Organic carbon causes interference with nitrate and nitrite measurements by UV/Vis spectrometers: the importance of local calibration

Compared with sporadic conventional water sampling, continuous water-quality monitoring with optical sensors has improved our understanding of freshwater dynamics. The basic principle in photometric measurements is the incident light at a given wavelength that is either reflected, scattered, or transmitted in the body of water. Here, we discuss the transmittance measurements. The amount of transmittance is inversely proportional to the concentration of the substance measured. However, the transmittance is subject to interference, because it can be affected by factors other than the substance targeted in the water. In this study, interference with the UV/Vis sensor nitrate plus nitrite measurements caused by organic carbon was evaluated. Total or dissolved organic carbon as well as nitrate plus nitrite concentrations were measured in various boreal waters with two UV/Vis sensors (5-mm and 35-mm pathlengths), using conventional laboratory analysis results as references. Organic carbon increased the sensor nitrate plus nitrite results, not only in waters with high organic carbon concentrations, but also at the lower concentrations (< 10 mg C L^?1) typical of boreal stream, river, and lake waters. Our results demonstrated that local calibration with multiple linear regression, including both nitrate plus nitrite and dissolved organic carbon, can correct the error caused by organic carbon. However, high-frequency optical sensors continue to be excellent tools for environmental monitoring when they are properly calibrated for the local water matrix.     

<Emphasis Type="Italic">Noctiluca</Emphasis> and copepods grazing on the phytoplankton community in a nutrient-enriched coastal environment along the southwest coast of India

The relative grazing impact of Noctiluca scintillans (hereafter referred only Noctiluca) and copepods (Acrocalanus gracilis, Paracalanus parvus, Acartia danae and Oithona similis) on the phytoplankton community in an upwelling–mudbank environment along the southwest coast India is presented here. This study was carried out during the Pre-Southwest Monsoon (April–May) to the Late Southwest Monsoon (August) period in 2014. During the sampling period, large hydrographical transformation was evident in the study area (off Alappuzha, Southwest coast of India); warmer Pre-Southwest Monsoon water column condition got transformed into cooler and nitrate-rich hypoxic waters during the Southwest Monsoon (June–August) due to intense coastal upwelling. Copepods were present in the study area throughout the sampling period with a noticeable increase in their abundance during the Southwest Monsoon. On the other hand, the first appearance of Noctiluca in the sampling location was during the Early Southwest Monsoon (mid-June) and thereafter their abundance increased towards the Peak Southwest Monsoon. The grazing experiments carried out as per the food removal method showed noticeable differences in the feeding preferences of Noctiluca and copepods, especially on the different size fractions of phytoplankton. Noctiluca showed the highest positive electivity for the phytoplankton micro-fraction (av. 0.49 ± 0.04), followed by nano-fraction (av. 0.17 ± 0.04) and a negative electivity for the pico-fraction (av. ?0.66 ± 0.06). In total ingestion of Noctiluca, micro-fraction contribution (83.7%) was significantly higher compared to the nano- (15.7%) and pico-fractions (0.58%). On the other hand, copepods showed the highest positive electivity for the phytoplankton nano-fraction (av. 0.38 ± 0.04) followed by micro- (av. -0.17 ± 0.05) and pico-fractions (av. ?0.35 ± 0.05). Similarly, in total ingestion of copepods, nano-fraction (69.7%) was the highest followed by micro- (28.9%) and pico-fractions (1.37%). The grazing pressure of Noctiluca on the total phytoplankton was found to be 27.7% of the standing stock and 45.6% of the production, whereas in the case of copepods, it was 9.95% of the standing stock and 16.6% of the production. The study showed that the grazing pressure of Noctiluca on the total phytoplankton as well as larger phytoplankton fraction was 2.8- and 8-folds higher than that of the copepods. This suggests the leading role of Noctiluca as an effective grazer of larger phytoplankton along the southwest west coast of India, especially during the Peak/Late Southwest Monsoon.     

