Second-order chlorine decay and trihalomethanes formation in a pilot-scale water distribution systems

It is well known that model-building of chlorine decay in real water distribution systems is difficult because chlorine decay is influenced by many factors (e.g., bulk water demand, pipe-wall demand, piping material, flow velocity, and residence time). In this paper, experiments were run to investigate the kinetic model of chlorine decay and the formation model of trihalomethanes (THMs) in pilot-scale water distribution systems. Experimental results show that the rate constants of chlorine decay, including wall decay and bulk decay, increasing with temperature. Moreover, the kinetic model of chlorine decay and the formation model of THMs describe experiment data of pilot-scale water distribution systems. The effect of different piping material on chlorine decay and THMs formation were also investigated. The rate constants of chlorine decay are ranked in order: stainless steel pipe, ductile iron pipe, and last, polyethelene pipe because wall decay is the largest in stainless steel pipe than that in other piping material. Correspondingly, the rate of THMs formation follows the order of stainless steel pipe, ductile iron pipe, and last, polyethelene pipe because of less chlorine in bulk water reacting with the trihalomethane formation potential (THMFP).     

超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

改性多壁碳纳米管对水中Cd~（2＋）的去除

为了增加多壁碳纳米管（multiwall carbon nanotubers,MWNTs）对水中Cd2＋的吸附量,使用混酸对多壁碳纳米管进行氧化处理,采用红外光谱进行结果表征,并探讨了吸附时间、pH值和MWNTs的使用量、Cd2＋的浓度及干扰离子对镉离子吸附的影响。结果表明,吸附时间为1.5 h、pH为5.3、吸附效果最佳,随MWNTs量的增加Cd2＋去除量增加,共存的阳离子会降低对Cd2＋的吸附效果,对Cd2＋的吸附符合Longmuir吸附定律。研究同时表明,pH小于2时Cd2＋能容易从碳纳米管上解吸。初步探讨了Cd2＋吸附机制。     

改性TiO_2光催化降解三苯甲烷类污染物

以硫酸钛为原料采用水热法制备了掺Fe3＋TiO2晶体粉末,采用X射线衍射仪（XRD）对样品的结构进行了表征。在可见光条件下,用溴酚蓝、甲基绿、甲基蓝、孔雀石绿、甲基紫和碱性品红等6种典型三苯甲烷类化合物为目标降解物,研究了以自制的掺Fe3＋TiO2晶体粉末对它们的催化降解作用。实验结果表明,制备的掺Fe3＋TiO2晶体属于锐钛矿型。6种化合物的光催化降解反应遵循拟一级动力学规律,且可用Langmuir-Hinshelwood（L-H）动力学模型描述,其表观反应速度常数（k）的大小顺序为：溴酚蓝〈甲基绿〈甲基蓝〈孔雀石绿〈甲基紫〈碱性品红,大小变化次序与其半衰期t1/2成反比,并从分子结构上对它们的降解规律进行定性解释。     

Management-oriented sensitivity analysis for pesticide transport in watershed-scale water quality modeling using SWAT

The Soil and Water Assessment Tool (SWAT) was calibrated for hydrology conditions in an agricultural watershed of Orestimba Creek, California, and applied to simulate fate and transport of two organophosphate pesticides chlorpyrifos and diazinon. The model showed capability in evaluating pesticide fate and transport processes in agricultural fields and instream network. Management-oriented sensitivity analysis was conducted by applied stochastic SWAT simulations for pesticide distribution. Results of sensitivity analysis identified the governing processes in pesticide outputs as surface runoff, soil erosion, and sedimentation in the study area. By incorporating sensitive parameters in pesticide transport simulation, effects of structural best management practices (BMPs) in improving surface water quality were demonstrated by SWAT modeling. This study also recommends conservation practices designed to reduce field yield and in-stream transport capacity of sediment, such as filter strip, grassed waterway, crop residue management, and tailwater pond to be implemented in the Orestimba Creek watershed.     

Cu^2＋、Zn^2＋对生物脱氮系统的影响

Cu^2＋和Zn^2＋是污水处理工艺中经常遇到的金属离子。在驯化好的活性污泥系统中,研究了金属离子Cu^2＋和Zn^2＋在0～100mg／L浓度下对活性污泥生物脱氮系统的影响。试验发现Cu^2＋＞5mg／L、Zn^2＋＞30mg／L时,对硝化过程具有明显的抑制作用,在同样浓度的试验条件下cu“对硝化过程的抑制作用比Zn^2＋大。Cu^2＋≤0．5mg／L时对反硝化过程具有一定的促进作用,有助于提高TN的去除效果;Cu^2＋＞0．5mg／L时,对反硝化产生抑制作用,随着浓度的增加,TN去除率逐渐下降。Zn^2＋不影响反硝化过程,仅在大于30mg／L时,对硝化过程产生抑制作用。重金属Cu^2＋对生物脱氮系统的影响明显强于Zn^2＋。     

Measurement of the vertical profile of atmospheric SO2 during the heating period in Beijing on days of high air pollution

This paper reports altitude-resolved concentrations of sulfur dioxide (SO₂) and particulate matter up to 10 microns in diameter (PM₁₀) in the planetary boundary layer of major urban centers during extreme pollution episodes. The concentration of SO₂ was observed continuously from November 24, 2004, to December 4, 2004, in Beijing during the heating period. Fluorescence SO₂ analyzers were used to measure the atmospheric SO₂ concentrations. Four SO₂ analyzers were placed at 4 different levels (8 m, 47 m, 120 m, and 280 m) of the 325-m high meteorological observation tower of the Institute of Atmospheric Physics (IAP), Chinese Academy of Sciences. A maximal SO₂ concentration of 172.3 ppb was measured during this pollution episode, and SO₂ concentration increased with altitude and reached its maximal value at ～50 m. The study also analyzed the meteorological situation before, during, and after the pollution episode.     

