Effects of storage method and duration on the toxicity of marine sediments to embryos of Crassostrea gigas oysters

The objective of laboratory sediment bioassays is to estimate in situ toxicity. This goal is difficult to achieve, as one of the main limitations of sediment toxicity tests is disruption of sediment geochemistry during sampling, handling and preservation. The effects of storage on the estimation of marine sediment toxicity to Crassostrea gigas embryos and larvae were investigated. Three storage methods and four storage periods were compared with three different sediment types contaminated by heavy metals, polycyclic aromatic hydrocarbons (PAHs) and both contaminants. Freezing and freeze-drying considerably increased the toxicity of decanted sediments and their elutriates as compared to the toxicity obtained with fresh sediments. Concerning the elutriates, the toxicity found with frozen and freeze-dried sediments was correlated with DOC, ammonia and PAH contents. However, the toxicity of fresh sediments kept at 4 degrees C increased with increasing duration of storage and was also correlated with the amount of ammonia in the elutriates.     

Electrochemical monitoring of methylparathion degradation in an acid aqueous medium in presence of Cu(II)

A study was undertaken to determine the effect of Cu(II) in degradation of methylparathion (o,o-dimethyl o,4-nitrophenyl phosphoriotioate) in acid medium. Initial electrochemical characterization of Cu(II) and methylparathion was done in an aqueous medium at a pH range of 2-7. Cu(II) was studied in the presence of different anions and it was observed that its electroactivity depends on pH and is independent of the anion used. Methylparathion had two reduction signals at pH < or = 6 and only one at pH > 6. The pesticide's transformation kinetic was then studied in the presence of Cu(II) in acid buffered aqueous medium at pH values of 2, 4, and 7. Paranitrophenol appeared as the only electroactive product at all three pH values. The reaction was first order and had k values of 5.2 x 10(-3) s(-1) at pH 2, 5.5 x 10(-3) s(-1) at pH 4 and 9.0 x 10(-3) s(-1) at pH 7. It is concluded that the principal degradation pathway of methylparathion in acid medium is a Cu(II) catalyzed hydrolysis reaction.     

Polychlorinated biphenyls and chlorinated pesticides in mussels from the Egyptian Red Sea coast

The residues of 17 organochlorine pollutants were analyzed in bivalve Brachiodontes sp. collected from 11 different locations in April 2000 along the Egyptian Red Sea coast. The pollutants studied were 10 individual polychlorinated biphenyl (PCB) congeners, alpha,alpha,alpha-hexachlorocyclohexane (HCHs), cyclodienes (heptachlor, heptachlorepoxide, aldrin, dieldrin) and dichlorodiphenyltrichloroethanes (DDTs) (p,p'-DDE, p,p'-DDD and p,p'-DDT). The concentration of total DDTs ranged between 125 and 772 ng/g of wet weight whereas the concentration of the PCBs, HCHs and cyclodienes ranged from 6.7 to 66.4 ng/g; 16.2 to 183.4 ng/g and 8.8 to 221.6 ng/g of wet weight, respectively. The levels are low to moderate in relation to the published data from other coastal areas. The present results indicate low to moderate PCBs and pesticides contamination in the investigated mussels except DDTs.     

Photocatalytic and combined anaerobic-photocatalytic treatment of textile dyes

A photocatalytic process based on immobilized titanium dioxide was used to treat crude solutions of azo, anthraquinone and phthalocyanine textile dyes. In addition, the process was applied to the treat autoxidized chemically reduced azo dyes, i.e. representatives of recalcitrant dye residues after biological sequential anaerobic-aerobic treatment. Photocatalysis was able to remove more than 90% color from crude as well as autoxidized chemically reduced dye solutions. UV-absorbance and COD were also removed but to a lower extent (50% in average). The end products of photocatalytic treatment were not toxic toward methanogenic bacteria. The results demonstrate that photocatalysis can be used as a pre- or post-treatment method to biological anaerobic treatment of dye-containing textile wastewater.     

Identification of relevant micropollutants in Austrian municipal wastewater and their behaviour during wastewater treatment

