Recycling of combined coal-biomass ash from electric power plant waste as a cementitious material: characteristics and improvement

Combined coal-biomass ash has an enormous impact on environmental quality near electric power plants. This paper describes an alternative to disposal in which the ash is used to produce cementitious materials. Ash was obtained from combustion of coal and biomass containing four mass ratios of anthracite, bitumen, rice husks, and eucalyptus bark. The cement-forming properties were systematically characterized including compressive strength development, durability, and expansion in water. The ash samples were ground to increase the specific surface area, and then used to partially replace ASTM Type I Portland cement in mixtures containing 15, 30, or 45 % ash by mass. The water-binder material's (Portland cement with or without combined coal-biomass ash) ratios (w/c) were held constant at 45, 55, or 65 % by mass. Types A, B, and D ash behaved similarly, while the properties of type C ash were slightly different. Increasing the ash fraction in Portland cement mixtures increased the water requirement and resulted in lower compressive strength. Thorough mechanical grinding reduced the porosity and significantly enhanced the material properties.     

Energy recovery and greenhouse gas reduction potential from food waste in Japan

Waste-to-energy is one effective waste management approach for a sustainable society. The purpose of this study was to clarify the potential for energy recovery and greenhouse gas (GHG) reduction that could be achieved by introducing anaerobic digestion (AD) facilities in the process of reconstructing aging incineration facilities in Japan. Using statistical data from 1068 incineration facilities, four future scenarios were considered and compared with the current situation. As results, compared with the current situation the amount of electricity generated could increase by 60 % in 2030, by combining AD facilities for food waste with new, high-efficiency incineration facilities for remaining municipal solid waste (MSW). From a life cycle perspective, net energy recovery in 2030 was approximately three times greater than in 2011, and GHG emission could be reduced by 27 %. The introduction of AD facilities is attractive for small authorities, which currently treat <100 t/day of MSW through incineration facilities without energy recovery. An AD facility is also beneficial for large authorities. On the contrary, in middle-scale authorities that treat 100–299 t/day of MSW, the reconstruction of incineration facilities to include electricity production capabilities requires careful consideration, because it will significantly influence energy recovery and GHG reduction effects.     

Landfill leachate enhances fermentative hydrogen production from glucose and sugarcane processing derivatives

Fermentation can use renewable raw materials as substrate, which makes it a sustainable method to obtain H₂. This study evaluates H₂ production by a mixed culture from substrates such as glucose and derivatives from sugarcane processing (sucrose, molasses, and vinasse) combined with landfill leachate. The leachate alone was not a suitable substrate for biohydrogen production. However, leachate blended with glucose, sucrose, molasses, or vinasse increased the H₂ production rate by 2.0-, 2.8-, 4.6-, and 0.5-fold, respectively, as compared with the substrates without the leachate. Determination of metals (Cu, Cd, Pb, Hg, Ni, and Fe) at the beginning and at the end of the fermentative assays showed how they were consumed during the fermentation and demonstrated improved H₂ production. During fermentation, Cu, Fe, and Cd were the most consumed leachate metals. The best substrate combination to produce H₂ was molasses and leachate, which gave high volumetric productivity—469 ml H₂/l h. However, addition of the leachate to the substrates stimulated lactic acid formation pathways, which lowered the H₂ yield. The use of leachate combined with sugarcane processing derivatives as substrates could add value to the leachate and reduce its polluting power, generating a clean energy source from renewable raw materials.     

Settlement decisions in blue tits: difference in the use of social information according to age and individual success

Dispersers are expected to assess breeding habitat quality before settlement. Although cues reflecting habitat quality are well studied, social cues have not been as well evaluated. In this paper, we studied breeding habitat selection during 3 years in a natural population of blue tits, Cyanistes caeruleus, breeding in nest-boxes. Our aim was to investigate if this species used conspecific density and/or reproductive success of con- and heterospecifics (i.e., social cues) in settlement decisions. The patterns observed were consistent with the idea that juveniles, when dispersing from their natal patches, did not react to any of the cues that we tested. In contrast, breeders that dispersed seemed to respond to both conspecific mean patch reproductive success (PRS) and breeding density of the settlement patch in the year of dispersal, their response differing according to their own reproductive success. Indeed, failed breeders moved to areas with high PRS and low density relative to source patches, while successful breeders behaved the opposite. The comparison between juveniles and adults might be modulated by the limited time available to juveniles to gather information on PRS and density at the end of the dispersing year. Adults lacking these time constraints, however, seemed to rely on these conspecific cues although limited by their own quality. Additionally, breeders were more likely to be immigrants in patches with relatively low breeding success and density the previous year, suggesting that settlement is influenced by multiple cues, which may reveal information on different aspects of habitat and be available at different moments. Collectively, our results support the importance of social cues for blue tits’ settlement.     

