用含固定化微生物的曝气生物滤池处理炼油厂高浓度废水

采用含固定化微生物的曝气生物滤池(G-BAF)处理炼油厂高浓度废水。当G-BAF池进水COD为298～11 278 mg/L时,出水COD为33.0～94.3 mg/L,COD平均去除率为97%;当G-BAF池进水ρ(NH_3-N)为12.1～188.0 mg/L时,出水ρ(NH_3-N)为0.9～49.4 mg/L,NH_3-N平均去除率为83%。经G-BAF处理后出水水质完全达到GB8978—1996《污水综合排放标准》第二类污染物的二级排放标准。     

Determination of antibiotics in sewage from hospitals, nursery and slaughter house, wastewater treatment plant and source water in Chongqing region of Three Gorge Reservoir in China

Sewage samples from 4 hospitals, 1 nursery, 1 slaughter house, 1 wastewater treatment plant and 5 source water samples of Chongqing region of Three Gorge Reservoir were analyzed for macrolide, lincosamide, trimethoprim, fluorouinolone, sulfonamide and tetracycline antibiotics by online solid-phase extraction and liquid chromatography-tandem mass spectrometry. Results showed that the concentration of ofloxacin (OFX) in hospital was the highest among all water environments ranged from 1.660 μg/L to 4.240 μg/L and norfloxacin (NOR, 0.136-1.620 μg/L), ciproflaxacin (CIP, ranged from 0.011 μg/L to 0.136 μg/L), trimethoprim (TMP, 0.061-0.174 μg/L) were commonly detected. Removal range of antibiotics in the wastewater treatment plant was 18-100% and the removal ratio of tylosin, oxytetracycline and tetracycline were 100%. Relatively higher removal efficiencies were observed for tylosin (TYL), oxytetracycline (OXY) and tetracycline (TET)(100%), while lower removal efficiencies were observed for Trimethoprim (TMP, 1%), Epi-iso-chlorotetracycline (EICIC, 18%) and Erythromycin-H₂O (ERY-H₂O, 24%). Antibiotics were removed more efficiently in primary treatment compared with those in secondary treatment.     

Effects of Urban Spatial Structure,Sociodemographics, and Climate on Residential Water Consumption in Hillsboro,Oregon1

House-Peters, Lily, Bethany Pratt, and Heejun Chang, 2010. Effects of Urban Spatial Structure, Sociodemographics, and Climate on Residential Water Consumption in Hillsboro, Oregon. Journal of the American Water Resources Association (JAWRA) 46(3):461-472. DOI: 10.1111/j.1752-1688.2009.00415.x Abstract: In the Portland metropolitan area, suburban growth in cities such as Hillsboro is projected to increase as people seek affordable housing near a burgeoning metropolis. The most significant determinants for increases in water demand are population growth, climate change, and the type of urban development that occurs. This study analyzes the spatial patterns of single family residential (SFR) water consumption in Hillsboro, Oregon, at the census block scale. The following research questions are addressed: (1) What are the significant determinants of SFR water consumption in Hillsboro, Oregon? (2) Is SFR water demand sensitive to drought conditions and interannual climate variation? (3) To what magnitude do particular census blocks react to drought conditions and interannual climate variation? Using ordinary least squares multiple regression and spatial regression methods, we found that base use, representing indoor water use, is dependent on household size and that seasonal use, representing external water use is dependent on both education level and the size of the property’s outdoor space. Spatial analysis techniques determined that although the water demand of the study area as a whole is not sensitive to drought conditions, certain individual census blocks do respond with a higher magnitude of water use. The most climate-sensitive census blocks tend to contain newer and larger homes, and have higher property values and more affluent and well-educated residents.     

Characteristics of springtime profiles and sources of ozone in the low troposphere over northern Taiwan

To quantify the possible sources of the high ambient ozone concentration in the low troposphere over Taiwan, ozone sounding data from a two-year intensive field measurement program conducted in April and early May of 2004 and 2005 in northern Taiwan has been examined. We found that the vertical ozone distributions and occurrence of enhanced ozone in the lower troposphere (below 6 km) mainly resulted from (1)Type NE: the long-range transport of ozone controlled by the prevailing northeasterly winds below 2 km, (2)Type LO: the local photochemical ozone production process, and (3)Type SW: the strong southwest/westerly winds aloft (2–6 km). In the boundary layer (BL), where Asian continental outflow prevails, the average profile for type NE is characterized by a peak ozone concentration of nearly 65 ppb at about 1500 m altitude. For type LO, high ozone concentration with an average ozone concentration greater than 80 ppb was also found in the BL in the case of stagnant atmospheric and sunny weather conditions dominated. For type SW, significant ozone enhancement with average ozone concentration of 70–85 ppb was found at around 4 km altitude. It is about 10 ppb greater than that of the types NE and LO at the same troposphere layer owing to the contribution of the biomass burning over Indochina. Due to Taiwan's unique geographic location, the complex interaction of these ozone features in the BL and aloft, especially features associated with northeasterly and south/southwesterly winds, have resulted in complex characteristics of ozone distributions in the lower troposphere over northern Taiwan.     

