Correction to: Ecotoxicological assessment of oil-based paint using three-dimensional multi-species bio-testing model: pre- and post-bioremediation analysis

Environmental Science and Pollution Research - The original publication of this paper contains a mistake.     

CLIMATOLOGICAL WATERSHED CALIBRATION1

ABSTRACT: This study tests the hypothesis that climatic data can be used to develop a watershed model so that stream flow changes following forest harvest can be determined. Measured independent variables were precipitation, daily maximum and minimum temperature, and concurrent relative humidity. Computed variables were humidity deficit, saturated vapor pressure, and ambient vapor pressure. These climatic variables were combined to compute a monthly evaporation index. Finally, the evaporation index and monthly precipitation were regressed with measured monthly stream flow and the monthly estimates of stream flow were combined for the hydrologic year. A regression of predicted versus measured annual stream flow had a standard error of 1.5 inches (within 6.1 percent of the measured value). When 10, 15, and 20 years of data were used to develop the regression equations, predicted minus measured stream flow for the last 7 years of record (1972–1978) were within 16.8, 11.5, and 9.7 percent of the measured mean, respectively. Although single watershed calibration can be used in special conditions, the paired watershed approach is expected to remain the preferred method for determining the effects of forest management on the water resource.     

Biomass energy consumption and sustainable development: empirical evidence from Asian economies

Environmental Science and Pollution Research - Biomass energy is an important source of energy consumption. It is a renewable, abundant, and easily produced energy source. Its usage supports...     

A comprehensive review of the energy efficiency on nano coated fin and tube condenser

The condenser is a piece of equipment used to effectively transfer heat from water to the environment. The fin and tube condenser is the most commonly used in commercial applications. The improved performance of heat transfer in the fin and tube condenser is a significant area of study all over the world because optimizing the efficiency of heat transfer in the condenser will contribute to enhancing the effectiveness of system performance. The vapor deposition, plasma spray, and thermal spray techniques are being used, and it is determined that a heat transfer enhancing coating improves condenser performance. This review discusses the nanomaterial coating over the fin and tube condenser in detail. The various nanomaterial coatings with various propositions and coating methods had been discussed with the evidence of previous researchers. At a 50-degree inclination angle on the condensate plate, the condensate over the coating surface increases by more than 30%. The thermal properties of the working fluid are improved over the condenser, and the overall effectiveness of the condenser is increased by approximately 40% over the non-coated condenser. A 1% volumetric concentration of Nanoparticles in the coated material achieves a maximum efficiency increase of 78.7%.     

Investigating effect of proton-exchange membrane on new air-cathode single-chamber microbial fuel cell configuration for bioenergy recovery from Azorubine dye degradation

Environmental Science and Pollution Research - One of the biggest challenges of using single-chamber microbial fuel cells (MFCs) that utilize proton-exchange membrane (PEM) air cathode for...     

Assessing the economic value of urban green spaces in Kuala Lumpur

Environmental Science and Pollution Research - This study assessed the economic value of public urban green spaces (UGSs) in Kuala Lumpur (KL) city by using the hedonic price method (HPM). It...     

Cytotoxicity,genotoxicity and oxidative stress of malachite green on the kidney and gill cell lines of freshwater air breathing fish Channa striata

The cytotoxicity, genotoxicity and oxidative stress of malachite green (MG) was investigated using the fish Channa striata kidney (CSK) and Channa striata gill (CSG) cell lines. Five concentrations ranging from 0.001 to 10 μg mL^?1 were tested in three independent experiments. Cytotoxicity was assessed by 3-(4, 5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) assay, Rhodamine 123 and Alamar Blue. The mitochondrial changes and apoptosis of MG-exposed cells were observed by Rhodamine 123 and acridine orange/ethidium bromide (AO/EB) staining, respectively. In vitro potential DNA damaging effect of MG was tested using comet assay. Mitochondrial damage, apoptosis and DNA fragmentation increased in a concentration-dependent manner. Additionally, DNA electrophoretic mobility experiments were carried out to study the binding effect of MG to double-stranded DNA (dsDNA) of cells. DNA shift mobility experiments showed that MG is capable of strongly binding to linear dsDNA causing its degradation. Biochemical parameters such as lipid peroxidation (MDA), catalase (CAT) activity and reduced glutathione (GSH) levels were evaluated after exposure to MG. In CSK and CSG cell lines exposed to MG for 48 h, a significant increase in lipid peroxidation, which might be associated with decreased levels of reduced glutathione and catalase activity in these cell lines (p?相似文献   

