Chlortetracycline and tylosin runoff from soils treated with antimicrobial containing manure

This study assessed the runoff potential of tylosin and chlortetracycline (CTC) from soils treated with manure from swine fed rations containing the highest labeled rate of each chemical. Slurry manures from the swine contained either CTC at 108 μ g/g or tylosin at 0.3 μ g/g. These manures were surface applied to clay loam, silty clay loam, and silt loam soils at a rate of 0.22 Mg/ha. In one trial, tylosin was applied directly to the soil surface to examine runoff potential of water and chemical when manure was not present. Water was applied using a sprinkler infiltrometer 24-hr after manure application with runoff collected incrementally every 5 min for about 45 min. A biofilm crust formed on all manure-treated surfaces and infiltration was impeded with > 70% of the applied water collected as runoff. The total amount of CTC collected ranged from 0.9 to 3.5% of the amount applied whereas tylosin ranged from 8.4 to 12%. These data indicate that if surface-applied manure contains antimicrobials, runoff could lead to offsite contamination.     

Application of a permethrin immunosorbent assay method to residential soil and dust samples

A low-cost, high throughput bioanalytical screening method was developed for monitoring cis/trans-permethrin in dust and soil samples. The method consisted of a simple sample preparation procedure [sonication with dichloromethane followed by a solvent exchange into methanol:water (1:1)] with bioanalytical detection using a magnetic particle enzyme-linked immunosorbent assay (ELISA). Quantitative recoveries (83–126 %) of cis/trans-permethrin were obtained for spiked soil and dust samples. The percent difference of duplicate ELISA analyses was within ± 20 % for standards and ± 35 % for samples. Similar sample preparation procedures were used for the conventional gas chromatography/mass spectrometry (GC/MS) analysis except that additional cleanup steps were required. Recoveries of cis/trans-permethrin ranged from 81 to 108 % for spiked soil and dust samples by GC/MS. The ELISA-derived permethrin concentrations were highly correlated with the GC/MS-derived sum of cis/trans-permethrin concentrations with a correlation coefficient (r) of 0.986. The ELISA method provided a rapid qualitative screen for cis/trans-permethrin in soil and dust while providing a higher sample throughput with a lower cost as compared to the GC/MS method. The ELISA can be applied as a complementary, low-cost screening tool to prioritize and rank samples prior to instrumental analysis for exposure studies.     

Sorption of 3,4-dichloroaniline on four contrasting Greek agricultural soils and the effect of liming

Sorption of 3,4-dichloroaniline (3,4-DCA) on four typical Greek agricultural soils, with distinct texture, organic matter content and cation exchange capacities, was compared by using sorption isotherms and the parameters calculated from the fitted Freundlich equations. The sorption process of 3,4-DCA to the soil was completed within 48–72 h. The 3,4-DCA sorption on all soils was well described by the Freundlich equation and all sorption isotherms were of the L-type. The sandy clay loam soil with the highest organic matter content and a slightly acidic pH was the most sorptive, whereas the two other soil types, a high organic matter and neutral pH clay and a low organic matter and acidic loam, had an intermediate sorption capacity. A typical calcareous soil with low organic matter had the lowest sorption capacity which was only slightly higher than that of river sand. The 3,4-DCA sorption correlated best to soil organic matter content and not to clay content or cation exchange capacity, indicating the primary role of organic matter. The distribution coefficient (K _d) decreased with increasing initial 3,4-DCA concentration and the reduction was most pronounced with the highly sorptive sandy clay loam soil, suggesting that the available sorption sites of the soils are not unlimited. Liming of the two acidic soils (the sandy clay loam and the loam) raised their pH (from 6.2 and 5.3, respectively) to 7.8 and reduced their sorption capacity by about 50 %, indicating that soil pH may be the second in importance factor (after organic matter) determining 3,4-DCA sorption.     

Improved xenobiotic-degrading activity of Rhodococcus opacus strain 1cp after dormancy