The influence of sampling protocol on nonmethane hydrocarbon mixing ratios

The effect of sampling protocol on ambient air hydrocarbon mixing ratios was examined on eight sampling days in Los Angeles during 2007 and 2008. Four protocols, which were based on previously published multi-city urban hydrocarbon studies in the United States, were compared and differences were quantified. Whole air canister samples were collected and analyzed for nonmethane hydrocarbons (NMHCs). Differing sampling protocols resulted in large differences in mixing ratios, up to an order of magnitude, for certain NMHCs on the same sampling day. However, the magnitude of the variability between NMHC levels obtained by the four protocols was not consistent throughout the eight sampling days. It was found that sampling time, followed by sampling location, had the greatest influence on the magnitude of the mixing ratio. Ratios between hydrocarbons, often used in urban studies to gain information on emission sources, also varied depending on the protocol used. Comparison of absolute NMHC mixing ratios collected in urban environments using differing sampling protocols should be made with care.     

Combining a finite mixture distribution model with indicator kriging to delineate and map the spatial patterns of soil heavy metal pollution in Chunghua County, central Taiwan

This study identifies the natural background, anthropogenic background and distribution of contamination caused by heavy metal pollutants in soil in Chunghua County of central Taiwan by using a finite mixture distribution model (FMDM). The probabilities of contaminated area distribution are mapped using single-variable indicator kriging and multiple-variable indicator kriging (MVIK) with the FMDM cut-off values and regulation thresholds for heavy metals. FMDM results indicate that Cr, Cu, Ni and Zn can be individually fitted by a mixture model representing the background and contamination distributions of the four metals in soil. The FMDM cut-off values for contamination caused by the metals are close to the regulation thresholds, except for the cut-off value of Zn. The receiver operating characteristic (ROC) curve validates that indicator kriging and MVIK with FMDM cut-off values can reliably delineate heavy metals contamination, particularly for areas lacking background information and high heavy metal concentrations in soil.     

Congener-specific accumulation and environmental risk assessment of polybrominated diphenyl ethers in diverse Korean sewage sludge types

Industrial, domestic wastewater, and livestock sludge samples were collected from 23 wastewater treatment plants in Korea and analyzed for polybrominated diphenyl ethers (PBDEs). The concentrations of Σ₁₉PBDE ranged from 4.01 to 10,400 ng/g dry weight. The average Σ₁₉PBDE concentrations in industrial, domestic wastewater, and livestock sludge were 1,560?±?3,610, 402?±?148, and 27.6?±?50.4 ng/g dry weight, respectively. The composition of PBDEs differed according to the type of sludge. Among the PBDE congeners, BDE 209 was dominant in all sludge samples. After BDE 209, relatively high levels were found for BDE 28 and 47 from industrial sludge, BDE 47 and 99 from domestic wastewater sludge, and BDE 206, 207, and 208 from livestock sludge. Using hierarchical cluster analysis, sludges were divided into three groups according to PBDE congener composition. A risk assessment of PBDEs in sludge used for soil amendment was carried out. Preliminary results indicated that the potential risk of soil exposed to PBDEs in sludge was relatively low.     

西北干旱地区农宅雨水转化为可饮水技术

雨水集流工程对于解决干旱地区人民生活用水问题起着重要作用,甘肃省兰州市榆中县北山地区处于严重缺水的地区,人畜的饮用水为雨水、雪水直接沉淀后的水窖水。经过对北山饮用水进行水质检测,发现水中浊度、锰含量、微生物数量均超过《生活饮用水卫生标准》(GB5749-2006)的规定值。通过对传统滤池进行改造并结合阳光消毒研制出了一种新型水处理器——阳光消毒-生物砂滤池(SBF)家庭水处理设备,通过生物砂滤池中微生物对雨水中污染物的氧化分解及河砂的过滤使水浊度及锰得到有效地去除,日光高温灭活和光氧化降解综合作用杀灭水中致病微生物。用SBF家庭水处理设备对雨水进行处理,水中浊度、锰含量、微生物数量均达到标准的规定值。     

Effects of water-emulsified fuel on a diesel engine generator’s thermal efficiency and exhaust

Water-emulsified diesel has proven itself as a technically sufficient improvement fuel to improve diesel engine fuel combustion emissions and engine performance. However, it has seldom been used in light-duty diesel engines. Therefore, this paper focuses on an investigation into the thermal efficiency and pollution emission analysis of a light-duty diesel engine generator fueled with different water content emulsified diesel fuels (WD, including WD-0, WD-5, WD-10, and WD-15). In this study, nitric oxide, carbon monoxide, hydrocarbons, and carbon dioxide were analyzed by a vehicle emission gas analyzer, and the particle size and number concentration were measured by an electrical low-pressure impactor. In addition, engine loading and fuel consumption were also measured to calculate the thermal efficiency. Measurement results suggested that water-emulsified diesel was useful to improve the thermal efficiency and the exhaust emission of a diesel engine. Obviously, the thermal efficiency was increased about 1.2 to 19.9%. In addition, water-emulsified diesel leads to a significant reduction of nitric oxide emission (less by about 18.3 to 45.4%). However, the particle number concentration emission might be increased if the loading of the generator becomes lower than or equal to 1800 W. In addition, exhaust particle size distributions were shifted toward larger particles at high loading. The consequence of this research proposed that the water-emulsified diesel was useful to improve the engine performance and some of exhaust emissions, especially the NO emission reduction.

Implications:The accumulated test results provide a good basis to resolve the corresponding pollutants emitted from a light-duty diesel engine generator. By measuring and analyzing transforms of exhaust pollutant from this engine generator, the effects of water-emulsified diesel fuel and loading on emission characteristics might be more clear. Understanding reduction of pollutant emissions during the use of water-emulsified diesel helps improve the effectiveness of the testing program. The analyzed consequences provide useful information to the government for setting policies to curb pollutant emissions from a light-duty diesel engine generator more effectively.