Inorganic nitrogen transformations in the treatment of landfill leachate with a high ammonium load: A case study

The inorganic nitrogen transformations occurring at a municipal waste leachate treatment facility were investigated. The treatment facility consisted of a collection well and an artificial wetland between two aeration ponds. The first aeration pond showed a decrease in ammonium (from 3480 (± 120) to 630(± 90) mg ⋅ L⁻¹), a reduction in inorganic nitrogen load (3480 to 1680 mg N ⋅ L⁻¹), and an accumulation of nitrite (< 1.3 mg-N ⋅ L⁻¹ in the collection well, to 1030 mg-N ⋅ L⁻¹). Incomplete ammonium oxidation was presumably the result of the low concentration of carbonate alkalinity (∼2 mg ⋅ L⁻¹), which may cause a limitation in the ammonium oxidation rate of nitrifiers. Low carbonate alkalinity levels may have been the result of stripping of CO₂ from the first aeration pond at the high aeration rates and low pH. Various chemodenitrification mechanisms are discussed as the reason for the reduction in the inorganic nitrogen load, including; the reduction of nitrite by iron (II) (producing various forms of gaseous nitrogen); and reactions involving nitrous acid. It is suggested that the accumulation of nitrite may be the result of inhibition of nitrite oxidizers by nitrous acid and low temperatures. Relative to the first aeration pond, the speciation and concentration of inorganic nitrogen was stable in the wetlands and 2nd aeration pond. The limited denitrification in the wetlands most probably occurred due to low concentrations of organic carbon, and short retention times.     

Modelling Dissolved Organic Carbon Turnover in Humic Lake Örträsket, Sweden

The organic carbon balance of a lake with high input of allochthonous organic carbon is modelled integrating physical, chemical and biological processes. The physical model captures the behaviour of real thermal stratification in the lake for different flow situations during the period 1993–1997. The dissolved organic carbon model is based on simulated trajectories of water parcels. By tracking parcels, account is kept of environmental factors such as temperature and radiation as well as DOC quality for each parcel. The DOC concentration shows seasonal variations primarily dependent on inflow. The organic matter degradation (bacterial- and photodegradation) in the lake amounts to 1.5–2.5 mg C l^–1 yr^–1, where photooxidation is responsible for approximately 10%. The estimated DIC production in the lake is large compared to sediment mineralisation and primary production. The main conclusion is that the model with the selected parameterisations of the degradation processes reasonably well describes the DOC dynamics in a forest lake.     

Identification of Characteristic Regions and Representative Stations: A Study of Water Quality Variables in the Kattegat

Gradients in nutrient distributions and the effects of eutrophication are common features in most coastal marine areas. These structures occur in aquatic systems due to spatial differences in hydrography, nutrient loading and key biogeochemical processes. Two statistical methods, cluster analysis and probability mapping, have been used in the present study to determine characteristics and patterns in water quality variables. Combined, these two methods provide a useful tool to statistically determine spatial homogeneity and representativity of areas and stations. A case study is presented here in which water quality variables (salinity, dissolved inorganic nitrogen, dissolved inorganic phosphorus and chlorophyll) in surface waters of the Kattegat are analysed for the time period 1993-1997. It was found that morphology, the proximity to sources of nutrient loading from land, nutrient uptake and the infrequent water exchange between the Baltic Sea in the south and the Skagerrak in the north all contribute to create distinct regions of water quality. Regions with concentrations significantly different from the overall mean are identified. In addition to identification of regions with similar characteristics, representative stations (as well as not representative stations) for the respective regions were made. This type of information can be used to design new or revise old monitoring programs.     

A comparison of temperate reef fish assemblages recorded by three underwater stereo-video techniques

Three underwater stereo-video techniques were used to sample the relative densities and species richness of temperate reef fish assemblages at three reef locations and two habitats (high- and low-relief reef) within Hamelin Bay, south-western Australia. The three techniques compared were diver-operated stereo-video strip transects, baited remote stereo-video and unbaited remote stereo-video. While unbaited remote stereo-video and diver-operated stereo-video transects recorded greater species richness at high compared to low-relief reefs, baited remote stereo-video recorded similar species richness at the two habitat types. The diver-operated stereo-video system was manoeuvred through caves and under overhangs recording small, cryptic, cave-dwelling species that were not recorded by either remote video techniques (Trachinops noarlungae, Trachinops brauni, Chromis klunzingeri, Trachichthys australis). Both remote video techniques recorded greater species richness and relative density of the most common species of Labridae, Ophthalmolepsis lineolatus. Baited remote video recorded the rarer, large predatory fish species (e.g. Seriola hippos, Glaucosoma hebraicum, Heterodontus portusjacksoni). None of the techniques sampled small cryptic fish families such as Gobiidae or Blenniidae. A combination of survey techniques is recommended for comprehensive fishery-independent studies that aim to sample broad components of fish assemblages.An erratum to this article can be found at     

