Assessment of metal pollution in urban road dusts from selected highways of the Greater Toronto Area in Canada

Over the last several decades, there has been increased attention on the heavy metal contamination associated with highways because of the associated health hazards and risks. Here, the results are reported of an analysis of the content of metals in roadside dust samples of selected major highways in the Greater Toronto Area of Ontario, Canada. The metals analysed are lead (Pb), zinc (Zn), cadmium (Cd), nickel (Ni), chromium (Cr), copper (Cu), manganese (Mn), calcium (Ca), potassium (K), magnesium (Mg) and iron (Fe). In the samples collected, the recorded mean concentrations (in parts per million) are as follows: Cd (0.51), Cu (162), Fe (40,052), Cr (197.9), K (9647.6), Mg (577.4), Ca (102,349), Zn (200.3), Mn (1202.2), Pb (182.8) and Ni (58.8). The mean concentrations for the analysed samples in the study area are almost all higher than the average natural background values for the corresponding metals. The geo-accumulation index of these metals in the roadside dust under study indicates that they are not contaminated with Cr, Mn and Ca; moderately contaminate with Cd and K; strongly contaminated with Fe and Mg; strongly to extremely contaminated with Ni and Pb; and extremely contaminated with Cu and Zn. The pollution load index (PLI) is used to relate pollution to highway conditions, and the results show that PLI values are slightly low at different samples collected from Highways 401 and 404 and high in many samples collected from Highway 400 and the Don Valley Parkway. Highway 400 exhibits the highest PLI values.     

Assessment using CFD of the wind direction on the air discharges caused by natural ventilation of a poultry house

Air inside poultry houses must be removed on a regular basis to prevent excess of heat, particles and noxious gases that can imperil animals. To cope with this issue, natural ventilation could be an effective method when assisted by accurate predictions. This study investigates air discharges caused by natural ventilation of a poultry house by means of a three-dimensional computational fluid dynamics (CFD) model. It solves the governing equations of momentum, heat and mass transport, radiative transfers and animal-generated heat. Wind directions of 0°, 36° and 56° (0° corresponds to a wind blowing perpendicular to the ridgeline) were investigated; the CFD model predictions achieved a RMSE of 1.2 °C and 0.6 g[H₂O] kg^?1 [dry air] for internal temperature and absolute humidity, respectively, when air blew with an angle of 36°. Air renewal rates (ARR) were 39.5 (±?1.9), 34.9 (±?2.2) and 33.6 (±?1.7) volumes of the building per hour, when air blew at 0°, 36° and 56°, respectively. Such ARR predictions served to know how the gases contained in air would likely spread downstream from the building in order to define regions of potentially high gas concentration that could endanger neighbouring habitable facilities.     

Future implications of urban intensification on residential water demand

Over recent decades Auckland, New Zealand, metropolitan area has vastly expanded as a result of rapid population growth and low-density housing developments. In order to manage the uncontrolled low-density urban sprawl, Auckland Council proposed a compact city model through promoting higher density housing developments. In order to understand the implications of this transition on future residential water demand, this study first evaluated water consumption in three major housing types in Auckland including single houses, low-rise and high-rise apartments. Using the geographic information system, the water consumption information, estimated from a large sample of 60,000 dwellings across Auckland, was subsequently integrated with the Proposed Auckland Unitary Plan outlining the future housing composition over different areas in Auckland. Through developing different growth scenarios, the study showed that the housing transition from single houses to more intensified multi-unit houses cannot considerably affect the average per capita water consumption in Auckland.     

Pollution-induced community tolerance in benthic macroinvertebrates of a mildly lead-contaminated lake

Environmental Science and Pollution Research - Pollution-induced community tolerance (PICT) has been used to demonstrate effects of sediment contamination on microbes and meiofauna. Our study...     

Overview of surface measurements and spatial characterization of submicrometer particulate matter during the DISCOVER-AQ 2013 campaign in Houston,TX

The sources of submicrometer particulate matter (PM₁) remain poorly characterized in the industrialized city of Houston, TX. A mobile sampling approach was used to characterize PM₁ composition and concentration across Houston based on high-time-resolution measurements of nonrefractory PM₁ and trace gases during the DISCOVER-AQ Texas 2013 campaign. Two pollution zones with marked differences in PM₁ levels, character, and dynamics were established based on cluster analysis of organic aerosol mass loadings sampled at 16 sites. The highest PM₁ mass concentrations (average 11.6 ± 5.7 µg/m³) were observed to the northwest of Houston (zone 1), dominated by secondary organic aerosol (SOA) mass likely driven by nighttime biogenic organonitrate formation. Zone 2, an industrial/urban area south/east of Houston, exhibited lower concentrations of PM₁ (average 4.4 ± 3.3 µg/m³), significant organic aerosol (OA) aging, and evidence of primary sulfate emissions. Diurnal patterns and backward-trajectory analyses enable the classification of airmass clusters characterized by distinct PM sources: biogenic SOA, photochemical aged SOA, and primary sulfate emissions from the Houston Ship Channel. Principal component analysis (PCA) indicates that secondary biogenic organonitrates primarily related with monoterpenes are predominant in zone 1 (accounting for 34% of the variability in the data set). The relevance of photochemical processes and industrial and traffic emission sources in zone 2 also is highlighted by PCA, which identifies three factors related with these processes/sources (~50% of the aerosol/trace gas concentration variability). PCA reveals a relatively minor contribution of isoprene to SOA formation in zone 1 and the absence of isoprene-derived aerosol in zone 2. The relevance of industrial amine emissions and the likely contribution of chloride-displaced sea salt aerosol to the observed variability in pollution levels in zone 2 also are captured by PCA.

