基于垂向沉积的近百年来鸭绿江河口环境演变分析

对鸭绿江河口剖面沉积物中生源要素和重金属含量的垂向变化进行了分析,探讨了重金属元素之间和重金属与生源要素之间的相关性,总结了近百年来鸭绿江河口地区的环境演变过程.结果表明,除Cu以外,Cr、Ni、Zn、Cd、Pb、As和Hg之间及它们与生源要素之间有着很高的相关性,主要来源于工业和农业污染物排放等,Cu与其他环境因子有着不同的来源,人类活动对鸭绿江河口地区环境变化贡献极大;鸭绿江河口地区的环境演变过程可以分为3个阶段;总体上鸭绿江河口地区的污染状况日益严重.     

改性多壁碳纳米管对水中Cd~（2＋）的去除

为了增加多壁碳纳米管（multiwall carbon nanotubers,MWNTs）对水中Cd2＋的吸附量,使用混酸对多壁碳纳米管进行氧化处理,采用红外光谱进行结果表征,并探讨了吸附时间、pH值和MWNTs的使用量、Cd2＋的浓度及干扰离子对镉离子吸附的影响。结果表明,吸附时间为1.5 h、pH为5.3、吸附效果最佳,随MWNTs量的增加Cd2＋去除量增加,共存的阳离子会降低对Cd2＋的吸附效果,对Cd2＋的吸附符合Longmuir吸附定律。研究同时表明,pH小于2时Cd2＋能容易从碳纳米管上解吸。初步探讨了Cd2＋吸附机制。     

Mo-N-TiO_2光催化剂的制备、表征及其活性提高机制

以钼酸铵和氨水分别为钼源和氮源,采用溶胶-凝胶法制备了Mo-N-TiO2光催化剂,并对其进行了XRD、XPS和UV-visDRS表征。XRD结果表明,Mo、N共掺杂有效抑制了TiO2晶粒的生长,提高了TiO2由锐钛矿向金红石相的转变温度。UV-vis表明,Mo-N-TiO2光催化剂可见光吸收能力增强,吸收带边明显＂红移＂,且钼酸铵添加量（相对TiO2）为0.5%的样品＂红移＂程度最大,最大吸收带边为550 nm。XPS分析结果表明,Mo取代了TiO2晶格中的部分Ti4＋,以Mo6＋形式存在的,而N以Ti—N及N—Ti—O形式存在。以罗丹明B为模型污染物,重点考察了钼酸铵添加量与焙烧温度对Mo-N-TiO2光催剂性能的影响。结果表明,400℃焙烧下、钼酸铵添加量为0.5%的样品催化活性最好。模拟太阳光下光照120min对罗丹明B的降解率达到96.8%,是纯TiO2的2.42倍。     

Carbonyl emissions from vehicular exhausts sources in Hong Kong

Vehicular emission (VE) is one of the important anthropogenic sources for airborne carbonyls in urban area. Six types of VE-dominated samples were collected at representative locations in Hong Kong where polluted by a particular fueled type of vehicles, including (i) a gas refilling taxis station (liquefied petroleum gas [LPG] emission); (ii) a light-duty passenger car park (gasoline emission); (iii) a minibus station (diesel emission); (iv) a single-deck-bus depot (diesel emission); (v) a double-deck-bus depot (diesel emission); and (vi) a whole-food market entrance for light- and heavy-duty vehicles (diesel emission). A total of 15 carbonyls in the samples were quantified. Formaldehyde was the most abundant carbonyl among the VE-dominated samples, and its contribution to the total quantified amount on a molar basis ranged from 54.8% to 60.8%. Acetaldehyde and acetone were the next two abundant carbonyls. The carbonyls were quantified at three roadside locations in Hong Kong. The highest concentrations of formaldehyde and acetaldehyde, 22.7 +/- 8.4 and 6.0 +/- 2.8 microg/m3, respectively, were determined in the samples collected at a main transportation gate for goods between Hong Kong and Mainland China. The total quantified carbonyl concentration, 37.9 +/- 9.3 microg/m3, was the highest at an entrance of a cross-harbor tunnel in downtown area. The theoretical carbonyls compositions of the three roadside locations were estimated according to the VE-dominated sample profiles and the statistics on vehicle numbers and types during the sampling period. The measured compositions of formaldehyde were much higher than the theoretical compositions in summer, demonstrating that photochemical reactions significantly contributed to the formaldehyde production in the roadsides.     

