Ni／Fe／Al2O3·PVDF催化还原剂的表征及制备过程优化

在PVDF基体改性的基础上,采用浸渍法制备出Ni／Fe／Al2O3PVDF催化还原剂。通过对一氯乙酸的脱氯效果研究,对交联液配比及交联时间、不同浓度硫酸镍浸渍时间、镍铁比等因素进行优化,实验优化结果表明,Ni／Fe／Al2O3PVDF催化还原剂对一氯乙酸脱氯60min脱氯率达到64％。经SEM表征,制备出的双金属在膜载体表面及断面分布均匀,呈球状和片状结构且双金属未发生团聚。     

混合液回流比对MSBR工艺强化生物脱氮的影响

针对二级城镇污水处理厂提标改造时出水氮、磷指标很难同时达到一级A标准（GB18918-2002）的情况,提出了改良式序批式反应器（MSBR）的强化生物脱氮运行模式,并通过生产性实验研究了MSBR工艺混合液回流比（6单元回流至5单元）对出水COD、TP、NH4＋-N及TN的影响。实验结果表明,MSBR工艺混合液回流比对COD、NH4＋-N去除基本上没有影响,但对TN和TP去除有影响。当回流比从0提高1和1．5时,TP去除效率分别降低了5．85％和4．06％;而TN去除效率分别提高了10．46％和7．87％,同时出水TN可稳定达到一级A标的要求。从控制运行能耗和脱氮效果的角度综合考虑,该污水厂强化生物脱氮的混合液回流比控制在1是比较合适的。     

Novel approach to predicting hormetic effects of antibiotic mixtures on Vibrio fischeri

The determination of the hormetic effects of a mixture is quite difficult because of the moderate simulation and the complexity of measurement in low doses. In the present study, two typical models for mixture toxicity prediction, concentration additive (CA) and independent action (IA), were used to predict the hormetic effects of mixtures. The predictive power of those models was validated by the hormetic effects (24-h exposure) of antibiotic’s binary mixtures to Vibrio fischeri. The results showed that CA and IA were unable to predict the hormetic dose-response of mixture, especially those of the interactive mixtures. As an alternative, a novel model, which was named as “six-point” and developed based on the quantitative features in the determined dose-response curve and on the Quantitative Structure Activity Relationships (QSARs) approach, was proposed for predicting the hormetic effects of mixtures in low dose. The results indicated that the “six-point” model can accurately predict the mixture hormetic effects in low dose, not only for non-interactive mixtures but also for interactive mixtures. Therefore, the “six-point” model is a powerful tool to predict the mixture hormetic effects at low dose, and may offer an important approach in the environment risk assessment of mixtures.     

电镀污泥的还原焙烧-酸浸

将电镀污泥作为一种重要的重金属资源加以回收利用,逐渐成为了国内外研究的重点。以电镀污泥为研究对象,在不同的温度及不同的焙烧时间下进行直接焙烧和还原焙烧,并对焙烧底渣进行酸浸,分别研究了污泥减量率以及Cu、Ni、Zn和Cr 4种重金属的含量和浸出率,并探索了还原剂(煤粉)和催化剂(CaCO3)投加量的影响。实验结果表明,原始电镀污泥中,Cu含量最高,达到10.05%,因此,电镀污泥中Cu具有回收价值;焙烧后电镀污泥得到了减量化,同时污泥中的金属得到了富集;还原焙烧比直接焙烧更有利于Cu的选择性浸出,当煤粉投加量为10%,CaCO3投加量为0.5%,在700℃下焙烧20 min时,Cu的浸出率达到98.73%,Cu的含量达到15.07%。     

臭氧—活性炭技术处理石油微污染地下水*

在实验室及中试条件下研究了臭氧-活性炭技术对石油微污染地下水的处理效果。通过石油类和高锰酸盐指数两个指标,考察了臭氧投加量、pH值、过滤速率等操作参数对污染物的去除效果。结果表明:臭氧投加量和活性炭过滤速率是最主要的影响因素,pH值对处理效果影响不显著。中试条件下适宜的臭氧投加量应为8mg/L左右,最佳过滤速率在10m/h附近。采用臭氧氧化与活性炭过滤组合工艺,当进水石油类浓度在1.5mg/L以下时,出水石油类低于0.3mg/L,高锰酸盐指数低于3.0mg/L。     

