Influence of coal particles on methane/air mixture ignition in a heated environment

The temperature at which coal dust glows is normally much lower than the auto-ignition temperature (AIT) of methane/air mixtures, and thus a better understanding is needed regarding methane/air ignition in a heated environment in the presence of coal particles. A horizontal tube apparatus was used to test the effect of brown coal and two kinds of bituminous and anthracite on methane/air combustibility. For the four coal samples tested, the presence of coal particles significantly reduced the minimum temperature for ignition of methane/air mixtures in a heated environment. No. 1 bituminous coal with 12 mm diameter decreased the ignition temperature value from 595 to 500 °C. It is thought that pre-ignition of low-AIT volatiles emitted from the heated coal particles ignited the methane/air mixtures. Volatiles, sulfur content, and large porosity of piled coal particles all enhanced ignition of methane/air mixtures in a hot environment, while water content and small particle size reduced ignition. For anthracite, no ignition occurred when temperatures of the heated environment were lower than the AIT of methane (595 °C), except for the 12-mm-diameter sample. Anthracite did not readily ignite methane/air mixtures and the ignition mechanism was somewhat similar to that of a burning cigarette.     

2002年我国事故与灾害状况综述

本对我国2002年的安全生产事故及自然灾害情况进行了总结和评述。包括火灾(城乡火灾、森林火灾、草原火灾)、天气气候特征、农业自然灾害(干旱、洪涝、风雹、低温冻害)、海洋灾害(风暴潮、赤潮、海浪)、地质灾害(地震、泥石流、水土流失)等。     

氯甲烷与偶氮染料混合废水的超声脱色

使用40 kHz超声（US）脱色氯甲烷（包括CCl4、CHCl3和CH2Cl2）与偶氮染料（包括甲基橙与铬黑T）混合模拟废水,考察了氯甲烷初始浓度对偶氮染料超声脱色和TOC去除的影响。结果表明：偶氮染料的单独超声脱色速率很慢;而在CCl4与CHCl3存在时超声能使偶氮染料短时间内脱色至无色,但对其TOC的超声去除促进作用较差;CH2Cl2对偶氮染料的超声脱色促进作用很小。使用0.392 W/cm2的超声处理24 mg/L铬黑T水溶液,当CCl4和CHCl3初始浓度分别为6.22 mmol/L和8.30 mmol/L时,20 min脱色率均达到90.86%,但相应的TOC去除率只有22.72%和17.76%。同样条件下,甲基橙处理效果比铬黑T稍优。     

Incidence of polybrominated diphenyl ethers in central air conditioner filter dust from a new office building

This study examined polybrominated diphenyl ethers (PBDEs) in central air conditioner filter (CACF) dust from a new office building in Shenzhen, China. Human exposure to PBDE via dust inhalation and ingestion were also estimated. PBDEs level in CACF dust was lower than those in the other countries and regions. Approximately 0.671 pg/kg bw/day PM_2.5 (Particulate Matter up to 2.5 μm in size) bounded Σ₁₅PBDEs can be inhaled deep into the lungs and 4.123 pg/kg bw/day PM₁₀ (Particulate Matter up to 10 μm in size) bounded Σ₁₅PBDEs tend to be deposited in the upper parts of the respiratory system. The average total intake of Σ₁₅PBDEs via dust inhalation and ingestion for adults reached ∼141 pg/kg bw/day in this building. This value was far below the reference dose (RfD) recommended by United States Environmental Protection Agency. Human exposure to PBDEs via dust inhalation and ingestion in the new building is less than the old ones.     

Removal of 2-chlorophenol from water using rice-straw derived ash

Removal of 2-chlorophenol from water using rice-straw derived ash (RSDA) was evaluated in this study to compare with commercial activated carbon. RSDA was obtained by burning rice-straw at 400 °C and 700 °C for 1 h. This ash can provide a better adsorbent for 2-chlorophenol. The adsorption capacities of RSDA at 400 °C and 700 °C are 37 and 52 mg g?1 at pH 4, respectively, and decrease to 9.0 and 40 mg g?1 at pH 10. Adsorption of either neutral or anionic 2-cholorphenol by the RSDA are shown as L-shaped nonlinear isotherms, suggesting surface adsorption rather than partitioning is occurring. At higher-burning temperatures, the surface area, porosity, point of zero charge and aromaticity of the resultant RSDA increase, but the oxygen content and surface acidity decrease. The combined effects result in a higher 2-chlorophenol adsorption of RSDA at 700 °C, which shows a slight pH effect on the adsorption of 2-chlorophenol, due to the lower content of oxygen-containing functional groups. Oxygen-containing functional groups contribute to surface acidity and H-bonding sites for adsorbed water, which compromises the interaction between 2-chlorophenol and the adsorbents. Thus, it suggests that rice-straw derived carbon (RSDC) can be used as an effective low-cost substitute material for activated carbon for removal of chlorophenols from wastewater.     

