硫氧同位素解析典型岩溶地下河流域硫酸盐季节变化特征和来源

全球约1/4的饮用水源为岩溶水,但岩溶含水层极易遭受人类活动污染.以八步地下河为例,利用硫酸盐（SO₄^2-）浓度、硫氧同位素（δ³⁴S-SO₄和δ¹⁸O-SO₄）和水中氧同位素（δ¹⁸O-H₂O）研究岩溶小流域SO₄^2-的丰、枯水期两个季节变化特征和来源.结果表明：①受酸性矿坑水（acid mine drainage,AMD）直接影响的采样点SO₄^2-浓度较高（≥250 mg·L^-1）,枯水期>丰水期,其他采样点浓度季节变化相对较弱且浓度低.②地表水丰水期δ³⁴S-SO₄与δ¹⁸O-SO₄平均值分别为-10.5‰和4.7‰,枯水期为-11.5‰和1.3‰;地下水丰水期δ³⁴S-SO₄与δ¹⁸O-SO₄平均值分别为-2.9‰和7.1‰,枯水期为-3.2‰和6.2‰.地表水和地下水中δ³⁴S-SO₄与δ¹⁸O-SO₄值都存在丰水期偏重、枯水期偏轻的特征.③丰、枯水期流域内地表水和地下水中各采样点δ³⁴S-SO₄值变化不明显,表明在特定的采样点SO₄^2-的来源相对稳定.④地表水和地下水中SO₄^2-主要来源于雨水、硫化物和石膏,地下河出口各来源丰水期所占的比例分别为13%、40%和47%,枯水期为18%、39%和43%.     

长输管道事故应急决策过程优化研究

针对长输管道事故应急决策指挥体系,综合应用系统科学的理论知识,结合ECOM模型对应急决策控制过程的特点进行全面的分析。在科学分析的基础上,从应急决策指挥体系组织结构与应急行动策划流程两个方面,对长输管道事故应急决策控制过程实现优化,实现了科学合理的组织结构以及高效、迅捷的决策过程,从而提高整个应急响应系统的应急水平。     

Decomposition of hexachlorobenzene over Al2O3 supported metal oxide catalysts

Decomposition of hexachlorobenzene(HCB)was investigated over several metal oxides(i.e.,MgO,CaO,BaO,La2O3,CeO2,MnO2, Fe2O3,and Co3O4)supported on Al2O3,which was achieved in closed system at a temperature of 300°C.Catalysts were prepared by incipient wetness impregnation with different metal oxides loading and impregnating solvents.The decomposition effciency of different catalysts for this reaction depends on the nature of the metal oxide used,and Al2O3 supported La2O3 was found to be the most active one.Pe...     

基于双电极传感器的腐蚀电流检测系统抗扰技术

目的 针对金属电化学腐蚀中腐蚀电流检测,设计一种高精度I-V转换的微电流检测电路,突破宽范围微弱电流高精度检测技术。方法 通过分析电路的稳定性,针对100 pA~10 mA的微弱腐蚀电流采集,采用法安级偏置运放实现I-V转换,设计基于ADG708电子开关的8档自动调节电路,并通过24位ADC实现高精度模数转换。针对微弱电流采集中信号易受噪声的影响,设计自适应滤波器用于信号滤波处理。结果 通过MATLAB仿真自适应滤波器的有效性,结果表明,在采集i(k)=2sin(2πk)电流时,误差从0.29 mA(1σ)降低到0.003 9 mA(1σ)。通过电流源校准测试系统精度,在100 pA时误差最大,为4.7%;在10 mA时误差最小,为0.049%。当电流值低于100 nA时,测量误差可以控制在5%以内;100 nA以上时,测量误差可以控制在1%以内。结论 在微弱电流采样中引入自适应滤波器后,系统的采样精度显著提高,突破了宽范围的腐蚀电流采集技术,实现了微弱电流检测。可以将腐蚀电流应用在金属腐蚀速率的评价中。     

铜卟啉修饰In2TiO5纳米带的制备及其光催化性能

以5,10,15,20-四苯基铜卟啉（CuTPP）和5-（4-氨基苯基）-10,15,20-三苯基铜卟啉（CuAPTPP）为敏化剂,采用溶剂热法成功制备了铜卟啉敏化In₂TiO₅复合光催化剂.利用紫外、FT-IR、XRD、SEM、UV-vis DRS和N₂吸附脱附曲线对所得铜卟啉及复合光催化剂进行表征和分析.结果表明,铜卟啉负载于In₂TiO₅纳米带表面,复合光催化剂的禁带宽度及比表面积出现一定程度的减小,但未改变In₂TiO₅的晶型及形貌.其中,CuTPP敏化In₂TiO₅复合光催化剂的光催化活性最强,在模拟太阳光的照射下,120 min时罗丹明B（RhB）的降解率高达98.9%,而In₂TiO₅纳米带对RhB的降解率仅为33.5%,且循环使用5次后其光催化降解率仍保持在95%以上.     

Quorum sensing regulation methods and their effects on biofilm in biological waste treatment systems: A review

• Quorum sensing enhancement and inhibition methods are summarized. • Effects of quorum sensing regulation on biofilm are reviewed. • Current knowledge gaps and research challenges are proposed. Quorum sensing (QS) plays an important role in microbial aggregation control. Recently, the optimization of biological waste treatment systems by QS regulation gained an increasing attention. The effects of QS regulation on treatment performances and biofilm were frequently investigated. To understand the state of art of QS regulation, this review summarizes the methods of QS enhancement and QS inhibition in biological waste treatment systems. Typical QS enhancement methods include adding exogenous QS molecules, adding QS accelerants and cultivating QS bacteria, while typical QS inhibition methods include additions of quorum quenching (QQ) bacteria, QS-degrading enzymes, QS-degrading oxidants, and QS inhibitors. The specific improvements after applying these QS regulation methods in different treatment systems are concluded. In addition, the effects of QS regulation methods on biofilm in biological waste treatment systems are reviewed in terms of biofilm formation, extracellular polymeric substances production, microbial viability, and microbial community. In the end, the knowledge gaps in current researches are analyzed, and the requirements for future study are suggested.     

Impact of particle sizes on health risks and source-specific health risks for heavy metals in road dust

Environmental Science and Pollution Research - To analyze the impact of particle sizes on sources and related health risks for heavy metals, road dust samples in Beijing were collected and sifted...     

小型四旋翼无人机悬停状态气动干扰与安全间隔研究*

为保证小型旋翼无人机近距编队悬停状态的安全性,采用数值模拟方法研究不同横向和纵向间隔双机悬停流场特征和气动参数变化规律,通过与实验结果对比,验证数值仿真方法的准确性。研究结果表明:无人机内部旋翼间的气动干扰会导致整机单旋翼拉力降低、扭矩增大,使整机气动效率下降;当双机无横向间隔时,双机下洗流场保持对称,同时2股下洗流叠加,呈现较明显的横向扩张趋势,此时后机所受气动影响主要为拉力损失,当纵向间隔大于5 D时,该影响基本消失;当横向间隔X=1 D时,位于尾流区一侧的旋翼拉力减小,后机所受俯仰力矩作用显著,无人机有侧翻风险;横向间隔X≥2 D时,2机之间气动干扰较弱,为较安全区域。