Quantitative evaluation of environmental risks of flotation tailings from hydrothermal sulfidation–flotation process

Floatation tailings (FT) are the main by-products of the hydrothermal sulfidation–flotation process. FT (FT₁ and FT₂) were obtained by treating two different neutralization sludges (NS) (NS₁ and NS₂). This paper quantitatively evaluated the environmental risks of heavy metals (Zn, Cd, Cu, Pb, and As) in FT versus NS. The total concentration and leaching rates (R ₂) of heavy metals in FT were much lower than those in NS, demonstrating that the hydrothermal sulfidation–flotation process was able to effectively suppress the mobility and leachability of heavy metals. The BCR-three sequence leaching procedure of FT confirmed that all metals were transformed into more stable forms (residue and oxidizable forms) than were found that in NS. The potential ecological risk index indicated that the overall risks caused by heavy metals decreased significantly from 6627.59 and 7229.67 (very serious risk) in NS₁ and NS₂, respectively, to 80.26 and 76.27 (low risk) in FT₁ and FT₂, respectively. According to the risk assessment code, none of the heavy metals in FT posed significant risk to the natural environment except Zn (with low risk). In general, the risk of heavy metals in FT had been well controlled.     

Application of 15N–18O double stable isotope tracer technique in an agricultural nonpoint polluted river of the Yangtze Delta Region

One strategy to combat nitrate (NO₃-N) contamination in rivers is to understand its sources. NO₃-N sources in the East Tiaoxi River of the Yangtze Delta Region were investigated by applying a ¹⁵N–¹⁸O dual isotope approach. Water samples were collected from the main channel and from the tributaries. Results show that high total N and NO₃-N are present in both the main channel and the major tributaries, and NO₃-N was one of the most important N forms in water. Analysis of isotopic compositions (δ ¹⁸O, δD) of water suggests that the river water mainly originated from three tributaries during the sampling period. There was a wide range of δ ¹⁵N-NO₃ (?1.4 to 12.4 ‰) and a narrow range of δ ¹⁸O-NO₃ (3.7 to 9.0 ‰) in the main channel waters. The δ ¹⁵N and δ ¹⁸O-NO₃ values in the upper, middle, and lower channels along the river were shifted as 8.2, 3.5, and 9.5 ‰, and 9.0, 4.2, and 6.0 ‰, respectively. In the tributary South Tiao, the δ ¹⁵N and δ ¹⁸O-NO₃ values were as high as 9.5 and 7.0 ‰, while in the tributaries Mid Tiao and North Tiao, NO₃-N in most of the samples had relatively low δ ¹⁵N and δ ¹⁸O-NO₃ values from 2.3 to 7.5 ‰ and 4.7 to 7.0 ‰, separately. Our results also suggest that the dual isotope approach can help us develop the best management practice for relieving NO₃-N pollution in the rivers at the tributary scale.     

Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.     

超滤膜深度处理染整废水的膜污染机理

实验采用不同规格和材料的超滤膜进行染整二级尾水分离实验,对超滤膜污染机理及影响因素进行了分析。实验采用红外光谱分析了聚醚(PES)膜、聚砜(PSF)膜和聚醚酰亚胺(PEI)膜3种超滤膜材料,对比了污染前后膜面的接触角以及不同切割分子量对膜通量及出水水质的影响,并利用线性化的Herman堵塞模型拟合了不同分子量超滤膜的堵塞模型,初步探讨了超滤膜的污染机理。实验结果表明,膜材料表面亲水性基团的多少与初始膜通量大小成正比,出水COD值随超滤膜切割分子量减小而减小。切割分子量同为2 000 Da的3种超滤膜中,PES膜的处理效果最佳,出水COD平均值为47.81 mg/L;PEI膜通量最高,平衡通量可达50 L/(m2.h);切割分子量为1 000、10 000的超滤膜堵塞机理符合滤饼过滤模型,100 000的超滤膜堵塞机理更接近于完全堵塞模型;1 000的聚醚砜材质膜(PES)更适合此类废水的深度处理。     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

臭氧催化氧化工艺深度处理印染废水

采用正交实验对催化剂NiO/γ-A12O3的制备条件进行优化,并探讨臭氧催化氧化法对于印染废水的深度处理效能.结果表明,最优的催化剂制备条件为:浸渍液浓度为3％、浸渍时间为4h、灼烧温度为450℃、灼烧时间为3h.臭氧催化氧化反应15 min时,COD浓度由84.22 mg/L降低至50.00 mg/L以下;氨氮浓度由10.88 mg/L降低至5.01 mg/L;色度去除率达到69％,明显高于单纯臭氧氧化的反应效率.     

