Application of chemical oxidation to remediate HCH-contaminated soil under batch and flow through conditions

This is the first study describing the chemical oxidation of hexachlorocyclohexanes (HCHs) in contaminated soil under water saturated and unsaturated flow through conditions. Soil contaminated with β-HCH (45 mg kg^?1) and γ-HCH (lindane, 25 mg kg^?1) was sampled from former lindane waste storage site. Efficiency of following treatments was tested at circumneutral pH: H₂O₂ alone, H₂O₂/Fe^II, Na₂S₂O₈ alone, Na₂S₂O₈/Fe^II, and KMnO₄. Experimental conditions (oxidant dose, liquid/solid ratio, and soil granulometry) were first optimized in batch experiments. Obtained results revealed that increasing dose of H₂O₂ improved the oxidation efficiency while in Na₂S₂O₈ system, maximum HCHs were removed at 300 mM. However, oxidation efficiency was slightly improved by Fe^II-activation. Increasing the solid/liquid ratio decreased HCH removal in soil samples crushed to 500 μm while an opposite trend was observed for 2-mm samples. Dynamic column experiments showed that oxidation efficiency followed the order KMnO₄ > Na₂S₂O₈/Fe^II > Na₂S₂O₈ whatever the flow condition, whereas the removal extent declined at higher flow rate (e.g., ~50% by KMnO₄ at 0.5 mL/min as compared to ~30% at 2 mL/min). Both HCH removal and oxidant decomposition extents were found higher in saturated columns than the unsaturated ones. While no significant change in relative abundance of soil mineral constituents was observed before and after chemical oxidation, more than 60% of extractable organic matter was lost after chemical oxidation, thereby underscoring the non-selective behavior of chemical oxidation in soil. Due to the complexity of soil system, chemical oxidation has rarely been reported under flow through conditions, and therefore our findings will have promising implications in developing remediation techniques under dynamic conditions closer to field applications.     

Assessing demineralization treatments for PVC effluent reuse in the resin polymerization step

To reduce fresh water consumption in a polyvinyl chloride (PVC) plant, the effluent from a biological treatment must be demineralized to be re-used in the resin polymerization process. Demineralization is a critical process, since the quality and the stability of the PVC resins are highly influenced by the water quality used in the process. The main target values for water parameters are the following: conductivity <10 μScm^?1, TOC < 10 mg L^?1, and Al < 0.1 mg L^?1. To achieve this quality, several reverse osmosis membranes from different materials and suppliers were tested and compared in the demineralization treatment. Polyamide membranes showed higher salt rejection compared to cellulose acetate membranes yielding both types similar flux and permeability. Two-pass reverse osmosis treatment was necessary to reach conductivities lower than 10 μS cm^?1. On the other hand, a good quality effluent for reuse was obtained by combining RO and ionic exchange resins. Results showed that good quality PVC resins in terms of color, granulometry, porosity, and bulk density were obtained when demineralized water from two-pass reverse osmosis was used as fresh water, proving the feasibility of the effluent reuse in the PVC industry.     

Comparison of episodic acidification in Canada, Europe and the United States

Episodic acidification is practically a ubiquitous process in streams and drainage lakes in Canada, Europe and the United States. Depressions of pH are often smaller in systems with low pre-episode pH levels. Studies on European surface waters have reported episodes most frequently with minimum pH levels below 4.5. In Canada and the United States, studies have also reported a number of systems that have had minimum pH levels below 4.5. In all areas, change in water flowpath during hydrological events is a major determinant of episode characteristics. Episodic acidification is also controlled by a combination of other natural and anthropogenic factors. Base cation decreases are an important contributor to episodes in circumneutral streams and lakes. Sulphate pulses are generally important contributors to episodic acidification in Europe and Canada. Nitrate pulses are generally more important to episodic acidification in the Northeast United States. Increases in organic acids contribute to episodes in some streams in all areas. The sea-salt effect is important in near-coastal streams and lakes. In Canada, Europe and the United States, acidic deposition has increased the severity (minimum pH reached) of episodes in some streams and lakes.     

Contribution of canopy leaching to sulphate deposition in a Scots pine forest

Radioactive sulphate (35SO4) was applied to the soil below a Scots pine forest on 23 June 1989, and its movement into the canopy and into throughfall and stemflow was measured over 4 months. The specific activity, Bq (mg S)(-1), of the canopy increased monotonically; uptake by current-year (1989) expanding needles was initially twice as fast as by older needles or live twigs. By 10 October the canopy average specific activity was 62 Bq (mg S)(-1). The specific activity of net throughfall (throughfall + stemflow - rain), deduced from measurements from six throughfall collectors, six stemflow collectors and two rain collectors, fell rapidly from 12.6 Bq (mg S)(-1) in late July to <1 Bq (mg S)(-1) in mid-August. The results suggest (assuming rapid equilibration of 35S with sulphate in soil) that root-derived sulphate contributed c. 3% of sulphate in net throughfall and that dry deposition of SO2 and sulphate particles contributed c. 97% of the 0.56 g S m(-2) measured in net throughfall over the period. Simultaneous measurements of SO2 at canopy height and of NH3 above and within the canopy gave mean concentrations of 5.9 and 0.86 microg m(-3), respectively, sufficient to account for the sulphate measured in net throughfall only if codeposition of NH3 and SO2 occurred to canopy surfaces. The large values of specific activity observed in July, however, indicate that throughfall composition may be closely related to recent soil input of sulphate, and that equilibrium cannot be safely assumed. The possibility of a significant contribution of soil-derived sulphate to sulphate deposition in net throughfall cannot be ruled out on the basis of this experiment.     

