Effect of alginate on the aggregation kinetics of copper oxide nanoparticles (CuO NPs): bridging interaction and hetero-aggregation induced by Ca<Superscript>2+</Superscript>

The stability of CuO nanoparticles (NPs) is expected to play a key role in the environmental risk assessment of nanotoxicity in aquatic systems. In this study, the effect of alginate (model polysaccharides) on the stability of CuO NPs in various environmentally relevant ionic strength conditions was investigated by using time-resolved dynamic light scattering. Significant aggregation of CuO NPs was observed in the presence of both monovalent and divalent cations. The critical coagulation concentrations (CCC) were 54.5 and 2.9 mM for NaNO₃ and Ca(NO₃)₂, respectively. The presence of alginate slowed nano-CuO aggregation rates over the entire NaNO₃ concentration range due to the combined electrostatic and steric effect. High concentrations of Ca²⁺ (>6 mM) resulted in stronger adsorption of alginate onto CuO NPs; however, enhanced aggregation of CuO NPs occurred simultaneously under the same conditions. Spectroscopic analysis revealed that the bridging interaction of alginate with Ca²⁺ might be an important mechanism for the enhanced aggregation. Furthermore, significant coagulation of the alginate molecules was observed in solutions of high Ca²⁺ concentrations, indicating a hetero-aggregation mechanism between the alginate-covered CuO NPs and the unabsorbed alginate. These results suggested a different aggregation mechanism of NPs might co-exist in aqueous systems enriched with natural organic matter, which should be taken into consideration in future studies.

Open image in new window

Graphical abstract Hetero-aggregation mechanism of CuO nanoparticles and alginate under high concentration of Ca²⁺

     

GC/MS法测定润滑油基础油中多环芳烃

对润滑油基础油中多环芳烃的气相色谱/质谱(GC/MS)测定方法进行了研究,探讨了样品的提取,固相萃取柱净化等前处理方法,同时也对仪器测定条件进行了优化.结果表明,在检测润滑油基础油中多环芳烃时,经优化的GC/MS法的加标回收率和精密度均达到较满意的水平.     

无银催化-分光光度法测定COD的研究

以XS-LP为催化剂,探讨了改进的无银催化HACH法测定污水中COD的系列条件实验。结果表明:在药剂A,B的投配比为1∶2,投加总量为12 g/L的条件下,其准确度、精密度与国标法有较好的可比性,分别小于10%和3%;对实际废水的测量结果与国标回流法的相关系数分别高达0.9951和0.9874,可满足一般环境检测技术规范要求。     

A process integration approach to industrial water conservation: a case study for a Chinese steel plant

A systematic approach to optimizing water network has traditionally been utilized to exam and plan water conservation in industrial processes. In the present case study, water-pinch technology was used to analyze and optimize the water network of a steel plant near China's Zhangjiakou city. A system design was developed and a limiting constraint (Cl(-) concentration) was identified based on investigations of water quality then the minimum freshwater and wastewater targets were determined without considering water losses. The analysis was then extended by calculating the additional input of freshwater required to balance the actual water losses. A nearest-neighbor algorithm (NNA) was used to distribute the freshwater and recycled water among each of the plant's operations. The results showed that with some reconstruction of the water network, the flow rates of freshwater and wastewater could be decreased by 57.5% and 81.9%, respectively.     

Effect of electrokinetic property of charged polyether sulfone membrane on bovine serum albumin fouling behavior

Negatively charged carboxymethylated polyethersulfone (CMPES) and positively charged quaternized polyethersulfone (QAPES) ultrafiltration (UF) membranes were prepared by bulk chemical modification and non-solvent induced phase separation method. The effects of PES membrane interfacial electrokinetic property on the bovine serum albumin (BSA) membrane fouling behavior were studied with the aid of the membrane-modified colloidal atomic force microscopy (AFM) probe. Electrokinetic test results indicated that the streaming potential (ΔE) of QAPES membrane was not consistent with its expected IEC value, however, within the pH range of 3–10, the ζ potentials of two charged-modified PES membranes were more stable than the unmodified membrane. When pH value was 3, 4.7 or 9, the interaction behavior between charged PES membrane and BSA showed that there was significant linear correlation between the jump distance r ₀ of membrane-BSA adhesion force (F/R) and the ζ potential absolute value. Charged modification significantly reduced the adhesion of PES membrane-BSA, and the adhesion data was good linear correlated with the flux decline rate in BSA filtration process, especially reflected in the CMPES membrane. The above experimental facts proved that the charged membrane interfacial electric double layer structure and its electrokinetic property had strong ties with the protein membrane fouling behavior.