基于产业集聚的化工行业绿色供应链管理模式研究

化工行业对环境的严重影响引起了政府、学术界和公众的共同关注,实施绿色供应链管理是解决环境问题的系统方法。尝试性地将产业集群理论与绿色供应链管理理论进行耦合,结合化工行业的特点,提出基于产业集聚的化工行业绿色供应链管理模式。通过培育集群内上下游企业的互动创新机制,发挥集群内上下游企业资源利用和废物处置的规模效应,通过因地制宜地发展化工生产型服务产业以及相关支撑机构的建设等措施,使化工行业能够可持续发展。     

A/O1/H/O2工艺处理焦化废水硝化过程的实现及其抑制

针对焦化废水中的有毒污染物会对敏感易受干扰的硝化细菌产生不利影响从而破坏硝化过程稳定性的现象,采用A/O1/H/O2工艺处理焦化废水的实际工程为研究对象,根据工程运行的水质监测数据分析,发现几种主要污染物的浓度变化会对二级好氧段的硝化过程产生抑制影响。序批式毒性抑制实验结果表明,苯酚、硫氰化物和喹啉对硝化过程具有毒性抑制作用,半抑制浓度EC50分别为34.26、278.5和73.24 mg/L。当二级好氧工艺段运行正常时（C/N约4.3/1,pH8～8.5,DO 4～4.5 mg/L）,出水氨氮浓度可低于5 mg/L,是由于焦化废水经厌氧/好氧/水解工艺后毒物浓度大幅下降,毒性得到削减,表明焦化废水生物处理A/O1/H/O2组合流化床工艺具有较强抵抗毒物抑制并实现高效的硝化作用。     

Toxicokinetics of tilapia following high exposure to waterborne and dietary copper and implications for coping mechanisms

One of the major challenges in assessing the potential metal stress to aquatic organisms is explicitly predicting the internal dose in target organs. We aimed to understand the main sources of copper (Cu) accumulation in target organs of tilapia (Oreochromis mossambicus) and to investigate how the fish alter the process of Cu uptake, depuration, and accumulation (toxicokinetics (TK)) under prolonged conditions. We measured the temporal Cu profiles in selected organs after single and combined exposure to waterborne and dietary Cu for 14 days. Quantitative relations between different sources and levels of Cu, duration of treatment, and organ-specific Cu concentrations were established using TK modeling approaches. We show that water was the main source of Cu in the gills (>94 %), liver (>89 %), and alimentary canal (>86 %); the major source of Cu in the muscle (>51 %) was food. Cu uptake and depuration in tilapia organs were mediated under prolonged exposure conditions. In general, the uptake rate, depuration rate, and net bioaccumulation ability in all selected organs decreased with increasing waterborne Cu levels and duration of exposure. Muscle played a key role in accounting for the rapid Cu accumulation in the first period after exposure. Conversely, the liver acted as a terminal Cu storage site when exposure was extended. The TK processes of Cu in tilapia were highly changed under higher exposure conditions. The commonly used bioaccumulation model might lead to overestimations of the internal metal concentration with the basic assumption of constant TK processes.     

Polybrominated diphenyl ethers occurrence in major inflowing rivers of Lake Chaohu (China): Characteristics,potential sources and inputs to lake

Eight commonly occurring polybrominated diphenyl ethers (PBDEs), including BDE 28, 47, 99, 100, 153, 154, 183, 207, and 209, were investigated in water samples from seven major inflowing rivers of Lake Chaohu to determine the distribution characteristics, potential sources and inputs to the lake. The sum of 8 BDE congeners (Σ₈PBDEs) had a concentration varied from 0.31 to 84 ng L⁻¹, with those of BDE 209, BDE 47, BDE 99, and BDE 153 being 0.31–83, <0.012–0.36, <0.012–1.3, and <0.012–0.77 ng L⁻¹, respectively. These levels were in the high range of the global PBDEs concentrations in the water environments. The highest concentrations of Σ₈PBDEs were detected in the western rivers, of which the main pollution sources were strongly related to human activities in urban centers, such as automobile-derived wastes. A sewage treatment plant was likely an important source of the lower brominated BDEs input to one western river. The correlation analyses (all p < 0.05) between PBDEs and DOC, TN, TP, and EC, suggested that the distributions and sources of PBDEs in rivers might also be related with the soil erosion by heave floods. Σ₈PBDEs input to Lake Chaohu from the rivers outlets was estimated at 344 kg yr⁻¹ during the flood season. BDE 209 was the dominant contributor with an input of 340 kg yr⁻¹, followed by BDE 99 (1.3 kg yr⁻¹), BDE 47 (0.83 kg yr⁻¹) and BDE 153 (0.60 kg yr⁻¹).