Development of low-cost ammonia gas sensors and data analysis algorithms to implement a monitoring grid of urban environmental pollutants

The present study is focused on the implementation of a novel, low cost, urban grid of nanostructured chemresistor gas sensors for ammonia concentration ([NH(3)]) monitoring, with NH(3) being one of the main precursors of secondary fine particulate. Low-cost chemresistor gas sensors based on carbon nanotubes have been developed, their response to [NH(3)] in the 0.17-5.0 ppm range has been tested, and the devices have been properly calibrated under different relative humidity conditions in the 33-63% range. In order to improve the chemresistor selectivity towards [NH(3)], an Expert System, based on fuzzy logic and genetic algorithms, has been developed to extract the atmospheric [NH(3)] (with a sensitivity of a few ppb) from the output signal of a model chemresistor gas sensor exposed to an NO(2), NO(X) and O(3) gas mixture. The concentration of these pollutants that are known to be the most significant interfering compounds during ammonia detection with carbon nanotube gas sensors has been tracked by the ARPA monitoring network in the city of Milan and the historical dataset collected over one year has been used to train the Expert System.     

Evaluation of a portable nephelometer against the Tapered Element Oscillating Microbalance method for monitoring PM(2.5)

Monitoring personal exposure to particle matter (PM(2.5)) in ambient air requires performing measurements using portable monitors. In this work, the portable nephelometer SidePak? AM510 Personal Aerosol Monitor manufactured by TSI Inc. was evaluated against a Tapered Element Oscillating Microbalance (TEOM) equipped with a Filter Dynamics Measurements System (FDMS). Conventionally, the SidePak is calibrated with respect to the Arizona Road Test Dust and then multiplied by an environmental calibration factor to yield mass concentration. To adapt this calibration to specific field conditions, we present an implementation of this calibration by introducing a growing factor correction which takes into account relative humidity and the dry and wet portions of the refractive index estimated from TEOM-FDMS measurements. PM(2.5) sampling with several SidePaks AM510 was carried out in background and rural sites in the Po Valley (Italy). Modeled SidePak data were plotted vs. reference TEOM-FDMS data which show a good agreement.     

Determination of 28 pesticides applied on two tomato cultivars with a different surface/weight ratio of the berries,using a multiresidue GC-MS/MS method

The behavior of 28 pesticides on two tomato cultivars with a different surface/weight (S/W) ratio of the berries (S/W, Birikino vs. Tombola) was studied, in order to provide appropriate indications about their persistence on crops reaching the pre-harvest interval (PHI). Quantitative analysis was performed using a GC MS/MS method. Birikino cv. (BIR) was a “cherry type tomato” with a double S/W ratio compared with Tombola cv. (TOM). The results showed a different pesticide behavior. Azoxystrobin, Boscalid, Bupirimate, Difenoconazole, Etofenprox, Iprodione, Mepanipyrim, Myclobutanil, Tebuconazole, Zoxamide, Metalaxyl M, Pyrimethanil, Tetraconazole, Benalaxyl, Cyprodinil, Fenamidone, Famoxadone and Fludioxonil immediately after treatments showed residues on BIR higher than TOM, and this behavior is consistent with its greater exposed surface. BIR showed higher decay rates of these pesticides during the whole trial, nevertheless residue averages remained higher than TOM reaching the time of harvest. Residues at the PHI were all below their Maximum Residue Levels (MRLs), but data indicated that they could exceed their legal limits especially if the above-mentioned active ingredients were employed more than once per crop cycle on cherry type tomatoes. As regards to Chlorpyrifos, Chlorpyrifos methyl, Triadimenol, Pyridaben and Tebufenpyrad, no different residual behavior related to S/W ratio of the cultivars was observed. Even in this case, residues at the PHI were all below MRLs. As for Cyfluthrin, Deltamethrin, Lambda cyhalothrin, Etoxazole and Cyproconazole, residues were lower than the limit of quantitation (LOQ) of the analytical method just after the treatment, according to their low doses of employment.     

