臭氧-曝气生物滤池处理酸性玫瑰红染料废水

在实验室配制含酸性玫瑰红染料的印染废水，采用臭氧氧化-曝气生物滤池工艺开展处理试验。试验运行结果表明，臭氧氧化处理能提高模拟废水的可生化性，BOD／COD值由原水的0．18上升到0．36。经组合工艺处理后出水COD〈40mg／L，色度40倍以下，SS约50mg／L，处理效果良好。     

接种厌氧消化污泥EGSB反应器的快速启动

对接种市政消化污泥的EGSB反应器的启动进行实验研究以寻求快速启动EGSB反应器的有效方法。接种厌氧消化污泥EGSB反应器的成功启动仅需要46d。在整个启动期保持适当的液体上升流速是非常重要的。启动初期，高液体上升流速能够将悬浮污泥冲出反应器，使适合聚集的微生物留在反应器内。接下来需要降低进水流量和液体上升流速以利于构建稳定的微生态系统，使高活性颗粒污泥尽快形成。然后适当提高液体上升流速能保持污水与微生物的良好接触，促进颗粒污泥内外高效传质，形成更加稳定高效的微生物群落结构。为尽快形成高活性颗粒污泥，保证产甲烷菌的最佳营养需求是关键，可通过考虑进水基质、微量营养元素和硫化物来提高其活性。     

Wet air oxidation of a reactive dye solution using CoAlPO(4)-5 and CeO(2) catalysts

Wet air oxidation of a prepared reactive dye solution was performed to assess the efficacy of CoAlPO(4)-5 and CeO(2) as catalysts in the reaction. Via adsorption and oxidation of dye, CoAlPO(4)-5 effectively decreased American Dye Manufacturers Institute and chemical oxygen demand (COD) values in the dye solution. At a reaction temperature of 135 degrees C and an applied pressure of 1.0 MPa, color and COD removal were as high as 95% and 90%, respectively, after 2 h. Active sites on the outer surface of CoAlPO(4)-5 are responsible for adsorption and decomposition of dye while active sites in the pores dominate further destruction and oxidation of intermediate products. Since the outer surface only represents a minor part of the total surface, the color removal does not increase appreciably with loading of CoAlPO(4)-5. The CeO(2) catalyst, calcined from cerium chloride under high thermal impact (type A CeO(2)) was very effective in removing color and COD from the solution. This catalyst demonstrated near 100% color removal at temperatures above 135 degrees C and the COD removal could be above 95% at 165 degrees C. With both CoAlPO(4)-5 and CeO(2) catalysts, COD rose and then fell back during the reaction, a feature typical of a consecutive reaction. In contrast to prepared CeO(2), a commercial CeO(2) did not exhibit any catalytic ability for the removal of color and COD. The durability of both CoAlPO(4)-5 and prepared CeO(2) is considered to be fair.     

Comparison of different sequential extraction procedures for mercury fractionation in polluted soils

Environmental Science and Pollution Research - Three sequential extraction procedures (SEPs), modified Tessier, modified BCR, and CIEMAT, were compared for mercury fractionation in polluted soils....     

Spatial distribution and ecological risk assessment of sediment metals in a highly industrialized coastal zone southwestern Taiwan

Spatial variations of Cr, Cu, Hg, Ni, Pb, and Zn in the surface sediments from 34 stations of the Kaohsiung coastal zone southwestern Taiwan were studied to address the current pollution status, sediment quality, and potential ecological risk. The study revealed that the concentrations of sediment metals in Kaohsiung Harbor were alarmingly high compared to the other region of Kaohsiung coast. The concentrations of Cr, Cu, Hg, Ni, Pb, and Zn in the harbor sediments were as high as 351, 247, 1.93, 61.8, 60.9, and 940 mg kg⁻¹, respectively. The current situation of metal pollution was assessed by different pollution indices and results showed moderate to severe enrichment of Cu, Hg, and Zn in the harbor sediments. According to the degree of contamination, pollution load index, and contamination severity index, the sediments from the inner Kaohsiung Harbor show high degree and high severity of metal contamination, while the rest of Kaohsiung coastal areas show uncontaminated or low-level pollution. Results of mean ERM quotient and potential ecological risk index also indicated that the harbor sediments posed a 49% probability of biological toxicity and very high ecological risk. The toxic units indicated that the negative biological effects of the six metals in the harbor sediments were Zn > Cu > Cr > Ni > Hg > Pb. In contrast to Kaohsiung Harbor as a trap where considerable amount of anthropogenic metal loadings accumulated in sediments, low metal concentrations were observed in most Kaohsiung coastal sediments. It probably resulted from the limited fine-grained sediment deposition. In the wave-dominated Kaohsiung coastal zone, fine-grained sediments associated with polluted metals tend to be easily resuspended and transported offshore via waves and wave-induced currents. The results of this study can provide valuable information for river and coastal zone management.

