Degradation of aqueous Rhodamine B by plasma generated along the water surface and its enhancement using nanocrystalline Fe-, Mn-, and Ce-doped TiO2 films

The degradation of aqueous Rhodamine B (RhB) was examined using a dual-channel spark switch module designed to regulate the steepness of pulsed high voltage with microsecond rise time. Depending on the energy per pulse, a spark along the water surface (SPWS) or streamer along the water surface (STWS) was formed. STWS was found to have a better degradation effect and energy efficiency toward RhB than SPWS at the same power; however, addition of H₂O₂ amounts resulted in increased degradation, the effect being more pronounced using SPWS. The initial concentration of RhB also appeared to influence the rate constant of the degradation reaction. Furthermore, TiO₂ films doped with Fe, Mn, and Ce were found to enhance the degradation performance of plasma. A possible reaction mechanism of plasma formation along the water surface was concluded by determination of the main inorganic products in the liquid and gas phases.     

Composting of waste algae: A review

Although composting has been successfully used at pilot scale to manage waste algae removed from eutrophied water environments and the compost product applied as a fertiliser, clear guidelines are not available for full scale algae composting. The review reports on the application of composting to stabilize waste algae, which to date has mainly been macro-algae, and identifies the peculiarities of algae as a composting feedstock, these being: relatively low carbon to nitrogen (C/N) ratio, which can result in nitrogen loss as NH₃ and even N₂O; high moisture content and low porosity, which together make aeration challenging; potentially high salinity, which can have adverse consequence for composting; and potentially have high metals and toxin content, which can affect application of the product as a fertiliser. To overcome the challenges that these peculiarities impose co-compost materials can be employed.     

臭氧氧化—包埋菌流化床生物处理组合工艺深度处理煤气化废水

采用臭氧氧化—包埋菌流化床生物处理组合工艺对煤气化废水进行深度处理。实验结果表明：当臭氧的质量浓度20 mg/L、臭氧进气流量1.5 L/min、臭氧通气时间30 min、包埋菌流化床水力停留时间24 h时,臭氧氧化工序的COD去除率达到30.0%~40.0%,总酚去除率达到100.0%;包埋菌流化床工序的COD去除率达到60.0%以上,氨氮的去除率大于95.0%;经组合工艺处理后,出水COD<60 mg/L,ρ（氨氮）<1.0 mg/L,ρ（总酚）未检出,色度小于50倍,达到GB8978—1996《污水综合排放标准》中的一级排放标准。     

石化行业的VOCs排放控制管理

概述了我国挥发性有机化合物（VOCs）的排放情况。介绍了国内外VOCs的管理现状。分析了国内石化行业VOCs排放控制管理中存在的主要问题以及污染物排放过程的类别。提出了明确定义、制定相关标准、完善分类管理体系、研究最佳的可行性控制技术等加强VOCs排放控制管理的对策和建议。     

抗铬菌株的筛选鉴定及其生物学特性和吸附特性

利用微生物分离纯化技术,在培养基中加入不同浓度的Cr3+、Cr6+,经过长时间驯化,从污染土壤中筛选出2株对Cr具有较高抗性的菌株(A和B),对其进行了形态、生理生化特性及分子生物学鉴定,并研究了其最佳生长条件及对Cr3+的生物吸附规律。结果表明,菌株A和B分别为蜡状芽孢杆菌(Bacillus cereus)和米根霉菌(Rhizopus oryzae)。菌株A和B的最适生长pH值均为7,最适生长温度均为30℃,最佳装液量为80~100 mL(250 mL摇瓶)。在培养时间一定时,随着Cr3+浓度的增加,菌株对Cr3+的吸附率减少,而生物吸附量则逐渐增大;在Cr3+浓度一定时,随着培养时间的延长,菌体对Cr3+的吸附率呈现出先增加后减少的趋势,这与生物吸附量的变化趋势基本一致。在Cr3+浓度为100 mg/L时,菌株A和B对Cr3+的吸附率达到最大,分别为51.47%和46.36%。     

介质阻挡放电协同Ag/Al_2O_3对NO_x脱除的影响

为有效去除发电厂烟气中产生的NOx,利用介质阻挡放电(DBD)产生低温等离子体并结合催化剂Ag/Al2O3进行烟气脱硝实验,研究了在加入乙烯的条件下,平均负载量、催化温度和装置的布置方式对NOx脱除的影响。结果表明,随着负载的增多,NO脱除率呈现先增大后减小的趋势,5种负载量中最佳为1.76%;随着催化温度的升高,NO脱除率同样呈现先增大后减小的趋势,最佳的催化温度为150℃左右;3种不同布置方式对NO和NOx脱除有明显差别,单独催化剂在NO和NOx的脱除率都比较低;单独介质阻挡放电NO脱除率很高,但是NOx很却很低;而两者结合在NO和NOx都达到了很好的效果。     

A novel use of anaerobically digested liquid swine manure to potentially control soybean cyst nematode

