Risk assessment on disinfection by-products of drinking water of different water sources and disinfection processes

The occurrences of trihalomethanes (THMs) and haloacetics (HAAs) in the water supply in Beijing and Canada were investigated. The concentrations of THMs and HAAs in Beijing and Canada were below the maximum contaminant levels specified by the USEPA and WHO standards. The multi-pathway risk assessment (assessed through oral ingestion, dermal absorption and inhalation exposure to drinking water) was used to assess the cancer risk and the hazard index of THMs and HAAs from fifteen waterworks in Beijing, China and three treatment plants using different disinfection processes in Canada. Residents in Beijing and residents who were served by three treatment plants using different disinfection processes in Canada had a higher risk of cancer through oral ingestion than through the other two pathways. The cancer risk resulted from disinfection by-products (DBPs) was 8.50E-05(for males), 9.25E-05(for females) in Beijing, China, while it was 1.18E-04, 1.44E-04 in Canada. The risk was higher when water treatment plants used surface water source than when they used ground water source and mixture water source in Beijing. The risk showed different changes in three treatment plants using different disinfection processes in Canada. The lifetime cancer risk for THMs followed the order: Plant 2>Plant 1>Plant 3. And, the lifetime cancer risk for HAAs was: Plant 1>Plant 2>Plant 3.     

团粒喷播在废弃采石场生态恢复方面的应用

废弃采石场严重影响城市周边的生态景观,极易导致生态环境的继续恶化。以文登某一采石场破损山体的绿化工程为例,运用团粒喷播生态修复技术对废弃矿山进行生态性治理,并探讨其生态恢复方法,以期为今后废弃矿山的残损山体植被恢复和生态环境重建提供参考。     

基于我国规范与PIARC标准的公路隧道需风量分析

以某长大高速公路隧道为例,结合我国隧道通风设计规范JTJ026.1-1999与PIARC2007标准(世界道路协会),针对不同行车速度,不同车辆更新情况、不同排放标准组合形式以及是否考虑NOx等情况,对各个不同工况的需风量分别进行计算,并从需风量计算方法、机动车排放量和污染物设计浓度三个方面对隧道需风量差异进行分析。研究结果表明:我国设计规范与PIARC2007存在较大差距,为了适应当前及今后我国交通量及机动车排放特点的发展趋势,我国现行规范应在机动车排放量、污染物设计浓度限值等方面做出必要改进以达到合理确定隧道需风量的目的。     

一体化接触氧化反应器处理景区生活污水

常州某旅游景区采用一体化生活污水处理装置处理该区生活污水,通过试验确定反应器的最佳工艺参数,研究表明采用接触氧化反应器处理农村污水,在反应器内溶解氧维持在2.0~4.0 mg/L,水力负荷为3.53 m3/(m3.d)的运行条件下,对COD、NH3-N及TN去除率分别达80.82%、69.12%、63.16%,出水可稳定达GB18918-2002《城镇污水处理厂污染物排放标准》一级标准。     

半干法脱硫配套布袋除尘器的特殊要求

由于半干法脱硫工艺对布袋除尘器的特殊要求,使得其配套的布袋除尘器构造不同于以往常规的布袋除尘器.从布袋除尘器的过滤风速、滤料选择、沉降室设置、布风均匀性、灰斗特性、旁路系统的要求做详细的说明.     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

印钞废水处理工艺的改进实验

印钞废水属高浓度难降解有机废水,对环境污染严重。鉴于现有处理工艺出水普遍不达标的情况,通过对比实验确定了改进方案:超滤浓缩液离心出水在进入接触氧化池前,增加新的处理单元(Fenton氧化-混凝)。Fenton氧化最佳条件:FeSO4.7H2O投加量14 g/L,H2O2的投加量34 mL/L,初始pH值6.0,氧化反应时间1.5h,温度18.8℃;混凝过程最佳条件:PAC投加量4 g/L,PAM(5‰)投加量10 mg/L,pH值7。新增单元对废水中COD去除率接近80%,可生化性提高1.6倍,色度降低36%。     

四川某中小城镇污水处理厂进水水质统计分析

生活污水水质对处理工艺的选择、设计参数的选取以及稳定运行十分重要。运用SPSS软件,对四川某中小城镇污水处理厂为期一年的进水指标(水量、COD、氨氮、总磷、pH、SS)进行方差和相关性分析。方差分析结果显示进水量、氨氮和SS在月份和季节之间存在显著性差异,而总磷和pH仅在月份之间存在显著差异,COD在季度和月份之间无显著性差异;指标相关性分析表明,进水量和氨氮之间呈负相关,氨氮和总磷、COD和总磷之间呈正相关,且相关性显著。在此分析的基础上对污水处理厂设计、工艺选择及运行管理提出了一些建议。     

Individual and combined toxic effects of cypermethrin and chlorpyrifos on earthworm

Toxicities were assessed for a pyrethroid (cypermethrin) and an organophosphate insecticide (chlorpyrifos) individually and in combination. A series of tests were conducted on di erent responses (acute, chronic, behavioral) of earthworms of species Eisenia fetida andrei in the ecological risk assessment of these pesticides. The results showed that the toxicity of the mixture of cypermethrin and chlorpyrifos was significantly higher than either of these pesticides individually, especially on the earthworm’s chronic responses. At a concentration of 5 mg/kg, the mixture caused significant reductions on the growth and reproduction rates of earthworms, but did not cause any significant e ect when the individual was tested. The increase in toxicity of the pesticide mixture means that the use of toxicity data obtained exclusively from single-pesticide experiments may underestimate the ecological risk of pesticides that actually present in the field.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).