A Versatile Electrochemical Monitor for Air-Quality Measurements

An electrochemical instrument of the type commonly used to monitor total oxidants was adapted to measure acid gases such as SO₂, HCI, and HCO₂H. By using chemical methods of treating the air sample prior to absorption, it is possible to monitor for specific oxidants and acids. Measurements of NO, NO_x, and SO₂ during smog-chamber experiments were found to be in good agreement with measurements made by other methods.     

Government/Industry Cost Sharing for Air Pollution Control

Several existing federal and state provisions act to reduce the cost to in dustry of controlling air pollution. Included are the federal corporate income tax, depreciation allowances, investment credits, small Business Administration loans, Economic Development Administration aid, and state tax laws. These provisions give government assistance to industry amounting to as much as 59 percent of the cost of air pollution control. Numerous bills have been introduced in Congress that would give additional government aid to industry in the form of special across-the-board tax allowances for air pollution control equipment. A typical bill of this type would result in the government bearing an additional 11 percent of these costs. There are several possible objectives for this kind of additional aid; however, none of these seem valid when the amount of present assistance is recognized. From this analysis, it would seem that additional across-the-board tax subsidies for air pollution control equipment are neither required nor advisable. Future studies and/or experience may show certain firms or industries for which air pollution control will be too great a burden and for which additional government assistance is advisable. When such cases are found, legislation should be enacted only after the pros and cons of the various assistance methods are considered.     

A Study of Sulfur Dioxide in Photochemical Smog I. Effect of SO2 and Water Vapor Concentration in the 1-Butene/NOx/SO2 System

There is an appreciable chemical interaction between SO₂ and photochemical smog which depends on the concentration of SO₂ and water vapor. The rate of decay of SO₂ concentration is greatly increased in the presence of photochemical smog. With 0.75 ppm SO₂, a light-scattering aerosol is produced in dry systems and systems at 22 and 55% relative humidity (RH). Aerosol is not observed until after the NO₂ peak has been reached and the NO concentration has fallen to a very low value. The formation of aerosol corresponds in time to the region of most rapid decrease in the SO₂ profile. In systems at 65% RH or with smaller amounts of SO₂, no light scattering is observed, but the percentage of SO₂ disappearing is greater. In relatively dry systems the presence of SO₂ results in a general slowing down of the photochemical smog reactions. In systems containing water vapor concentrations comparable to those found in the atmosphere, the inhibiting influence of SO₂ on the smog reaction is less pronounced. However, the maximum concentration of oxidant produced by the photochemical smog reactions is significantly lower when SO₂ is present.     

Synthetic SO2 Sorbents for Fluidized-Bed Coal Combustors

The information presented in this paper is directed to engineers who are involved with environmental emissions from coal conversion plants. Synthetic sorbents were investigated as an alternative to natural sorbents (limestone) for the removal of SO₂ from the combustion gas in a fluidized-bed coal combustor. The sulfation rate of a synthetic sorbent, CaO in α-AI₂O₃, was determined as a function of gas composition, temperature, and calcium concentration in the sorbent. The reaction was found to be diffusion-controlled above 850°C and kinetically controlled at lower temperatures. The physical characteristics of the support material have a major effect oh the sulfation kinetics. Porosity measurements indicated that supports containing large pores (>0.2 µm) produced sorbents having high sulfation rates and that pores with diameters less than 0.2 µm did not contribute significantly to the capture of SO₂. The sorbents SrO in α-AI₂O₃ and BaO in α-AI₂O₃ had lower SO₂ capture rates than did CaO in α-AI₂O₃. The alkali metal oxide sorbents K₂O and Na₂O in α-AI₂O₃ captured SO₂ much faster than did the alkaline earth metal oxides.     