     

新生态MnO2吸附剂对酸性媒介染料废水脱色特性研究

本文主要报道了一种用于染料废水处理的新型材料即新生态MnO2 及其对三种酸性媒介染料染色废水的脱色作用及影响脱色效果的主要因素。研究结果表明 ,新生态MnO2 对酸性媒介染料的吸附能力很强 ,当染料浓度为2 0 0mg/L、pH <2时 ,其对酸性媒介黑T、酸性媒介绿G和酸性媒介黄GG的脱色率分别达 98.2 %、94.5 %和 96 .4%。染料吸附效果受体系pH值、MnO2 投加量、吸附时间及温度等因素的影响 ,其中pH值是最主要的影响因素。新生态MnO2 对酸性媒介黄GG的吸附作用符合Langmuir吸附等温式     

前置反硝化生物滤池深度脱氮效能与影响因素

前置反硝化生物滤池具有良好的脱氮性能,被广泛用于污水的深度处理。采用该工艺对城市污水处理厂尾水进行深度处理,通过调节硝化液回流比（50%、100%、150%）和水力负荷（1.0、1.5和2.0 m3·（m2·h）-1）,考察前置反硝化生物滤池工艺对COD、TN、NH4+-N的去除效果。结果表明,当硝化液回流比为100%时,系统对污染物去除效果最好。在进水COD、TN、NH4+-N平均浓度为120、35和15 mg·L-1的水质条件下,出水COD、TN、NH4+-N平均浓度可降到7.62、5.02和0.60 mg·L-1,去除率分别为93.65%、85.65%和96.00%。在水力负荷为1.5 m3·（m2·h）-1条件下,系统对COD、TN和NH4+-N的平均去除率达到了83.00%、90.14%和95.73%,出水可以达到《城镇污水处理厂污染物排放标准》（GB 18918-2002）一级A标准。     

烟气脱硫过程锰催化氧化亚硫酸钙的研究

利用直径280 mm、高320 mm的间歇式搅拌槽,在MnSO4加入浓度为0～0.05 mol/L的情况下,对亚硫酸钙悬浮液进行了催化氧化实验研究.实验结果表明,锰离子的加入会改变亚硫酸钙的氧化机理及氧化过程,表现为终点氧化率和氧化速率的变化.当Mn2 浓度为0.05 mol/L时,亚硫酸钙的终点氧化率比未加入Mn2 时高30%;此外,与非催化反应过程相比,Mn2 的加入能使亚硫酸钙在一个更宽的浓度范围内(0.02～0.073 mol/L)和一个更宽的时间范围内(20～100 min)均保持较高的氧化速率水平.     

响应面分析法优化稀土废水MAP沉淀法脱氮

经过预处理后的稀土生产废水,其氨氮浓度大幅降低,但并未达到中华人民共和国《稀土工业污染物排放标准》（GB26451-2011）中氨氮浓度限值。实验通过响应面分析法中的Box-Behnken实验设计（BBD）,取pH、n（Mg）：n（N）、n（P）：n（N）3因素,采用Design-Expert 8.0.6,建立合适的剩余氨氮浓度及剩余总磷浓度模型,得到回归方程,并分析模型各项指标,各因素及其相互作用对剩余氨氮浓度及剩余总磷浓度的影响。利用预测模型预测最佳实验条件,在最佳实验条件下验证预测结果,并对沉淀物进行X射线衍射（XRD）分析。结果显示,二次响应模型适用于剩余氨氮浓度及剩余总磷浓度,2个模型均拥有较好的拟合程度、可信度及精密度,最优反应条件为：pH=9.88、n（Mg）：n（N）=1.50：1、n（P）：n（N）=1.38：1时,剩余氨氮浓度为46.58 mg/L,剩余总磷浓度为7.85 mg/L。在最优条件下所得到的沉淀物并非纯净的MgNH₄PO₄·6H₂O,还有Mg₃（PO₄）₂·22H₂O生成。     

Degradation of bisphenol A in aqueous solution by persulfate activated with ferrous ion

Degradation of bisphenol A (BPA) in aqueous solution was studied with high-efficiency sulfate radical (SO₄ ^?·), which was generated by the activation of persulfate (S₂O₈ ^2?) with ferrous ion (Fe²⁺). S₂O₈ ^2? was activated by Fe²⁺ to produce SO₄ ^?·, and iron powder (Fe⁰) was used as a slow-releasing source of dissolved Fe²⁺. The major oxidation products of BPA were determined by liquid chromatography-mass spectrometer. The mineralization efficiency of BPA was monitored by total organic carbon (TOC) analyzer. BPA removal efficiency was improved by the increase of initial S₂O₈ ^2? or Fe²⁺ concentrations and then decreased with excess Fe²⁺ concentration. The adding mode of Fe²⁺ had significant impact on BPA degradation and mineralization. BPA removal rates increased from 49 to 97 % with sequential addition of Fe²⁺, while complete degradation was observed with continuous diffusion of Fe²⁺, and the latter achieved higher TOC removal rate. When Fe⁰ was employed as a slow-releasing source of dissolved Fe²⁺, 100 % of BPA degradation efficiency was achieved, and the highest removal rate of TOC (85 %) was obtained within 2 h. In the Fe⁰–S₂O₈ ^2? system, Fe⁰ as the activator of S₂O₈ ^2? could offer sustainable oxidation for BPA, and higher TOC removal rate was achieved. It was proved that Fe⁰–S₂O₈ ^2? system has perspective for future works.