Characteristics and chemical speciation of waste copper slag

Environmental Science and Pollution Research - Waste copper slag contains abundant valuable metal element Fe, and residual elements such as Cu, As, Pb, Zn, and Mo. Simply stockpiling or landfilling...     

Analysis of China’s carbon emission driving factors based on the perspective of eight major economic regions

Environmental Science and Pollution Research - Low-carbon transition has gradually become the focus of research on environmental issues. This paper takes China’s eight major economic regions...     

Light absorption enhancement of particulate matters and their source apportionment over the Asian continental outflow site and South Yellow Sea

Environmental Science and Pollution Research - Light absorption enhancement of black carbon due to the aerosol mixing states is an important parameterization for climate modeling, while emission...     

Sol-gel-derived transparent metal oxide flexible field effect transistors

Environmental Science and Pollution Research - ZnO and ZnO:Al thin films have been successfully synthesized by simple solution processable method at low temperature. Highly crystalline (002)...     

Applicability of LIVE/DEAD BacLight stain with glutaraldehyde fixation for the measurement of bacterial abundance and viability in rainwater

Rainwater contains substantial bacteria and rain is an efficient pathway for the dissemination of bacteria from the atmosphere to land and water surfaces.However,quantitative information on rainwater bacteria is very limited due to the lack of a reliable method.In this study,the epifluorescence microscopy enumeration with the LIVE/DEAD BacLight Bacterial Viability Kit stain was verified to quantify the abundance of viable and non-viable bacterial cells in rainwater,with the 4',6-diamidino-2-phenylindole(DAPI) stain for the reference of total cell counts.Results showed that the total counts of bacterial cells by LIVE/DEAD BacLight staining were consistent with those by DAPI staining,and the average detection efficiency was(109 ± 29)%.The ratio of cell count with glutaraldehyde fixation to that without fixation was(106 ± 5)%on average.The bacterial concentration in negative control was usually an order of magnitude lower than that in rainwater samples.However,in case of small precipitation,the abundance in negative control could be more than that in rainwater samples.These results indicate that the enumeration with LIVE/DEAD BacLight bacterial viability assay coupled with glutaraldehyde fixation and careful negative control investigation is an approach applicable to the measurement of the concentration and viability of bacterial cells in rainwater.     

Metal distribution characteristic of MSWI bottom ash in view of metal recovery

Bottom ash is the major by-product of municipal solid waste incineration(MSWI), and is often reused as an engineering material, such as road-base aggregate. However, some metals(especially aluminum) in bottom ash can react with water and generate gas that could cause expansion and failure of products containing the ash; these metals must be removed before the ash is utilized. The size distribution and the chemical speciation of metals in the bottom ash from two Chinese MSWI plants were examined in this study, and the recovery potential of metals from the ash was evaluated. The metal concentrations in these bottom ashes were lower than that generated in other developed countries. Specifically, the contents of Al,Fe, Cu and Zn were 18.9–29.2, 25.5–32.3, 0.7–1.0 and 1.6–2.5 g/kg, respectively. Moreover,44.9–57.0 wt.% of Al and 55.6–75.4 wt.% of Fe were distributed in bottom ash particles smaller than 5 mm. Similarly, 46.6–79.7 wt.% of Cu and 42.9–74.2 wt.% of Zn were concentrated in particles smaller than 3 mm. The Fe in the bottom ash mainly existed as hematite, and its chemical speciation was considered to limit the recovery efficiency of magnetic separation.     

Shifts in microbial community structure and diversity in a MBR combined with worm reactors treating synthetic wastewater

The chemical oxygen demand (COD) and NH₃-N removal, membrane fouling, sludge characteristics and microbial community structure in a membrane bioreactor (MBR) coupled with worm reactors (SSBWR) were evaluated for 210 days. The obtained results were compared to those from a conventional MBR (C-MBR) operated in parallel. The results indicated that the combined MBR (S-MBR) achieved higher COD and NH₃-N removal efficiency, slower increase in membrane fouling, better sludge settleability and higher activities of the related enzymes in the activated sludge. Denaturing gradient gel electrophoresis was used to analyze the microbial community structures in the C-MBR and the S-MBR. The microbial community structure in the S-MBR was more diverse than that in the C-MBR. Additionally, the slow-growing microbes such as Saprospiraceae, Actinomyces, Frankia, Clostridium, Comamonas, Pseudomonas, Dechloromonas and Flavobacterium were enriched in the S-MBR, further accounting for the sludge reduction, membrane fouling alleviation and wastewater treatment.     