不同流量分配比对多级A/O工艺去除有机物及脱氮的影响

采用三级A/O工艺分段进水工艺处理低碳源生活污水,考察了进水流量分配比对系统去除有机物、硝化反硝化能力以及去除TN的影响。通过对水质指标沿程监测结果表明,不同流量分配比(4∶3∶3,5∶3∶2,6∶3∶1)对系统去除有机物及硝化效率影响不大,出水COD、氨氮分别均在30 mg/L、1 mg/L以下。但反硝化效果受流量分配比的影响较大,在流量比为5∶3∶2时,有效利用原水中碳源进行反硝化,反硝化效果最好。在流量比为5∶3∶2的情况下,TN出水为5.7 mg/L去除率为82.9%,优于流量分配比为6∶3∶1和4∶3∶3时的脱氮效果。总体而言,分段进水工艺在对碳源的有效利用及能耗节省方面优于单点进水。     

紫外辐照-催化湿式过氧化氢氧化技术处理酸性大红GR染料废水

采用自制的负载型CuO-ZnO-CeO2/γ-Al2O3催化剂,常温常压下通过紫外辐照-催化湿式氧化技术处理酸性大红GR模拟染料废水。考察了催化剂加入量、H2O2加入量、废水pH、反应时间、初始酸性大红GR质量浓度等对废水脱色率的影响。实验得到最佳工艺条件为初始酸性大红GR质量浓度200mg/L,催化剂加入量10.0g/L,H2O2加入量2.0mL/L,废水pH4,反应时间2h。最佳工艺条件下废水脱色率达99.33%。     

The influence of mariculture on mercury distribution in sediments and fish around Hong Kong and adjacent mainland China waters

To study the influence of mariculture on mercury (Hg) speciation and distribution in sediments and cultured fish around Hong Kong and adjacent mainland China waters, sediment samples were collected from six mariculture sites and the corresponding reference sites, 200-300 m away from the mariculture sites. Mariculture activities increased total mercury, organic matter, carbon, nitrogen and sulfur concentrations in the surface sediments underneath mariculture sites, possibly due to the accumulation of unconsumed fish feed and fish excretion. However, methylmercury (MeHg) concentrations and the ratio of MeHg to THg (% MeHg) in sediments underneath mariculture sites were lower than the corresponding reference sites. The % MeHg in sediments was negatively correlated (r = −0.579, p < 0.05) with organic matter (OM) content among all sites, indicating that OM may have inhibited Hg methylation in surface sediments. Three mariculture fish species were collected from each mariculture site, including red snapper (Lutjanus campechanus), orange-spotted grouper (Epinephelus coioides) and snubnose pompano (Trachinotus blochii). The average MeHg concentration in fish muscle was 75 μg kg⁻¹ (wet weight), and the dietary intake of MeHg through fish consumption for Hong Kong residents was 0.37 μg kg⁻¹ week⁻¹, which was lower than the corresponding WHO limits (500 μg kg⁻¹ and 1.6 μg kg⁻¹ week⁻¹).     

Biotoxicity of nickel oxide nanoparticles and bio-remediation by microalgae Chlorella vulgaris

Adverse effects of manufactured nickel oxide nanoparticles on the microalgae Chlorellavulgaris were determined by algal growth-inhibition test and morphological observation via transmission electron microscopy (TEM). Results showed that the NiO nanoparticles had severe impacts on the algae, with 72 h EC(50) values of 32.28 mg NiOL(-1). Under the stress of NiO nanoparticles, C. vulgaris cells showed plasmolysis, cytomembrane breakage and thylakoids disorder. NiO nanoparticles aggregated and deposited in algal culture media. The presence of algal cells accelerated aggregation of nanoparticles. Moreover, about 0.14% ionic Ni was released when NiO NPs were added into seawater. The attachment of aggregates to algal cell surface and the presence of released ionic Ni were likely responsible for the toxic effects. Interestingly, some NiO nanoparticles were reduced to zero valence nickel as determined by X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) analysis. The maximum ratios of nickel reduction was achieved at 72 h of exposure, in accordance with the time-course of changes in soluble protein content of treated C. vulgaris, implying that some proteins of algae are involved in the process. Our results indicate that the toxicity and bioavailability of NiO nanoparticles to marine algae are reduced by aggregation and reduction of NiO. Thus, marine algae have the potential for usage in nano-pollution bio-remediation in aquatic system.