The goals of the present work were as follows: to obtain the dormant forms of R. opacus 1cp; to study the phenotypic variability during their germination; to compare phenotypic variants during the growth on selective and elective media; and to reveal changes in the ability of the strain to destruct xenobiotics that had not been degradable before dormancy. It was shown that Rhodococcus opacus 1cp (the strain degrading chlorinated phenols) became able to utilize a broader spectrum of xenobiotics after storage in the dormant state. Germination of the dormant forms of R. opacus 1cp on an agarized medium was followed by emergence and development of phenotypic variants that could grow on 4-chlorophenol and 2,4,6-trichlorophenol without adaptation. The cells of R. opacus 1cp phenotypic variants also utilized all of the tested chlorinated phenols: 2,3-, 2,5-, and 2,6-dichloro-, 2,3,4- and 2,4,5-trichloro-, pentachlorophenol, and 1,2,4,5-tetrachlorobenzene in concentrations up to 60 mg/L, though at the lower rates than 4-CP and 2,4,6-TCP. The improved degradation of chlorinated phenols by R. opacus strain 1cp exposed to the growth arrest conditions demonstrates the significance of dormancy for further manifestation of the adaptive potential of populations. A new principle of selection of variants with improved biodegradative properties was proposed. It embraces introduction of the dormancy stage into the cell life cycle with subsequent direct inoculation of morphologically different colonies into the media with different toxicants, including those previously not degraded by the strain.     

The electron density distribution in pyridinium and bipyridylium compounds and its relevance to their adsorption by expanding lattice clays

Abstract

Charge distributions in 1, 1'‐ethylene‐2, 2'‐bipyridylium (diquat), 1,1'‐dimethyl‐4,4'‐bipyridylium (paraquat) and 1‐methylpyridinium organocations were calculated by a Complete Neglect of Differential Overlap semi‐empirical quantum mechanical procedure. The data show that the positive charges in the organocations are distributed around the molecules and are greatest in the positions ortho and para to the heterocyclic nitrogen atoms. Earlier interpretations of the mechanisms of adsorption of paraquat and diquat by soils and clays assumed that the charges were located in the heterocyclic nitrogen atoms. Here some consideration is given to the influence of the charge delocalizations on the processes of adsorption by montmorillonite and vermiculite clay preparations.     

Effect of some xenobiotics on kynurenine hydrolase and kynurenine aminotransferase of mouse liver

Abstract

The effects of some xenobiotics on the activity of the B₆‐dependent kynurenine hydrolase (KH) and kynurenine aminotransferase (KATE) in mouse liver, were investigated. Polychlorinated biphenyl (Aroclor 1254) (400mg/kg/day ×4) markedly decreased the activity of both enzymes. Benzo(a)pyrene (BP) and 3‐methylcholanthrene (3‐MC) (40mg/Kg/day ×1) as well as phénobarbital (PB) (75mg/kg/day ×3) did not alter the activity of KH, while that of KATE was mildy reduced. The response of the two enzymes to treatment with chlorpromazine (CPZ) (5mg/Kg/day ×5) were opposite with marked elevation of KH and inhibition of KATE activities. Treatment with B‐naphthoflavone (B‐NF) (80mg/Kg/day ×2), Pyrazole (200mg/Kg/day ×1) or indole (400mg/kg/day ×1) produce no change in the activity of either enzyme. It, seems therefore, that Aroclor(1254) and chlorpromazine may cause disordered kynurenine metabolism through alterations in the activities of its metabolizing enzymes. This, in turn, might affect nicotinamide adenine dinucleotide biosynthesis and/or the accumulation of some tryptophan metabolites suspected of being carcinogenic or co‐carcinogenic.     

Hazardous Waste Minimization: Part IV Waste Reduction in the Metal Finishing Industry

The metal finishing industry uses over 40 production processes to produce a wide range of metal products. Waste streams generated include wastewater, waste oils, spent solvents, and spent process solutions. Currently a wide variety of techniques which minimize waste are available. Cost-effective methods to reduce electroplating wastewater contamination include water conservation and drag-out reduction, recovery and management. Ways to cost-effectively reduce the generation of spent metal-working fluids include establishing a fluid management program and installing a fluid recovery system. However, before any techniques are selected, a waste reduction survey should first be conducted.     

HCI Sorption by Dry NaHCO3 for Incinerator Emissions Control

The sorption of hydrochloric acid (HCI) by thermally decomposed sodium bicarbonate (NaHCO₃) was investigated using a fixed-bed reactor containing sorbent particles dispersed in a bed of spherical glass beads. The gas flow rate (68° F and 760 mm Hg) was 0.039 cfm (1.1 liter/min) and the bed had a cross-sectional area of 0.0055 sq. ft. (5.1 sq. cm). The influence of particle diameter (10, 45 and 163 μm), temperature (225, 275, 375, 455, and 550° F), superficial gas velocity (11 and 21 fpm at reactor conditions, 375° F), and Inlet HCI gas concentration (415 ppm and 760 ppm in N₂, 275 and 455° F) were studied. Results showed that HCI sorption increased strongly with increasing temperature but was only weakly dependent on particle diameter, superficial gas velocity, and HCI gas concentration.