Comparison of homologous and heterologous formats in nanocolloidal gold-based immunoassays for parathion residue determination

The effectiveness of homologous and heterologous formats in a nanocolloidal gold-based immunoassay for pesticide residue determination was investigated. Parathion, one of the most toxic organophosphorus pesticides, was used as the target analyte. One-step homologous and heterologous test strips based on a nanocolloidal gold-labeled monoclonal antibody were developed for the rapid detection of parathion residues. The results showed that the heterologous format was more effective than the homologous format, being more sensitive, more specific to parathion and more tolerant of matrix interferences. The best competitive hapten was found to have a moderate heterology and the opposite electronic distribution to the immunizing hapten. The detection limits for parathion using the preferred heterologous strip were 1 μg/L in water samples and 5 μg/kg in soil and food samples.     

Speciation distribution and mass balance of copper and zinc in urban rain, sediments, and road runoff

Heavy metal pollution in road runoff had caused widespread concern since the last century. However, there are little references on metal speciation in multiple environmental media (e.g., rain, road sediments, and road runoff). Our research targeted the investigation of metal speciation in rain, road sediments, and runoff; the analysis of speciation variation and mass balance of metals among rain, road sediments, and runoff; the selection of main factors by principal component analysis (PCA); and the establishment of equation to evaluate the impact of rain and road sediments to metals in road runoff. Sequential extraction procedure contains five steps for the chemical fractionation of metals. Flame atomic absorption spectrometry (Shimadzu, AA-6800) was used to determine metal speciation concentration, as well as the total and dissolved fractions. The dissolved fractions for both Cu and Zn were dominant in rain. The speciation distribution of Zn was different from that of Cu in road sediments, while speciation distribution of Zn is similar to that of Cu in runoff. The bound to carbonates for both Cu and Zn in road sediments were prone to be dissolved by rain. The levels of Cu and Zn in runoff were not obviously influenced by rain, but significantly influenced by road sediments. The masses for both Cu and Zn among rain, road sediments, and road runoff approximately meet the mass balance equation for all rainfall patterns. Five principal factors were selected for metal regression equation based on PCA, including rainfall, average rainfall intensity, antecedent dry periods, total suspended particles, and temperature. The established regression equations could be used to predict the effect of road runoff on receiving environments.     

Fe-MCM-41催化氧化2,4-二氯苯氧乙酸

采用水热法合成了Fe-MCM-41中孔分子筛,紫外、红外及XRD表征显示铁离子已进入中孔分子筛骨架。以H2O2为氧化剂形成类Fenton试剂,实验结果表明,在催化剂加入量为1 g/L、H2O2体积分数为6%、pH为4、反应时间为10h、反应温度为35℃的条件下,处理质量浓度为50 mg/L的2,4-D废水的降解率达94.95%。宏观动力学研究显示,该反应近似为一级反应,反应速率常数、表观活化能分别为0.21667 min-1和26.65 kJ/mol。     

Subcellular distribution and toxicity of cadmium in Potamogeton crispus L

The submerged macrophyte Potamogeton crispus L. was subjected to varying doses of cadmium (0, 20, 40, 60 and 80 μM) for 7 d, and the plants were analyzed for subcellular distribution of Cd, accumulation of mineral nutrients, photosynthesis, oxidative stress, protein content, and ultrastructural distribution of calcium (Ca). Leaf fractionation by differential centrifugation indicated that 48-69% of Cd was accumulated in the cell wall. At all doses of Cd, the levels of Ca and B rose and the level of Mn fell; the levels of Fe, Mg, Zn, Cu, Mo, and P rose initially only to decline later. Exposure to Cd caused oxidative stress as evident by increased content of malondialdehyde and decreased contents of chlorophyll and protein. Photosynthetic efficiency, as indicated by the quenching of chlorophyll a fluorescence (Fv/Fm, Fo and Fm), decreased significantly, the extent of decrease being directly proportional to the concentration of Cd. Increased amounts of precipitates of calcium were noticed in the treated plants, located either outside the cell membrane or in chloroplasts, mitochondria, the nucleus, and the cytoplasm whereas control plants showed small deposits of the precipitates around surface of the vacuole membrane and in the intercellular space but rarely in the cytoplasm. Photosynthetic efficiency and oxidative stress could be used as indicators of physiological end-points in determining the extent of Cd phytotoxicity.     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