The effects of manganese precursors on Mn-based/TiO2 catalysts for catalytic reduction of NO with NH3

Manganese acetate (MnAc) and manganese nitrate (MnN) were employed as precursors for the preparation of MnAc)/TiO2, Mn (N)/TiO2, Mn(Ac)-Ce/TiO2, and Mn(N)-Ce/TiO2 by impregnation. These complexes were used as catalysts in the low-temperature selective catalytic reduction of NO with NH3. The influence of manganese precursors on catalyst characteristics, the reduction activity, and the stability of the catalysts to poisoning by H2O and SO2 were studied. Experiments showed that Mn(N) produced MnO2 with large grain sizes in Mn(N)/TiO2 catalyst. On the contrary, Mn(Ac) led to highly dispersed and amorphous Mn2O3 in Mn (Ac)/TiO2 catalyst, which had better catalytic activity and stability to SO2 at low temperatures. The doping of cerium reduced the differences in catalytic performance between the catalysts derived from different Mn precursors.     

改性粉煤灰对糖蜜废水的吸附效果及机理

采用改性粉煤灰(MCFA)吸附糖蜜废水中的有机污染物,对吸附行为和机理进行了考察和分析。结果表明,MCFA投加量为30 g/L及pH为5.0的优化条件下,COD去除率为88.6%,饱和吸附量为89.7 mg COD/g MCFA。准二级方程能更好地描述糖蜜废水在MCFA上的吸附动力学。颗粒内扩散方程结果表明孔扩散并非唯一的速度控制步骤。吸附平衡表明,Freundlich等温线最符合吸附模式,为优惠吸附。D-R模式中的吸附自由能Ea值推断更可能是物理吸附而不是化学吸附。吸附热力学参数ΔG0(<0)、ΔH0(5.130 kJ/mol)和ΔS0(19.936 J/(mol.K))表明MCFA对糖蜜废水的吸附过程为可行的,自发性的吸热反应。     

改性酚醛基炭泡沫的表面结构及脱硫脱硝

采用前驱体改性的方法,以CuCl2、FeCl2和MgCl2为改性剂,制备出改性酚醛泡沫,经炭化/活化得到改性酚醛基炭泡沫。研究了不同金属对酚醛基炭泡沫表面物理与化学特性的影响,并进行同时脱硫脱硝实验研究。通过研究发现,添加CuCl2的样品比添加FeCl2、MgCl2的样品的中孔孔容大接近10倍;比表面积和孔容是CFCu>CF0>CFFe>CFMg;金属改性剂主要以金属和金属氧化物的形式存在于酚醛基炭泡沫中,而表面其他官能团大体结构不变。经CuCl2、FeCl2和MgCl2改性后,脱硫效率分别提高了39%、11%和13%,脱硝效率分别提高了19%、10%和4%,其中以CuCl2改性的酚醛基炭泡沫的效率最高。     

一种活性污泥总DNA提取方法的优化

对3种活性污泥DNA提取方法———传统蛋白酶K-SDS-氯仿异戊醇法(CPSCI法)、液氮研磨法和脱腐处理法进行了对比,并针对CPSCI法从污泥量、保温时间、裂解方式及沉淀时间等4个方面进行了优化。结果表明,优化的蛋白酶K-氯仿-异戊醇法(OPSCI法)采用污泥量0.10 g、37℃静置10 min,加SDS常温旋涡振荡及异丙醇直接离心等条件可获得长度在23.1 kb左右的DNA,OD260nm/OD280nm为1.86,稀释10倍后即可进行16S rDNA PCR。该方法重复性好,提取得率高,纯度好,操作简便,为常规实验室开展活性污泥微生物多样性研究提供了帮助。     

一株产絮酵母菌废菌体对Cd2+的吸附特性

将一株产絮酵母菌(编号B-02号)发酵后的废菌体制成生物吸附剂,研究该生物吸附剂对废水中Cd2+的生物吸附特性。结果表明:(1)pH值对Cd2+会产生较大的影响,偏酸性(pH=4～6)条件利于吸附;该吸附剂对Cd2+吸附速率较快,8～10 min就可达到吸附平衡;(2)吸附剂的吸附动力学符合二级动力学模型,吸附Cd2+的实验数据对Langmuir等温式的拟合情况良好,吸附剂吸附Cd2+的最大吸附量为70.752 mg/g。用0.5 mol/L HNO3对吸附Cd2+的酵母菌进行解吸,解吸率可达89.7%。     

玉米深加工废水的混凝实验

在室温条件下,分别选用聚合氯化铝(PAC)、聚合氯化铝铁(PAFC)及三氯化铁(FeCl3)对玉米深加工废水进行混凝实验。综合考虑各种混凝剂对磷、COD以及SS的去除效果,最终选取PAC作为混凝剂。采用PAC和聚丙烯酰胺(PAM)作为复合混凝剂,对其去除效果做进一步研究,并确定了最佳投加量及pH值。实验结果表明,在PAC投加量25mg/L,PAM投加量0.5 mg/L,pH为8条件下,混凝效果最佳。磷、COD、SS去除率可分别达到90.1%、53.3%和88.2%,对应的出水质量浓度分别为0.41、26.8和2 mg/L。