大气中苯乙烯的气相色谱法测定

采用活性炭管吸附大气中基苯乙烯，以二硫化碳洗脱，以溴水加成后，用气相色谱电子捕获器测定苯乙烯的二溴加成物。本方法适合于检测多种污染物共存的大气中痕量苯乙烯。其线性范围为０．０１５－０．７４ｎｇ，最低检出浓度为０．００１ｍｇ／ｍ＾３；重现性实验的变异系数为２．３％：当活性炭管吸附苯乙烯在２．９μｇ时，回收率为９０％，吸附苯乙烯０．２９μｇ时，回收率为７２％。     

云南热海热田中的碱金属元素

1982至1983年在云南腾冲一已知水热区及其毗邻约 60km² 范围内采集了131个土壤样品。样品分析结果表明锂和铷的异常能圈定两个已知水热区,且与若干已知热田地球化学指示元素的异常相当一致,从而进一步肯定了这一地区的开发前景。与此同时,对区内水样中的钠钾含量也进行了测定并做出解译。锂铷和已知地球化学指标之间的相关分析表明它们之间确存有某种内在联系,同时可看出盐湖与古地热系统之间的一些联系。最后得出结论:土壤中的锂铷可作为圈定热田的地球化学指标;地热系统不仅能作为能源资源而且也应视作矿产资源。     

Mn-Cu-O负载型催化剂上CO氧化性能的研究

研究了ＺｒＯ２或Ａｌ２Ｏ３负载Ｍｎ－Ｃｕ－Ｏ体系催化剂ＣＯ催化氧化活性，以及物相结构，表面氧性能与活性的关系。结果表明，锆基催化剂的氧化活性明显优于铝基催化剂，起燃温度Ｔ５０低达５０℃，ＺｒＯ２载 利于活性组份形成高活性物相，并促进表面吸附氧的脱附，表现出催化剂表面吸附氧的脱附温度高低次序与其氧化活性有一致的对应关系。     

弧焊机器人用数控焊接变位机的研制

依据现有进口弧焊机器人的技术特点和工作要求 ,研制了与之配套的数控焊接变位机。该机工作台可进行旋转和倾斜两个运动 ,可使工件在最佳的位置进行焊接 ,与弧焊机器人一起构成了柔性加工单元。在实际焊接应用中 ,效果良好     

关于环境生物技术在水污染治理中的研究与应用

分析了国内外关于微生物遗传学、酶学在环境生物技术领域中的研究进展以及环境生物技术在污水治理学的开发与应用及其发展趋势，为选择实用的污水处理技术提供了参考依据。     

Treatment of black liquor from the papermaking industry by acidification and reuse

Two different kinds of black liquor from the papermaking industry were treated by acidification and reuse. The experimental parameters and conditions were discussed in detail. The experimental results indicated that the treatment process mentioned in this article is an effective process for the treatment of black liquor from the papermaking industry. By the treatment, the solid materials in black liquor are transferred into two by-products and the other components are reused or evaporated. Thus, no wastewater except some condensation water would be discharged in pulping process and the problem of oollution of black liauor would be effectively solved.     

染化废水厌氧生物处理技术的研究

鉴于厌氧微生物对偶氮染料的还原裂解作用，开发了以易降解工业有机废水作为外加碳源的染化废水厌氧生物处理的新技术．试验结果表明：在进水ＣＯＤ３１００—３５００ｍｇ／Ｌ，ＣＯＤ总／ＣＯＤ染化比值４０，ＨＲＴ３．０ｄ下，ＣＯＤ去除率＞８０％，最低染化ＣＯＤ去除率＞４５％，色度去除率＞８５％；实验证实，在厌氧处理过程中，染料组分的结构已发生了明显的变化；反应器内的污泥大多呈颗粒状；污泥活性和工艺性能可控制工艺运行参数得以维持．     

用传递矩阵法计算消声器插入损失的理论探讨

采用声电类比的传递矩阵法，本文对消声器插入损失进行了理论探讨，所推导的理论公式准确地反映了整个内燃机排气系统对消声器插入损失的影响，克服了其它学者在研究此问题中的不足，考虑了声源声阻抗对传递损失的影响，对消声器的整体优化设计具有重要的指导意义。     

以TS为载体的催化剂对脱除三甲胺性能的研究

用Ti(SO4)2和硅溶胶制备TS载体。研究了以TS为载体的催化剂催化氧化脱除三甲胺的臭味。在制备TS载体的研究中考察了反应温度、钛硅比、焙烧温度、老化条件（如老化时间、pH值）等因素对载体吸附性能和比表面积的影响，并考察了不同活性组分、不同钛硅比的催化剂对脱除三甲胺的催化活性的影响。实验结果表明，添加Pd活性组分以及Ti:Si比为4：1mol的催化剂具有低温催化活性，脱臭效果好。     

Photodegradation of acetochlor in water and UV photoproducts identified by mass spectrometry

The sunlight photodegradation half-lives of 20 mg/L acetochlor were 151, 154 and 169 days in de-ionized water, river water and paddy water, respectively. When exposed to ultraviolet (UV) light, acetochlor in aqueous solution was rapidly degraded. The half-lives were7.1, 10.1, and 11.5 min in de-ionized water, river water and paddy water, respectively. Photopreduets of acetochlor were identified by gas chromatography/mass spectrometry(GC/MS) and found at least twelve photoproducts resulted from dechlorination with subsequent hydrtrxylation and cyclization processes. The chemical structures of ten photoproducts were presumed on the basis of mass spectrum interpretation and literature data. Photoproducts are identified as 2-ethyl-6-methylaniline; N, N-diethylaniline ; 4, 8-dimethyl-2-oxo- 1,2,3,4- tetrahydroquino-line; 2-oxo-N-(2-ethyl-6-methylphenyl)-N-(ethoxymethyl) acetamide; N-(ethoxymethyl)-2‘-ethyl-6‘-methylformanilide; 1-hydroxyaeetyl-2-ethoxyl-7-ethylind ole; 8-ethyl-l-ethoxymethyl-2-oxo-1, 2, 3, 4-tetrahydroquinoline; 4, 8-dimethyl-l-ethoxymethyl-2-oxo-1, 2, 3, 4-tetrahydroquinoline; 2-hydroxy-2‘-ethyl-6‘-methyl-N-(ethoxymethyl) acetanilide and a compound related to acetochlor. The other two photoproducts were detected by GC/MS although their chemical structure was unknown.