蒙脱土原位生长MoS2复合材料光催化降解罗丹明B的机理研究

通过在Na⁺-MMT表面生长MoS₂来提高窄带隙半导体光生电子分离速率及稳定性.利用阳离子填充法及水热法成功制备了复合光催化剂Na⁺-MMT/MoS₂,并通过FT-IR、SEM、TEM、Raman、XRD、TG、XPS、UV-DRS和ESR等表征进一步证明了材料的成功负载及光、电化学性能. 同时,以有机染料罗丹明B为待降解染料来评价光催化剂的催化性能,发现其在80 min可有效降解罗丹明B,降解率达96%.经过5次循环使用后,Na⁺-MMT/MoS₂复合光催化剂仍具有较好的光催化性能.因此,利用MMT的表面电负性及稳定的片层结构负载MoS₂,可形成光生电子迁移通道进一步提高电荷迁移速率及光催化剂的稳定性.本研究可为黏土材料调控窄带隙半导体制备环境友好型光催化剂提供新思路.     

森林保险支付意愿及影响因素分析——基于异质性营林主体视角

基于期望效用函数理论分析了异质性营林主体的森林保险支付意愿及差异,并以传统小林农和新型林业经营主体为研究对象,以福建省382户传统小林农和88户新型林业经营主体的调研数据为基础,综合运用条件估值法、卡方检验及Cox比例风险模型,对异质性营林主体的森林保险支付意愿与差异及支付意愿影响因素进行对比与分析。研究表明：传统小林农和新型林业经营主体的森林保险意愿支付水平存在显著差异,在1000~2500元/亩保障水平下,传统小林农的意愿支付水平分别为1.911元/亩、2.941元/亩、3.532元/亩及3.979元/亩,新型林业经营主体为1.632元/亩、3.971元/亩、5.809元/亩及6.864元/亩;两类营林主体的支付意愿均随保额的提高而提高,但新型林业经营主体的提升幅度远高于小林农。异质性营林主体的森林保险支付意愿影响因素也存在明显差别,这与其在森林保险认知特征、林业生产经营特征、林业灾损特征、森林保险产品评价特征等方面存在显著差异有关。此外,林地面积对两类营林主体支付意愿均具有显著影响,规模化、集约化的林业生产经营可促进林业经营主体的森林保险愿意支付水平。     

Enhancing anoxic denitrification of low C/N ratio wastewater with novel ZVI composite carriers

External organic carbon sources are needed to provide electron donors for the denitrification of wastewater with a low COD/NO₃^--N（C/N） ratio, increasing the treatment cost. The economic strategy is to enhance the bioactivity and/or biodiversity of denitrifiers to efficiently utilize organic substances in wastewater. In this study, novel zero-valent iron（ZVI） composite carriers were prepared and implemented in a suspended carrier biofilm reactor to enhance the bioactivity an...     

我国沿海地区水污染区域治理探讨

本文分析了我国当前水污染区域治理的难度，沿海地区水污染的主要问题，探讨了污染区域治理的基本原则，提出了水污染治理的重点区域和水污染区域治理的主要途径，并以浑河流域沈阳地区２０００年水污染物总量控制为例，概述总量控制方法和目标     

中国农业可持续发展的策略措施

中国农业经历了多种策略阶段,可持续发展策略是新近出现的最先进、最适合现在和将来农业发展的策略。新策略带有系统性原理,其实质是发展与生态环境保护协调的农业。因此,可持续发展措施应同时重视解决农业经济发展与生态环境保护两方面的问题。据此,本文提出了六项措施。     

Daily Bank Erosion Rates in the Lower Yellow River Before and After Dam Construction

During the period of water impoundment and sediment detention of the Sanmenxia Reservoir, riverbank erosion processes played a key role in the channel evolution of the Lower Yellow River (LYR). However, research into bank erosion rates of the LYR has been neglected due to the lack of direct field monitoring. In this study, an indirect method is proposed to determine bank erosion rates at daily time scales by outlining a detailed calculation procedure using measured hydrological data. A total of 810 data points of daily bank erosion rates before and after the construction of Sanmenxia Dam was calculated at seven hydrometric sections along the LYR, with the corresponding values of the bank stability coefficient and the width‐to‐depth ratio also being calculated. Empirical relations were then developed to estimate the daily bank erosion rates, using these parameters at the sections. Temporal and spatial variability in daily bank erosion rates in the LYR before and after dam construction were also investigated, revealing that: (1) the bank erosion rates had a mean value of 16.7‐29.1 m/day in the braided reach, with a maximum value of 290.0 m/day, while they were relatively low in the meandering reach, with a mean value of 2.5 m/day; (2) the erosion rates before dam construction were slightly greater than those after dam construction, with the difference reaching 5‐10 m/day in the braided reach, decreasing in the transitional reach gradually, and being slight in the meandering reach.     