Residues behavior of some fungicides applied on two greenhouse tomato varieties different in shape and weight

The degradation of 12 fungicides (azoxystrobin, cymoxanil, cyproconazole, cyprodinil, fenarimol, fludioxonil, iprovalicarb, mepanipyrim, penconazole, pyrimethanil, tolclofos-methyl, triadimenol), commonly used in pest management strategies on Sardinian greenhouse tomato crops was studied. A different residue behaviour was observed between the studied cultivar. On the smaller, a “cherry” type tomato, field data showed an initial residue mostly higher than the “beefsteak” tomato. In any case, except for penconazole, all pesticide residues were below their maximum residue levels (MRLs) reaching the pre-harvest interval (PHI). On both cultivar, triadimenol and cymoxanil residues completely disappeared reaching their PHI, while iprovalicarb, fenarimol, and fludioxonil disappeared in a time of 17 to 24 days. On the contrary, azoxystrobin, cyproconazole, cyprodinil, penconazole, tolclofos-methyl, mepanipyrim, and pyrimethanil showed a long persistence on both tested cultivar and may have residual problems due to an accumulation effect if repeated field treatments will be performed. The first group of molecules according to their rapid degradation could be used in low pesticide-input management in order to obtain tomatoes with low or no detectable residues.     

Waste collection multi objective model with real time traceability data

Waste collection is a highly visible municipal service that involves large expenditures and difficult operational problems, plus it is expensive to operate in terms of investment costs (i.e. vehicles fleet), operational costs (i.e. fuel, maintenances) and environmental costs (i.e. emissions, noise and traffic congestions). Modern traceability devices, like volumetric sensors, identification RFID (Radio Frequency Identification) systems, GPRS (General Packet Radio Service) and GPS (Global Positioning System) technology, permit to obtain data in real time, which is fundamental to implement an efficient and innovative waste collection routing model. The basic idea is that knowing the real time data of each vehicle and the real time replenishment level at each bin makes it possible to decide, in function of the waste generation pattern, what bin should be emptied and what should not, optimizing different aspects like the total covered distance, the necessary number of vehicles and the environmental impact. This paper describes a framework about the traceability technology available in the optimization of solid waste collection, and introduces an innovative vehicle routing model integrated with the real time traceability data, starting the application in an Italian city of about 100,000 inhabitants. The model is tested and validated using simulation and an economical feasibility study is reported at the end of the paper.     

Serum levels of PCDDs, PCDFs and PCBs in non-occupationally exposed population groups living near two incineration plants in Tuscany, Italy

A pilot study was carried out in Tuscany, Italy, to provide preliminary information on the concentrations of polychlorinated dibenzodioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), dioxin-like polychlorobiphenyls (DL-PCBs), and selected non-dioxin-like PCBs (NDL-PCBs) in groups of subjects living in the vicinity of two incineration plants. Seventy-four volunteers were enrolled from areas identified as under a potential impact from incinerator emissions and from not exposed areas. No significant differences were observed between subjects living in the two types of areas. Total concentrations of PCDDs, PCDFs, and DL-PCBs resulted to be in the range 23-30 pg WHO-TEQ g(-1), lipid base, for subjects in the 27-54 year age groups, while concentrations increased to 40-44 pgTEQ g(-1) for the two 55-67 year age groups. The levels of PCDDs and PCDFs were in good agreement with those observed for unexposed population groups in Italy, while the contribution to total TEQ from DL-PCBs was appreciably higher than those currently observed in the general population in Italy and other countries. As to NDL-PCBs, serum levels of the six "indicator" congeners were in the range 240-300 ng g(-1), lipid base, for subjects in the 27-54 year age groups. A raise in NDL-PCB body burden (430-470 ng g(-1), lipid base) was observed for the two 55+ year age groups, in agreement with the expected age-dependent increase. The findings from this study do not show an incremental exposure to PCDDs and PCDFs in the samples from subjects living around the two incineration plants, whereas PCB congener profiles in all samples suggest a possible impact on the area of interest of industrial activities from near industrial settlements.     