The European Union has defined environmental quality standards (EQSs) for surface waters for priority substances and several other pollutants. Furthermore national EQSs for several chemicals are valid in Austria. The study investigated the occurrence of these compounds in municipal wastewater treatment plant (WWTP) effluents. In a first screening of 15 WWTPs relevant substances were identified, which subsequently were monitored in 9 WWTPs over 1 year (every 2 months). Out of 77 substances or groups of substances (including more than 90 substances) 13 were identified as potentially relevant in respect to water pollution and subjected to the monitoring, whereas most other compounds were detected in concentrations far below the respective EQS for surface waters and therefore not further considered. The preselected 13 compounds for monitoring were cadmium (Cd), nickel (Ni), copper (Cu), selenium (Se), zinc (Zn), diuron, polybrominated diphenyl ethers (PBDEs), di(ethyl-hydroxyl)phthalate (DEHP), tributyltin compounds (TBT), nonylphenoles (NP), adsorbable organic halogens (AOX) and the complexing agents ethylenediaminetetraacetic acid (EDTA) as well as nitrilotriacetic acid (NTA). In the effluents of WWTPs the concentrations of the priority substances Cd, NP, TBT and diuron frequently exceeded the respective EQS, whereas the concentrations for DEHP and Ni were below the respective EQS. The effluent concentrations for AOX, EDTA, NTA, Cu, Se and Zn frequently are in the range or above the Austrian EQS for surface waters. Besides diuron and EDTA all compounds are removed at least partially during wastewater treatment and for most substances the removal via the excess sludge is the major removal pathway. For the 13 compounds which were monitored in WWTP effluents population equivalent specific discharges were calculated. Since for many compounds no or only few information is available, these population equivalent specific discharges can be used to assess emissions from municipal WWTPs to surface waters as well as to make a first assessment of the impact of a discharge on surface waters chemical status. Comparing discharges and river pollution on a load basis, the influence of diffuse sources becomes obvious and therefore should also be taken into consideration in river management.     

Characterization of aluminium-based water treatment residual for potential phosphorus removal in engineered wetlands

Aluminium-based water treatment residual (Al-WTR) is the most widely generated residual from water treatment facilities worldwide. It is regarded as a by-product of no reuse potential and landfilled. This study assessed Al-WTR as potential phosphate-removing substrate in engineered wetlands. Results indicate specific surface area ranged from 28.0 m² g⁻¹ to 41.4 m² g⁻¹. X-ray Diffraction, Fourier transform infrared and energy-dispersive X-ray spectroscopes all indicate Al-WTR is mainly composed of amorphous aluminium which influences its phosphorus (P) adsorption capacity. The pH and electrical conductivity ranged from 5.9 to 6.0 and 0.104 dS m⁻¹ to 0.140 dS m⁻¹ respectively, showing that it should support plant growth. Batch tests showed adsorption maxima of 31.9 mg P g⁻¹ and significant P removal was achieved in column tests. Overall, results showed that Al-WTR can be used for P removal in engineered wetlands and it carries the benefits of reuse of a by-product that promotes sustainability.     

Arsenic species in ecosystems affected by arsenic-rich spring water near an abandoned mine in Korea

The objectives of this study were to quantitatively estimate the distribution of arsenic with its speciation and to identify potential pathways for transformation of arsenic species from samples of water, sediments, and plants in the ecosystem affected by the Cheongog Spring, where As(V) concentration reached levels up to 0.270 mg L⁻¹. After flowing about 100 m downstream, the arsenic level showed a marked reduction to 0.044 mg L⁻¹ (about 84% removal) without noticeable changes in major water chemistry. The field study and laboratory hydroponic experiments with the dominant emergent plants along the creek (water dropwort and thunbergian smartweed) indicated that arsenic distribution, reduction, and speciation appear to be controlled by, (i) sorption onto stream sediments in exchangeable fractions, (ii) bioaccumulation by and possible release from emergent plants, and (iii) transformation of As(V) to As(III) and organic species through biological activities.     

Oxidative dealkylation of five phenylurea herbicides by the fungus CunninghamellaechinulataThaxter

Microorganisms isolated from soil degrade phenylurea herbicides via two major pathways: (i) direct hydrolysis by an amidase leading to N,O-dimethylhydroxylamine, CO₂ and aniline¹ and (ii) N-dealkylation, which has been described as the first step in urea herbicide degradation by a variety of organisms including mammals, plants and microbial systems (for a review see reference 2).Until now no attempts have been made to investigate the mechanism of N-demethylation of substituted ureas in soil microorganisms, due to the instability of the N-hydroxymethyl intermediates. This reaction mechanism has only been described in detail in green plants^3–5. As among soil fungi Phycomycetes are known to demethylate phenylurea herbicides^6,7 this study has been made to identify intermediate hydroxymethyl compounds from urea herbicides, when incubated with the fungus $\text{Cunninghamella echinulata Thaxter}$.     

Effect of depithing on the safety and environmental aspects of bagasse stockpiling

Large scale sugarcane bagasse storage in uncovered stockpiles has the potential to result in adverse impacts on the environment and surrounding communities through hazards associated with nuisance dust, groundwater seepage, spontaneous combustion and generation of contaminated leachates. Managing these hazards will assist in improved health and safety outcomes for factory staff and reduced potential environmental impacts on surrounding communities. Removal of the smaller fibres (pith) from bagasse prior to stockpiling reduced the dust number of bagasse by 50% and modelling suggests peak ground level PM₁₀ dust emissions would reduce by 70%. Depithed bagasse has much lower water holding capacity (～43%) than whole bagasse.This experimental and modelling study investigated the physical properties of depithed and whole bagasse. Dust dispersion modelling was undertaken to determine the likely effects associated with storage of whole and depithed sugarcane bagasse.