Implications: This article describes an urban-scale mobile study to characterize spatial variations in submicrometer particulate matter (PM₁) in greater Houston. The data set indicates substantial spatial variations in PM₁ sources/chemistry and elucidates the importance of photochemistry and nighttime oxidant chemistry in producing secondary PM₁. These results emphasize the potential benefits of effective control strategies throughout the region, not only to reduce primary emissions of PM₁ from automobiles and industry but also to reduce the emissions of important secondary PM₁ precursors, including sulfur oxides, nitrogen oxides, ammonia, and volatile organic compounds. Such efforts also could aid in efforts to reduce mixing ratios of ozone.     

Influence of operating conditions on nitrous oxide formation during nitritation and nitrification

Nitrous oxide (N₂O), a strong greenhouse gas, can be produced by ammonium-oxidizing bacteria (AOB) as a by-product of ammonium oxidation and can potentially be formed in all types of nitrification processes. However, partial nitritation has been reported to cause significantly higher N₂O emissions than complete nitrification. In the study presented here, the mechanisms and factors that drive N₂O formation by AOB were investigated with respect to different operational strategies to achieve nitrite accumulation base on combined evaluation of oxygen uptake rate (OUR) and N₂O formation rate. On the one hand, N₂O formation during partial nitritation and nitrification in a continuously stirred tank reactor (CSTR) with continuous aerobic conditions was observed. On the other hand, the effect of intermittent aeration on N₂O formation during nitrification was investigated. The presence of nitrite, the extend of sludge-specific ammonium loading, low oxygen concentration, and transition from aerobic to anoxic conditions significantly increased N₂O formation in this reactor independently from each other, indicating that different formation pathways, supposedly via nitrite or hydroxylamine, were active.     

A robust simulation–optimization modeling system for effluent trading—a case study of nonpoint source pollution control

In this study, a robust simulation–optimization modeling system (RSOMS) is developed for supporting agricultural nonpoint source (NPS) effluent trading planning. The RSOMS can enhance effluent trading through incorporation of a distributed simulation model and an optimization model within its framework. The modeling system not only can handle uncertainties expressed as probability density functions and interval values but also deal with the variability of the second-stage costs that are above the expected level as well as capture the notion of risk under high-variability situations. A case study is conducted for mitigating agricultural NPS pollution with an effluent trading program in Xiangxi watershed. Compared with non-trading policy, trading scheme can successfully mitigate agricultural NPS pollution with an increased system benefit. Through trading scheme, [213.7, 288.8]?×?10³ kg of TN and [11.8, 30.2]?×?10³ kg of TP emissions from cropped area can be cut down during the planning horizon. The results can help identify desired effluent trading schemes for water quality management with the tradeoff between the system benefit and reliability being balanced and risk aversion being considered.     

Reproductive toxicity of lead,cadmium, and phthalate exposure in men

Environmental toxicants viz lead or cadmium and phthalate esters (di(2-ethylhexyl) phthalate [DEHP], dibutyl phthalate [DBP], and diethyl phthalate [DEP]) widely found in different environmental strata are linked to deteriorating male reproductive health. The objective was to assess the relationships between the seminal lead, cadmium, and phthalate (DEHP, DBP, DEP) concentrations at environmental level and serum hormone levels and semen quality in non-occupationally exposed men and specify the effect of individual and combined exposure of toxicants on semen quality. A study of 60 male partners of couples attending the Andrology Laboratory of the Reproductive Biology Department, All India Institute of Medical Sciences (AIIMS), New Delhi, India for semen analysis to assess their inability to achieve a pregnancy was selected for the study. The results of univariate and stepwise multiple regression analysis in the unadjusted model showed a significant correlation between lead or cadmium and phthalates DEHP/DBP/DEP and sperm motility, sperm concentration, and DNA damage. After adjusting for potential confounders, an association with lead or DEHP was only observed. The present data shows that lead (Pb) or cadmium (Cd) or phthalates might independently contribute to decline in semen quality and induce DNA damage. Phthalates might influence reproductive hormone testosterone. These findings are significant in light of the fact that men are exposed to a volley of chemicals; however, due to the small sample size, our finding needs to be confirmed in a larger population.