Occurrence of naproxen,ibuprofen, and diclofenac residues in wastewater and river water of KwaZulu-Natal Province in South Africa

The present paper reports a detailed study that is based on the monitoring of naproxen, ibuprofen, and diclofenac in Mbokodweni River and wastewater treatment plants (WWTPs) located around the city of Durban in KwaZulu-Natal Province of South Africa. Target compounds were extracted from water samples using a multi-template molecularly imprinted solid-phase extraction prior to separation and quantification on a high-performance liquid chromatography equipped with photo diode array detector. The analytical method yielded the detection limits of 0.15, 1.00, and 0.63 μg/L for naproxen, ibuprofen, and diclofenac, respectively. Solid-phase extraction method was evaluated for its performance using deionized water samples that were spiked with 5 and 50 μg/L of target compounds. Recoveries were greater than 80% for all target compounds with RSD values in the range of 4.1 to 10%. Target compounds were detected in most wastewater and river water samples with ibuprofen being the most frequently detected pharmaceutical. Maximum concentrations detected in river water for naproxen, ibuprofen, and diclofenac were 6.84, 19.2, and 9.69 μg/L, respectively. The concentrations of target compounds found in effluent and river water samples compared well with some studies. The analytical method employed in this work is fast, selective, sensitive, and affordable; therefore, it can be used routinely to evaluate the occurrence of acidic pharmaceuticals in South African water resources.     

Assessment of aluminum bioavailability in alum sludge for agricultural utilization

Inorganic aluminum ions, [Al(H₂O)₆]³⁺, [Al(OH)(H₂O)₅]²⁺, and [Al(OH)₂(H₂O)₄]⁺, are toxic to a number of crops. The aim of this study was to estimate the danger of soil contamination of bioavailable aluminum and heavy metals forms because of alum sludge which was a by-product of water, and wastewater treatment technology using aluminum coagulant is introduced into the soil. Aluminum and selected heavy metal fractionation was carried out in the post-coagulation sludge collected at a water treatment plant (where aluminum was used as a coagulant), fermented sewage sludge at a municipal wastewater treatment plant (which did not apply aluminum coagulant), and soil from water treatment plant as well as the mixtures of sludge and soil. It has been found that post-coagulation sludge used as natural fertilizer is a secondary source of bioavailable aluminum, especially when aluminum coagulants are used during water and wastewater treatment. The evaluation of applicability of the sludge to very weak acidic and acidic agricultural soils was carried out. The authors shall debate the question whether, in this case, the Regulation of EU and Polish Government on sewage sludge should also take the bioavailable aluminum into account and add to the list of the elements whose allowable contents are limited.     

Pollution characteristics and ecological risk assessment of heavy metals in three land-use types on the southern Loess Plateau,China

The accumulation of heavy metals in agricultural soils has been the subject of great concern because these metals have the potential to be transferred to soil solutions and subsequently accumulate in the food chain. To study the persistence of trace metals in crop and orchard soils, representative surface soil samples were collected from terrace farmland that had been cultivated for various numbers of years (3, 8, 12, 15, and >20 years), terrace orchard land that had been cultivated for various numbers of years (4, 7, 10, 12, 15, 18, 25, and >30 years), and slope farmland with various gradients (3°, 5°, 8°, 12°, 15°, and 25°) and analyzed for heavy metals (As, Cr, Cu, Hg, Ni, and Zn). These samples were collected from Nihegou catchment of Chunhua county in the southern Loess Plateau of China. The six heavy metals demonstrated different trends with time or gradient in the three land-use types. The Cu and Zn contents of the soil were higher than the referee background values of the loessal soil, and the contents of Cr and Ni, and especially those of As and Hg, were lower. Cu was the only heavy metal that just met the Grade III Environmental Quality Standard for Soils of China, while the others reached grade I. Cu and Hg were considered contaminant factors and Hg was a moderate potential ecological risk factor in the catchment. Of the sites investigated, 89.5% fell into the category with a low degree of contamination (C _d ) and rest were moderate, while all three land-use types had low potential ecological risk (RI). Changes of C _d and RI were consistent with the cultivated time in the terrace farmland and terrace orchard land. Values of RI increased while C _d decreased with the increasing of slope gradient in the slope farmland. Evaluating the ecological risk posed by heavy metals using more soil samples in a larger study area is necessary on the Loess Plateau of China.     

