Superior photodecomposition of pyrene by metal ion-loaded TiO₂ catalyst under UV light irradiation

BACKGROUND: The photocatalytic degradation of pyrene under UV (125 W Hg-Arc, 10.4 mW/cm2) irradiation of TiO2 aqueous suspension has been found to be highly improved with the dissolved transition metal ions like Cu2+, Fe3+, Ag+, and Au3+, etc. As the reduction potential of these metals lies below the conduction band (CB) position (?0.1 eV) of TiO2, the photoexcited electron transfer occurs more readily and reduces electron–hole recombination rate. Therefore, it has a beneficial influence on the photocatalytic ability of TiO2 because of rapid Fermi energy equilibrium between the CB of TiO2 and its surface adsorbed metal ions. RESULTS AND DISCUSSION: The Fermi level is referred to as the electrochemical potential and plays an important role in the band theory of solids. When metal and semiconductor are in contact, electron migration from photoirradiated semiconductor to the deposited metal occurs at the interface until two Fermi levels equilibrate and enhanced the photocatalytic activity of semiconductor photocatalyst. Ni2+ having more negative reduction potential (?0.25 eV) than the CB of TiO2 imparts negligible co-catalytic activity to TiO2 photoreaction. It also revealed that loading of Au3+ ions displayed higher degradation rate of pyrene than Au photodeposition. Furthermore, when the amount of dissolved Fe+3 and Au3+ ions gradually increases from 0.1 to 2 wt.%, the pyrene photodecomposition rate also become faster.     

Zerovalent iron encapsulated chitosan nanospheres - a novel adsorbent for the removal of total inorganic arsenic from aqueous systems

Evaluation of Chitosan zerovalent Iron Nanoparticle (CIN) towards arsenic removal is presented. Addition of chitosan enhances the stability of Fe(0) nano particle. Prepared adsorbent was characterized by FT-IR, SEM EDX, BET and XRD. It was found that, with an initial dose rate of 0.5 g L⁻¹, concentrations of As (III) and As (V) were reduced from 2 mg L⁻¹ to <5 μg L⁻¹ in less than 180 min and the adsorbent was found to be applicable in wide range of pH. Langmuir monolayer adsorption capacity was found to be 94 ± 1.5 mg g⁻¹ and 119 ± 2.6 mg g⁻¹ at pH 7 for As (III) and As (V) respectively. Major anions including sulfate, phosphate and silicate did not cause significant interference in the adsorption behavior of both arsenite and arsenate. The adsorbent was successfully recycled five times and applied to the removal of total inorganic arsenic from real life groundwater samples.     

Controlled release of thiram fungicide from starch-based hydrogels

In order to make the judicious use of thiram fungicide and to exploit the potential of agri-polymers, we have developed the starch- poly(acrylamide) and starch-poly(acrylic acid) based agrichemical delivery system (hydrogels) for its controlled and sustained release. Polymeric networks have been prepared by using N,N'-methylenebisacrylamide (N,N-MBAAm) as crosslinker and ammonium persulfate (APS) as initiator and characterized by Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA) and swelling studies. Release dynamics of thiram fungicide from polymeric matrices has been studied for the evaluation of the diffusion mechanism and diffusion coefficients. It has been established that Non-Fickian diffusion mechanism has occurred for the release of thiram from these polymeric matrices. Furthermore, the initial rate of diffusion of thiram from these polymeric matrices is more as compared to the late stages of diffusion, which is analogous to the trends obtained for the diffusion of water molecules from these polymer matrices.     

A simple chemical free arsenic removal method for community water supply - A case study from West Bengal, India

This report describes a simple chemical free method that was successfully used by a team of European and Indian scientists (www.qub.ac.uk/tipot) to remove arsenic (As) from groundwater in a village in West Bengal, India. Six such plants are now in operation and are being used to supply water to the local population (www.insituarsenic.org). The study was conducted in Kasimpore, a village in North 24 Parganas District, approximately 25 km from Kolkata. In all cases, total As in treated water was less than the WHO guideline value of 10 μg L⁻¹. The plant produces no sludge and the operation cost is 1.0 US$ per day for producing 2000 L of potable water.     