无硫膨胀石墨的制备及吸油性能

通过单因子实验考察了无硫膨胀石墨制备过程中氧化剂及插层剂用量、氧化反应及插层反应时间、氧化反应及插层反应温度对无硫膨胀石墨膨胀体积的影响。通过正交实验确定了制备无硫膨胀石墨的最优条件是:石墨(g)∶浓硝酸(mL)∶30%H2O2(mL)∶乙酸酐(mL)=1∶2.25∶0.25∶0.6,在30℃条件下氧化反应60 min,加入插层剂后在60℃条件下插层反应90 min,此条件无硫膨胀石墨的膨胀体积达317 mL/g使用XPS、FT-IR、XRD和SEM对无硫膨胀石墨进行了表征并对其吸油性能和再生性能进行了研究。结果表明,所制备无硫膨胀石墨对原油和柴油的最大吸附量分别为66.3 g/g和62.7 g/g。吸附原油后的无硫膨胀石墨抽滤再生后首次再生率为49.1%,原油的回收率为64.5%。     

Source apportionment of fine particles in Tennessee using a source-oriented model

Source apportionment of fine particles (PM2.5, particulate matter < 2 microm in aerodynamic diameter) is important to identify the source categories that are responsible for the concentrations observed at a particular receptor. Although receptor models have been used to do source apportionment, they do not fully take into account the chemical reactions (including photochemical reactions) involved in the formation of secondary fine particles. Secondary fine particles are formed from photochemical and other reactions involving precursor gases, such as sulfur dioxide, oxides of nitrogen, ammonia, and volatile organic compounds. This paper presents the results of modeling work aimed at developing a source apportionment of primary and secondary PM2.5. On-road mobile source and point source inventories for the state of Tennessee were estimated and compiled. The national emissions inventory for the year 1999 was used for the other states. U.S. Environmental Protection Agency Models3/Community Multi-Scale Air Quality modeling system was used for the photochemical/secondary particulate matter modeling. The modeling domain consisted of a nested 36-12-4-km domain. The 4-km domain covered the entire state of Tennessee. The episode chosen for the modeling runs was August 29 to September 9, 1999. This paper presents the approach used and the results from the modeling and attempts to quantify the contribution of major source categories, such as the on-road mobile sources (including the fugitive dust component) and coal-fired power plants, to observed PM2.5 concentrations in Tennessee. The results of this work will be helpful in policy issues targeted at designing control strategies to meet the PM2.5 National Ambient Air Quality Standards in Tennessee.     

射流曝气周期活性污泥法脱氮除磷研究

针对零星居民点的污水处理,开发了射流曝气周期活性污泥法工艺.它是一种连续进水、周期性间歇曝气的改良型SBR工艺,也是一种时间程序和空间程序相结合的污水处理工艺,具有良好的脱氮除磷效果.试验表明,在水力负荷4 m3/d,曝气周期为每2 h曝气15 min、静置105 min的条件下,出水COD为48.8～53.5 mg/L,去除率达79.4%～80.5%;出水TN为2.81～3.98 mg/L,去除率达82.4%～89.4%;出水NH3-N为0.36～0.78 mg/L,去除率高达96.4%～98.4%;出水TP为0.63～1.18 mg/L,去除率为67.2%～78.9%,均可达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)中的一级B排放标准.     

啤酒生产废水处理设计及运行研究

分析了年产15万t啤酒的生产废水情况,介绍了采用IC厌氧反应器-一体化氧化沟处理该生产废水(7 200 m3/d)的工艺路线和主要设计参数,讨论了废水处理系统的运行情况.其中IC厌氧反应器的HRT为8 h,运行温度为35～37 ℃;一体化氧化沟包括氧化沟段和沉淀池段,总尺寸为40 m×24 m×6 m.IC厌氧反应器COD容积负荷在7.78 kg/(m3·d)时,COD去除率为84%左右.整套废水处理系统的COD总去除率为98%左右,出水COD小于80 mg/L.厌氧所产生的沼气可用于废水的升温.     

The concentrations and distribution of polycyclic musks in a typical cosmetic plant

Polycyclic musks [cashmeran (DPMI), celestolide (ADBI), phantolide (AHMI), traseolide (ATII), tonalide (AHTN) and galaxolide (HHCB)] in the air, wastewater, sludge samples of a typical cosmetic plant were analyzed. DPMI, ADBI, HHCB and AHTN were found in all samples, and ATII was not found in any sample. HHCB and AHTN were the major components in all samples. The polycyclic musk concentrations were very high in the air of the cosmetic plant, and polycyclic musks were mostly contained in the gas phase at the percentage of 86.35-97.70%. Average polycyclic musk concentrations in effluent were high, and ranged from 0.62 to 32.06 microgl-1. The removal efficiency during the active sludge wastewater treatment was also high, resulting from the adsorption of those compounds into the sludge. So the polycyclic musk concentrations were very high in the primary sludge and second sludge, and ranged from 1.78 to 92.45 mgkg-1 (dry), and from 2.87 to 65.67 mgkg-1 (dry), respectively. Results suggested that the sludge needed to be further treated to make polycyclic musks less influence to the environment.