基于洪涝风险分析的纽约市城市绿地规划设计及其对中国的启示

1968年美国开始推行洪涝保险计划,不断完善对洪涝风险的研究,并逐步形成了一套相对完善的洪泛区管理体系,而洪涝风险分析在洪涝保险、城市规划、土地开发、应急管理等领域广泛应用。纽约市在经历了多次飓风侵害,尤其是2012年飓风桑迪（Sandy）之后,意识到城市绿地在极端暴雨事件时对雨洪调蓄的重要作用,经过持续的研究实践,提出了基于洪涝风险分析的城市绿地规划设计要求。基于总结美国纽约市在飓风桑迪影响下对洪涝风险图的调整,及其对城市绿地规划设计相关要求,提出其对我国洪涝风险管控及城市绿地规划设计的启示。     

新型厌氧多级喷动床及其厌氧氨氧化脱氮性能分析

为改善厌氧反应器内的流态,加快污泥的颗粒化和形成具有生态梯度的微生物生态系统,设计并制作了新型厌氧多级喷动床,实验测试了反应器的水力喷动、气体喷涌和污泥分层分级现象。在常温下,利用新型厌氧多级喷动床接种混合污泥,经过42 d的培养,成功启动厌氧氨氧化反应器,稳定运行18 d后,NH₄+-N、NO₂--N去除率均达到90%以上。启动60 d后,反应器底部出现大量粒径2 mm左右的颗粒污泥,且污泥具有良好的稳定性和沉降性能,沉降速度达到70 m/h。结果表明:厌氧多级喷动床因其特殊的水力结构,可有效加快污泥的颗粒化。     

基于“BIM+GIS”技术的建筑垃圾精准管控信息管理平台研究初探

近年来,我国建筑垃圾产量不断增加,全国600多座大中城市中有70%被垃圾所包围,其中建筑垃圾贡献率达到40%,而相比于部分发达国家,我国尚缺少针对于建筑垃圾的全过程实时监测与智能管控手段。将"BIM+GIS"技术引入建筑垃圾监管领域,并基于此技术建立建筑垃圾实时监测与智能管控信息管理平台,可实现对建筑垃圾的精准管控。     

基于在线监测+模型的海绵城市建设径流水量控制效果研究

以青岛市海绵城市典型项目区为研究区,通过收集、整理和概化汇水区资料,构建了研究区降雨径流模型——SWMM模型。利用2018年雨季的降雨-径流实时监测数据,进行了模型关键参数的率定和模型验证,研究了海绵城市建设在削减径流量、增加入渗与滞蓄雨量方面的定量效果。结果显示:海绵改造后,不同降雨强度下形成径流的雨量占总雨量的平均比例由56%下降至29%;下渗雨水的平均比例由40%增加至60%,滞蓄深度由0.63 mm增加至5 mm。海绵改造前后研究区场降雨径流总量控制率变化显著,当以1~10年一遇的短历时（120 min）设计降雨作为模型边界条件进行模拟时,海绵化改造后场次降雨径流总量控制率提高了26%~34%,认为研究区基本达到了海绵城市关于水量控制的建设要求。     

Aerosol optical properties under different pollution levels in the Pearl River Delta (PRD) region of China

To clarify the aerosol hygroscopic growth and optical properties of the Pearl River Delta(PRD)region,integrated observations were conducted in Heshan City of Guangdong Province from October 19 to November 17,2014.The concentrations and chemical compositions of PM_(2.5),aerosol optical properties and meteorological parameters were measured.The mean value of PM_(2.5) increased from less than 35(excellent) to 35-75 μg/m~3(good) and then to greater than 75 μg/m~3(pollution),corresponding to mean PM_(2.5) values of 24.9,51.2,and 93.3 μg/m~3,respectively.The aerosol scattering hygroscopic growth factor(f(RH = 80%)) values were 2.0,2.12,and 2.18 for the excellent,good,and pollution levels,respectively.The atmospheric extinction coefficient(σext)and the absorption coefficient of aerosols(σ_(ap)) increased,and the single scattering albedo(SSA)decreased from the excellent to the pollution levels.For different air mass sources,under excellent and good levels,the land air mass from northern Heshan had lower f(RH) and σ_(sp) values.In addition,the mixed aerosol from the sea and coastal cities had lower f(RH) and showed that the local sources of coastal cities have higher scattering characteristics in pollution periods.     

