Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.     

Further studies using X-ray fluorescence to sample lead contaminated carpeted surfaces

The sampling of carpeted surfaces to test for lead contamination primarily focuses upon vacuum techniques. Vacuum sampling techniques, however, require time-consuming, expensive laboratory analysis of the dusts obtained and are unable to determine total lead load on the carpet. X-ray fluorescence (XRF) analysis is an on-site, inexpensive, non-destructive, quick technique for predicting metals levels in a variety of media, such as water, soil, filter paper and painted surfaces. A 1992 study of the feasibility of XRF to analyze for lead and soil loadings on carpeted surfaces indicated that XRF can detect lead at a low enough level to warrant further study. This paper expands this earlier study and developes lead and soil loading calibration curves for three different carpet types based upon XRF lead L-beta peak areas and XRF iron and barium K-alpha peak and background areas. Results indicate that variation in the data can be reduced through modifications of the XRF analysis technique, thus reducing the statistically determined detection level, and that carpet type does affect the calibration. Detection levels of approximately 70 mg/m² for lead and 5 g/m² for soil were obtained. Overall, good agreement was found between results of this study and the earlier one. XRF shows excellent potential for quantitative analysis of lead on carpeted surfaces.     

Factor analysis of trace-element data from tree-bark samples in The Netherlands

Monte Carlo-assisted factor analysis has been applied to a data set of 20 trace-element concentrations in tree-bark samples obtained from 123 locations in The Netherlands, with the aim to investigate the suitability of bark as a biomonitor for air pollution. A Monte Carlo approach was used to give more insight to the uncertainties and significance levels of the factor analysis results. Notwith-standing a rather strong influence of soil material on the concentration levels, factor analysis enabled the identification of five significant pollution source types, all of which corresponded with source types found in an earlier biomonitoring study in The Netherlands using epiphytic lichens. A more detailed comparison with the lichen results showed a remarkable difference in lead concentrations between bark and lichen. It was concluded that bark can be successfully employed as a biomonitor for air pollution. The power of factor analysis to adequately determine the soil contribution may render extensive sample washing procedures superfluous.     

Characterizing soils for hazardous waste site assessments

This paper provides a review and justification of the minimum data needed to characterize soils for hazardous waste site assessments and to comply with the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA). Scientists and managers within the regulatory agency and the liable party need to know what are the important soil characteristics needed to make decisions about risk assessment, what areas need remediation and what remediation options are available. If all parties involved in characterizing a hazardous waste site can agree on the required soils data set prior to starting a site investigation, data can be collected in a more efficient and less costly manner. Having the proper data will aid in reaching decisions on how to address concerns at, and close-out, hazardous waste sites.This paper was prepared to address two specific concerns related to soil characterization for CERCLA remedial response. The first concern is the applicability of traditional soil classification methods to CERCLA soil characterization. The second is the identification of soil characterization data type required for CERCLA risk assessment and analysis of remedial alternatives. These concerns are related, in that the Data Quality Objective (DQO) process addresses both. The DQO process was developed in part to assist CERCLA decision-makers in identifying the data types, data quality, and data quantity required to support decisions that must be made during the remedial investigation/feasibility study (RI/FS) process. Data Quality Objectives for Remedial Response Activities: Development Process (US EPA, 1987a) is a guidebook on developing DQOs. This process as it relates to CERCLA soil characterization is discussed in the Data Quality Objective Section of this paper.     

Use of cluster and principal component analyses to profile areas in California where ground water has been contaminated by pesticides

An empirical approach to profiling areas of ground water contamination by pesticides was devised that did not rely upon determining the level of vulnerability between land areas and that did not assume any particular pathway for ground water contamination. Climatic and soil data were obtained for 1-square mile sections of land in California where pesticide residues had been found in well water samples and the detection was attributed to legal agricultural applications. These sections were designated as known contaminated (KC) sections. Climate and soil data were also obtained for sections which lacked either well sampling data or a positive pesticide detection. These sections were designated as candidate sections. Statistical procedures were used to cluster groups of KC sections first with respect to climate characteristics and then with respect to soil characteristics. Principal components analysis (PCA) was used to construct a statistical profile of soil variables for each cluster of KC sections. A method based on the PCA was developed to compare the similarity of soil profiles derived for each KC section cluster to individual candidate sections. Since the profiling scheme was based only on data from KC sections, candidate sections that did not match any KC cluster profile could only be considered dissimilar to contaminated sections, receiving a status of not-classified. This profiling method is flexible and it can be revised to incorporate updated well sampling information.     

Ambient air concentrations of PCDDs,PCDFs, coplanar PCBs,and PAHs at the Mississippi Sandhill Crane National Wildlife Refuge,Jackson County,Mississippi

Our objective was to determine the levels of selected airborne contaminants in ambient air at the Mississippi Sandhill Crane National Wildlife Refuge, Mississippi, that might be affecting the health of endangered cranes living there. Two high-volume air samplers were operated at separate locations on the Refuge during May–September 1991. The sampling media were micro-quartz filters in combination with polyurethane foam plugs. Composite bimonthly samples from each station were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs), coplanar polychlorinated biphenyls (PCBs), and polycyclic aromatic hydrocarbons (PAHs). Overall, residue concentrations were low. The toxic PCDD isomer 2,3,7,8-tetra-CDD was not detected, nor was penta-CDD. There was no difference (P>0.05) in residue concentrations between stations or over time and meteorological parameters were not correlated with residue concentrations. Because contaminant levels and patterns may differ seasonally, we recommend that air samples collected during winter months also be analyzed for these same chemical groups.     