Open image in new window

     

Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.     

Quantifying interactions between propranolol and dissolved organic matter (DOM) from different sources using fluorescence spectroscopy

Beta blockers are widely used pharmaceuticals that have been detected in the environment. Interactions between beta blockers and dissolved organic matter (DOM) may mutually alter their environmental behaviors. To assess this potential, propranolol (PRO) was used as a model beta blocker to quantify the complexation with DOM from different sources using the fluorescence quenching titration method. The sources of studied DOM samples were identified by excitation–emission matrix spectroscopy (EEMs) combined with fluorescence regional integration analysis. The results show that PRO intrinsic fluorescence was statically quenched by DOM addition. The resulting binding constants (log K _oc) ranged from 3.90 to 5.20, with the surface-water-filtered DOM samples claiming the lower log K _oc and HA having the highest log K _oc. Log K _oc is negatively correlated with the fluorescence index, biological index, and the percent fluorescence response (P _i,n) of protein-like region (P _I,n) and the P _i,n of microbial byproduct-like region (P _II,n) of DOM EEMs, while it is correlated positively with humification index and the P _i,n of UVC humic-like region (P _III,n). These results indicate that DOM samples from allochthonous materials rich in aromatic and humic-like components would strongly bind PRO in aquatic systems, and autochthonous DOM containing high protein-like components would bind PRO more weakly.     

辉县市城区环境空气质量现状及污染防治对策

对辉县市城区2006—2011年间环境空气质量监测数据进行了评价,并对城区污染物浓度时空变化进行了分析。结果表明,辉县市城区大气污染主要表现为可吸入颗粒物污染严重,主要是能源结构不合理、锅炉废气污染严重、城区道路保洁方式落后等原因造成的,由此提出了合理规划城市布局、减少结构性污染等对策。     

Distribution and transport characteristics of fine particulate matter in beijing with mobile lidar measurements from 2015 to 2018

Accurately quantifying the concentration and transport flux of atmospheric fine particulate matter(PM_2.5) is vital when attempting to thoroughly identify the pollution formation mechanism.In this study,the mobile lidar measurements in Beijing on heavily polluted days in December from 2015 to 2018 are presented.The lidar was mounted on a vehicle,which could perform measurements along designated routes.On the basis of mobile lidar measurements along closed circuits of the 6 th Ring Road...     

Comparison of different liquid anaerobic digestion effluents as inocula and nitrogen sources for solid-state batch anaerobic digestion of corn stover

Effluents from three liquid anaerobic digesters, fed with municipal sewage sludge, food waste, or dairy waste, were evaluated as inocula and nitrogen sources for solid-state batch anaerobic digestion of corn stover in mesophilic reactors. Three feedstock-to-effluent (F/E) ratios (i.e., 2, 4, and 6) were tested for each effluent. At an F/E ratio of 2, the reactor inoculated by dairy waste effluent achieved the highest methane yield of 238.5 L/kgVS_feed, while at an F/E ratio of 4, the reactor inoculated by food waste effluent achieved the highest methane yield of 199.6 L/kgVS_feed. The microbial population and chemical composition of the three effluents were substantially different. Food waste effluent had the largest population of acetoclastic methanogens, while dairy waste effluent had the largest populations of cellulolytic and xylanolytic bacteria. Dairy waste also had the highest C/N ratio of 8.5 and the highest alkalinity of 19.3 g CaCO₃/kg. The performance of solid-state batch anaerobic digestion reactors was closely related to the microbial status in the liquid anaerobic digestion effluents.