Continuous measurement of peroxyacetyl nitrate (PAN) in suburban and remote areas of western China

Knowledge on atmospheric abundance of peroxyacetyl nitrate (PAN) is important in assessing the severity of photochemical pollution, and for understanding chemical transformation of reactive odd nitrogen and its impact on the budget of tropospheric ozone (O₃). In summer 2006, continuous measurements of PAN were made using an automatic GC–ECD analyzer with an on-line calibrator at a suburban site of Lanzhou (LZ) and a remote site of Mt. Waliguan (WLG) in western China, with concurrent measurements of O₃, total reactive nitrogen (NO_y) and carbon monoxide (CO). At LZ, several photochemical episodes were observed during the study, and the average mixing ratio of PAN (plus or minus standard deviation) was 0.76 (±0.89) ppbv with the maximum value of 9.13 ppbv, compared to an average value of 0.44 (±0.16) ppbv at remote WLG. The PAN mixing ratios in LZ exhibited strong diurnal variations with a maximum at noon, while enhanced concentrations of PAN were observed in the evening and a minimum in the afternoon at WLG. The daily O₃ and PAN concentration maxima showed a strong correlation (r² = 0.91) in LZ, with a regression slope (PAN/O₃) of 0.091 ppbv ppbv^?1. At WLG, six well-identified pollution plumes (lasting 2–8 h) were observed with elevated concentrations of PAN (and other trace gases), and analysis of backward particle release simulation shows that the high-PAN events at WLG were mostly associated with the transport of air masses that had passed over LZ.     

Characterization of on-road vehicle emission factors and microenvironmental air quality in Beijing,China

In this paper, we report the results and analysis of a recent field campaign in August 2007 investigating the impacts of emissions from transportation on air quality and community concentrations in Beijing, China. We conducted measurements in three different environments, on-road, roadside and ambient. The carbon monoxide, black carbon and ultrafine particle number emission factors for on-road light-duty vehicles are derived to be 95 g kg^?1-fuel, 0.3 g kg^?1-fuel and 1.8 × 10¹⁵ particles kg^?1-fuel, respectively. The emission factors for on-road heavy-duty vehicles are 50 g kg^?1-fuel, 1.3 g kg^?1-fuel and 1.1 × 10¹⁶ particles kg^?1-fuel, respectively. The carbon monoxide emission factors from this study agree with those derived from remote sensing and on-board vehicle emission testing systems in China. The on-road black carbon and particle number emission factors for Chinese vehicles are reported for the first time in the literature. Strong traffic impacts can be observed from the concentrations measured in these different environments. Most clear is a reflection of diesel truck traffic activity in black carbon concentrations. The comparison of the particle size distributions measured at the three environments suggests that the traffic is a major source of ultrafine particles. A four-day traffic control experiment conducted by the Beijing Government as a pilot to test the effectiveness of proposed controls was found to be effective in reducing extreme concentrations that occurred at both on-road and ambient environments.     

Measurement of gas-phase total peroxides at the summit of Mount Tai in China

Measurement of ambient gas-phase total peroxides was performed at the summit of Mount Tai (Mt. Tai, 1534 m above sea level) in central-eastern China during March 22–April 24 and June 16–July 20, 2007. The hourly averaged concentration of peroxides was 0.17 ppbv (± 0.16 ppbv, maximum: 1.28 ppbv) and 0.55 ppbv (± 0.67 ppbv, maximum: 3.55 ppbv) in the spring and summer campaigns, respectively. The average concentration of peroxides at Mt. Tai, which is in a heavily polluted region, was much lower than hydrogen peroxide measurements made at some rural mountain sites, suggesting that significant removal processes took place in this region. An examination of diurnal variation and a correlation analysis suggest that these removal processes could include chemical suppression of peroxide production due to the scavenging of peroxy and hydroxy radicals by high NO_x, wet removal by clouds/fogs rich in dissolved sulfur dioxide which reacts quickly with peroxides, and photolysis. These sinks competed with photochemical sources of peroxides, resulting in different mean concentrations and diurnal pattern of peroxides in the spring and summer. A principal component analysis was conducted to quantify the major processes that influenced the variation of peroxide concentrations. This analysis shows that in the spring photochemical production was an important source of peroxides, and the major sink was scavenging during upslope transport of polluted and humid air from the lower part of the planetary boundary layer (PBL) and wet removal by synoptic scale clouds. During the summer, highly polluted PBL air (with high NO_x) was often associated with very low peroxides due to the chemical suppression of HO₂ by high NO_x and wet-removal by clouds/fogs in this sulfur-rich atmosphere, especially during the daytime. Higher concentrations of peroxides, which often appeared at mid-nighttime, were mainly associated with subsidence of air masses containing relatively lower concentrations of NO_y.