performing well close to the source.     

Investigations of an intense aerosol loading during 2007 cyclone SIDR – A study using satellite data and ground measurements over Indian region

Tropical cyclones are prominent weather systems characterized by high atmospheric pressure gradients and wind speeds. Intense tropical cyclones occur in India during the pre-monsoon (spring), early monsoon (early summer), or post-monsoon (fall) periods. Originating in both the Bay of Bengal (BoB) and the Arabian Sea (AS), these tropical cyclones often attain velocities of more than 100 km h^?1 and are notorious for causing intense rain and storm surge as they cross the Indian coast. In this study, we examine the changes in the aerosol properties associated with an intense tropical cyclone “SIDR”, that occurred during 11–16 November 2007 over BoB. This cyclone, accompanied with very strong surface winds reaching 223 km h^?1, caused extensive damage over Bangladesh. Ground-based measurements of Aerosol Optical Depth (AOD) in the neighboring urban environment of Hyderabad, India, showed significant variations due to changes in wind velocity and direction associated with the cyclone passage. The Terra-MODIS and AVHRR satellite images showed prevalence of dust particles mixed with emissions from anthropogenic sources and biomass-burning AS, while the aerosol loading over BoB was significantly lower. The positive values of Aerosol index (AI) obtained from the Ozone Monitoring Instrument (OMI) suggested the presence of an elevated aerosol layer over the West coast of India, AS and Thar Desert during and after the cyclone episode. Meteorological parameters from the MM5 mesoscale model were used to study the variations in winds associated with the cyclonic activity. Particulate matter loading over the region during the cyclone period increased by ～45% with an accompanying decrease in columnar aerosol optical depth. The variations in Angstrom parameters suggested coarse-mode particle loading due to dust aerosols as observed in satellite data.     

Fast response measurements of the dispersion of nanoparticles in a vehicle wake and a street canyon

The distributions of nanoparticles (below 300 nm in diameter) change rapidly after emission from the tail pipe of a moving vehicle due to the influence of transformation processes. Information on this time scale is important for modelling of nanoparticle dispersion but is unknown because the sampling frequencies of available instruments are unable to capture these rapid processes. In this study, a fast response differential mobility spectrometer (Cambustion Instruments DMS500), originally designed to measure particle number distributions (PNDs) and concentrations in engine exhaust emissions, was deployed to measure particles in the 5–1000 nm size range at a sampling frequency of 10 Hz. This article presents results of two separate studies; one, measurements along the roadside in a Cambridge (UK) street canyon and, two, measurements at a fixed position (20 cm above road level), centrally, in the wake of a single moving diesel-engined car. The aims of the first measurements were to test the suitability and recommend optimum operating conditions of the DMS500 for ambient measurements. The aim of the second study was to investigate the time scale over which competing influences of dilution and transformation processes (nucleation, condensation and coagulation) affect the PNDs in the wake of a moving car. Results suggested that the effect of transformation processes was nearly complete within about 1 s after emission due to rapid dilution in the vehicle wake. Furthermore, roadside measurements in a street canyon showed that the time for traffic emissions to reach the roadside in calm wind conditions was about 45 ± 6 s. These observations suggest the hypothesis that the effects of transformation processes are generally complete by the time particles are observed at roadside and the total particle numbers can then be assumed as conserved. A corollary of this hypothesis is that complex transformation processes can be ignored when modelling the behaviour of nanoparticles in street canyons once the very near-exhaust processes are complete.     

Ra–Po–Pb isotope systematics in waters of Sambhar Salt Lake,Rajasthan (India): geochemical characterization and particulate reactivity

