Measurement of the pesticide methomyl by modified quartz crystal nanobalance with molecularly imprinted polymer

A simple and cost-effective analysis method based on quartz crystal nanobalance (QCN) coated with a molecularly imprinted polymer (MIP) for measurement of methomyl was investigated. In the first part of this study, a sensitive, selective and reliable quartz crystal nanobalance (QCN) sensor was designed for the selective determination of methomyl in aqueous solutions. In the second part, in order to demonstrate the applicability and performance of the fabricated sensor in the real world situation, it was successfully applied for the determination of methomyl residual in photo catalytic degradation by ZnO powders in aqueous solutions. The fabricated sensor presents a high selectivity and sensitivity (4.56 Hz per mg L^?1) for methomyl and it can be used for determination of methomyl concentration ranged between 1 to 45 mg L^?1. Furthermore, good reproducibility, R.S.D. = 2.14% (n = 5) was observed. To investigate the performance of the sensor, the change in the insecticide concentration during the photocatalytic degradation of methomyl by ZnO was investigated by QCN and UV/Vis spectroscopy. Results obtained from QCN sensor and UV/Vis spectroscopy measurement are in good mutual agreement. So the fabricated sensor may provide an efficient, low cost, easy-to-use method for the in-field evaluation of specific targeted analytes in aqueous solutions which in turn may lead to improved food and water safety.     

Photochemical Reactivities of Paraffinic Hydrocarbon-Nitrogen Oxide Mixtures Upon Addition of Propylene or Toluene

Effects associated with photochemical air pollution were measured during irradiation of n-butane-nitrogen oxide or n-butane-ethane-nitrogen oxide mixtures, with small amounts of propylene or toluene added. The effects measured including nitrogen dioxide and oxidant dosages, yields of formaldehyde and peroxy-acetyl nitrate, and eye irritation response. The results obtained clearly show that beneficial effects result from selective changes in hydrocarbon composition as well as from reduction of total hydrocarbon concenfration. Exclusion of olefins and alkylbenzenes was highly effective in reducing oxidant dosage, formaldehyde and peroxyacetyl nitrate concentrations, and eye irritation response. The only penalty was a modest increase in nitrogen dioxide dosage. A large reduction in nitrogen oxide concentration reduced nitrogen dioxide dosage and eye irritation response, but with the penalty of a large increase in oxidant dosage. The desirability of preferentially reducing olefins and alkylbenzenes rather than paraffinic hydrocarbons, acetylene, and benzene is strongly supported by this study. Research and development efforts should be directed toward preferential hydrocarbon control by mechanical or catalytic control     

Effect of water washing on the thermal behavior of rice straw

Rice straw can be used as a renewable fuel for heat and power generation. It is a viable mean of replacing fossil fuels and preventing pollution caused by open burning, especially in the areas where this residual biomass is generated. Nevertheless, the thermal conversion of rice straw can cause some operating problems such as slag formation, which negatively affects thermal conversion systems. So, the main objective of this research is studying the combustion behavior of rice straw samples collected from various regions by applying thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). In addition, the thermal behavior of ashes from rice straw was also analyzed in order to detect their melting points, and ash sintering was detected at different temperatures within the range between 550 and 1000 °C. Since washing rice straw with water could reduce the content of undesirable inorganic compounds related to the ash fusibility, samples of washed rice straw were analyzed under combustion conditions to investigate its differences regarding the thermal behavior of rice straw. The results showed that rice straw washing led to a significant improvement in its thermal behavior, since it reduced the ash contents and sintering formation.     

Black carbon aerosols in urban air in South Asia

We report data from a yearlong (2006–2007) study of black carbon concentrations ([BC]) measured at 5-min intervals with an Aethalometer in Karachi, Pakistan. Daily mean [BC] varied from about 1 to 15 μg m^?3. However, short-term spikes exceeding 40 μg m^?3 were common, occurring primarily during the morning and evening rush-hour periods. The [BC] values were highest during November through February, ～10 μg m^?3, and lowest during June through September, ～2 μg m^?3. Diurnal, seasonal, and day-of-the-week trends are discussed. It is demonstrated that these trends are strongly affected by meteorological patterns. A simple expression is applied to the concentration profiles to separate the effects of meteorological conditions and elucidate the underlying emissions patterns. Daily emissions varied from 14,000 to 22,000 kg of BC per day. When integrated over the year emissions for Karachi Proper were estimated at 6.7 kilometric tons per year and emissions for greater Karachi were 17.5 kilometric tons per year. Folding in the populations of each area yields BC emissions of 0.74 and 1.1 kg per person per year, respectively. Applying the model to previously collected data at Lahore, Pakistan yields emissions during November–January that are around a factor of two higher than those in Karachi, but because the BC measurements in Lahore covered only three months, no estimates of annual emissions were attempted. Given the large populations of these cities the local health impact from PM alone is expected to be severe but because of the high [BC] emissions the impact on the global climate may be equally significant.     

Geography and Recovery under the U.S. Endangered Species Act

Abstract: The U.S. Endangered Species Act (ESA) defines an endangered species as one “at risk of extinction throughout all or a significant portion of its range.” The prevailing interpretation of this phrase, which focuses exclusively on the overall viability of listed species without regard to their geographic distribution, has led to development of listing and recovery criteria with fundamental conceptual, legal, and practical shortcomings. The ESA's concept of endangerment is broader than the biological concept of extinction risk in that the “esthetic, ecological, educational, historical, recreational, and scientific” values provided by species are not necessarily furthered by a species mere existence, but rather by a species presence across much of its former range. The concept of “significant portion of range” thus implies an additional geographic component to recovery that may enhance viability, but also offers independent benefits that Congress intended the act to achieve. Although the ESA differs from other major endangered‐species protection laws because it acknowledges the distinct contribution of geography to recovery, it resembles the “representation, resiliency, and redundancy” conservation‐planning framework commonly referenced in recovery plans. To address representation, listing and recovery standards should consider not only what proportion of its former range a species inhabits, but the types of habitats a species occupies and the ecological role it plays there. Recovery planning for formerly widely distributed species (e.g., the gray wolf [Canis lupus]) exemplifies how the geographic component implicit in the ESA's definition of endangerment should be considered in determining recovery goals through identification of ecologically significant types or niche variation within the extent of listed species, subspecies, or “distinct population segments.” By linking listing and recovery standards to niche and ecosystem concepts, the concept of ecologically significant type offers a scientific framework that promotes more coherent dialogue concerning the societal decisions surrounding recovery of endangered species.     

Sulfur Dioxide and Material Damage

Whereas most estimates of material damage are based on industrial surveys, the estimates produced in this study were derived from material damage experiments and ambient air quality data. Air quality data on SO₂ were obtained from 200 or more monitoring sites primarily located in heavily populated or polluted areas. Material threshold damage function data were then compared with SO₂ levels, and an estimate of losses, as reflected in increased maintenance and replacement costs, was determined. Estimates of the total stock of various materials in use were derived from census and industry data and allocated geographically according to population. A substantial decrease in the ambient SO₂ levels, particularly in larger urban areas, has occurred during the past five years. From 1968 to 1972, the estimated amount of material damage from SO₂ in the U. S. decreased from $900 million/yr to less than $100 million. During this period, the estimated percentage of man made materials exposed to SO₂ levels exceeding the proposed secondary annual average standard (60 μg/m³) and primary annual average standard (80 μg/m³) in the U. S. fell respectively, from 20% to less than 5% and from more than 10% to less than 1%. Most of the present loss is attributed to corrosion damage of metallic surfaces that are normally exposed to the ambient environment.