Ambient air quality during wheat and rice crop stubble burning episodes in Patiala

Open crop stubble burning events were observed in and around Patiala city, India. A ground level study was deliberated to analyze the contribution of wheat (Triticum aestivum) and rice (Oriza sativa) crop stubble burning practices on concentration levels of aerosol, SO₂ and NO₂ in ambient air at five different sites in and around Patiala city covering agricultural, commercial and residential areas. Aerosols were collected on GMF/A and QMF/A (Whatman) sheets for a 24 h period throughout the year in 2007. Simultaneously, sampling of SO₂ and NO₂ was conducted and results obtained during stubble burning periods were compared to the non-stubble burning periods. Results clearly pointed out a distinct increase in aerosol, SO₂ and NO₂ levels during the crop stubble burning periods.     

Uptake and translocation of metals in Spinacia oleracea L. grown on tannery sludge-amended and contaminated soils: effect on lipid peroxidation, morpho-anatomical changes and antioxidants

The plants of Spinacia oleracea L. grown on contaminated soil (CS) and different amendments of tannery sludge (TS) have shown high accumulation of metals in its edible part. The accumulation of toxic metal (Cr) in the leaves of the plants grown on CS was recorded as 40.67 microgg(-1)dw. However, the leaves of the plants grown on 100% TS have accumulated about two times (70.80 microgg(-1)dw) higher Cr than the 10% TS (31.21 microgg(-1)dw). Among growth parameters, the root length was more affected at 90 d than the shoot length, number of leaves and leaf area. The study of scanning electron micrographs showed 29.31% increase in stomatal length in the leaves of the plants grown on CS as compared to garden soil (GS), which served as control, however it decreased in the plants grown on higher amendments of TS. The decrease in MDA content at initial period of exposure and lower amendment was recorded in the leaves, whereas, significant increase (>10% TS onward) was observed with increase in tannery sludge ratio at 90 d as compared to GS. A coordinated increase in all the studied antioxidants (cysteine, non-protein thiol, ascorbic acid, carotenoid contents) was found up to 75 d of growth. At 90 d, most of the antioxidant decreased as compared to 75 d causing oxidative stress as evidenced by increased level of lipid peroxidation and decreased chlorophyll and protein contents. Maximum increase of 181.43% in MDA content and maximum decrease of 53.69% in total chlorophyll content was recorded in the leaves of the plants grown on 100% TS after 90 d of growth. The plants grown on CS have shown an increase in shoot length, number of leaves, leaf area, photosynthetic pigments and protein contents and in all the studied antioxidants. Thus, these plants are able to combat stress involving defense mechanism, resulting in healthy growth of the plants. The results are well coordinated as there is no change in the MDA content as compared to the plants grown on GS. In view of high Cr accumulation in edible part of S. oleracea grown on CS after irrigation with tap water, it is not advisable to use these plants for edible purposes. Summing up, it is recommended that the level of metals in the edible part should be checked instead of healthy growth as deciding parameter for consumption. It is demonstrated through this study that metal enriched plants have detoxification mechanism and grow well on organic matter enriched contaminated soil.     

Treatment of phenolic wastewater by horseradish peroxidase immobilized by bioaffinity layering

Horseradish peroxidase was immobilized by bioaffinity layering and used for the treatment of wastewater containing p-chlorophenol. For this purpose, lectin Concanavalin A was bound to Sephadex beads. The glycoenzyme peroxidase was layered upon this Con A layer. Subsequently, alternate layers of the enzyme and Con A were applied. The most efficient design consisted of three layers of Con A and peroxidase each. This immobilized enzyme preparation retained 80% of the activity of the free peroxidase used for immobilization. PEG at the concentration of 0.1 mg ml(-1) was found to prevent enzyme inactivation by the products, although it increased the process time. Thus 60 U ml(-1) of enzyme completely converted the p-chlorophenol (into products) in 4 min in the absence of PEG. On the other hand, only 0.05 U ml(-1) of enzyme was required for this purpose in the presence of PEG but the process required 60 min. Peroxidase converts phenol molecules into free radicals. These free radicals then polymerize and get precipitated. As a further means of minimizing exposure of the enzyme to free radicals and enhancing the reusability, it was decided to remove the enzyme from reaction medium after 10 min. With this strategy, the bioaffinity layered peroxidase preparation could be reused five times without any loss of activity.