Self-build packed-bed bioreactor for rapid and effective BOD estimation

This work demonstrated a simple, low-cost, rapid, and effective biochemical oxygen demand (BOD) estimation system based on a packed-bed bioreactor that can be easily self-built on-site at a particular wastewater treatment plant for continuous monitoring of the influent and effluent. The use of natural microbial consortium that were collected from the target wastewater and immobilized on a cheap porous carrier simply by adhesion resulted in an acceptable accuracy of over 95%. The newly developed semi-continuous operating mode with peak-type signals was shown to be able to continuously estimate BOD at a high flow rate to overcome the flow dependence of the oxygen electrode, limit clogging issues, enhance the response time, and lower the limit of detection. The resulting packed-bed bioreactors could work continuously for 22 h with a coefficient of variance (CoV) of only 1.8% or for 13 h a day for several days with a maximum CoV of 1.4% and their response was observed to be stable over 80 consecutive measurements. They exhibited stable responses at a wide pH range of 6.5–8.5, which is also the recommended range for aerobic wastewater treatment, emphasizing the greater ease of use of natural microorganisms for BOD estimation.

     

Geochemistry and pH control of seepage from Ni-Cu rich mine tailings at Selebi Phikwe,Botswana

Acid mine drainage from mine tailings at Selebi Phikwe, eastern Botswana, has been investigated using a combination of total decomposition, sequential extraction, X-ray diffraction, Mössbauer spectroscopy, and SEM analyses of solid phase samples, water analyses, isotopic analyses, and geochemical modeling. The principal ferric phases in the seepage stream sediments are jarosite and goethite, which incorporate Ni and Cu. The Mössbauer spectroscopy (MS) indicated exclusively 3+ oxidation state of iron with typical features of ferric hydroxides/sulfates. A fraction of dissolved sulfate is also sequestered in gypsum which precipitates further downstream. Significant portions of Fe, Ni, and Cu are transported in suspension. Values of pH decreased downstream due to H⁺ generated by the precipitation of jarosite. Values of δ²H and δ¹⁸O indicate evaporation of pore water in the mine tailings before seepage. Values of δ³⁴S(SO₄) are consistent with the oxidation of sulfides, but sample from the seepage face is affected by dissolution of gypsum. No minerals of Ni and Cu were detected and the principal attenuation processes seem to be adsorption and co-precipitation with jarosite. Higher contents of Cu are sequestered in solid phases compared to Ni, in spite of much higher dissolved Ni concentrations. Based on the speciation calculations, seepage water is undersaturated with respect to all Ni and Cu phases and adsorption and co-precipitation with jarosite seems to be the principal attenuation processes. Direct geochemical modeling was able to reproduce downstream pH trends, thus confirming the precipitation of jarosite as the principal pH-controlling process.     

Phthalates removal efficiency in different wastewater treatment technology in the Eastern Cape,South Africa

The removal capacity of different wastewater treatment plant (WWTP) technologies adopted in rural areas for phthalate was investigated in the Eastern Cape, South Africa. Wastewater samples collected from three selected WWTPs which use activated sludge (AS), trickling filter (TF), and oxidation pond (OP) technology were extracted using the solid-phase extraction method followed by gas chromatography-mass spectrometry (GC-MS) analysis. The six selected phthalate esters (PAEs) dimethyl phthalate (DMP), diethyl phthalate (DEP), di-n-butyl phthalate (DBP), benzyl butyl phthalate (BBP), di(2-ethyl hexyl) phthalate (DEHP), and di-n-octyl phthalate (DOP) were detected in all the samples collected from the WWTPs. DBP was the most abundant compound in the influent, effluent, and sludge samples with a maximum detection of 2497 μgL^?1, 24.2 μgL^?1, and 1249 μg/g dW, respectively, followed by DEHP and BBP. There was a relatively high removal capacity achieved by AS in Alice, TF in Berlin, and OP in Bedford with a removal efficiency that varied between 77 and 99%, 76 and 98%, and 61 and 98%, respectively. A high significant correlation of PAE removal with total suspended solids (TSS) and turbidity suggests that the removal performance proceeded more through adsorption on settling particles and sludge than on biodegradation. However, the concentrations of PAEs detected in the final effluent and sludge samples exceeded acceptable levels allowed internationally for a safe aquatic environment. AS may have exhibited a more stable and better performance across the different seasons; however, pollution source control still deserves a special attention to prevent the risk posed by these micropollutants.     

Developing strategies for managing construction and demolition wastes in Malaysia based on the concept of circular economy

Construction and demolition (C&D) waste is a pressing issue not only in Malaysia, but it is also a worldwide concern including the developed countries as well. C&D waste should be managed throughout the construction cycle. The concept of circular economy (CE) is an emerging notion that has the potential to be utilized as waste minimization approach. This paper aims to assess the potentials of incorporating the CE concept as an approach to minimizing C&D wastes, by developing a CE-based theoretical framework for C&D waste management in Malaysia. In line with this objective, a systematic review has been conducted to determine how CE can be operationalised as a strategy to minimize wastes, while considering it as a key factor for mitigating the environmental impacts. Based on the literature review, a CE-based theoretical framework has been proposed using Malaysia as a case study. The framework has been developed following a three-layer approach namely micro-, meso-, and macro-levels. Waste minimization strategies have been identified for each level taking into account the main stages in the construction industry, i.e., planning, designing, procurement, construction, and demolition. The different stakeholders involved at each stage and their interactions in the stages have also been identified.     

