Replacement of H2O2 by O2 in Fenton and photo-Fenton reactions

The consumption of oxygen during the degradation of aniline by Fenton and photo-Fenton reactions is studied. The effect that parameters like aniline, Fe(II) and H2O2 initial concentration, pH, temperature and O2 flow rate have on the ratio O2 consumed/H2O2 consumed is examined. The determination of those combinations of experimental conditions for which an effective partial replacement of H2O2 by O2 as electron acceptor takes place is investigated. The results show that this replacement takes place in a variable extent, but the presence of H2O2 is necessary along the reaction, and the maximum consumption of O2 only takes place when the ratio amount of aniline mineralized vs. initial aniline concentration is minimal.     

Characterization of the organic matter of sludge: determination of lipids, hydrocarbons and PAHs from road retention/infiltration ponds in France

This paper presents the results of the organic matter characterization of sludge from two ponds (retention and infiltration) located in France. Special focus was placed on studying hydrocarbons and PAHs. This investigation is part of a global project on road and urban sludge with the aim of identifying a better means for managing these materials. Gas chromatographic and GC/MS analyses indicate that the main component of the organic fraction stems from petroleum-derived products like diesel fuel and motor oil. This finding was confirmed by the presence of biomarkers from the hopane series, as well as by pyrolytic and alkylated PAHs. Results from this study clearly show that the contaminants are mainly generated from anthropogenic petroleum sources. Due to their levels of hydrocarbon contamination, these sludge deposits must be considered as waste and cannot therefore be disposed anywhere, especially within the current context of sustainable development.     

Mechanism of effective nocardioform foam control measures for non-selector activated sludge systems.

Solids retention time (SRT), biological scum trapping and recycle, and the dynamic equilibrium between Nocardioform populations in the foam and the mixed liquor are the controlling factors in activated sludge foaming events caused by Nocardioform bacteria. For the operating modes described in this paper, a cured mixed liquor foaming condition (filament counts of approximately 10(5) intersections/g volatile suspended solids) was only achieved when SRT control, selective wasting, and polymer addition were in effect. Solids retention time control, with the SRT remaining below 1.5 days, and selective wasting will cure a severely foaming mixed liquor, but effects will only be observed after 3 or 4 months after implementation. The combined wastage of Nocardioform bacteria from selective wasting and SRT control can ensure long-term foam control to the operation of a pure-oxygen activated sludge system with foam-trapping features. An SRT of 0.3 days will result in the complete washout of Nocardioform bacteria from the activated sludge system, which can then operate at an SRT of 3 days free of Nocardioform. Polymer addition to mixed liquor is only effective for foam control when a large portion of the system biomass exists as a heavy layer of foam above the mixed liquor.     

An analytical solution for vertical transport of volatile chemicals in the vadose zone

An analytical solution is presented for one-dimensional vertical transport of volatile chemicals through the vadose zone to groundwater. The solution accounts for the important transport mechanisms of the steady advection of water and gas, diffusion and dispersion in water and gas, as well as adsorption, and first-order degradation. By assuming a linear, equilibrium partitioning between water, gas and the adsorbed chemical phases, the dependent variable in the mathematical model becomes the total resident concentration. The general solution was derived for cases having a constant initial total concentration over a discrete depth interval and a zero initial total concentration elsewhere. A zero concentration gradient is assumed at the groundwater table. Examples are given to demonstrate the application of the new solution for calculating the case of a non-uniform initial source concentration, and estimating the transport of chemicals to the groundwater and the atmosphere. The solution was also used to verify a numerical code called VLEACH. We discovered an error in VLEACH, and found that the new solution agreed very well with the numerical results by corrected VLEACH. A simplified solution to predict the migration of volatile organic chemical due to the gas density effect has shown that a high source concentration may lead to significant downward advective gas-phase transport in a soil with a high air-permeability.     