车载接地装置的冲击接地阻抗研究

为解决车载装置在不同路面的接地问题,我们研制了可迅速安装和撤收的便携式接地装置,并选取一种组合在不同岩土介质地面上进行了实验,测得各自的冲击接地阻抗。然后,采用时域有限差分法对实验装置进行了数值分析,得出了该接地装置冲击接地阻抗的时域特性。与实验结果进行对比的结果表明,两者具有较好的一致性。     

北京夏季灰霾天臭氧近地层垂直分布与边界层结构分析

后奥运时期首都北京的空气质量被更加关注,尤其是对于灰霾天与光化学复合污染的状况,而近地层数百米高度内的大气污染物与大气物理参数垂直分布观测对于空气质量变化过程评估至关重要.因此,本研究于2009年8月1-16日,在北京市325 m气象塔进行了相应的立体观测,观测平台垂直分布在距离地面高度8、47、120和280 m四层中.同时,在近地面320 m高度以内,分15层分别观测了大气温度、湿度、风速、风向.另外,使用气溶胶后向散射云高仪观测了边界层2.5 km内气溶胶后向散射系数.利用垂直分层的O3数据与边界层物理观测数据并结合天气形势、后向轨迹模式等方法,综合分析了本次观测数据之间的相互关系和内在联系.结果表明:夏季西北部低压槽控制的北京区域不利于低空大气扩散,容易形成光化学污染叠加灰霾污染,污染形成时白天地面小时最大φ(O3)可达120×10-9,280 m高度处可达155×10-9;来自西北偏西的气流一般较为干净,有利于北京污染物的清除,而来自西南和偏南的气流使北京的O3污染加重,导致区域性高浓度O3污染;在稳定天气条件下,夜间残留层与地面的φ(O3)差别越大,次日光化学生成的φ(O3)起点越高,表明残留层O3在次日混合层抬升过程中卷夹到地面,影响地面空气质量;300 m以内的近地层,在50 m高度左右存在φ(O3)变化程度剧烈层,这是城市冠层界面与大气化学反应共同作用的结果.     

Modification of Thermo-Mechanical Properties of Recycled PET by Vinyl Acetate (VAc) Monomer Grafting Using Gamma Irradiation

Vinyl acetate (VAc) monomer of different percentage was grafted onto the recycled polyethylene terephthalate (r-PET) films using gamma irradiation. The properties of these modified films were characterized by Fourier transform infrared spectroscopy (FTIR), mechanical properties testing (Tensile strength, Elongation at break), dynamic mechanical analysis (DMA) and thermo-gravimetric analysis (TGA). The Tensile Strength (TS) of the modified PET film increased by 132.25?% to the highest value of 50.12 MPa at 15% VAc monomer concentration at 3 kGy gamma dose, while the elongation at break (EB) decreased by 31.83?%. FTIR was used to investigate the molecular interaction of the modified films. TGA revealed that curve of the modified PET film shifted toward higher temperature region by 95?°C, which is very close to that of PET film made from virgin flakes. The results indicate that modified PET films of better mechanical and thermal properties were successfully prepared using VAc monomer grafting by gamma irradiation technique.     

Utilization of Industrial Wastes from Mining and Packaging Industries in Wood-Plastic Composites

The manufacturing industry produces a lot of different by-products and waste. In this research, the utilization of different industrial wastes as a part of wood-plastic composites was tested. Limestone waste and carton cutting waste were tested by replacing part of the reinforcing fibers of the composite with these materials. The materials were made with the extrusion process, and they were tested for their mechanical properties, water absorption and thickness swelling. The materials were also viewed with a scanning electron microscope. The results showed that both industrial wastes affected the properties of the composite. Mining waste in the composite improved the moisture properties, impact strength and hardness of the material. Carton cutting waste improved the impact strength remarkably.