Inhalation of Concentrated Ambient Particulate Matter near a Heavily Trafficked Road Stimulates Antigen-Induced Airway Responses in Mice

Abstract

The goal of this study was to test the following hypotheses:(1) exposure to mobile emissions from mobile sources close to a heavily trafficked roadway will exacerbate airway inflammation and allergic airway responses in a sensitized mouse model, and (2) the magnitude of allergic airway disease responses will decrease with increasing distance from the roadway. A particle concentrator and a mobile exposure facility were used to expose ovalbumin (OVA)-sensitized BALB/c mice to purified air and concentrated fine and concentrated ultrafine ambient particles at 50 m and 150 m downwind from a roadway that was heavily impacted by emissions from heavy duty diesel-powered vehicles. After exposure, we assessed interleukin (IL)-5, IL-13, OVA-specific immunoglobulin E, OVA-specific immunoglobulin G1, and eosinophil influx as biomarkers of allergic responses and numbers of polymorphonuclear leukocytes as a marker of inflammation. The study was performed over a two-year period, and there were differences in the concentrations and compositions of ambient particulate matter across those years that could have influenced our results. However, averaged over the two-year period, exposure to concentrated ambient particles (CAPs) increased the biomarkers associated with airway allergies (IL-5, immunoglobulin E, immunoglobulin G1 and eosinophils). In addition, mice exposed to CAPs 50 m downwind of the roadway had, on the average, greater allergic responses and showed greater indications of inflammation than did mice exposed to CAPs 150 m downwind. This study is consistent with the hypothesis that exposure to CAPs close to a heavily trafficked roadway influenced allergic airway responses.     

Solubilization of nitrotoluenes in micellar nonionic surfactant solutions

A key factor in selecting surfactants to enhance chemical or biological transformation or physical removal of an organic pollutant from contaminated soil is knowledge of the pollutant's solubility behavior in the surfactant solution. This study investigated the influence of nonionic surfactant structure on the solubility of 4-nitrotoluene (NT), 2,3-dinitrotoluene, 2,4-dinitrotoluene, 2,6-dinitrotoluene, and 2,4,6-trinitrotoluene (TNT) at room temperature. For a series of alkyl phenol ethoxylates (Tergitol NP-8 to NP-40), decreasing the ethoxylate chain length increased the solubility of these nitrotoluenes by a factor of two or less in 10 g l(-1) surfactant solutions, but did not significantly change their molar solubilization ratios (MSR, e.g. 0.02 for TNT) or their micelle-water partition coefficients (K(m), e.g. 3.4 for TNT). For Tergitol NP-8 solutions ranging from 1.0 to 12.4 g l(-1), no enhancement in NT solubility was found, suggesting that the cloud point was reached. The MSRs for Tween 80 were higher than those of Tween 20 and the MSRs of Brij-58 were higher than those for Brij-35. When comparing solutes, NT had the highest solubility and MSR (0.28-0.41), while TNT had the lowest solubility and MSR (0.02-0.03). A linear relationship between K(m) values and octanol-water partition coefficients based on Triton X-100 predicted the logK(m) values within 0.5 of their measured values. A linear solvation free energy correlation for K(m) suggested the importance of solute volume and effective hydrogen bond basicity in the partitioning process while implying that the nitrotoluenes are solubilized in a polar portion of the micelle.     

Mechanical Equipment Injuries in Small Manufacturing Businesses. Knowledge,Behavioral, and Management Issues

This paper presents findings from an extensive study intofactors that impact upon the high rate of injuries due to mechanical equipment, especially in small manufacturing firms. Issues relating to knowledge of health and safety issues and to management practices have been shown to be extremely important with regards to safety in smaii businesses. Knowledge and awareness of hazards were found to be relatively low and few respondents, especially managers, had received adequate safety training. Managers did not regard the identification and control of risks as a priority. Workplaces generally lacked effective safety management procedures such as safety rules and regulations, procedures for recording and learning from accidents, and clearly defined responsibilities for safety. Some issues requiring further investigation, and some recommendations for improving safety in small businesses, are presented.     

The Effects of Three Chemical Algaecides on Cell Numbers and Toxin Content of the Cyanobacteria Microcystis aeruginosa and Anabaenopsis sp.