Examination of environmental quality of raw and composting de-inking paper sludge

Paper sludges were traditionally landfilled or burned. Over the years, the use of paper sludges on soils has increased, as well as the concerns about their environmental effects. Therefore, the chemical characterization of paper sludges and their young (immature) compost needed to be investigated, and over 150 inorganic and organic chemicals were analyzed in de-inking paper sludge (DPS). In general, nitrogen, phosphorus and potassium contents were low but variable in raw DPS and its young compost. The contents of arsenic, boron, cadmium, cobalt, chromium, manganese, mercury, molybdenum, nickel, lead, selenium, and zinc were also low and showed low variability. However, the copper contents were above the Canadian compost regulation for unrestricted use and required a follow-up. The fatty- and resin acids, and polycyclic aromatic hydrocarbons were the organic chemicals measured at the highest concentrations. For resinic acids, care should be taken to avoid that leachates reach aquatic life. For polycyclic aromatic hydrocarbons, naphthalene should be followed until soil content reaches 0.1 microg g(-1), the maximum allowed for soil use for agricultural purposes according to Canadian Environmental Quality Guidelines. In young compost, the concentration of these chemical families decreased over time and most compounds were below the detection limits after 24 weeks of composting. In raw DPS, among the phenol, halogenated and monoaromatic hydrocarbons, dioxin and furan, and polychlorinated biphenyl families, most compounds were below the detection limits. The raw DPS and its young compost do not represent a major threat for the environment but can require an environmental follow-up.     

The toxicity of pyrene in the fish : Synergism by piperonyl butoxide and by ultraviolet light

A saturated solution of pyrene in water was not toxic to the fish , even in the presence of ultraviolet light. A survival curve possessing one minimum, and therefore defining two LC₅₀ values, was obtained when fish placed in water containing increasing amounts of a pyrene solution in dimethylsulfoxide were exposed to ultraviolet light after a short incubation period. The phototoxicity was linked to the presence of undissolved pyrene. A normal survival curve with only one LC₅₀ value was found when pyrene was solubilized with the surfactant Tween-20. Practically no phototoxicity was produced when the pyrene mixtures were filtered before use, or when a saturated aqueous solution of pyrene was used. Piperonyl butoxide, present at a concentration where it was not toxic, synergized the toxicity of pyrene . The environmental significance of this observation may be considerable.     

Exposure to polychlorinated biphenyls from an overheated transformer

A Polychlorinated Biphenyl (PCB) containing transformer released approximately 50 gallons of askarel oil. No polychlorinated dibenzofurans (PCDF) or polychlorinated dibenzodioxins (PCDD) were detected in a sample of the askarel (analytical limit of detection of 40 parts per billion per isomer group). Skin irritation, unusual tiredness, and headaches occurred in approximately 20% of the individuals at the scene of the incident. Serum PCB levels, and mean values for blood and urine tests were within normal ranges.     

Influence of pre-treatment step on PAHs analyses in contaminated soils

There is no specific standardization for the pre-treatment of a soil sample for PAHs analyses. The ISO/FDIS 14507 method for soil quality gives a guidance for sample pre-treatment before measurement of organic contaminants in soil. It refers to cryogenic crushing which is not so easy to carry out. So, analysts lead to develop in house methods which can be very different from a laboratory to another and can involve deviations in the pollution quantification. This study has explored different ways of drying, grinding and sieving in order to determine the influence of the soil sample handling on the measured pollutant concentration. It appears that the influence of pre-treatment depends on the soil nature and on the PAHs distribution. As a conclusion, it is advised "light" drying ways like air drying or drying at 40 degrees C in a drying oven instead of more "drastic" ways (freeze-drying, cryogenic crushing) which can induce some losses. Crushing and sieving are also recommended for more reproducible measures.     

An analysis of candidates for addition to the Clean Air Act list of hazardous air pollutants

There are 188 air toxics listed as hazardous air pollutants (HAPs) in the Clean Air Act (CAA), based on their potential to adversely impact public health. This paper presents several analyses performed to screen potential candidates for addition to the HAPs list. We analyzed 1086 HAPs and potential HAPs, including chemicals regulated by the state of California or with emissions reported to the Toxics Release Inventory (TRI). HAPs and potential HAPs were ranked by their emissions to air, and by toxicity-weighted (tox-wtd) emissions for cancer and noncancer, using emissions information from the TRI and toxicity information from state and federal agencies. Separate consideration was given for persistent, bioaccumulative toxins (PBTs), reproductive or developmental toxins, and chemicals under evaluation for regulation as toxic air contaminants in California. Forty-four pollutants were identified as candidate HAPs based on three ranking analyses and whether they were a PBT or a reproductive or developmental toxin. Of these, nine qualified in two or three different rankings (ammonia [NH3], copper [Cu], Cu compounds, nitric acid [HNO3], N-methyl-2-pyrrolidone, sulfuric acid [H2SO4], vanadium [V] compounds, zinc [Zn], and Zn compounds). This analysis suggests further evaluation of several pollutants for possible addition to the CAA list of HAPs.