Characterization of gas/particle concentrations and partitioning of polychlorinated biphenyls (PCBs) measured in an urban site of Turkey

Air concentrations of polychlorinated biphenyls (PCBs) in both gas and particle phases were measured in an urban site (BUTAL-Merinos) of the city of Bursa, Turkey between August 2004 and May 2005. The mean of total (particle+gas) PCB concentrations was about 491.8+/-189.4pg/m(3). The main contributors for PCBs in the sampling site were the local sources and long-range atmospheric transport supported by back trajectory analysis. Lower molecular weight PCB congeners generally dominated in the samples. The particle phase of the measured PCBs accounted for 15% of the total PCB concentrations. Gas/particle distribution was investigated using different approaches such as log K(P)-log P(L)(o), log K(P)-log K(OA) and the Junge-Pankow model. Regression analysis among log K(P), log P(L)(o) and log K(OA) exhibited significant correlation at p<0.05. Correlation between PCB homologs and meteorological parameters was formed to investigate the possible relationships.     

Vegetable and synthetic tannins induce hormesis/toxicity in sea urchin early development and in algal growth

Mimosa tannin and phenol-based synthetic tannin (syntan) were tested for toxicity to sea urchin (Paracentrotus lividus and Sphaerechinus granularis) early development and to marine algal growth (Dunaliella tertiolecta). Sea urchin embryogenesis was affected by vegetable tannin and syntan water extracts (VTWE and STWE) at levels >or=1mg/L. Developmental defects were significantly decreased at VTWE and STWE levels of 0.1 and 0.3mg/L when control cultures displayed suboptimal quality, i.e. <70% "viable" (normal or retarded) larvae. Fertilization success of sea urchin sperm was increased up to 0.3 mg/L STWE or VTWE, then was inhibited by increasing tannin levels (1-30 mg/L). Offspring abnormalities, following sperm exposure to VTWE or STWE, showed the same shift from hormesis to toxicity. Cell growth bioassays in D. tertiolecta exposed to VTWE or STWE (0.1-30 mg/L) showed non-linear concentration-related toxicity. Novel criteria are suggested in defining control quality that should reveal hormetic effects.     

Effects of mercury on visible/near-infrared reflectance spectra of mustard spinach plants (Brassica rapa P.)

Mustard spinach plants were grown in mercury-spiked and contaminated soils collected in the field under controlled laboratory conditions over a full growth cycle to test if vegetation grown in these soils has discernible characteristics in visible/near-infrared (VNIR) spectra. Foliar Hg concentrations (0.174-3.993ppm) of the Mustard spinach plants were positively correlated with Hg concentration of soils and varied throughout the growing season. Equations relating foliar Hg concentration to spectral reflectance, its first derivative, and selected vegetation indices were generated using stepwise multiple linear regression. Significant correlations are found for limited wavelengths for specific treatments and dates. Ratio Vegetation Index (RVI) and Red Edge Position (REP) values of plants in Hg-spiked and field-contaminated soils are significantly lower relative to control plants during the early and middle portions of the growth cycle which may be related to lower chlorophyll abundance or functioning in Hg-contaminated plants.     

Bibliography of Environmental Studies in Natural Characteristics and Anthropogenic Influences on the Ganga River

During the second half of the 20th century, the Ganga River ecosystem has been continuously altered by several ongoing anthropogenic processes, accommodating multi-dimensional pressure due to increase of nearly four-fold human population. For solution of any environmental issues of the river, the Earth System Science approach is required to have maximum socio-economic benefits to millions of people living in Indian and Bangladesh. A bibliography containing more than 250 references on environmental studies of the Ganga River was prepared to preserve its ecosystem by providing the baseline support in this regard.     

Factors affecting river health and its assessment over broad geographic ranges: the Western Australian experience

AusRivAS is an Australia-wide program that measures river condition using predictive models to compare the macroinvertebrate families occurring at a river site with those expected if the site were in natural condition. Results of assessment of 685 sites across all major rivers in Western Australia are presented. Most rivers were in relatively natural condition in the northern half of the state where the human population is low and pastoralism is the major land use. In the south, where the human population is higher and agriculture is more intensive, rivers were mostly more disturbed. AusRivAS assessment produced some erroneous results in rivers of the south-west cropping zone because of the lack of appropriate reference site groups and biased distribution of sampling sites. Collecting low numbers of animals from many forested streams, because of low stream productivity and samples that were difficult to sort, also affected assessments. Overall, however, AusRivAs assessment identified catchment processes that were inimical to river health. These processes included salinisation, high nutrient and organic loads, erosion and loss of riparian vegetation. River regulation, channel modification and fire were also associated with river degradation. As is the case with other assessment methods, one-off sampling at individual sites using AusRivAS may be misleading. Seasonal drought, in particular, may make it difficult to relate conditions at the time of sampling to longer-term river health. AusRivAS has shown river condition in Western Australia is not markedly different from other parts of Australia which, as a whole, lacks the substantial segments of severely degraded river systems reported in England.     

Concentrations of cadmium and lead heavy metals in Dardanelles seawater

Cadmium and lead were determined simultaneously in seawater by differential pulse stripping voltammetry (DPSV) preceded by adsoptive collection of complexes with 8-hydroxyquinoline (oxine) on to a hanging mercury drop electrode (HMDE). In preliminary experiments the optimal analytical condition for oxine concentration was found to be 2.10⁻⁵ M, at pH 7.7, the accumulation potential was −1.1 V, and the initial scannig potential was −0.8 V. The peak potentials were found −0.652 V for Cd and −0.463 V for Pb At the 60 s accumalation time. The limit of detection (LOD) and limit of quantitatification (LOQ) were found to be by voltammetry as 0.588 and 1.959 μg l⁻¹ (RSD, 5.50%) for Cd and 0.931 and 3.104 μg l⁻¹ (RSD, 4.10%) for Pb at 60 s stirred accumulation time respectively. In these conditions the most of the seawater samples are amenable for direct voltammetric determination of cadmium and lead using a HMDE. An adsorptive stripping mechanism of the electrode reaction was proposed. For the comparison, seawater samples were also analysed by ICP-atomic emission spectrometry method (ICP-AES). The applied voltammetric technique was validated and good recoveries were obtained.     

