Calcite-seeded crystallization of calcium phosphate for phosphorus recovery

For phosphorus recovery from wastewater, the present paper aims at understanding the crystallization of calcium phosphate by using calcites (Juraperle and Coccolith) as seeds from hard water. Synthetic hard water with 60 mgCl(-1) carbonate and 10 mgPl(-1) phosphate was prepared and used in the batch experiments of calcite-seeded crystallization. The solution composition was measured throughout the batch crystallization process, and the corresponding saturation indices with respect to the minerals were calculated with PHREEQC Program. The surface of the calcite seeds was observed and measured with environmental scanning electron microscopy (ESEM), Fourier transform infrared (FTIR) and BET method. The studies show that both calcites are effective seeds for the crystallization of calcium phosphate from hard water; the used calcites are more efficient than the original ones because newly formed crystals with calcium phosphate have covered their surfaces. The studies show that the calcite seeds can be used for phosphorus recovery from hard waters.     

3种不同基质潜流湿地对磷的去除效果

基质是潜流式人工湿地污水处理系统的重要组成部分，直接影响到系统的处理效果。本文研究了由沸石、页岩陶粒和碎石3种不同基质构建的潜流式人工湿地对磷的去除效果。结果表明，在设计水力停留时间3d，连续进出水情况下，碎石单元对磷的去除效果最好，页岩陶粒单元次之，沸石单元效果最差，平均去除率分别为95％、60％和35％。在潜流式人工湿地污水处理系统运行初期观察到磷释放现象，沸石单元最为明显。进水磷浓度较低时，磷的去除率随浓度升高而升高，当正磷、总磷浓度分别升高到2．4—2．5和3．1～3．3mg／L时，正磷、总磷的去除率开始迅速下降。     

一种新型复合球填料在低浓度污水再生回用中的应用研究

新型复合球填料为沸石与悬浮球填料的有机组合体,密度约为0.92～0.97g/cm3,比表面积为711～1185m2/m3,表面粗糙,物化性能稳定.在曝气量为20∶1,停留时间为6 h时,装有新型复合球填料的反应柱挂膜容易,成膜时间短,膜不易脱落,且生物相丰富.膜成熟时对生活污水中的氨氮和COD都有很好的去除效果,出水氨氮浓度≤2 mg/L,去除率≥93%;出水COD浓度≤22 mg/L,去除率≥80%.新型复合球反应柱在稳定状态处理低浓度的二级出水时,出水氨氮浓度≤2 mg/L,去除率≥89%,出水COD浓度为10～36 mg/L,去除率为48%～81%.出水水质符合GB50335-2002标准.     

Insights into aqueous carbofuran removal by modified and non-modified rice husk biochars

Biochar has been considered as a potential sorbent for removal of frequently detected pesticides in water. In the present study, modified and non-modified rice husk biochars were used for aqueous carbofuran removal. Rice husk biochars were produced at 300, 500, and 700 °C in slow pyrolysis and further exposed to steam activation. Biochars were physicochemically characterized using proximate, ultimate, FTIR methods and used to examine equilibrium and dynamic adsorption of carbofuran. Increasing pyrolysis temperature led to a decrease of biochar yield and increase of porosity, surface area, and adsorption capacities which were further enhanced by steam activation. Carbofuran adsorption was pH-dependant, and the maximum (161 mg g^?1) occurred in the vicinity of pH 5, on steam-activated biochar produced at 700 °C. Freundlich model best fitted the sorption equilibrium data. Both chemisorption and physisorption interactions on heterogeneous adsorbent surface may involve in carbofuran adsorption. Langmuir kinetics could be applied to describe carbofuran adsorption in a fixed bed. A higher carbofuran volume was treated in a column bed by a steam-activated biochar versus non-activated biochars. Overall, steam-activated rice husk biochar can be highlighted as a promising low-cost sustainable material for aqueous carbofuran removal.     

Bringing together raptor collections in Europe for contaminant research and monitoring in relation to chemicals regulations

Raptors are good sentinels of environmental contamination and there is good capability for raptor biomonitoring in Europe. Raptor biomonitoring can benefit from natural history museums (NHMs), environmental specimen banks (ESBs) and other collections (e.g. specialist raptor specimen collections). Europe’s NHMs, ESBs and other collections hold large numbers of raptor specimens and samples, covering long periods of time. These collections are potentially a valuable resource for contaminant studies over time and space. There are strong needs to monitor contaminants in the environment to support EU and national chemical management. However, data on raptor specimens in NHMs, ESBs and other collections are dispersed, few are digitised, and they are thus not easy to access. Specimen coverage is patchy in terms of species, space and time. Contaminant research with raptors would be facilitated by creating a framework to link relevant collections, digitising all collections, developing a searchable meta-database covering all existing collections, making them more visible and accessible for contaminant research. This would also help identify gaps in coverage and stimulate specimen collection to fill gaps in support of prioritised contaminant monitoring. Collections can further support raptor biomonitoring by making samples available for analysis on request.     