Development impact of advocacy initiatives in solid waste management in Nigeria

Solid waste management (SWM) in many low- and middle-income countries is sometimes driven by the informal sector. Unfortunately, contributions of the sector to SWM are not acknowledged in many developing countries. This situation often arises from inadequate awareness and lack of advocacy for these development contributions. This article reports on the impact of a study conducted by final-year geography undergraduates on the informal waste management sector in Nsukka urban area, Nigeria. The purposes of this exercise were to stimulate development intervention on behalf of the sector to improve perceptions, attitudes and performance, to impart a range of development research skills and to expose the students to the business opportunities provided by SWM and recycling. Informal waste sector workers and government officials responsible for SWM were interviewed, and some commercial data on recycling operations were collected. Findings of this study indicate that such advocacy initiatives were effective in increasing students’ awareness of opportunities and interest in working in the informal waste sector to promote better SWM and development in Nigeria. Lessons from this university case study are also drawn for other developing countries struggling to achieve the poverty reduction and job creation Millennium Development Goals (MDGs).     

Plant Species Richness and Developmental Morphology Stage Influence Mycorrhizal Patagonia Plants Root Colonization

The objectives of this study were to determine the percentage of root colonization by arbuscular mycorrhizal (AM) fungi at various levels of plant species richness and developmental morphology stages in various perennial grass, and herbaceous and woody dicots species using experimental plots during 2013 and 2014. An auger was used to obtain six replicate root + soil samples at each sampling time on each of the study parameters. Roots were washed free of soil, and percentage AM was determined. The shrub Larrea divaricata was the species which showed the lowest percentage of colonization by AM at the vegetative developmental morphology stage at the monocultures and six-species-mixtures on the experimental plots. Dicots, but not grass, species showed a greater percentage colonization by AM fungi at the greatest (i.e., six-species-mixtures) than lowest (i.e., monocultures) species richness. Although at different degrees of species richness and developmental morphology stages, the perennial grasses Nassella longiglumis and N. tenuis, the herbaceous dicot Atriplex semibaccata, and the shrubs L. divaricata and Schinus fasciculatus showed a greater (p < 0.050) percentage colonization by AM fungi during the second than the first study year. Even though it was species- and sampling time-dependent, percentage colonization by AM fungi increased as species richness also increased most of the times. Our results demonstrated that the plant species differences in percentage colonization by AM fungi in the experimental plots were species richness-, developmental morphology stage-, and sampling-time dependents.     

Climatic changes and their impact on socio-economic sectors in the Bhutan Himalayas: an implementation strategy

This paper contributes to an enhanced understanding of present climatic conditions, observed climate trends and regional climate vulnerability of the Bhutan Himalayas. Bhutan’s complex, often high-altitude terrain and the severe impact of the Indian summer monsoon leads to a strong exposure of the countries’ key economic sectors (agriculture, forestry, hydropower generation and tourism) to climatic changes. Climate change also threatens Bhutan’s vast biodiversity and increases the likelihood of natural hazards (e.g. glacier lake outburst floods, flash floods, droughts and forest fires). A better understanding of Bhutan’s climate and its variability, as well as observed and possible climate impacts, will help in improving the handling of regional social, economic and ecologic challenges not limited to the Himalayas. Only a few climatological studies exist for the eastern Himalayas. They mainly focus on adaptation to immediate threats by glacier lake outbursts. In contrast, this paper (1) investigates the average spatial and inner-annual diversity of the air temperature regime of Bhutan, based on local meteorological observations, (2) discusses past temperature variability, based on global datasets, and (3) relates effects of observed warming to water availability, hydropower development, natural hazards, forests, biodiversity, agriculture, human health and tourism in the Bhutan Himalayas. Results indicate a large spatial and temporal temperature variability within Bhutan and considerably increasing temperatures especially over recent decades. Implications of regional climatic changes on various socio-economic sectors and possible adaptation efforts are discussed.     