Green examination: integration of technology for sustainability

The recent development of infrastructure all around the world has resulted in an increasing trend of online examination in universities. The paper is an approach in theory and practical aimed at analyzing the feasibility of sustainable examination in four universities and its environmental impact reducing the paper use terming it as green examination. The paper studied the integration of sustainability through the use of computers and technology in the examination of the universities viz. King Khalid University (KKU), Saudi Arabia, Integral University (IU), India, Aligarh Muslim University (AMU), India, and The Hague University (HU), The Netherlands. The study has analyzed the trend of paper requirement, paper utilized and paper wasted in all the four universities. The environmental impact resulting from reduced paper use has been also analyzed. The feasibility of e-examination, its implementation and the implications has been undertaken in the study. The study concludes that the e-examination can almost make the examinations paperless and feasible in the four universities.     

Induction of enhanced methane oxidation in compost: temperature and moisture response

Landfilling is one of the most common ways of municipal solid waste disposal. Degradation of organic waste produces CH(4) and other landfill gases that significantly contribute to global warming. However, before entering the atmosphere, part of the produced CH(4) can be oxidised while passing through the landfill cover. In the present study, the oxidation rate of CH(4) was studied with various types of compost as possible landfill cover. The influence of incubation time, moisture content and temperature on the CH(4) oxidation capacity of different types of compost was examined. It was observed that the influence of moisture content and temperature on methane oxidation is time-dependent. Maximum oxidation rates were observed at moisture contents ranging from 45% to 110% (dry weight basis), while the optimum temperature ranged from 15 to 30 degrees C.     

Marine Birds as Indicators of Arctic Marine Ecosystem Health: Linking the Northern Ecosystem Initiative to Long-Term Studies

Marine birds are sensitive indicators of the condition of marine ecosystems in the Arctic, partly because they feed at the top of the arctic food chain. The Northern Ecosystem Initiative (NEI) recently supported four separate studies that investigated aspects of Arctic marine bird science which simultaneously addressed goals of the NEI to better understand northern ecosystems and their response to environmental stressors. The projects used both scientific and traditional knowledge to examine the relationship between sea-ice, contaminants, and the ecology of marine birds, and to transfer environmental knowledge to students. Results from these investigations confirm that changes are occurring in Arctic environments, and that these are captured through marine bird research. Collectively these studies provided new data that supported NEI objectives of monitoring the health of the Arctic ecosystem, and contributed to Canada's international obligations for Arctic science.     

A More Cost-Effective Emap Benthic Macrofaunal Sampling Protocol

Benthic macrofaunal sampling protocols in the U.S. Environmental Protection Agency's Environmental Monitoring and Assessment Program (EMAP) are to collect 30 to 50 random benthic macrofauna [defined as animals retained on a 0.5 mm (East and Gulf Coasts, USA) or a 1.0 mm mesh sieve (West Coast, USA)] samples per reporting unit using a 0.044 m² (East and Gulf Coasts) or 0.1 m² (West Coast) grab. Benthic macrofaunal community conditions in the reporting unit are characterized by cumulative distribution functions (CDFs) on end points of interest, such as number of species (S), abundance (A), and Shannon--Wiener diversity (H′). An EMAP and a companion field study were conducted concurrently in Tillamook Bay (Oregon, USA) to compare the cost effectiveness of benthic macrofauna samples collected using the EMAP West Coast (0.1 m² × ≥7 cm deep, 1.0 mm mesh), a 0.01 m² × 5 cm deep, 1.0 mm mesh, and a 0.01 m² × 5 cm deep, 0.5 mm mesh sampling protocol. Cost was estimated in relative laboratory sample-processing time. Sampling protocols were judged equally effective for EMAP purposes if, after linear transformation to adjust for scale changes in end point distributions, their S, A, and H′ CDFs were not significantly different. The 0.01 m² × 5 cm deep, 1.0 mm mesh sampling protocol was the most cost effective.     

Characterization of land-based sources of pollution in Jobos Bay,Puerto Rico: status of heavy metal concentration in bed sediment

As part of an assessment of land-based sources of pollution in Jobos Bay, Puerto Rico, sediment samples were collected at 43 sites to characterize concentrations of a suite of pollutants, including metals. Fifteen major and trace metals (Ag, Al, As, Cd, Cr, Cu, Fe, Hg, Mn Ni, Pb, Sb, Se, Sn, and Zn) were measured along with total organic carbon and grain size in surficial sediments. For most metals, maximum concentrations were seen in the eastern bay; however, values were still within concentration ranges found in other estuarine systems. In contrast, silver was higher in the western region. In general, metal distribution in the bay was positively correlated with grain size. Additionally, correlations between Al and other metals suggest natural sources for metals. The data presented here suggest that, although the Jobos Bay watershed contains both urban centers along with industrial and agricultural developments, anthropogenic inputs of metals may be negligible.     

Evolution of building façade road traffic noise levels in Flanders

The evolution of daytime fa?ade noise levels by road traffic at 250 dwellings in Flanders is assessed. Three identical man-operated measurement campaigns have been conducted in the years 1996, 2001 and 2009, during fall. A practical methodology has been developed, based on short time noise measurements and context observations at these locations. The uncertainty introduced by short-term sampling has been quantified as a function of the noise level. Furthermore, a correction is proposed for measuring at a random moment during daytime. Analysis of the data showed that road traffic noise levels hardly changed globally over this period of 13 years. The distribution of changes in noise level at corresponding measurement locations is nevertheless rather wide-all improvements are equally compensated by increases in noise levels at other locations. The percentage of the dwelling fa?ades exposed to daytime noise levels above 65 dBA has increased slightly between 1996 and 2001, but seems to stagnate in 2009. In spite of the increased interest and actions of policy makers during the past decades, noise exposure caused by road traffic at dwelling fa?ades is a persistent problem.