The Sambhar Salt Lake hydrological system, including river waters, groundwaters, evaporating pans and sub-surface brines, has been analyzed for the salt content (TDS) and naturally occurring radionuclides (²¹⁰Po, ²¹⁰Pb and ^226,228Ra). The abundance of these radionuclides and their activity ratios show a wide variation in different hydrological regimes, which helps to geochemically characterize the lake system. A significantly lower Ra to total dissolved solids (TDS) ratio in the brines (by two to three orders of magnitude), when compared to the groundwaters and river waters, suggests removal of dissolved Ra by co-precipitation with Ca–Mg minerals at an early stage of the brine evolution. The concentration of Ra in evaporating lake/pan waters saturates at a value of about 35 Bq L⁻¹ over the salinity range of 100–370 g L⁻¹; attributable to its equilibration with the clay minerals. The two distinct regimes, saline lake system (lake water, evaporating pans and sub-surface brines) and groundwaters have been identified based on their differences in the distribution of ^226,228Ra isotopes. This observation points to the conclusion that the groundwaters and the lake brines are not intimately coupled in terms of their origin and evolution. The abundances of ²¹⁰Po and ²¹⁰Pb along with their activity ratios (²¹⁰Po/²¹⁰Pb) are markedly different among the surface lake waters/evaporating pans, sub-surface lake brines and groundwaters. These differences are explained in terms of different geochemical behaviour of these nuclides in presence of algae and organic matter present in these water regimes.     

Role of Alternative Electron Acceptors (AEA) to control methane flux from waterlogged paddy fields: Case studies in the southern part of West Bengal, India

The rice fields, depleted of O₂, contain large amount of moisture and organic substrates to provide an ideal anaerobic environment for methanogenesis and are one of the principal anthropogenic sources of methane. In order to mitigate this emission Alternative Electron Acceptors (AEA) were altered in the soil. The experiments were carried out in four seasons at the site of Balarampur, near Baruipur, South 24 Parganas, West Bengal, namely September–December, 2005 (Cultivar: Sundari), February–May, 2006 (Cultivar: Sundari), September–December, 2006 and February–May, 2007 (Cultivar: Swarna-Pankaj). The seasonal average methane flux (Fe treated), for the cultivar type “Sundari” (season: September–December, 2005), is 4.41 t ha⁻¹, as compared to the value of 6.40 t ha⁻¹ for the untreated soil. Similarly for February–May, 2006, the seasonal average methane flux (Fe treated) is 5.52 t ha⁻¹, whereas the untreated flux is 5.69 t ha⁻¹. In the third and fourth seasons we had two treatments with Ammonium Thiosulphate and Ferric Hydroxide. The seasonal average methane flux (treatment: Ammonium Thiosulphate) is 4.35 t ha⁻¹ and 5.41 t ha⁻¹ respectively, whereas for the ferric hydroxide treated soil it is 4.35 t ha⁻¹ and 6.14 t ha⁻¹ respectively. The properties related to the nutrient quality of the harvested paddy seeds supplement these results.     

Assessment of the status of municipal solid waste management in metro cities, state capitals, class I cities, and class II towns in India: an insight

Solid waste management is one of the most challenging issues in urban cities, which are facing a serious pollution problem due to the generation of huge quantities of solid waste. This paper presents an assessment of the existing situation of municipal solid waste management (MSWM) in major cities in India. The quantity and composition of MSW vary from place to place, and bear a rather consistent correlation with the average standard of living. Extensive field investigations were carried out for quantification, analysis of physical composition, and characterization of MSW in each of the identified cities. The MSW management status (per the MSW Rules, 2000) has also been assessed, and an action plan for better management has been formulated; both are presented in this paper. Studies carried out in 59 selected cities in India have revealed that there are many shortcomings in the existing practices used in managing the MSW. These shortcomings pertain mainly to inadequate manpower, financial resources, implements, and machinery required for effectively carrying out various activities for MSWM. To overcome the deficiencies in the existing MSWM systems, an indicative action plan has been presented incorporating strategies and guidelines. Based on this plan, municipal agencies can prepare specific action plans for their respective cities.     

Modeling perceived collision risk in port water navigation

An increase in the likelihood of navigational collisions in port waters has put focus on the collision avoidance process in port traffic safety. The most widely used on-board collision-avoidance system is the automatic radar plotting aid which is a passive warning system that triggers an alert based on the pilot’s pre-defined indicators of distance and time proximities at the closest point of approaches in encounters with nearby vessels. To better help pilot in decision making in close quarter situations, collision risk should be considered as a continuous monotonic function of the proximities and risk perception should be considered probabilistically. This paper derives an ordered probit regression model to study perceived collision risks. To illustrate the procedure, the risks perceived by Singapore port pilots were obtained to calibrate the regression model. The results demonstrate that a framework based on the probabilistic risk assessment model can be used to give a better understanding of collision risk and to define a more appropriate level of evasive actions.