Simultaneous removal of Cu(II) and Cr(VI) by Mg–Al–Cl layered double hydroxide and mechanism insight

Mg–Al–Cl layered double hydroxide (Cl-LDH) was prepared to simultaneously remove Cu(II) and Cr(VI) from aqueous solution. The coexisting Cu(II) (20 mg/L) and Cr(VI) (40 mg/L) were completely removed within 30 min by Cl-LDH in a dosage of 2.0 g/L; the removal rate of Cu(II) was accelerated in the presence of Cr(VI). Moreover, compared with the adsorption of single Cu(II) or Cr(VI), the adsorption capacities of Cl-LDH for Cu(II) and Cr(VI) can be improved by 81.05% and 49.56%, respectively, in the case of coexisting Cu(II) (200 mg/L) and Cr(VI) (400 mg/L). The affecting factors (such as solution initial pH, adsorbent dosage, and contact time) have been systematically investigated. Besides, the changes of pH values and the concentrations of Mg²⁺ and Al³⁺ in relevant solutions were monitored. To get the underlying mechanism, the Cl-LDH samples before and after adsorption were thoroughly characterized by X-ray powder diffraction, transmission electron microscopy, Fourier transform infrared spectroscopy, and X-ray photoelectron spectroscopy. On the basis of these analyses, a possible mechanism was proposed. The coadsorption process involves anion exchange of Cr(VI) with Cl⁻ in Cl-LDH interlayer, isomorphic substitution of Mg²⁺ with Cu²⁺, formation of Cu₂Cl(OH)₃ precipitation, and the adsorption of Cr(VI) by Cu₂Cl(OH)₃. This work provides a new insight into simultaneous removal of heavy metal cations and anions from wastewater by Cl-LDH.     

Assessment of the maximum allowed acid deposition load at current stage in China

Soil acidification caused by acid deposition has been significant in some forests in southern China. We present an approach for assessing the current stage maximum allowed load (SML) of acid deposition for terrestrial system in the country. The main idea was that soil base cation exchange as a finite buffer to acidity was included in the soil acidity mass balance calculation at current acidification stage. We calculated the SML for five forests in southern China. The usual critical loads for the same forests were also calculated by the steady state mass balance model for comparison. The results showed that the SML is a more tolerant limit than the critical load for the forests with soils not acidified seriously at current stage. However, the SML become a more stringent limit to acid deposition when the forest soils have acidified seriously to very low base cation saturation. In this case the SML assessment is beneficial for the soils recovering from a serious acidified state. Based on a national scale database, the SML mapping for non-agricultural soil system in China was carried out.     

Control of aliphatic halogenated DBP precursors with multiple drinking water treatment processes: Formation potential and integrated toxicity

The comprehensive control efficiency for the formation potentials(FPs) of a range of regulated and unregulated halogenated disinfection by-products(DBPs)(including carbonaceous DBPs(C-DBPs), nitrogenous DBPs(N-DBPs), and iodinated DBPs(I-DBPs)) with the multiple drinking water treatment processes, including pre-ozonation, conventional treatment(coagulation–sedimentation, pre-sand filtration), ozone-biological activated carbon(O_3-BAC) advanced treatment, and post-sand filtration, was investigated. The potential toxic risks of DBPs by combing their FPs and toxicity values were also evaluated.The results showed that the multiple drinking water treatment processes had superior performance in removing organic/inorganic precursors and reducing the formation of a range of halogenated DBPs. Therein, ozonation significantly removed bromide and iodide,and thus reduced the formation of brominated and iodinated DBPs. The removal of organic carbon and nitrogen precursors by the conventional treatment processes was substantially improved by O_3-BAC advanced treatment, and thus prevented the formation of chlorinated C-DBPs and N-DBPs. However, BAC filtration leads to the increased formation of brominated C-DBPs and N-DBPs due to the increase of bromide/DOC and bromide/DON.After the whole multiple treatment processes, the rank order for integrated toxic risk values caused by these halogenated DBPs was haloacetonitriles(HANs)》haloacetamides(HAMs) haloacetic acids(HAAs) trihalomethanes(THMs) halonitromethanes(HNMs) 》I-DBPs(I-HAMs and I-THMs). I-DBPs failed to cause high integrated toxic risk because of their very low FPs. The significant higher integrated toxic risk value caused by HANs than other halogenated DBPs cannot be ignored.