Particulate matter levels in a South American megacity: the metropolitan area of Lima-Callao,Peru

The temporal and spatial trends in the variability of PM₁₀ and PM_2.5 from 2010 to 2015 in the metropolitan area of Lima-Callao, Peru, are studied and interpreted in this work. The mean annual concentrations of PM₁₀ and PM_2.5 have ranges (averages) of 133–45 μg m^?3 (84 μg m^?3) and 35–16 μg m^?3 (26 μg m^?3) for the monitoring sites under study. In general, the highest annual concentrations are observed in the eastern part of the city, which is a result of the pattern of persistent local winds entering from the coast in a south-southwest direction. Seasonal fluctuations in the particulate matter (PM) concentrations are observed; these can be explained by subsidence thermal inversion. There is also a daytime pattern that corresponds to the peak traffic of a total of 9 million trips a day. The PM_2.5 value is approximately 40% of the PM₁₀ value. This proportion can be explained by PM₁₀ re-suspension due to weather conditions. The long-term trends based on the Theil-Sen estimator reveal decreasing PM₁₀ concentrations on the order of ?4.3 and ?5.3% year^?1 at two stations. For the other stations, no significant trend is observed. The metropolitan area of Lima-Callao is ranked 12th and 16th in terms of PM₁₀ and PM_2.5, respectively, out of 39 megacities. The annual World Health Organization thresholds and national air quality standards are exceeded. A large fraction of the Lima population is exposed to PM concentrations that exceed protection thresholds. Hence, the development of pollution control and reduction measures is paramount.     

Spatial Validation of Land Use Change Models Using Multiple Assessment Techniques: A Case Study of Transition Potential Models

Using land use and cover change (LUCC) models for the urban growth planning, environmental assessment, and decision-making needs the establishment of an appropriate level of confidence in their performance. The objective of this research is to explore the importance of using multiple assessment techniques in order to fairly evaluate the performance of land use models. An application is conducted by using the Land Change Modeler for Ecological Sustainability (LCM) which is an empirical and transition potential model. LCM is applied to model the agricultural to developed areas transition in Rennes metropolitan area (France). The land demand is estimated using the Markov Chain model; whereas, the transition potential map is implemented using the Multi-Layer Perceptron Neural Network (MLP) method based on historical changes and driving variables. The model performance is assessed based on a variety of the most commonly used validation techniques. At the study area level, the correctness and disagreement analysis shows that LCM performs better at predicting the amount than the allocation of developed areas. Additionally, landscape metrics reveal that LCM tends to predict a fragmented urban form, which seems evident because of the large number of the individual urban patches. At the municipality level, the error budget analysis shows that the model performance, which varies highly between different subareas, needs to be improved. Moreover, the cross-tabulation between the transition potential map and both the observed and the predicted agricultural to developed areas transitions reveals that the order of the transition potential values does not perfectly fit the observed change; whereas, the predicted change is not solely limited to areas with high potential.     

Combining mapped and statistical data in forest ecological inventory and monitoring – supplementing an existing system

A forest ecological inventory and monitoring system combining information derived from maps and samples is proposed based on ecosystem regions (Bailey, 1994). The system extends the design of the USDA Forest Service Region 6 Inventory and Monitoring System (R6IMS) in the Pacific Northwest of the United States. The key uses of the information are briefly discussed and expected results are illustrated with examples. The system is flexible, allowing regions based on ecological considerations to be modified. Sampling intensities that are affordable are likely to be insufficient to provide meaningful estimates for key parameters relating to rare and endangered species, watersheds, and other ecological units. Methods are proposed for collecting additional information in follow-up surveys and combining it with relevant information obtained in R6IMS. Near-continuous information on weather and possible pollution variables recorded by instruments at sampling sites is needed to develop meaningful models to understand what is happening in the ecoregions. R6IMS and the proposed additions constitute a dynamic system which will be modified further as data are analyzed.     

Climate impact on social systems: the risk assessment approach

A novel approach to the problem of estimating climate impact on social systems is suggested. This approach is based on a risk concept, where the notion of critical events is introduced and the probability of such events is estimated. The estimation considers both the inherent stochasticity of climatic processes and the artificial stochasticity of climate predictions due to scientific uncertainties. The method is worked out in some detail for the regional problem of crop production and the risks associated with global climate change, and illustrated by a case study (Kursk region of the FSU). In order to get local climatic characteristics (weather), a so-called statistical weather generator is used. One interesting finding is that the 3% risk level remains constant up to 1.0–1.1°C rise of mean seasonal temperature, if the variance does not change. On the other hand, the risk grows rapidly with increasing variance (even if the mean temperature rises very slowly). The risk approach is able to separate two problems: (i) assessment of global change impact, and (ii) decision making. The main task for the scientific community is to provide the politicians with different options; the choice of admissible (from the social point of view) critical events and the corresponding risk levels is the business of decision makers.