Chilled ammonia process for CO2 capture

The chilled ammonia process absorbs the CO₂ at low temperature (2–10 °C). The heat of absorption of carbon dioxide by ammonia is significantly lower than for amines. In addition, degradation problems can be avoided and a high carbon dioxide capacity is achieved. Hence, this process shows good perspectives for decreasing the heat requirement. However, a scientific understanding of the processes is required. The thermodynamic properties of the NH₃–CO₂–H₂O system were described using the extended UNIQUAC electrolyte model developed by Thomsen and Rasmussen in a temperature range from 0 to 110 °C and pressure up to 100 bars. The results show that solid phases consisting of ammonium carbonate and bicarbonate are formed in the absorber. The heat requirements in the absorber and in the desorber have been studied. The enthalpy calculations show that a heat requirement for the desorber lower than 2 GJ/ton CO₂ can be reached.     

Sources of PCDD/Fs, non-ortho PCBs and PAHs in sediments of high and low impacted transboundary rivers (Belgium-France)

PAHs, PCDD/Fs and non-ortho PCBs have been assessed in Yser and Upper-Scheldt river sediments. Higher contamination levels were observed in the Upper-Scheldt sediments: maximum concentrations for the 16 US-EPA PAHs, PCDD/Fs and non-ortho PCBs respectively amount to 8.9 mg kg⁻¹, 12 ng TEQ kg⁻¹ and 5.1 ng TEQ kg⁻¹. Diagnostic PAH ratios in sediments and atmospheric samples suggest that the PAH compounds are from pyrolytic origin, more specifically combustion processes. The huge consumption of coal in cokes-ovens and smelters and its use for house-heating in Northern France, although decreasing during the last decades, are in support of that suggestion. PCDD/F fingerprints in sediments and deposition material indicate that OCDD is the dominant congener. In addition use of pentachlorophenol (PCP) in the past led to a minor contribution of PCDD/Fs in our sediment samples. Non-ortho PCBs form a substantial fraction of the total TEQ concentrations observed in the sediments. Since the 1980s and 1990s a substantial reduction of the PCDD/F sediment concentrations is observed, but this is not the case for the PAHs.     

Biocatalytic dechlorination of hexachlorocyclohexane by immobilized bio-Pd in a pilot scale fluidized bed reactor

Lindane (??-hexachlorocyclohexane, ??-HCH) is a recalcitrant and toxic organochlorine insecticide. Due to its non-selective production process and widespread use, HCH isomers and their degradation products have been detected frequently in soils and groundwater. An innovative technology using microbial produced Pd(0) nanoparticles, i.e. bio-Pd, was developed to treat groundwater containing a mixture of HCHs and chlorobenzenes. In a first step, the groundwater was de-ironized and most of the chlorobenzenes were removed in a biological trickling filter. The ??g?L^?1 levels of HCHs and chlorobenzenes were removed in a second step by the bio-Pd-based technology. Therefore, a 200-L pilot scale reactor was developed with 100?mg?L^?1 bio-Pd encapsulated in alginate beads. Hydrogen gas was bubbled at the bottom of the reactor and served to charge the bio-Pd catalyst. The reactor influent contained 5.2???g?L^?1 HCHs and 51.1???g?L^?1 chlorobenzenes. During a test period of 10?days, 29% of the HCH isomers and 63% of the chlorobenzenes were removed applying a nominal hydraulic residence time of 4?h. These removal percentages could be increased to 75 and 68% by doubling the nominal hydraulic residence time to 8?h. This study demonstrated that biologically produced nanoparticles of Pd can be applied for the large-scale remediation of groundwater contaminated with HCHs.     

Advantages and possibilities of solid recovered fuel cocombustion in the European energy sector

The 1999/31 Elemental Carbon Directive sets strict rules on the disposal of untreated municipal solid waste in the European Union countries and forces a reduction of the biodegradable quantities disposed off to landfills up to 35% of the amount produced in 1995 in the coming decade. More environmentally friendly waste management options shall be promoted under the framework of the Community Waste Strategy ([96] 399 Final). In this context, the production and thermal use of solid recovered fuels (SRFs), derived from nonhazardous bioresidues and mixed- and mono-waste streams, could be a key element in a future waste management system. Within the scope of the European Demonstration Project, RECOFUEL, SRF cocombustion was demonstrated in two large-scale lignite-fired coal boilers at RWE power station in Weisweiler, Germany. As a consequence of the high biogenic share of the cocombusted material, this approach can be considered beneficial following European Directive 2001/77/EC on electricity from renewable energy sources (directive). During the experimental campaign, the share of SRF in the overall thermal input was adjusted to approximately 2%, resulting into a feeding rate of approximately 25 t/hr. The measurement campaign included boiler measurements in different locations, fuel and ash sampling, and its characterization. The corrosion rates were monitored by dedicated corrosion probes. The overall results showed no significant influence of SRF cocombustion on boiler operation, emissions behavior, and residues quality for the thermal shares applied. Also, no effect of the increased chlorine concentration of the recovered fuel was observed in the flue gas path after the desulfurization unit.     

Polymerase chain reaction analysis of the cystic fibrosis ΔF508 mutation in human blastomeres following oocyte injection of a single sperm from a carrier

The efficiency of the polymerase chain reaction (PCR) in detecting the cystic fibrosis (CF) ΔF508 mutation (which is the most common mutation of CF) was assessed in single human blastomeres. Twenty-one human immature oocytes (germinal-vesicle-stage oocytes) that had been donated for research were matured in vitro and a single spermatozoon from a carrier of the CF ΔF508 mutation was injected into the ooplasm. Fourteen embryos were obtained after intracytoplasmic sperm injection (ICSI). PCR analysis was carried out on 70 single blastomeres isolated from these 14 embryos. The results showed that the efficiency of DNA amplification by PCR in single nucleate blastomeres was 94 per cent (59/63). There were no false-positive results since none of the blank samples or the blastomeres without a nucleus showed an amplified signal. We found that nine embryos were homozygous for the unaffected genotype and that four embryos were heterozygous since they contained both the unaffected and the ΔF508 genotype. In a four-cell embryo, we observed the homozygous unaffected genotype in one blastomere and a heterozygous ΔF508/unaffected genotype in the other three blastomeres.     

Assessment of carbon leakage in multiple carbon-sink projects: a case study in Jambi Province,Indonesia

Rehabilitation of degraded forest land through implementation of carbon-sink projects can increase terrestrial carbon (C) stock. However, carbon emissions outside the project boundary, which is commonly referred to as leakage, may reduce or negate the sequestration benefits. This study assessed leakage from carbon-sink projects that could potentially be implemented in the study area comprised of 11 sub-districts in the Batanghari District, Jambi Province, Sumatra, Indonesia. The study estimates the probability of a given land use/cover being converted into other uses/cover, by applying a logit model. The predictor variables were: proximity to the center of the land use area, distance to transportation channel (road or river), area of agricultural land, unemployment (number of job seekers), job opportunities, population density and income. Leakage was estimated by analyzing with and without carbon-sink projects scenarios. Most of the predictors were estimated as being significant in their contribution to land use cover change. The results of the analysis show that leakage in the study area can be large enough to more than offset the project’s carbon sequestration benefits during the period 2002–2012. However, leakage results are very sensitive to changes of carbon density of the land uses in the study area. By reducing C-density of lowland and hill forest by about 10% for the baseline scenario, the leakage becomes positive. Further data collection and refinement is therefore required. Nevertheless, this study has demonstrated that regional analysis is a useful approach to assess leakage.