Different compensatory mechanisms in two metal-accumulating aquatic macrophytes exposed to acute cadmium stress in outdoor artificial lakes

Mechanisms underlying cadmium (Cd) detoxification were compared in two aquatic macrophytes commonly used in phytoremediation, namely Pistia stratiotes L. and Eichhornia crassipes (Mart.) Solms. To simulate Cd pollution in the open environment, plants growing in outdoor artificial lakes were exposed for 21d to either 25 or 100microM Cd, in two consecutive years. Toxicity symptoms were absent or mild in both species. Metal accumulation was much higher in the roots of P. stratiotes, whereas in E. crassipes a comparatively higher fraction was translocated to the leaves. In both species, Cd was neither included in phenolic polymers or Ca-oxalate crystals, nor altered the levels of Cd-complexing organic acids. Glutathione levels were constitutively remarkably higher and much more responsive to Cd exposure in P. stratiotes than in E. crassipes. Abundant phytochelatin synthesis occurred only in P. stratiotes, both in roots and in leaves. In E. crassipes, on the other side, the constitutive levels of some antioxidant enzymes and ascorbate were higher and more responsive to Cd than in P. stratiotes. Thus, in these two aquatic plants grown in the open, different detoxification mechanisms might come into play to counterbalance Cd acute stress.     

Postconsumer polyethylene terephthalate (PET)/polyolefin blends through reactive processing

Increasing awareness of environmental and energy problems has promoted greater governmental interest in selected waste collection and consequently has attracted the interest of several research groups to the challenge of converting recovered plastics into useful materials. The reactive blending of postconsumer polyethylene terephthalate (PET) with different polyolefins (PO) was studied in attempts to obtain a new material with enhanced properties with respect to the starting materials. The success of the project depends mainly on the possibility of obtaining a compatibilized blend between two starting polymers that, from chemical and thermomechanical viewpoints, are very different. This was approached by employing polyolefins bearing functional groups capable of specific interaction or chemical reaction with PET end groups. Ternary blends of very low density polyethylene (VLDPE)/PET/functionalized polyolefin (FPO) in a weight composition of 70/20/10 and binary blends of FPO/PET in a weight composition of 90/10 were prepared and studied to obtain reinforced polyolefin thermoplastic materials. Reactive blending was achieved in a Brabender Plastograph with a mixing chamber of 30 or 50cm³, at 250°C, and 40rpm for 10min. Differential scanning calorimetry, scanning electron microscopy, and tensile tests were used to investigate the phase behavior, the efficiency of compatibilization, and the mechanical properties of the blends.     

Estimating the magnitude of morphoscapes: how to measure the morphological component of biodiversity in relation to habitats using geometric morphometrics

Ecological indicators are currently developed to account for the different facets of loss of biological diversity due to direct or indirect effects of human activities. Most ecological indicators include species richness as a metric. Others, such as functional traits and phylogenetic diversity, account for differences in species, even when species richness is the same. Here, we describe and apply a different indicator, called morphoscape dimension, accounting for morphological variability across habitats in a geographical region. We use the case of ground beetles (Coleoptera: Carabidae) in four different habitats in the Po Plain in Northern Italy to exemplify how to quantify the magnitude of the morphological space (i.e. the dimension of the morphoscape) occupied by the species in each habitat using geometric morphometrics. To this aim, we employed a variety of metrics of morphological disparity related to univariate size, and more complex multivariate shape and form. Our ‘proof of concept’ suggests that metrics assessing size and form might largely tend to simply mirror the information provided by species richness, whereas shape morphoscape disparity may be able to account for non-trivial differences in species traits amongst habitats. This is indicated by the woodland morphoscape being on average bigger than that of crops, the most species-rich habitat, despite having almost 20% less species. We conclude suggesting that the analysis of morphoscape dimension has the potential to become a new additional and complimentary tool in the hands of conservation biologists and ecologists to explore and quantify habitat complexity and inform decisions on management and conservation based on a wide set of ecological indicators.