Assessment of Human Exposure to Ambient Particulate Matter

ABSTRACT

Recent epidemiological studies have consistently shown that the acute mortality effects of high concentrations of ambient particulate matter (PM), documented in historic air pollution episodes, may also be occurring at the low to moderate concentrations of ambient PM found in modern urban areas. In London in December 1952, the unexpected deaths due to PM exposure could be identified and counted as integers by the coroners. In modern times, the PM-related deaths cannot be as readily identified, and they can only be inferred as fractional average daily increases in mortality rates using sophisticated statistical filtering and analyses of the air quality and mortality data. The causality of the relationship between exposure to ambient PM and acute mortality at these lower modern PM concentrations has been questioned because of a perception that there is little significant correlation in time between the ambient PM concentrations and measured personal exposure to PM from all sources (ambient PM plus indoor-generated PM).

This article shows that the critical factor supporting the plausibility of a linear PM mortality relationship is the expected high correlation in time of people's exposure to PM of ambient origin with measured ambient PM concentrations, as used in the epidemiological time series studies. The presence of indoor and personal sources of PM masks this underlying relationship, leading to confusion in the scientific literature about the strong underlying temporal relationship between personal exposure to PM of ambient origin and ambient PM concentration. The authors show that the sources of PM of non-ambient origin operate independently of the ambient PM concentrations, so that the mortality effect of non-ambient PM, if any, must be independent of the effects of the ambient PM exposures.     

Source apportionment of atmospheric polycyclic aromatic hydrocarbons (PAHs) in Palm Beach County,Florida

Due to concerns about adverse health effects associated with inhalation of atmospheric polycyclic aromatic hydrocarbons (PAHs), 30 ambient air samples were obtained at an air quality monitoring station in Palm Beach County, Florida, from March 2013 to March 2014. The ambient PAH concentration measurements and fractional emission rates of known sources were incorporated into a chemical mass balance model, CMB8.2, developed by EPA, to apportion contributions of three major PAH sources including preharvest sugarcane burning, mobile vehicles, and wildland fires. Strong association between the number of benzene rings and source contribution was found, and mobile vehicles were identified to be the prevailing source (contribution ≥56%) for the observed PAHs concentration with lower molecular weights (four or fewer benzene rings) throughout the year. Preharvest sugarcane burning was the primary contributing source for PAHs with relatively higher molecular weights (five or more benzene rings) during the sugarcane burning season (from October to May of the next year). Source contribution of wildland fires varied among PAH compounds but was consistently lower than for sugarcane burning during the sugarcane harvest season. Determining the major sources responsible for ground-level PAHs serves as a tool to improving management strategies for PAH emitting sources and a step toward better protection of the health of residents in terms of exposure to PAHs. The results obtain insight into temporal dominance of PAH polluting sources for those residential areas located near sugarcane burning facilities and have implications beyond Palm Beach County, in areas with high concerns of PAHs and their linked sources.

Implications: Source apportionment of atmospheric polycyclic hydrocarbons (PAHs) in Palm Beach County, Florida, meant to estimate contributions of major sources in PAH concentrations measured at Belle Glade City of Palm Beach County. Number of benzene rings was found to be the key parameter in determining the source with the prevailing contribution. Mobile vehicle sources showed a higher contribution for species with four or fewer benzene rings, whereas sugarcane burning contributed more for species with five or more benzene rings. Results from this study encourage more control for sugarcane burns and help to better manage authorization of the sugarcane burning incidents and more restrictive transportation plans to limit PAH emissions from mobile vehicles.     

Effects of γ-Fe2O3 nanoparticles on the survival and reproduction of Biomphalaria glabrata (Say, 1818) and their elimination from this benthic aquatic snail

Environmental Science and Pollution Research - This study aims to evaluate the effects of maghemite nanoparticles (γ-Fe2O3) coated with meso-2, 3-dimercaptosuccinic acid (DMSA) stabilizer on...     

Community resilience,land degradation and endogenous lock-in effects: evidence from the Alento region,Campania, Italy

This study analyses social, economic and political “lock-ins” for understanding community resilience and land degradation. The study focuses on lock-ins from within communities, using four case study communities in Italy affected by land degradation. The analysis highlights the complex interrelationships between various lock-ins, and suggests that the communities are on declining resilience pathways that may lead to increasing difficulties in addressing land degradation issues in future.