Seed yeast cultivation for salad oil manufacturing wastewater treatment

The mixture of five yeast strains obtained from soil could remove about 85% TOC of oil-rich wastewater in batch test.While the highest MLSS was obtained at an N:C of 1:5,the oil removal decreased with the increase of N:C during yeast sludge cultivation.Ammonium chloride was the best nitrogen source for yeast cultivation from the viewpoint of yeast growth and oil utilizxation.An ammonia concentration of over 1300 mg/L led to mass death of yeast at a pH of 5.The ammonia concentration should be controlled at a level of 1000 mg/L or lower.     

MPT—AES法测定矿泉水中硅、镁、钙、锶、钾元素

应用MPT－AES法测定了四种矿泉水中的Si,Mg,Ca,K五种元素，实验证明该方法具有分析速度快，准确度及精密度高等优点。     

可发性聚苯乙烯废水处理工程的设计与运行

介绍了采用中和混凝 水解酸化 生物接触氧化 化学除磷工艺对可发性聚苯乙烯 (EPS)废水的处理工艺。在废水中的CODCr、TP、SS、NH3 N分别为 194 0mg L、112mg L、5 92mg L、2 3 6mg L的条件下 ,废水经过处理后 ,出水CODCr、TP、SS、NH3 N分别为 70mg L、0 38mg L、2 6mg L、0 32mg L ,均可达到《污水综合排放标准》中的一级标准 ,废水中CODCr、TP、SS、NH3 N的平均去除率分别为 96 4 %、99 3%、95 6 %、98 6 %。     

多级环流曝气技术处理工业污水的实验研究

在结构简单、占地面积小、氧利用率高的多级环流曝气小型实验装置上，对某种石油化工排放污水进行了生化处理性能实验。分别利用间歇和连续两种装置进行污水的处理，均得到了良好的试验结果。间歇实验探索了污水降解与系统中溶解氧的变化情况的对比，摸索出了两者之间的初步关系。连续实验表明，污水的停留时间在3-5h时，出水COD可以降到80mg／L以下。     

活性炭性质对其吸附水中硝基苯性能的影响

通过对活性炭进行HNO3氧化及热处理改性,研究了活性炭性质对其吸附硝基苯性能的影响.以低温液氮(N2/77 K)吸附测定活性炭的比表面积和孔容、孔径分布;以Boehm滴定、零电荷点pHPZC的测定及元素分析定量表征活性发表面含氧官能团变化.结果表明:经改性后,活性炭比表面积及总孔容略有减小,表面性质发生较大变化.改性活性炭对硝基苯的吸附容量明显改变,吸附容量大小依次为:AC1′＞AC0′＞AC0＞AC1.经硝酸氧化后,比表面积下降、存在过多表面含氧官能团是导致AC1吸附硝基苯能力降低的主要原因;而AC1'表面适量酚羟基所提供的氢键吸附是其对硝基苯吸附量增加的主要原因.     

英国的人造伊甸园--现代设计改变荒废矿坑

伊甸园引来370万观众 不占用耕地资源,在寸草不生的荒废矿坑建造热带植物园的现代建筑,这不是神话,而是在英国已经建成的现代新景观伊甸园。伊旬园被称为世界最大的脚手架工程,2000年正在施工时,就有50多万人慕名前往观看这个新概念建筑,未及开放,投资人便获得了150万英镑票房收入。最初设计时估算每年有大约150万游客到伊甸园,投资人     

机械强化污泥回流式一体化活性污泥法的运行机理研究

活性污泥通过机械搅拌强化污泥内循环回流,提高了污泥的活性,并且使污泥浓度可达到4.5kg/m3,用该机械强化污泥回流式一体化活性污泥法处理小区生活污水,当水力停留时间为3h,溶解氧为2.2mg/L,机械搅拌速度为250r/min时,CODcr、氨氮去除率均可达到83% 以上,出水达到国家污水排放一级标准.该一体化活性污泥法简单易行,运行成本低,投资小,操作维护方便,是生活小区生活污水适宜的处理工艺技术.     

ZDMC絮凝剂工业应用研究

叙述采用两种复合配方分阶段在炼油厂净化水车间一级浮选池进行工业应用试验，并与车间现用絮凝剂PAFC进行对比，试验结果表明：PAFC20＋ZDMC5的除油效果与PAFC的相当，浮渣产生量比PAFC减少26％，药剂费用低，药剂用量少，值得推广应用。     

减振复合钢板的成形性及其数值模拟研究进展

减振复合钢板是一种应用于汽车覆盖件方面的新型材料 ,有利于减振和减轻重量。介绍了其成形性和成形过程数值模拟的研究进展 ,并对未来发展进行了展望     

Fulvic acid removal by nanoparticle TiO2 using a submerged membrane photocatalysis reactor

The degradation of fulvic acid（FA） by nanoparticle TiO2 in a submerged membrane photocatalysis（SMPC） reactor was studied. In this reactor, photocatalytic oxidation and membrane separation co-occured. The continuous air supplier provided O2 for the photocatalytical reaction and mixed the solution through an airflow controller. The particle TiO2 could automatically settle due to gravity without particle agglomeration so it could be easily separated by microfiltration（MF） membrane. It was efficient to maintain high flux of membranes. The effects of operational parameters on the photocatalytic oxidation rate of FA were investigated. Results indicated that photocatalyst at 0.5 g/L and airflow at 0.06 m^3/h were the optimum condition for the removal of fulvic acid, the removal efficiency was higher in acid media than that in alkaline media. The effects of different filtration duration on permeate flux rate of MF with P25 powder and with nanoparticle TiO2 were compared. Experimental results indicated that the permeate flux rate of MF was improved and the membrane fouling phenomenon was reduced with the addition of nanoparticle TiO2 catalyst compared with conventional P25 powder. Therefore, this submerged membrane photocatalysis reactor can faciliate potential application of photocatalytic oxidation process in drinking water treatment.