Toxic cyanobacteria blooms are a growing concern for public health and safety, due in part to the production of the hepatotoxin microcystin by certain species, including Microcystis aeruginosa. Management strategies for controlling cyanobacteria blooms include algaecide treatments, often with copper sulfate, and more recently oxidizers such as sodium percarbonate that produce hydrogen peroxide. This study assessed the effects of two copper-containing algaecides and one sodium percarbonate-containing algaecide on mitigating cell numbers and toxin content of cultured M. aeruginosa and summer (July) bloom samples of Anabaenopsis sp. in a brackish stormwater detention pond. Monitoring of the bloom revealed that Anabaenopsis sp. was associated with elevated levels of orthophosphate compared to nitrogen (dissolved inorganic nitrogen to phosphorus ratios were 0.19–1.80), and the bloom decline (September–October) was likely due to lower autumn water temperatures combined with potential grazing by the dinoflagellate Protoperidinium quinquecorne. Laboratory-based algaecide experiments included three dose levels, and cyanobacteria cell numbers and microcystin concentrations (particulate and dissolved) were evaluated over 7 d. Following exposure, copper-containing treatments generally had lower cell numbers than either sodium percarbonate-containing or control (no algaecide) treatments. Addition of algaecides did not reduce overall microcystin levels, and a release of toxin from the particulate to dissolved phase was observed in most treatments. These findings indicate that algaecide applications may visibly control cyanobacteria bloom densities, but not necessarily toxin concentrations, and have implications for public health and safety.     

Modeling riverine nutrient transport to the Baltic Sea: a large-scale approach

We developed for the first time a catchment model simulating simultaneously the nutrient land-sea fluxes from all 105 major watersheds within the Baltic Sea drainage area. A consistent modeling approach to all these major watersheds, i.e., a consistent handling of water fluxes (hydrological simulations) and loading functions (emission data), will facilitate a comparison of riverine nutrient transport between Baltic Sea subbasins that differ substantially. Hot spots of riverine emissions, such as from the rivers Vistula, Oder, and Daugava or from the Danish coast, can be easily demonstrated and the comparison between these hot spots, and the relatively unperturbed rivers in the northern catchments show decisionmakers where remedial actions are most effective to improve the environmental state of the Baltic Sea, and, secondly, what percentage reduction of riverine nutrient loads is possible. The relative difference between measured and simulated fluxes during the validation period was generally small. The cumulative deviation (i.e., relative bias) [Sigma(Simulated - Measured)/Sigma Measured x 100 (%)] from monitored water and nutrient fluxes amounted to +8.2% for runoff, to -2.4% for dissolved inorganic nitrogen, to +5.1% for total nitrogen, to +13% for dissolved inorganic phosphorus and to +19% for total phosphorus. Moreover, the model suggests that point sources for total phosphorus compiled by existing pollution load compilations are underestimated because of inconsistencies in calculating effluent loads from municipalities.     

Processes controlling metal transport and retention as metal-contaminated groundwaters efflux through estuarine sediments

Factors affecting the transport and retention of Cd, Cr, Cu, Ni, Pb and Zn in acidic groundwaters as they pass through estuarine sediments were investigated using column experiments. Acidic groundwaters caused the rapid dissolution of iron sulfide (AVS) and other iron and manganese phases from sediments that are important for metal binding and buffering. Metal breakthrough to overlying water occurred in the order of Ni>Zn>Cd>Cu>Cr/Pb. Metal transport increased as the sediment permeability increased, reflecting the low resistance to flow caused by larger sand-sized particles and the decreased abundance of metal adsorption sites on these materials. Metal mobility increased as the groundwater pH decreased, as flow rate or metal concentrations increased, and as the exposure duration increased. Groundwater Cr and Pb were promptly attenuated by the sediments, the mobility of Cu was low and decreased rapidly as sediment pH increased above 4.5, while Cd, Ni and Zn were the most easily transported to the surface sediments and released to the overlying waters. For groundwaters of pH 3, metal migration velocities through sandy sediments were generally 0.5-2% (Cr, Pb), 1-6% (Cu) and 4-13% (Cd, Ni, Zn) of the total groundwater velocity (9-700 m/yr). The oxidative precipitation of Fe(II) and Mn(II) in the groundwaters did not affect metal mobility through the sediments. The results indicated that the efflux of acidic and metal-contaminated groundwater through estuarine sediments would affect organisms resident in sandy sediments more greatly than organisms resident in fine-grained, silty, sediments.