Testing and Commercialization of Byproduct Dibasic cids as Buffer Additives for Limestone Flue Gas esulfurization Systems

Pilot plant (0.1 MW) tests and utility boiler full scale demonstration (194 MW) of byproduct organic dibasic acids (DBA) as buffer additives to limestone scrubbers have shown performance improvements equivalent to those achieved by the addition of pure adipic acid. Both SO₂ removal efficiency and limestone utilization increased, and no significant operating problems were observed with three of the four DBA tested. Chemical and biological evaluations of scrubber samples taken during the DBA testing indicated no detectable tOxicity or mutagenicity, and no significant environmental impact is expected as a result of DBA addition. Economic estimates indicate that substitution of DBA for pure adipic acid as a buffer additive will result in additive cost savings of 30 % or greater.     

Trends and Relationships of O3, NOx and HC in the South Coast Air Basin of California

A basin-wide air quality trend analysis for the South Coast Air Basin of California is conducted for hydrocarbons (HC), NO_x, O₃ and CO using multi-station composite daily maximum-hour average ambient concentrations for the third quarter (July, August and September) from 1968 to 1985. Emissions and air quality trends are compared for the period 1968-1984. Ambient HC and NOX trends are somewhat different from estimated emission trends of HC and NO_x, while a definite, downward trend of ambient CO is consistent with vehicular emission control measures. Basin-wide ambient HC, NO_x and O₃ appear to show downward trends for the period 1970-1985, but because of high fluctuations it is difficult to delineate trends for shorter periods. The meteorology (850 mb temperature)-adjusted O₃ shows a more consistent downward trend than does unadjusted O₃. Polynomial and multiplicative regression models for basin-wide empirical O₃-HC-NO_x relationships Indicate that the O₃ variation is explained largely by the meteorological variable (850 mb temperature) although model estimations are improved by adding HC and NO_x concentration terms.     

A temporal trend study (1972-2008) of perfluorooctanesulfonate, perfluorohexanesulfonate, and perfluorooctanoate in pooled human milk samples from Stockholm, Sweden

The widespread presence of perfluorooctanesulfonate (PFOS), perfluorooctanoate (PFOA), and perfluorohexanesulfonate (PFHxS) in human general populations and their slow elimination profiles have led to renewed interest in understanding the potential human neonatal exposures of perfluoroalkyls (PFAs) from consumption of human milk. The objective of this study was to evaluate the concentrations of PFOS, PFHxS, and PFOA in pooled human milk samples obtained in Sweden between 1972 and 2008 (a period representing the most significant period of PFA production) and to see whether the time trend of these analytes parallels that indicated in human serum. Chemical analysis of PFOS, PFHxS, and PFOA was performed on pooled Swedish human milk samples from 1972 to 2008 after methodological refinements. The 20 samples which formed the 2007 pool were also analyzed individually to evaluate sample variations. Analyses were performed by HPLC-MS/MS. Due to the complexities of the human milk matrix and the requirement to accurately quantitate low pg/mL concentrations, meticulous attention must be paid to background contamination if accurate results are to be obtained. PFOS was the predominant analyte present in the pools and all three analytes showed statistically significant increasing trends from 1972 to 2000, with concentrations reaching a plateau in the 1990s. PFOA and PFOS showed statistically significant decreasing trends during 2001-2008. At the end of the study, in 2008, the measured concentrations of PFOS, PFHxS, and PFOA in pooled human milk were 75 pg/mL, 14 pg/mL, and 74 pg/mL, respectively. The temporal concentration trends of PFOS, PFHxS, and PFOA observed in human milk are parallel to those reported in the general population serum concentrations.     

Electrocatalytic oxidation of PCP-Na by a novel nano-PbO2 anode: degradation mechanism and toxicity assessment

Environmental Science and Pollution Research - This study aims at investigating the electrocatalytic oxidation of sodium pentachlorophenate (PCP-Na) using a novel nano-PbO2 powder anode. The...     

动火作业中的安全现状分析

结合新疆八一钢铁集团实际,对动火作业现状进行分析,提出不足;并结合法规、标准要求以及工作实践,从管理、技术、培训等方面提出动火安全的几点对策.     

