Numerical Simulation of Synoptic Condition on a Severe Sand Dust Storm

By using observational data and MM5, an observational analysisand numerical study was conducted on the synoptic condition of a severe dust storm that was caused by a Mongolian cyclone whichoccurred from 6 to 8 April 2001. Results illustrated thatthe cyclogenesis was due to the isentropic potential vorticity (IPV) advection in the upper troposphere and the terrain modifiedbaroclinicity in the mid-lower troposphere. The Altai-Sayan complex of mountains blocked the lower level cold air and made the isentropic surface sharply steep. When the air slid down along the isentropic surface the increasing of baroclinicity anddecreasing of stability blew up the vertical vorticity development.The formation of the dust storm was a result of a cyclonic cold front passing across the area. The occurrence of this dust stormwas closely related to the strong surface wind, which was accompanied by a cold front passing, rather than the cyclogenesis, itself. Hence, the reason for the pre-front dust storm formulation was the formation of heating convection. Reasons behind the formation of a black storm (visibilitylower than 50 m), which occurred in the mid-north part ofInner Mongolia, lay in several aspects. Firstly, in thisarea the surface wind was strong, a direct result of thedownward transport in mid-lower troposphere. Secondly,the cold front passed over the effected area near sunsetso the air obtained much more surface heating to form adeeper mixed layer (ML). Thirdly, cooperation between thelower level wind and the terrain made the atmosphere inthis area and acquired the maximum advective contributionnecessary to form a deep post-front ML. The sensitivityexperiment revealed that surface heat flux was important to the frontal lifting. In addition, the forcing of surface heating wasalso seen as the primary forcing mechanism of frontogenesis. Meanwhile, removal of the surface heat flux made the atmosphericstratification became stable and the pre-storm ML very shallow,which weakened the strength of the dust storm.     

Regional Variations in the Implementation of the Local Air Quality Management Process within Great Britain

The UK National Air Quality Strategy has required local authorities to review and assess air quality in their area of jurisdiction and determine locations in their areas where concentrations of specific air quality pollutants are predicted to exceed national air quality objectives in the future. Statutory air quality management areas (AQMAs) are designated where air quality is predicted to be above specified objective concentrations by specific target dates, and statutory air quality action plans will be necessary to improve the local air quality within these areas. Over 124 local authorities in England (including London), Wales and Scotland anticipate declaring AQMAs following the conclusion of the statutory air quality review and assessment process. However, other influences are being exerted on the local air quality management process and AQMA decision-making processes. Such influences include regional and sub- regional collaborative working between local authorities and government agencies and wider political decision-making processes. Some regions of Great Britain (encompassing England (including London), Scotland and Wales) anticipate many AQMA designations, whilst other regions are not anticipating any such designations despite apparently similar air quality circumstances. Evidence for regional or sub-regional variations in the locations of anticipated AQMAs are examined through an evaluation of the outcomes of the scientific review and assessment process undertaken by local authorities declaring AQMAs, and through a local authority survey to identify influences on decision-making processes at a level above that of the local authority. Regional variation is reported in the type of pollutant causing AQMAs to be declared, in the numbers of AQMAs in regions and in the spatial distribution of AQMAs across Great Britain.     

COMPARATIVE STUDY OF OPTIMIZATION TECHNIQUES FOR IRRIGATION PROJECT PLANNING1

ABSTRACT: This study presents three optimization techniques for on‐farm irrigation scheduling in irrigation project planning: namely the genetic algorithm, simulated annealing and iterative improvement methods. The three techniques are applied to planning a 394.6 ha irrigation project in the town of Delta, Utah, for optimizing economic profits, simulating water demand, and estimating the crop area percentages with specific water supply and planted area constraints. The comparative optimization results for the 394.6 ha irrigated project from the genetic algorithm, simulated annealing, and iterative improvement methods are as follows: (1) the seasonal maximum net benefits are $113,826, $111,494, and $105,444 per season, respectively; and (2) the seasonal water demands are 3.03*10³ m³, 3.0*10³ m³, and 2.92*10³ m³ per season, respectively. This study also determined the most suitable four parameters of the genetic algorithm method for the Delta irrigated project to be: (1) the number of generations equals 800, (2) population size equals 50, (3) probability of crossover equals 0.6, and (4) probability of mutation equals 0.02. Meanwhile, the most suitable three parameters of simulated annealing method for the Delta irrigated project are: (1) initial temperature equals 1,000, (2) number of moves equal 90, and (3) cooling rate equals 0.95.     

