A biomimetic absorbent for removal of trace level persistent organic pollutants from water

A novel biomimetic absorbent containing the lipid triolein was developed for removing persistent organic pollutants (POPs) from water. The structural characteristics of the absorbent were obtained by SEM and a photoluminescence method. Under optimum preparation conditions, triolein was perfectly embedded in the cellulose acetate (CA) spheres, the absorbent was stable and no triolein leaked into the water. Dieldrin, endrin, aldrin and heptachlor epoxide were effectively removed by the CA--triolein absorbent in laboratory batch experiments. This suggests that CA-triolein absorbent may serve as a good absorbent for those selected POPs. Triolein in the absorbent significantly increased the absorption capacity, and lower residual concentrations of POPs were achieved when compared to the use of cellulose acetate absorbent. The absorption rate for lipophilic pollutants was very fast and exhibited some relationship with the octanol--water partition coefficient of the analyte. The absorption mechanism is discussed in detail.     

Distribution of elements in needles of Pinus massoniana (Lamb.) was uneven and affected by needle age

Macronutrients (P, S, K, Na, Mg, Ca), heavy metals (Fe, Zn, Mn, Cu, Pb, Cr, Ni, Cd,) and Al concentrations as well as values of Ca/Al in the tip, middle and base sections, and sheaths of current year and previous year needles of Pinus massoniana from Xiqiao Mountain were analyzed and the distribution patterns of those elements were compared. The results indicated that many elements were unevenly distributed among the different components of needles. Possible deficiency of P, K, Ca, Mn and Al toxicity occurred in needles under air pollution. Heavy metals may threaten the health of Masson pine. Needle sheaths were good places to look for particulate pollutants, in this case including Fe, Cu, Zn, Pb, Cr, Cd and Al.     

Comparison of vehicle activity and emission inventory between Beijing and Shanghai

Vehicle emission inventory is a critical element for air quality study. This study created systemic methods to establish a vehicle emission inventory in Chinese cities. The methods were used to obtain credible results of vehicle activity in Beijing and Shanghai. On the basis of the vehicle activity data, the International Vehicle Emission model is used to establish vehicle emission inventories. The emissions analysis indicates that 3 t of particulate matter (PM), 199 t of nitrogen oxides (NO(x)), 192 t of volatile organic compounds (VOCs), and 2403 t of carbon monoxide (CO) are emitted from on-road vehicles each day in Beijing, whereas 4 t of PM, 189 t of NO(x), 113 t of VOCs, and 1009 t of CO are emitted in Shanghai. Although common features were found in these two cities (many new passenger cars and a high taxi proportion in the fleet), the emission results are dissimilar because of the different local policy regarding vehicles. The method to quantify vehicle emission on an urban scale can be applied to other Chinese cities. Also, knowing how different policies can lead to diverse emissions is beneficial knowledge for other city governments.     

石化企业事故应急预案中的安全防护距离探讨

对石化企业在事故应急预案中安全防护距离的确定给出了各种可以参考的计算方法及参考数据,为企业在事故应急中合理确定安全防护距离提供了决策参考。     

Effect of manganese ion on the mineralization of 2,4-dichlorophenol by ozone

Mineralization of 2,4-dichlorophenol (DCP) was studied by ozone with Mn(2+) as an ozonation catalyst. Laboratory scale semi-batch ozonation experiments were conducted at room temperature. The results showed that trace amount of Mn(2+) accelerated the mineralization of DCP. Total organic carbon removal rate was independent on Mn(2+) dosage at its range of 0.1-0.5 mgL(-1). Dissolved ozone concentration in the solution remained low level in the catalytic ozonation process, which indicated that Mn(2+) catalyzed decomposition of ozone. DCP mineralization was inhibited in catalytic ozonation by the addition of carbonate. Electron spin resonance/spin-trapping technique was used to determine hydroxyl radicals, and the results showed that larger amounts of hydroxyl radicals were produced in catalytic ozonation system than those of single ozonation. Intermediates mainly including aliphatic carboxylic acids were determined qualitatively and semi-quantitatively by GC-MS. And, a general pathway for mineralization of DCP was proposed.     

Radiation-induced degradation of methyl orange in aqueous solutions

Degradation of methyl orange under gamma-irradiation was investigated. The reactions followed pseudo first-order kinetics. Apparent degradation rate constant, estimated through linear regression analysis, increased with an increase of dose rate and a decrease of initial methyl orange concentration. Degradation of methyl orange was significantly accelerated under oxidative condition, but was slightly enhanced under reductive condition. However, the result of decoloration was better under reductive condition than oxidative one. An analysis on the intermediates using Fourier transform infrared and gas chromatography/mass spectrometry demonstrates that the radiolytic degradation of methyl orange was processed with different C-N cleavages under oxidative and reductive conditions.     

Mechanical Property Characterization of Plasticized Sugar Beet Pulp and Poly(Lactic Acid) Green Composites Using Acoustic Emission and Confocal Microscopy

Sorbitol and glycerol were used to plasticize sugar beet pulp-poly(lactic acid) green composites. The plasticizer was incorporated into sugar beet pulp (SBP) at 0%, 10%, 20%, 30% and 40% w/w at low temperature and shear and then compounded with poly(lactic acid) (PLA) using twin-screw extrusion and injection molding. The SBP:PLA ratio was maintained at 30:70. As expected, tensile strength decreased by 25% and the elongation increased. Acoustic emission (AE) showed correlated debonding and fracture mechanisms for up to 20% w/w plasticizer and uncorrelated debonding and fracture for 30–40% sorbitol and 30% glycerol content in SBP–PLA composites. All samples had a well dispersed SBP phase with some aggregation in the PLA matrix. However, at 40% glycerol plasticized SBP–PLA composites exhibited unique AE behavior and confocal microscopy revealed the plasticized SBP and PLA formed a co-continuous two phase system.

Global fallout Pu recorded in lacustrine sediments in Lake Hongfeng, SW China

Studies on the distribution and isotope compositions of fallout Pu are important for source characterization of possible future non-fallout Pu contamination in aquatic environments, and useful for dating of recent sediments to understand the pollution history of environmental contaminants. We present the historical record of atmospheric Pu fallout reconstructed from a sediment core from Lake Hongfeng, China. The Pu activity profile was in agreement with the 137Cs profile. Inventories were 50.7 Bq m(-2) for 239+240Pu and 1586 Bq m(-2) for 137Cs. The average 240Pu/239Pu atom ratio was 0.185+/-0.009, indicating that Pu originated from global stratospheric fallout rather than from direct tropospheric or close-in fallout from the Chinese nuclear testing conducted in the 1970s. Our data suggested that Lake Hongfeng would be an ideal setting for monitoring atmospheric fallout and environmental changes in this region.