南亚国际河流及其水资源开发

本文全面介绍了南亚地区的主要国际河流,印度河、恒河和布拉马普特拉河水资源开发的地理和历史背景。详细评述了印度河用水争端的来龙去脉和印度河条约的谈判和签署过程,以及印度与巴基斯坦和孟加拉在分享印度河和恒河水资源问题上的立场,笔者还分析了南亚国际河流水资源开发的现状,提出了流域综合开发,以合理利用水资源的建议。 文章中,笔者简要介绍了国际法律界经常采用的水资源分享的理论和学说。     

生物炭和碳纳米管固定化漆酶去除水体雌二醇

漆酶是一类具有高效的催化氧化能力的含铜多酚的氧化酶,而固定化漆酶技术在有机废水处理领域受到了越来越多的关注。通过比较吸附法和包埋法利用木炭(WB)、竹炭(BB)和碳纳米管(CNT)固定游离漆酶去除水体雌二醇(E2)。在25 °C 、pH=5条件下,固定化漆酶经120 h 贮存仍保留80%的活性。经过5次循环研究,固载的漆酶仍保留了27%~58%的剩余活性。结合扫描电子显微镜和傅里叶变换红外光谱,证实了漆酶成功地负载在碳基材料上。仅在 8 h内,50 mg·L⁻¹ E2通过吸附法制备的WB、BB、CNT固定化漆酶去除了42.92%、47.66%、43.92%,而包埋法制备的WB、BB、CNT固定化漆酶分别去除84.08%、87.20%、87.86%。结果表明,包埋法固定化漆酶对E2的去除效率更优,这是由于包埋固载在生物炭和CNT的漆酶更为稳定。此外,K⁺和Mn²⁺离子可能通过干扰漆酶的电子传递过程影响漆酶的活性,从而抑制E2的去除。本研究旨在为固定化漆酶在有机废水处理的实际应用提供指导。     

Atmospheric polycyclic aromatic hydrocarbons (PAHs) in Asia: a review from 1999 to 2004

Polycyclic aromatic hydrocarbons (PAHs) are present in both gaseous and particulate phases. These compounds are considered to be atmospheric contaminants and are human carcinogens. Many studies have monitored atmospheric particulate and gaseous phases of PAH in Asia over the past 5 years. This work compares and discusses different sample collection, pretreatment and analytical methods. The main PAH sources are traffic exhausts (AcPy, FL, Flu, PA, Pyr, CHR, BeP) and industrial emissions (BaP, BaA, PER, BeP, COR, CYC). PAH concentrations are highest in areas of traffic, followed by the urban sites, and lowest in rural sites. Meteorological conditions, such as temperature, wind speed and humidity, strongly affect PAH concentrations at all sampling sites. This work elucidates the characteristics, sources and distribution, and the healthy impacts of atmospheric PAH species in Asia.     

Partitioning and removal of dioxin-like congeners in flue gases treated with activated carbon adsorption

Activated carbon adsorption is commonly used to control dioxin-like congener (PCDD/Fs and PCBs) emissions. Partitioning of PCDD/Fs and PCBs between vapor and solid phases and their removal efficiencies achieved with existing air pollution control devices (APCDs) at a large-scale municipal waste incinerator (MWI) and an industrial waste incinerator (IWI) are evaluated via intensive stack sampling and analysis. Those two facilities investigated are equipped with activated carbon injection (ACI) with bag filter (BF) and fixed activated carbon bed (FACB) as major PCDD/F control devices, respectively. Average PCDD/F and PCB concentrations of stack gas with ACI+BF as APCDs are 0.031 and 0.006ng-TEQ/Nm(3), and that achieved with FACB are 1.74 and 0.19ng-TEQ/Nm(3) in MWI and IWI, respectively. The results show that FACB could reduce vapor-phase PCDD/Fs and PCBs concentrations in flue gas, while the ACI+BF can effectively adsorb the vapor-phase dioxin-like congener and collect the solid-phase PCDD/Fs and PCBs in the meantime. Additionally, the results of the pilot-scale adsorption system (PAS) experimentation indicate that each gram activated carbon adsorbs 105-115ng-PCDD/Fs and each surface area (m(2)) of activated carbon adsorbs 10-25ng-PCDD/Fs. Based on the results of PAS experimentation, this study confirms that the surface area of mesopore+macropore (20-200A) of the activated carbon is a critical factor affecting PCDD/F adsorption capacity.