COALBED METHANE PRODUCT WATER CHEMISTRY IN THREE WYOMING WATERSHEDS1

ABSTRACT: The Powder River Basin in Wyoming has become one of the most active areas of coalbed methane (CBM) development in the western United States. Extraction of methane from coalbeds requires pumping of aquifer water, which is called product water. Two to ten extraction wells are manifolded into one discharge point and product water is released into nearby unlined holding ponds. The objective of this study was to evaluate the chemistry, salinity, and sodicity of CBM product water at discharge points and associated holding ponds as a function of watershed. The product water samples from the discharge points and associated holding ponds were collected from the Cheyenne River (CHR), Belle Fourche River (BFR), and Little Powder River (LPR) watersheds during the summers of 1999 and 2000. These samples were analyzed for pH, electrical conductivity (EC), total dissolved solids (TDS), alkalinity, sodium (Na), calcium (Ca), magnesium (Mg), potassium (K), sulfate (SO₄^2‐), and chloride (C^1‐). From the chemical data, practical sodium adsorption ratio (SARp) and true sodium adsorption ratio (SARt) were calculated for the CBM discharge water and pond water. The pH, EC, TDS, alkalinity, Na, Ca, Mg, K, SARp, and SARt of CBM discharge water increased significantly moving north from the CHR watershed to the LPR watershed. CBM discharge water in associated holding ponds showed significant increases in EC, TDS, alkalinity, Na, K, SARp, and SARt moving north from the CHR to the LPR watershed. Within watersheds, the only significant change was an increase in pH from 7.21 to 8.26 between discharge points and holding ponds in the LPR watershed. However, the LPR and BFR exhibited larger changes in mean chemistry values in pH, salinity (EC, TDS), and sodicity (SAR) between CBM product water discharges and associated holding ponds than the CHR watershed. For instance, the mean EC and TDS of CBM product water in LPR increased from 1.93 to 2.09 dS/m, and froml,232 to 1,336 mg/L, respectively, between discharge and pond waters. The CHR exhibited no change in EC, TDS, Na, or SAR between discharge water and pond water. Also, while not statistically significant, mean alkalinity of CBM product water in BFR and LPR watersheds decreased from 9.81 to 8.01 meq/L and from 19.87 to 18.14 meq/L, respectively, between discharge and pond waters. The results of this study suggest that release of CBM product water onto the rangelands of BFR and LPR watersheds may precipitate calcium carbonate (CaCO₃) in soils, which in turn may decrease infiltration and increase runoff and erosion. Thus, use of CBM product water for irrigation in LPR and BFR watersheds may require careful planning based on water pH, EC, alkalinity, Na, and SAR, as well as local soil physical and chemical properties.     

STREAM DISCHARGE PREDICTION VIA A GRID BASED SOIL WATER ROUTING WITH PADDY FIELDS1

ABSTRACT: A grid based daily hydrologic model for a watershed with paddy fields was developed to predict the stream discharge. ASCII formatted elevation, soil, and land use data supported by the GRASS Geographic Information System are used to generate distributed results such as surface runoff and subsurface flow, soil water content, and evapotranspiration. The model uses a single flow path algorithm and simulates a water balance at each grid element. A linear reservoir assumption was used to predict subsurface runoff components. The model was applied to a 75.6 km² watershed located in the middle of South Korea, and observed stream flow hydrographs from 1995 and 1996 were compared to model predictions. The stream flow predictions of 1995 and 1996 generally agreed with the observed flow, resulting in a Nash‐Sutcliffe efficiency R² of 0.60 and 0.62, respectively. The hydraulic conductivity for percolating water through the saturated layer affected baseflow generation. The levee height of the paddy influenced the time and magnitude of the surface runoff, depending on irrigation management. The model will be used for making low flow management decisions by evaluating the role of each land use to stream flow, especially in case of paddy decrease by gradual urbanization of a watershed.     