Development of a static test apparatus for evaluating the performance of three PM2.5 separators commonly used in China

PM_(2.5) separator directly affects the accuracy of PM_(2.5) sampling.The specification testing and evaluation for PM_(2.5) separator is particularly important,especially under China's wide variation of terrain and climate.In this study,first a static test apparatus based on polydisperse aerosol was established and calibrated to evaluate the performance of the PM_(2.5) separators.A uniform mixing chamber was developed to make particles mix completely.The aerosol concentration relative standard deviations of three test points at the same horizontal chamber position were less than 0.57%,and the particle size distribution obeyed logarithmic normal distribution with an R~2 of 0.996.The flow rate deviation between the measurement and the set point flow rate agreed to within ± 1.0% in the range of -40 to 50℃.Secondly,the separation,flow and loading characteristics of three cyclone separators(VSCC-A,SCC-A and SCC112) were evaluated using this system.The results showed that the 50% cutoff sizes(D_(50)) of the three cyclones were 2.48,2.47 and 2.44 μm when worked at the manufacturer's recommended flow rates,respectively.The geometric standard deviation(GSD) of the capture efficiency of VSCCA was 1.23,showed a slightly sharper than SCC-A(GSD = 1.27),while the SCC112 did not meet the relevant indicator(GSD = 1.2 ± 0.1) with a GSD = 1.44.The flow rate and loading test had a great effect on D_(50),while the GSD remained almost the same as before.In addition,the maintenance frequency under different air pollution conditions of the cyclones was summarized according to the loading test.     

Synergistic effects of Cu species and acidity of Cu-ZSM-5 on catalytic performance for selective catalytic oxidation of n-butylamine

In this work, a series of Cu-ZSM-5 catalysts with different SiO₂/Al₂O₃ ratios (25, 50, 100 and 200) were synthesized and investigated in n-butylamine catalytic degradation. The n-butylamine can be completely catalytic degradation at 350°C over all Cu-ZSM-5 catalysts. Moreover, Cu-ZSM-5 (25) exhibited the highest selectivity to N₂, exceeding 90% at 350°C. These samples were investigated in detail by several characterizations to illuminate the dependence of the catalytic performance on redox properties, Cu species, and acidity. The characterization results proved that the redox properties and chemisorption oxygen primarily affect n-butylamine conversion. N₂ selectivity was impacted by the Brønsted acidity and the isolated Cu²⁺ species. Meanwhile, the surface acid sites over Cu-ZSM-5 catalysts could influence the formation of Cu species. Furthermore, in situ diffuse reflectance infrared Fourier transform spectra was adopted to explore the reaction mechanism. The Cu-ZSM-5 catalysts are the most prospective catalysts for nitrogen-containing volatile organic compounds removal, and the results in this study could provide new insights into catalysts design for VOC catalytic oxidation.     

UV/H2O2 oxidation of tri(2-chloroethyl) phosphate: Intermediate products, degradation pathway and toxicity evaluation