Dehalogenation of polychlorinated biphenyls and polybrominated diphenyl ethers using a hybrid bioinorganic catalyst

The environmentally prevalent polybrominated diphenyl ether (PBDE) #47 and polychlorinated biphenyls (PCBs) #28 and #118 were challenged for 24 hours with a novel biomass-supported Pd catalyst (Bio-Pd(0)). Analysis of the products via GC-MS revealed the Bio-Pd(0) to cause the challenged compounds to undergo stepwise dehalogenation with preferential loss of the least sterically hindered halogen atom. A mass balance for PCB #28 showed that it is degraded to three dichlorobiphenyls (33.9%), two monochlorobiphenyls (12%), and biphenyl (30.7%). The remaining mass was starting material. In contrast, while PCB #118 underwent degradation to yield five tetra- and five trichlorinated biphenyls, no less chlorinated products or biphenyl were detected, and the total mass of degraded products was 0.3%. Although the Bio-Pd(0) material was developed for treatment of PCBs, a mass balance for PBDE #47 showed that the biocatalyst could prove a potentially useful method for treatment of PBDEs. Specifically, 10% of PBDE #47 was converted to identifiable lower brominated congeners, predominantly the tribrominated PBDE #17 and the dibrominated PBDE #4, 75% remained intact, while 15% of the starting mass was unaccounted for.     

Coastal Flood Risk Analysis Using Landsat-7 ETM+ Imagery and SRTM DEM: A Case Study of Izmir, Turkey

The Intergovernmental Panel on Climate Change (IPCC) reports an acceleration of the global mean sea-level rise (MSLR) in the twentieth century in response to global climate change. If this acceleration remains constant, then some coastal areas are most likely to be inundated by the year 2100. The ability to identify the differential vulnerability of coastlines to future inundation hazards as result of global climate change is necessary for timely actions to be taken. Yildiz et al. (Journal of Mapping, 17, 1-75, 2003) reported that the local MSLR in the city of Izmir rose at a rate of 6.8 +/- 0.9 mm year(-1) between 1984 and 2002. In this study, the spatial distribution of the coastal inundation hazards of Izmir region was determined using not only land-use and land-cover (LULC) types derived from the maximum likelihood classification of Landsat-7 Enhanced Thematic Mapper Plus (ETM+) multi-spectral image set but also the classification of the digital elevation model (DEM) acquired by the shuttle radar topography mission (SRTM). Coastal areas with elevations of 2 and 5 m above mean sea-level vulnerable to inundation were found to cover 2.1 and 3.7% of the study region (6,107 km(2)), respectively. Our findings revealed that Menemen plain along Gediz river, and the settlements of Karsiyaka, Alacati, Aliaga, Candarli and Selcuk are at high risk in order of decreasing vulnerability to permanent and episodic inundation by 2100 under the high MSLR scenarios of 20 to 50 mm year(-1).     

Comparative evaluation of a bioluminescent bacterial assay in terrestrial ecotoxicity testing

Despite the widespread and successful use of luminescence-based bioassays in water testing, their applications to soils and sediments is less proven. In part this is because such bioassays have mainly been carried out in an aqueous-based medium and, as such, favour contaminants that are readily water-soluble. In this study, aqueous solutions and soils contaminated with heavy metals (HM), polar organic contaminants and hydrophobic organic contaminants (HOCs) were tested using a range of luminescence-based bioassays (Vibrio fischeri, Escherichia coli HB101 pUCD607 and Pseudomonas fluorescens 10586r pUCD607). For the first two chemical groups, the assays were highly reproducible when optimised extraction procedures were employed but for HOCs the bioassay response was poor. Quantitative structure-activity relationships (QSARs) obtained from aqueous solutions had a linear response although correlation for the chemicals tested using bacterial bioassays was significantly less sensitive than that of sublethal tests for Tetrahymena pyriformis. Bacterial and Dendrobaena veneta bioassay responses to extracts from HM amended soils showed that a clear relationship between trophic levels could be obtained. There is no doubt that the wide range of bioluminescent-based bioassays offers complementary applications to traditional testing techniques but there is a significant need to justify and optimise the extraction protocol prior to application.     

Evaluation of marine outfall with three-dimensional hydrodynamic and water quality modeling

Numerical models are often used to evaluate the potential impact of human alternation of natural water bodies and to help the design of the alternation to mitigate its impacts. In the past decade, three-dimensional hydrodynamic and reactive transport modeling has matured from a research subject to a practical analysis technology. This paper presents a practical study in which a three-dimensional hydrodynamic and water quality model [hydrodynamic eutrophication model (HEM-3D)] was applied to determine the optimal location for treated wastewater discharged from marine outfall system in the Keelung harbor and the adjacent coastal sea. First, model validation was conducted with respect to surface elevation, current, and water quality variables measured in the Keelung harbor station and its coastal sea. The overall performance of the model was in qualitative agreement with the available field data. The model was then used to evaluate several scenarios of the locations from marine outfall system. Based on model simulation results, a location at the northeast of Ho-Ping Island was recommended for adoption because the environmental impact is smaller than any other alternative.