GROUND WATER NITRATE REDUCTION IN GIANT CANE AND FOREST RIPARIAN BUFFER ZONES1

ABSTRACT: Ground water contamination by excess nitrate leaching in row‐crop fields is an important issue in intensive agricultural areas of the United States and abroad. Giant cane and forest riparian buffer zones were monitored to determine each cover type's ability to reduce ground water nitrate concentrations. Ground water was sampled at varying distances from the field edge to determine an effective width for maximum nitrate attenuation. Ground water samples were analyzed for nitrate concentrations as well as chloride concentrations, which were used as a conservative ion to assess dilution or concentration effects within the riparian zone. Significant nitrate reductions occurred in both the cane and the forest riparian buffer zones within the first 3.3 m, a relatively narrow width. In this first 3.3 m, the cane and forest buffer reduced ground water nitrate levels by 90 percent and 61 percent, respectively. Approximately 40 percent of the observed 99 percent nitrate reduction over the 10 m cane buffer could be attributed to dilution by upwelling ground water. Neither ground water dilution nor concentration was observed in the forest buffer. The ground water nitrate attenuation capabilities of the cane and forest riparian zones were not statistically different. During the spring, both plant assimilation and denitrification were probably important nitrate loss mechanisms, while in the summer nitrate was more likely lost via denitrification since the water table dropped below the rooting zone.     

COLD WATER PATCHES IN WARM STREAMS: PHYSICOCHEMICAL CHARACTERISTICS AND THE INFLUENCE OF SHADING1

ABSTRACT: Discrete cold water patches within the surface waters of summer warm streams afford potential thermal refuge for cold water fishes during periods of heat stress. This analysis focused on reach scale heterogeneity in water temperatures as influenced by local influx of cooler subsurface waters. Using field thermal probes and recording thermistors, we identified and characterized cold water patches (at least 3°C colder than ambient streamflow temperatures) potentially serving as thermal refugia for cold water fishes. Among 37 study sites within alluvial valleys of the Grande Ronde basin in northeastern Oregon, we identified cold water patches associated with side channels, alcoves, lateral seeps, and floodplain spring brooks. These types differed with regard to within floodplain position, area, spatial thermal range, substrate, and availability of cover for fish. Experimental shading cooled daily maximum temperatures of surface waters within cold water patches 2 to 4°C, indicating a strong influence of riparian vegetation on the expression of cold water patch thermal characteristics. Strong vertical temperature gradients associated with heating of surface layers of cold water patches exposed to solar radiation, superimposed upon vertical gradients in dissolved oxygen, can partially restrict suitable refuge volumes for stream salmonids within cold water patches.     

提高化学需氧量质控合格率的研究

大庆油田化工总厂废水中化学需氧量（COD）的测定采用库仑法。为了提高质控合格率，从人员素质、仪器设备、电级内液等9个方面分析寻找导致误差的主要影响因素并制定对策。同时对影响电极内液及消解的因素进行正交实验确定最佳条件。结果使库仑法质控合格率由90％提高到95％，测定38次标样全部合格。     

Marine protected areas and local coastal conservation and management in Hong Kong

This paper focuses on the role of marine parks and reserves in the conservation of Hong Kong's coastal environment. This environment is under serious threat as a result of pollution of marine waters and habitat loss associated with urbanisation, large-scale reclamation projects, and inadequate treatment and disposal of sewage and industrial effluents. The paper discusses whether in a highly urbanised and stressed environment like Hong Kong, which currently lacks a conservation strategy and an overall framework for handling sustainability issues, small marine parks and reserves can be effective in helping to conserve local biodiversity. The paper also suggests that Hong Kong should adopt a broader regional perspective on its coastal conservation and management problems, a perspective that recognises the significance for the territory of the rapid urban and industrial development taking place in neighbouring Guangdong Province. This will require more extensive and focused liaison with Chinese agencies.     

Climate Convention Implementation: An Opportunity for the Pacific Island Nations to Move Toward Sustainable Energy Systems

This article does not focus on adaptation or mitigation policy directly but on an allied opportunity that exists for the Pacific Islands via the auspices of the Climate Convention, because the existing very costly energy systems used in the Pacific Island region are fossil-fuel dependent. It is argued here that efforts can be made towards the development of energy systems that are ecologically sustainable because Pacific Island nations are eligible to receive assistance to introduce renewable energy technology and pursue energy conservation via implementation mechanisms of the Climate Convention and, in particular, through transfer of technology and via joint implementation. It is contended that assistance in the form of finance, technology, and human resource development from developed countries and international organizations would provide sustainable benefits in improving the local Pacific Island environments. It is also emphasized that mitigation of greenhouse gas emissions is not the responsibility of the Pacific Islands as they contribute very little on a per capita global scale and a tiny proportion of total global greenhouse gas emissions.