Organochlorine contaminant concentrations in caddisfly adults (Trichoptera) collected from great lakes connecting channels

Pennsylvania-style light traps were used to capture adult Trichoptera from the St. Marys, St. Clair, Detroit and Niagara rivers, Canada. Adequate biomass was acquired in single, 2-h collections to permit triplicate gas chromatographic analyses of 1–4 g samples for 36 organochlorine contaminants. Contaminant levels varied unpredictably but relatively little among samples taken at monthly intervals over the summer. Samples collected simultaneously from the two sides of the Detroit R. reflected local sediment contaminant patterns, suggesting limited dispersal by adults. Genus-specific differences in contaminant concentrations within the Hydropsychidae and Leptoceridae probably reflect differences in larval habitats and manner of feeding. Contaminant concentrations and relative composition paralleled published reports of contaminants in sediments from collection locations. St. Marys R. caddisflies contained contaminant levels indistinguishable from samples collected at reference sites. St. Clair R. samples contained high levels of compounds associated with petrochemical industries located in the river's upstream reaches. High levels of polychlorinated biphenyls (PCBs) and most other contaminants in Detroit R. samples reflected industrial loadings near Detroit, Michigan. Niagara R. samples contained elevated concentrations of PCBs and pesticides. Cluster analysis grouped samples into five clusters each with unique contaminant composition. These also corresponded to geographic origin: St. Marys, St. Clair, Detroit and upper and lower Niagara rivers. The relative ease of collection and consistent results obtained render adult Trichoptera potentially valuable candidates for surveys of aquatic contamination over a broad range of geographical and ecological conditions.     

Multimedia environmental monitoring: 50 years at Hanford

Environmental monitoring has been an ongoing activity on the U.S. Department of Energy's Hanford Site in southeastern Washington for almost 50 years. Objectives are to detect and assess potential impacts of Site operations on air, surface and ground waters, foodstuffs, fish, wildlife, soil and vegetation. Data from monitoring effects are used to calculate the overall radiological dose to humans working onsite or residing in nearby communities. In 1989, measured Hanford Site perimeter concentrations of airborne radionuclides were below applicable guidelines. Concentrations of radionuclides and nonradiological water quality in the Columbia River were in compliance with applicable standards. Foodstuffs irrigated with river water taken downstream of the Site showed radionuclide levels that were similar to those found in foodstuffs from control areas. Low levels of ¹³⁷Cs and ⁹⁰Sr in most onsite wildlife samples and concentrations of radionuclides in soils and vegetation from on- and offsite locations were typical of those attributable to worldwide fallout. The calculated dose potentially received by a maximally exposed individual (i.e., based on hypothetical, worst-case assumptions for all routes of exposure) in 1989 (0.05 mrem/yr) was similar to those calculated for 1985 through 1988.In addition to monitoring radioactivity in fish and wildlife, population numbers of key species are determined. Chinook salmon (Oncorhynchus tshawytscha) spawning in the Columbia River at Hanford has increased in recent years with a concomitant increase in winter roosting activity of bald eagles (Haliaeetus leucocephalus). An elk (Cervus elaphus) herd, established by immigration in 1972, is also increasing. The Hanford Site currently serves as a refuge for Canada goose (Branta canadensis), great blue heron (Ardea herodias), and various plants and other animals, e.g., mule deer (Odocoileus hemionus), and coyotes (Canis latrans).     

Patchy distributions: Optimising sample size

A method for estimating sample size which does not require an a priori definition of desired precision, or the assumption that the population is normally distributed with constant variance, has recently been proposed. This paper discusses this method and presents five modifications which make the method easier to use and reduce the probability of estimating a larger sample size than is actually required. The method is extended and used to estimate the mean abundance of patchily distributed benthic organisms. The technique can be used to guide the design of any environmental sampling programme, be it physical, chemical or biological, where comparisons between times and/or locations are required. Trade-offs between numbers of replicates and numbers of levels/sites are discussed.     

Trend evaluation of water quality parameters in the Niagara and St. Lawrence Rivers

Physical and chemical (nutrients and major ions) indicators of water quality monitored by Environment Canada between 1977 and 1987 in the Niagara River at Niagara-on-the-Lake and in the St. Lawrence River at Wolfe Island are analyzed for seasonal and annual variations. Parametric methods such as moving averages and linear regression and nonparametric methods (Spearman's rank coefficient) are used to test for the existence of trends in these data. The results indicate that specific conductivity, sodium and chloride have decreased significantly over the period of study. During the same period there is no significant trend for either discharge and nutrients.