Atmospheric bulk deposition of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in the vicinity of an iron and steel making plant

An IRA-743 resin bulk sampler was validated to monitor long-term bulk deposition of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). Six consecutive sampling campaigns (2008-2009) were conducted at four sites around steel complexes in Pohang, South Korea to investigate spatial and seasonal variations of PCDD/F bulk deposition. The bulk deposition within the steel complex showed the highest ∑_4-8PCDD/F (Tetra-Octa) fluxes, ranging from 204 to 608 (mean: 352) pg m⁻² d⁻¹, indicating steel complexes were major sources of PCDD/Fs. The homologue profiles were dominated with lower chlorinated PCDFs. Furthermore, the prevailing winds were confirmed to influence the spatial distribution of PCDD/F deposition. There were apparent seasonal variations of the bulk deposition at each site, and seasonal homologue patterns of PCDD/Fs were clearly observed. According to the passive air sampling, however, no significant seasonal change of ambient air concentrations of PCDD/Fs was observed. Therefore, it was concluded that the seasonal variations of deposition fluxes of PCDD/Fs probably resulted from temperature-dependent gas/particle partitioning.     

Differences in Eye and Hand Movements of Novice and Experienced Press Operators

Presses are very widely used in industrial and commercial companies and are often the source of serious accidents occurring during operation. Most of the accidents are due to inadequate training of novice operators. Continuous recordings of eye and hand movements of five novice operators and five experienced operators in press operation were made. Significant difference between novice and experienced operators was observed in eye fixation time, eye movement patterns, hand dwell time, and eye-hand coordination. Also, differences were observed in spatial distribution of eye fixations during the die-closing portion of a stroke. There were no significant differences between novice and experienced operators in the eye and the hand movement time. The results could be used as basic data to establish a guide determining the method and training period to train novice operators.     

Preferred surface microscopic geometric features on floors as potential interventions for slip and fall accidents on liquid contaminated surfaces

PROBLEM: Surface roughness affects friction, so selection of floor surfaces with certain roughness characteristics could potentially reduce slip and fall accidents. This article summarizes the preferred surface microscopic geometric features that could increase friction on surfaces covered with liquid contaminants. METHOD: Three types of surface features, represented by the average of the maximum height above the mean line in each cut-off length (R(pm)), the arithmetical average of surface slope (Delta(a)), and the kernel roughness depth (R(k)), are identified as preferred surface microscopic geometric features for a higher friction. The proper settings on the profilometers (instruments used to measure surface roughness) for optimizing these surface parameters are specified. The friction mechanisms involved reveal why these features are more desirable. RESULTS: Although surface roughness is important in determining slipperiness, there is still insufficient information to establish a safety criterion based on roughness; however, the method presented in this paper can readily provide a relative comparison. IMPACT ON INDUSTRY: The summary presented will help safety professionals properly select new floor surfaces or assess existing floors to reduce slip and fall accidents.     

Combined toxicity of imidacloprid,acetochlor, and tebuconazole to zebrafish ( Danio rerio ): acute toxicity and hepatotoxicity assessment

Compound pollution refers to two or more kinds of pollutants with different properties, a pollutant from different sources, or the simultaneous existence of two or more different types of pollutants in the same environment. In this study, we aimed to investigate the individual and combined toxicity of the insecticide imidacloprid (IMI), the herbicide acetochlor (ACT), and the fungicide tebuconazole (TBZ) to zebrafish. The acute toxicity test results showed that the 96-h LC50 values of IMI, ACT, and TBZ were 276.84 (259.62–294.35) mg active ingredient (a.i.) L−1, 1.52 (1.34–1.74) mg a.i. L−1, and 8.16 (7.7–8.6) mg a.i. L−1, respectively. The combinations of IMI, ACT, and TBZ with toxicity ratios of 1:2:2, 1:4:4, 2:4:1, and 4:1:4 displayed synergistic toxic effects on zebrafish, while the toxicity ratios of 1:1:1, 1:1:2, 2:1:2, 2:2:1, and 4:2:1 of IMI, ACT, and TBZ, respectively, exhibited antagonistic toxic effects on zebrafish. The following experiments were performed with a toxicity ratio of 1:4:4 (IMI:ACT:TBZ). The activities of four enzyme biomarkers related to oxidative stress in the liver, catalase (CAT), superoxide dismutase (SOD), glutathione S-transferase (GST), and malondialdehyde (MDA) content were evaluated in each exposure group on days 7, 14, 21, and 28. Compared with those of the control group, the activities of CAT, SOD, and GST and the MDA content were significantly altered at different time points in the individual and combined exposure groups. Additionally, the activities of CAT, SOD, and GST and the MDA content were significantly altered in the combined group compared with those of the individual group after 14 days or 21 days of exposure. Therefore, it was confirmed that combined toxicity studies are indispensable in risk assessment.     

Immobilization of fungal laccase onto a nonionic surfactant-modified clay material: application to PAH degradation

Nonionic surfactant-modified clay is a useful absorbent material that effectively removes hydrophobic organic compounds from soil/groundwater. We developed a novel material by applying an immobilized fungal laccase onto nonionic surfactant-modified clay. Low-water-solubility polycyclic aromatic hydrocarbons (PAHs) (naphthalene/phenanthrene) were degraded in the presence of this bioactive material. PAH degradation by free laccase was higher than degradation by immobilized laccase when the surfactant concentration was allowed to form micelles. PAH degradation by immobilized laccase on TX-100-modified clay was higher than on Brij35-modified clay. Strong laccase degradation of PAH can be maintained by adding surfactant monomers or micelles. The physical adsorption of nonionic surfactants onto clay plays an important role in PAH degradation by laccase, which can be explained by the structure and molecular interactions of the surfactant with the clay and enzyme. A system where laccase is immobilized onto TX-100-monomer-modified clay is a good candidate bioactive material for in situ PAHs bioremediation.