Monitoring the impact of urban effluents on mineral contents of water and sediments of four sites of the river Ravi, Lahore

We assessed the impact of urban effluents on the concentrations of selected minerals (Cd, Cr, Cu, Fe, Pb, Zn, Mn, Ni, and Hg) in river Ravi before and after its passage through Lahore city. Water and sediment samples were collected from three lowly to highly polluted downstream sites (Shahdera (B), Sunder (C), and Balloki (D)) alongside the least polluted upstream site (Siphon (A)) during high and low river flow seasons. All the mineral concentrations increased up to site C but stabilized at site D, showing some recovery as compared to the third sampling site. The trend of mean mineral concentration was significantly higher during the low than the high flow season at all the sites. The mean Hg concentrations approached 0.14 and 0.12 mg/l at site A which increased (%) up to 107 and 25 % at site B, 1,700 and 1,317 % at site C, and 1,185 and 1,177 % at site D during low and high river flows, respectively. All mineral concentrations were much higher in the sediment than the water samples. Mean Cd (917 %), Cr (461 %), Cu (300 %), Fe (254 %), Pb (179 %), Zn (170 %), Mn (723 %), Ni (853 %), and Hg (1,699 %) concentrations were higher in riverbed sediments sampled from site C in comparison with the sample collected at site A during low flow season. The domestic and industrial discharges from Lahore city have created undesirable water qualities during the low river flow season. As majority of the mineral levels in the river Ravi were higher than the permissible and safe levels, this is of immediate concern for riverine fish consumers and the users of water for recreation and even irrigation. The use of these waters may pose health risks, and therefore, urgent intervention strategies are needed to minimize river water pollution and its impact on fish-consuming communities of this study area and beyond.     

Development of a novel mathematical model using a group contribution method for prediction of ionic liquid toxicities

A new mathematical model has been developed that expresses the toxicities (EC₅₀ values) of a wide variety of ionic liquids (ILs) towards the freshwater flea Daphnia magna by means of a quantitative structure-activity relationship (QSAR). The data were analyzed using summed contributions from the cations, their alkyl substituents and anions. The model employed multiple linear regression analysis with polynomial model using the MATLAB software. The model predicted IL toxicities with R² = 0.974 and standard error of estimate of 0.028. This model affords a practical, cost-effective and convenient alternative to experimental ecotoxicological assessment of many ILs.     

Kinetic of formation for single carbon dioxide and mixed carbon dioxide and tetrahydrofuran hydrates in water and sodium chloride aqueous solution

A laboratory-scale reactor system is built and operated to measure the kinetic of formation for single and mixed carbon dioxide–tetrahydrofuran hydrates. The T-cycle method, which is used to collect the kinetic data, is briefly discussed. For single carbon dioxide hydrate, the induction time decreases with the increase of the initial carbon dioxide pressure up to 2.96 MPa. Beyond this pressure, the induction time is becoming relatively constant with the increase of initial carbon dioxide pressure indicating that the liquid phase is completely supersaturated with carbon dioxide. Experimental results show that the inclusion of tetrahydrofuran reduces the induction time required for hydrate formation. These observations indicate hydrate nucleation process and onset growth are more readily to occur in the presence of tetrahydrofuran. In contrast, the presence of sodium chloride prolongs the induction time due to clustering of water molecules with the ions and the salting-out effects. It is also shown that the degree of subcooling required for hydrate formation is affected by the presence of tetrahydrofuran and sodium chloride in the hydrate forming system. The presence of tetrahydrofuran in the hydrate system significantly reduces the amount of carbon dioxide uptake. The apparent rate constant, k, for those systems are reported.