Changes in concentration of five PCDD/F congeners after cooking beef from treated cattle

A large piece of meat taken from a single animal, which had been dosed with five selected PCDD/Fs, was prepared and cooked by a selection of different methods; burgers (fried, grilled, barbecued), roasts (cooked using conventional and microwave ovens) and stews (open pan and pressure cooked). For some of the cooking methods, concentration changes, on a whole product basis, were observed between raw and cooked product. However, in all cases these could be explained simply through changes arising from loss of water and elimination of PCDD/Fs with released fat. The total amounts of PCDD/Fs present in the system (including in released fat) remained unchanged. Dietary intake of PCDD/Fs could therefore be reduced by the removal of visible fat from meat before cooking and by discarding any fat released from foods during the cooking process.     

Adsorption of imidazolinone herbicides on ferrihydrite-humic acid associations.

Adsorption of the imidazolinone herbicides imazapyr, imazethapyr and imazaquin was studied on two binary systems (ferrihydrite-humic acid) prepared by treating ferrihydrite (Fh) immediately after its precipitation with a soil humic acid (HA) at different loadings (4% and 8% HA content), and on a blank ferrihydrite sample prepared in the same way, but without HA addition. Imidazolinone adsorption on pure Fh and on the 4% Fh-HA decreased with increasing of the herbicide hydrophobicity (imazaquin相似文献   

Primary biodegradation of veterinary antibiotics in aerobic and anaerobic surface water simulation systems

The primary aerobic and anaerobic biodegradability at intermediate concentrations (50-5000 microg/l) of the antibiotics olaquindox (OLA), metronidazole (MET), tylosin (TYL) and oxytetracycline (OTC) was studied in a simple shake flask system simulating the conditions in surface waters. The purpose of the study was to provide rate data for primary biodegradation in the scenario where antibiotics pollute surface waters as a result of run-off from arable land. The source of antibiotics may be application of manure as fertilizer or excreta of grazing animals. Assuming first-order degradation kinetics, ranges of half-lives for aerobic degradation of the four antibiotics studied were 4-8 days (OLA), 9.5-40 days (TYL), 14-104 days (MET) and 42-46 days (OTC). OLA and OTC were degraded with no initial lag phase whereas lag phases from 2 to 34 days (MET) and 31 to 40 days (TYL) were observed for other substances. The biodegradation behaviour was influenced by neither the concentrations of antibiotics nor the time of the year and location for sampling of surface water. Addition of 1 g/l of sediment or 3 mg/l of activated sludge from wastewater treatment increased the biodegradation potential which is believed to be the result of increased bacterial concentration in the test solution. Biodegradation was significantly slower in tests conducted in absence of oxygen. Assessments of the toxic properties of antibiotics by studying the influence on the biodegradation rates of 14C-aniline at different concentrations of antibiotics showed that no tests were conducted at toxic concentrations.     

Degradation of 14C-carbofuran in soil using a continuous flow system

14C-carbofuran underwent considerable mineralization (approximately 30% of the applied activity) in Vertisol soil under moist and flooded conditions during 60 days incubation. Bound residues were formed under both the conditions, the extent being more in moist soils (approximately 55% of the applied activity) than under flooded conditions (approximately 41% of the applied activity). 3-Keto carbofuran was the only significant metabolite observed under flooded conditions.     

Formation of PCDDs and PCDFs during the combustion of polyvinylidene chloride

In laboratory-scale combustion of polyvinylidene chloride (PVDC) with a quartz tubular furnace designed and fabricated to provide the desired combustion temperature and mixing state of combustion gas with air, it was found that at 800 degrees C or higher the level of polychlorinated dibenzo-p-dioxins/polychlorinated dibenzofurans [corrected] (PCDDs/PCDFs) resulting from PVDC combustion was no higher than that from heating air alone, and thus far below the levels which resulted from PVDC combustion at 750 degrees C or lower. The results provide the first laboratory confirmation of the relation between PVDC incineration temperature and PCDD/PCDF formation, and of the primary importance of high temperature, turbulence for mixing between air and combustion gas, and sufficient residence time, as governing factors for the minimization of PCDD/PCDF formation in municipal solid waste incinerators.