Glyphosate input modifies microbial community structure in clear and turbid freshwater systems

Since it was commercially introduced in 1974, glyphosate has been one of the most commonly used herbicides in agriculture worldwide, and there is growing concern about its adverse effects on the environment. Assuming that glyphosate may increase the organic turbidity of water bodies, we evaluated the effect of a single application of 2.4?±?0.1 mg l^?1 of glyphosate (technical grade) on freshwater bacterioplankton and phytoplankton (pico, micro, and nanophytoplankton) and on the physical and chemical properties of the water. We used outdoor experimental mesocosms under clear and oligotrophic (phytoplanktonic chlorophyll a?=?2.04 μg l^?1; turbidity?=?2.0 NTU) and organic turbid and eutrophic (phytoplanktonic chlorophyll a?=?50.3 μg l^?1; turbidity?=?16.0 NTU) scenarios. Samplings were conducted at the beginning of the experiment and at 1, 8, 19, and 33 days after glyphosate addition. For both typologies, the herbicide affected the abiotic water properties (with a marked increase in total phosphorus), but it did not affect the structure of micro and nanophytoplankton. In clear waters, glyphosate treatment induced a trend toward higher bacteria and picoeukaryotes abundances, while there was a 2 to 2.5-fold increase in picocyanobacteria number. In turbid waters, without picoeukaryotes at the beginning of the experiment, glyphosate decreased bacteria abundance but increased the number of picocyanobacteria, suggesting a direct favorable effect. Moreover, our results show that the impact of the herbicide was observed in microorganisms from both oligo and eutrophic conditions, indicating that the impact would be independent of the trophic status of the water body.     

Long-term geochemical evolution of the near field repository: insights from reactive transport modelling and experimental evidences

The KBS-3 underground nuclear waste repository concept designed by the Swedish Nuclear Fuel and Waste Management Co. (SKB) includes a bentonite buffer barrier surrounding the copper canisters and the iron insert where spent nuclear fuel will be placed. Bentonite is also part of the backfill material used to seal the access and deposition tunnels of the repository. The bentonite barrier has three main safety functions: to ensure the physical stability of the canister, to retard the intrusion of groundwater to the canisters, and in case of canister failure, to retard the migration of radionuclides to the geosphere. Laboratory experiments (< 10 years long) have provided evidence of the control exerted by accessory minerals and clay surfaces on the pore water chemistry. The evolution of the pore water chemistry will be a primordial factor on the long-term stability of the bentonite barrier, which is a key issue in the safety assessments of the KBS-3 concept.In this work we aim to study the long-term geochemical evolution of bentonite and its pore water in the evolving geochemical environment due to climate change. In order to do this, reactive transport simulations are used to predict the interaction between groundwater and bentonite which is simulated following two different pathways: (1) groundwater flow through the backfill in the deposition tunnels, eventually reaching the top of the deposition hole, and (2) direct connection between groundwater and bentonite rings through fractures in the granite crosscutting the deposition hole. The influence of changes in climate has been tested using three different waters interacting with the bentonite: present-day groundwater, water derived from ice melting, and deep-seated brine. Two commercial bentonites have been considered as buffer material, MX-80 and Deponit CA-N, and one natural clay (Friedland type) for the backfill. They show differences in the composition of the exchangeable cations and in the accessory mineral content. Results from the simulations indicate that pore water chemistry is controlled by the equilibrium with the accessory minerals, especially carbonates. pH is buffered by precipitation/dissolution of calcite and dolomite, when present. The equilibrium of these minerals is deeply influenced by gypsum dissolution and cation exchange reactions in the smectite interlayer. If carbonate minerals are initially absent in bentonite, pH is then controlled by surface acidity reactions in the hydroxyl groups at the edge sites of the clay fraction, although its buffering capacity is not as strong as the equilibrium with carbonate minerals. The redox capacity of the bentonite pore water system is mainly controlled by Fe(II)-bearing minerals (pyrite and siderite). Changes in the groundwater composition lead to variations in the cation exchange occupancy, and dissolution–precipitation of carbonate minerals and gypsum. The most significant changes in the evolution of the system are predicted when ice-melting water, which is highly diluted and alkaline, enters into the system. In this case, the dissolution of carbonate minerals is enhanced, increasing pH in the bentonite pore water. Moreover, a rapid change in the population of exchange sites in the smectite is expected due to the replacement of Na for Ca.