The effects and the toxicity increases caused by bicarbonate,chloride, and other water components during the UV/TiO<Subscript>2</Subscript> degradation of oxazaphosphorine drugs

The influences of HCO₃ ^?, Cl^?, and other components on the UV/TiO₂ degradation of the antineoplastic agents ifosfamide (IFO) and cyclophosphamide (CP) were studied in this work. The results indicated that the presence of HCO₃ ^?, Cl^?, NO₃ ^?, and SO₄ ^2? in water bodies resulted in lower degradation efficiencies. The half-lives of IFO and CP were 1.2 and 1.1 min and increased 2.3–7.3 and 3.2–6.3 times, respectively, in the presence of the four anions (initial compound concentration = 100 μg/L, TiO₂ loading =100 mg/L, anion concentration = 1000 mg/L, and pH = 8). Although the presence of HCO₃ ^? in the UV/TiO₂/HCO₃ ^? system resulted in a lower degradation rate and less byproduct formation for IFO and CP, two newly identified byproducts, P11 (M.W. = 197) and P12 (M.W. = 101), were formed and detected, suggesting that additional pathways occurred during the reaction of ?CO₃ ^? in the system. The results also showed that ?CO₃ ^? likely induces a preferred ketonization pathway. Besides the inorganic anions HCO₃ ^?, Cl^?, NO₃ ^?, and SO₄ ^2?, the existence of dissolved organic matter in the water has a significant effect and inhibits CP degradation. Toxicity tests showed that higher toxicity occurred in the presence of HCO₃ ^? or Cl^? during UV/TiO₂ treatment and within 6 h of reaction time, implying that the effects of these two anions should not be ignored when photocatalytic treatment is applied to treat real wastewater.     

Investigation of low-level <Superscript>242</Superscript>Pu contamination on nutrition disturbance and oxidative stress in <Emphasis Type="Italic">Solanum tuberosum</Emphasis> L.

Plutonium associated with higher molecular weight molecules is presumed to be poorly mobile and hardly plant available. In our present study, we investigate the uptake and effects of Pu treatments on Solanum tuberosum plants in amended Hoagland medium at concentrations of [²⁴²Pu] = 100 and 500 nm, respectively. We found a direct proof of oxidative stress in the plants caused by these rather low concentrations. For the confirmation of oxidative stress, we explored the production of nitric oxide (NO) and hydrogen peroxide (H₂O₂) by epifluorescence microscopy. Oxidative stress markers like lipid peroxidation and superoxide radicals (O₂ ^??) are monitored through histochemical analysis. The biochemical parameters i.e. chlorophyll and carotenoids are measured as an indicator of cellular damage in the tested plants including the enzymatic parameters such as catalase and glutathione reductase. From our work, we conclude that Pu in low concentration has no significant effects on the uptake of many trace and macroelements. In contrast, the content of O₂ ^?? , malondialdehyde (MDA), and H₂O₂ increases with increasing Pu concentration in the solution, while the opposite effects was found for NO, catalase, and glutathione reductase. These findings prove that even low concentration of Pu regulates ROS production and generate oxidative stress in S. tuberosum L.     

Application of chemical oxidation to remediate HCH-contaminated soil under batch and flow through conditions

This is the first study describing the chemical oxidation of hexachlorocyclohexanes (HCHs) in contaminated soil under water saturated and unsaturated flow through conditions. Soil contaminated with β-HCH (45 mg kg^?1) and γ-HCH (lindane, 25 mg kg^?1) was sampled from former lindane waste storage site. Efficiency of following treatments was tested at circumneutral pH: H₂O₂ alone, H₂O₂/Fe^II, Na₂S₂O₈ alone, Na₂S₂O₈/Fe^II, and KMnO₄. Experimental conditions (oxidant dose, liquid/solid ratio, and soil granulometry) were first optimized in batch experiments. Obtained results revealed that increasing dose of H₂O₂ improved the oxidation efficiency while in Na₂S₂O₈ system, maximum HCHs were removed at 300 mM. However, oxidation efficiency was slightly improved by Fe^II-activation. Increasing the solid/liquid ratio decreased HCH removal in soil samples crushed to 500 μm while an opposite trend was observed for 2-mm samples. Dynamic column experiments showed that oxidation efficiency followed the order KMnO₄ > Na₂S₂O₈/Fe^II > Na₂S₂O₈ whatever the flow condition, whereas the removal extent declined at higher flow rate (e.g., ~50% by KMnO₄ at 0.5 mL/min as compared to ~30% at 2 mL/min). Both HCH removal and oxidant decomposition extents were found higher in saturated columns than the unsaturated ones. While no significant change in relative abundance of soil mineral constituents was observed before and after chemical oxidation, more than 60% of extractable organic matter was lost after chemical oxidation, thereby underscoring the non-selective behavior of chemical oxidation in soil. Due to the complexity of soil system, chemical oxidation has rarely been reported under flow through conditions, and therefore our findings will have promising implications in developing remediation techniques under dynamic conditions closer to field applications.     

Assessing demineralization treatments for PVC effluent reuse in the resin polymerization step

To reduce fresh water consumption in a polyvinyl chloride (PVC) plant, the effluent from a biological treatment must be demineralized to be re-used in the resin polymerization process. Demineralization is a critical process, since the quality and the stability of the PVC resins are highly influenced by the water quality used in the process. The main target values for water parameters are the following: conductivity <10 μScm^?1, TOC < 10 mg L^?1, and Al < 0.1 mg L^?1. To achieve this quality, several reverse osmosis membranes from different materials and suppliers were tested and compared in the demineralization treatment. Polyamide membranes showed higher salt rejection compared to cellulose acetate membranes yielding both types similar flux and permeability. Two-pass reverse osmosis treatment was necessary to reach conductivities lower than 10 μS cm^?1. On the other hand, a good quality effluent for reuse was obtained by combining RO and ionic exchange resins. Results showed that good quality PVC resins in terms of color, granulometry, porosity, and bulk density were obtained when demineralized water from two-pass reverse osmosis was used as fresh water, proving the feasibility of the effluent reuse in the PVC industry.     

Changes of foraging patch selection and utilization by a giant panda after bamboo flowering

Environmental Science and Pollution Research - The bamboo flowering leads to the habitat fragmentation and food quality decline of a giant panda. Few empirical research has been conducted about the...