Tri(2-chloroethyl) phosphate (TCEP) with the initial concentration of 5 mg/L was degraded by UV/H₂O₂ oxidation process. The removal rate of TCEP in the UV/H₂O₂ system was 89.1% with the production of Cl^? and PO₄^3? of 0.23 and 0.64 mg/L. The removal rate of total organic carbon of the reaction was 48.8% and the pH reached 3.3 after the reaction. The oxidative degradation process of TCEP in the UV/H₂O₂ system obeyed the first order kinetic reaction with the apparent rate constant of 0.0025 min^?1 (R²=0.9788). The intermediate products were isolated and identified by gas chromatography-mass spectrometer. The addition reaction of HO? and H₂O and the oxidation reaction with H₂O₂ were found during the degradation pathway of 5 mg/L TCEP in the UV/H₂O₂ system. For the first time, environment risk was estimated via the “ecological structure activity relationships” program and acute and chronic toxicity changes of intermediate products were pointed out. The luminescence inhibition rate of photobacterium was used to evaluate the acute toxicity of intermediate products. The results showed that the toxicity of the intermediate products increased with the increase of reaction time, which may be due to the production of chlorine compounds. Some measures should be introduced to the UV/H₂O₂ system to remove the highly toxic Cl-containing compounds, such as a nanofiltration or reverse osmosis unit.     

底泥原位洗脱过程中氮磷含量与形态变化特征

随着城市化进程的不断推进,城市河流底泥中内源氮磷污染问题日益突出.为研究原位洗脱技术对污染底泥中氮、磷物质和成分的作用效果,以北京市凉水河作为研究对象,分别比较了现场试验洗脱与对照组0~30 cm分层底泥以及实验室模拟洗脱处理前后0~10 cm底泥中pH、E_h（氧化还原电位）、容重、含水率、OM（有机质）、TN、TP和氮、磷形态分布的变化特征.结果表明:①现场洗脱对0~5 cm厚度底泥的处理和模拟洗脱处理均对底泥中pH、E_h、含水率的改变以及其中TN、TP的去除效果表现显著,其中,现场试验洗脱组0~5 cm范围底泥中w（TN）、w（TP）分别较对照组降低了66.4%±17.4%、40.8%±24.4%,模拟洗脱处理对底泥中OM、TN、TP的去除率分别达70.1%±4.8%、66.8%±2.0%、43.1%±3.1%.②原位洗脱技术对底泥中TN的去除主要通过对PON（颗粒态有机氮）的去除来实现,现场和模拟试验过程中PON对TN去除的贡献率分别达55.0%和73.6%.③原位洗脱对底泥中TP的去除主要通过对Al-P（铝结合态磷）、OP（有机磷）的去除来实现,现场和模拟试验中Al-P、OP对TP去除的贡献率分别达37.0%、66.2%和31.3%、43.7%.研究显示,原位洗脱技术可有效去除城市河流底泥处理层中的氮磷物质,并以有机氮、磷物质的去除为主.      

Photodegradation of Hexafluoropropylene Oxide Trimer Acid under UV Irradiation

As a novel alternative to traditional perfluoroalkyl substances (PFASs), including perfluorooctanoic acid (PFOA) and perfluorooctane sulfonate (PFOS), hexafluoroproplyene oxide trimer acid (HFPO-TA) has been detected worldwide in surface water. Moreover, recent researches have demonstrated that HFPO-TA has stronger bioaccumulation potential and higher hepatotoxicity than PFOA. To treat these contaminants e.g. PFOA and PFOS, some photochemical techniques by adding exogenous substances had been reported. However, there is still no report for the behavior of HFPO-TA itself under direct UV irradiation. The current study investigated the photo-transformation of HFPO-TA under UV irradiation in aqueous solution. After 72 hr photoreaction, 75% degradation ratio and 25% defluorination ratio were achieved under ambient condition. Reducing active species, i.e., hydrated electrons and active hydrogen atoms, generated from water splitting played dominant roles in degradation of HFPO-TA, which was confirmed by different effects of reaction atmospheres and quenching experiments. A possible degradation pathway was proposed based on the products identification and theoretical calculations. In general, HFPO-TA would be transformed into shorter-chain PFASs, including hexafluoropropylene oxide dimer acid (HFPO-DA), perfluoropropionic acid (PFA) and trifluoroacetate (TFA). This research provides basic information for HFPO-TA photodegradation process and is essential to develop novel remediation techniques for HFPO-TA and other alternatives with similar structures.