炼油废水污泥脱水工艺条件的优化

采用化学除油降黏—污泥调理—离心脱水工艺处理某炼油厂废水处理系统的混合污泥,并对工艺条件进行优化。实验结果表明,最佳的工艺条件为：化学除油降黏阶段处理体系的pH=4,反应温度35 ℃,H₂O₂加入量 2 g/L,m（H₂O₂）∶ m（Fe²⁺）=4,反应时间 60 min;污泥调理反应阶段的CaO加入量7.0 g/L;离心脱水阶段在分离因数为1 558时脱水5 min。在此条件下,得到的泥饼的含水率为70.0%~75.0%（w）,含油率小于2%（w）,污泥比阻约为3.0×10⁷ s²/g。     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

As(V)在金红石TiO_2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As(V)在金红石TiO2颗粒表面吸附的影响,探讨了As(V)在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As(V)初始浓度为10 mg/L,pH为7的条件下,25℃时的吸附量0.41 mg/g高于30℃时的吸附量0.31 mg/g,As(V)在金红石TiO2上的吸附为放热过程。CaCl2和MgCl2的添加对As(V)在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2+或Mg2+浓度为10 mmol/L时,As(V)吸附量分别为0.64和0.56 mg/g,Ca2+比Mg2+对As(V)吸附促进作用强。As(V)在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As(V)在金红石TiO2颗粒表面吸附的动力学过程。     

基于CA-MAS的水域总有机碳扩散模拟研究

当前水环境污染扩散研究一般基于普通数值模型模拟,忽略了水污染扩散微观驱动力的影响。为能更真实地反映其动态扩散过程,针对水域总有机碳(TOC)扩散机理,基于CA和MAS技术,将影响TOC扩散的自然和社会经济因素抽象为微观的水流Agent、风速Agent、径流量Agent、污水排放口Agent、人工管理Agent以及农业生产地Agent,将研究水域抽象为CA元胞空间,建立了CA-MAS水域总有机碳扩散模型,对水域总有机碳的动态演化过程进行模拟,并以武汉理工大学鉴湖水域作为实验区域,借助NetLogo仿真平台完成了模型的实现与验证。模拟结果表明,该模型基本能够反映水体总有机碳的扩散规律,可以为水环境污染控制提供参考。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

Solid beef cattle manure application impacts on soil properties and 17β-estradiol fate in a clay loam soil

Livestock manure applied to agricultural land is one of the ways natural steroid estrogens enter soils. To examine the impact of long-term solid beef cattle (Bos Taurus) manure on soil properties and 17β-estradiol sorption and mineralization, this study utilized a soil that had received beef cattle manure over 35 years. The 17β-estradiol was strongly sorbed and sorption significantly increased (P < 0.05) with increasing soil organic carbon content (SOC) and with an increasing annual rate of beef cattle manure. The 17β-estradiol mineralization half-life was significantly negatively correlated, and the total amount of 17β-estradiol mineralized at 90 days (MAX) was significantly positively correlated with 17β-estradiol sorption. The long-term rate of manure application had no significant effect on MAX, but the addition of fresh beef cattle manure in the laboratory resulted in significantly (P < 0.05) smaller MAX values. None of the treatments showed MAX values exceeding one-third of the 17β-estradiol applied.     

The characteristics of nitrate removal by the psychrotolerant denitrifying bacterium Acinetobacter johnonii DBP-3, isolated from a low-temperature eutrophic body of water

A psychrotolerant denitrifying bacterial strain, DBP-3, was isolated from a eutrophic body of water by low-temperature-oriented acclimation culture. Based on its morphologicalandbiochemicalcharacteristics and 16S rDNA gene sequence, the bacterium was identified as belonging to the genus Acinetobacter and closely related to A. johnonii. The satisfactory growth of DBP-3 was observed at 10–30°C and pH 7–9. Strain DBP-3 was able to utilize three types of carbon sources (sodium acetate > sodium citrate > glucose) to support growth and denitrification. DBP-3 grew faster, but with lower nitrate removal efficiency and higher nitrite accumulation, under aerobic conditions than under anoxic conditions. DBP-3 was extremely susceptible to tetracycline and rifampicine and less sensitive to ampicillin and penicillin. The growth of DBP-3 was significantly affected by Hg (II), Cr (VI), Pb (II), Cd (II), and As (III) at 0.32, 0.63, 1.25, 2.5, and 25.0 mg L^?1, respectively. Interestingly, chromium (VI) significantly promoted DBP-3 growth at concentrations lower than 0.32 mg L^?1. These data may be helpful to support the use of strain DBP-3 in the purification of eutrophic water bodies at low temperatures.     

Calculation Of Electric Field Strength Distributions For New Electrostatic Precipitator Discharge Electrode Designs

New collecting and discharge electrode configurations are being used in electrostatic precipitators. In order to mathematically model preclpitators with these arrangements, it is necessary to develop reliable models of the field strength distributions of these electrodeplate geometries. This paper presents the concept of an equivalent wire diameter and attenuation functions, permitting use of the well-known wire-plate calculations. Experimental data presented in this paper shows the approximation techniques are sufficiently accurate.     

The Kinetics of Catalytic Incineration of Dimethyl Sulfide and Dimethyl Disulfide over an MnO/Fe2O3 Catalyst

ABSTRACT

The catalytic incineration of dimethyl sulfide and dimethyl disulfide [(CH₃)₂S and (CH₃)₂S₂] over an MnO/Fe₂O₃ catalyst was carried out in a bench-scale catalytic incinerator. Three kinetic models (i.e., the power-rate law, the Mars and Van Krevelen model, and the Langmuir-Hinshelwood model) were used to analyze the results. A differential reactor design was used for best fit of kinetic models in this study. The results show that the Langmuir-Hinshelwood model may be feasible to describe the catalytic incineration of (CH₃)₂S and (CH₃)₂S₂. This suggests that the chemical adsorption of O₂ molecules is important in this incineration.     

An Assessment of the Emissions Inventory Processing Systems EMS-2001 and SMOKE in Grid-Based Air Quality Models

Abstract

In the United States, emission processing models such as Emissions Modeling System-2001 (EMS-2001), Emissions Preprocessor System-Version 2.5 (EPS2.5), and the Sparse Matrix Operator Kernel Emissions (SMOKE) model are currently being used to generate gridded, hourly, speciated emission inputs for urban and regional-scale photochemical models from aggregated pollutant inventories. In this study, two models, EMS-2001 and SMOKE, were applied with their default internal data sets to process a common inventory database for a high ozone (O₃) episode over the eastern United States using the Carbon Bond IV (CB4) chemical speciation mechanism. A comparison of the emissions processed by these systems shows differences in all three of the major processing steps performed by the two models (i.e., in temporal allocation, spatial allocation, and chemical speciation). Results from a simulation with a photochemical model using these two sets of emissions indicate differences on the order of ±20 ppb in the predicted 1-hr daily maximum O₃ concentrations. It is therefore critical to develop and implement more common and synchronized temporal, spatial, and speciation cross-reference systems such that the processes within each emissions model converge toward reasonably similar results. This would also help to increase confidence in the validity of photochemical grid model results by reducing one aspect of modeling uncertainty.