Experiments were carried out in two steps to determine the effect of anaerobically digested swine manure on soybean cyst nematode (SCN) egg control. In the first step, liquid swine manure underwent anaerobic digestion to search for the best digestion time for both volatile fatty acids (VFA) and ammonium nitrogen (NH₄ ⁺) enrichment. The results showed that about 17 and 28 days of incubation were needed, respectively, to reach the maximal levels of VFA and NH₄ ⁺ in the manure. In the second step, raw, VFA-enriched, and NH₄ ⁺-enriched manure were applied separately, at four different rates (25, 50, 100, and 200 mL/pot), to soil pots inoculated with nematode eggs in a greenhouse environment. Soil samples were collected 35 and 61 days after inoculation to determine the effect of such treated manure on SCN egg productivity. The data indicated that the SCN egg counts were inversely related to the manure application rates in a linear manner with correlation coefficients of 0.998, 0.967, and 0.900 for raw, NH₄ ⁺-enriched, and VFA-enriched manure for the 35-day samples. While no such relationships were found for the 61-day samples, implying that none of the treatments were still effective 61 days after application. At the four application rates, the VFA-enriched manure performed best in reducing SCN egg counts (by 18.1, 19.5, 34.3, and 18.6%) as compared to the raw manure treatment. In contrast, the NH₄ ⁺-enriched manure achieved mostly negative reductions. To achieve the best control of SCN egg growth, the VFA-enriched manure should be used and applied to soybean fields every 35 days.     

Kinetics study of fermentative hydrogen production from liquid swine manure supplemented with glucose under controlled pH

Kinetics of H₂ production from liquid swine manure supplemented with glucose by mixed anaerobic cultures was investigated using batch experiments under four different pH conditions (4.4, 5.0, 5.6, and uncontrolled). The temperature for the experiments was controlled at 37 ± 1°C and the length of experiments varied between 50 and 120 hours, depending upon the time needed for completion of each individual experiment. The modified Gompertz model was evaluated for its suitability for describing the H₂ production potential, H₂ production rate, and substrate consumption rate for all the experiments. The results showed that the Gompertz model could adequately fit the experimental results. The effect of pH was significant on all kinetic parameters for H₂ production including yield, production rate and lag time, and the substrate utilization rate. The optimal pH was found to be 5.0, at which a maximum H₂ production rate (0.64 L H₂/h) was obtained, and deviation from the optimal pH could result in substantial reductions in H₂ production rate (0.32 L H₂/h for pH 4.0 and 0.43 L H₂/h for pH 5.6). The results also showed that if pH was not controlled for the batch fermentation process, the substrate utilization efficiency could steeply decrease from 98.8% to 33.7%.     

Measurement of Fine Particles in Diesel Emissions Using a Real-Time Aerosol Monitor

Abstract

A real-time monitoring methodology to determine diesel fine particles in diesel emissions has been evaluated. The range of particle size captured by the monitor was ～0.1 μm to 1 μm. DustTrak real-time monitors were connected to the dilution tunnel of the vehicle exhaust to measure the emissions during the vehicle tests under both dynamic and steady-state driving conditions, and concentration data were recorded every 5 sec. Test variation of the real-time monitoring among different test days was similar to that measured by traditional filter-based gravi-metric method, whereas the repeatability of the monitor data within the same-day tests was better than that of gravimetric method. Correlations between the two methods were established for different fuels tested on a single light duty vehicle. When the emissions from the reference fuel was used to convert the monitor’s response to diesel fuels, the levels determined by the real-time monitor were consistent with those measured by gravimetric method among different fuels tested. Use of the real-time monitor could provide information on the levels of fine particles that is more relevant to the public health than the total particles.     

Characteristics and management of domestic waste in a rural area of the Tibetan Plateau

In the rural area of the Tibetan Plateau (RATP), the characteristics of domestic waste, people’s environmental awareness, people’s willingness to pay and their influence factors were firstly studied by questionnaires, field samplings and laboratory tests. The results showed that, in the RATP, the generation of domestic waste was 85 g?d-1 per capita and it was mainly composed of plastics, inert waste, kitchen waste, glass and paper. The waste bulk density, moisture content, ash, combustible and low calorific value were 65 kg?m-3, 19.25%, 44.90%, 35.85% and 10,520 kJ?kg-1 respectively. These characteristics are influenced by income sources and geographical position to some extent. Classified collection should be promoted widely on the household and the village basis. Compost, fermentation, landfill, bioreactor landfill and semi-aerobic landfill have been approved as effective techniques to treat domestic waste, except incineration. The distance of 50–800 m between each collection facility and the disposal fee of around $0.8 per month per household are suggested. For suburbs or large population villages, it’s better to treat domestic waste by the centralized way. But for the remote rural areas, a decentralized way is proposed. Significantly, the educational and economic influence should be considered into an effective domestic waste management program.

Implications:?The current situatio n of the environment in the rural areas of the Tibetan Plateau (RATP) was surveyed. There, the generation of organics and moisture of domestic waste were low but ash, recyclables, and combustibles were high. People’s knowledge of domestic waste was absent but their participation in management was strong. Based on the current situation, compost, fermentation, and landfill were effective but incineration was inappropriate. Also, a localized mini landfill for a cluster of villages and or settlements was the best method there.