LCA and economic evaluation of landfill leachate and gas technologies

Landfills receiving a mix of waste, including organics, have developed dramatically over the last 3-4 decades; from open dumps to engineered facilities with extensive controls on leachate and gas. The conventional municipal landfill will in most climates produce a highly contaminated leachate and a significant amount of landfill gas. Leachate controls may include bottom liners and leachate collection systems as well as leachate treatment prior to discharge to surface water. Gas controls may include oxidizing top covers, gas collection systems with flares or gas utilization systems for production of electricity and heat.The importance of leachate and gas control measures in reducing the overall environmental impact from a conventional landfill was assessed by life-cycle-assessment (LCA). The direct cost for the measures were also estimated providing a basis for assessing which measures are the most cost-effective in reducing the impact from a conventional landfill. This was done by modeling landfills ranging from a simple open dump to highly engineered conventional landfills with energy recovery in form of heat or electricity. The modeling was done in the waste LCA model EASEWASTE. The results showed drastic improvements for most impact categories. Global warming went from an impact of 0.1 person equivalent (PE) for the dump to −0.05 PE for the best design. Similar improvements were found for photochemical ozone formation (0.02 PE to 0.002 PE) and stratospheric ozone formation (0.04 PE to 0.001 PE).For the toxic and spoiled groundwater impact categories the trend is not as clear. The reason for this was that the load to the environment shifted as more technologies were used. For the dump landfill the main impacts were impacts for spoiled groundwater due to lack of leachate collection, 2.3 PE down to 0.4 PE when leachate is collected. However, at the same time, leachate collection causes a slight increase in eco-toxicity and human toxicity via water (0.007E to 0.013PE and 0.002 to 0.003 PE respectively). The reason for this is that even if the leachate is treated, slight amounts of contaminants are released through emissions of treated wastewater to surface waters.The largest environmental improvement with regard to the direct cost of the landfill was the capping and leachate treatment system. The capping, though very cheap to establish, gave a huge benefit in lowered impacts, the leachate collection system though expensive gave large benefits as well. The other gas measures were found to give further improvements, for a minor increase in cost.     

Thermo- and fluid-dynamical modelling of two-phase multi-component carbon dioxide mixtures

A method for calculating the transport and depressurization of a two-phase multi-component CO₂ mixture is presented. The thermodynamical and transport properties for a CO₂–CH₄ mixture are calculated using the Soave–Redlich–Kwong equation of state (SRK). The fluid flow is described by a drift-flux model, which is solved using the multi-stage (MUSTA) centred scheme. Numerical results are shown, illustrating the effect of mixture composition and the feasibility of the approach.     

Methane production during storage of anaerobically digested municipal organic waste

Anaerobic digestion of source-separated municipal organic waste is considered feasible in Denmark. The limited hydraulic retention in the biogas reactor (typically 15 d) does not allow full degradation of the organic waste. Storage of anaerobically digested municipal organic waste can therefore be a source of methane (CH4) emission that may contribute significantly to the potential global warming impact from the waste treatment system. This study provides a model for quantifying the CH4 production from stored co-digested municipal organic waste and estimates the production under typical Danish climatic conditions, thus quantifying the potential global warming impact from storage of the digested municipal organic waste before its use on agricultural land. Laboratory batch tests on CH4 production as well as temperature measurements in eight full-scale storage tanks provided data for developing a model estimating the CH4 production in storage tanks containing digested municipal organic waste. The temperatures measured in separate storage tanks on farms receiving digested slurry were linearly correlated with air temperature. In storage tanks receiving slurry directly from biogas reactors, significantly higher temperatures were measured due to the high temperatures of the effluent from the reactor. Storage tanks on Danish farms are typically emptied in April and have a constant inflow of digested material. During the warmest months the content of digested material is therefore low, which limits the yearly CH4 production from storage.     

Sensitivity of the DERMA long-range Gaussian dispersion model to meteorological input and diffusion parameters

The Danish Emergency Response Model of the Atmosphere (DERMA) is described and applied to the first ETEX experiment. By using analysed low-resolution numerical weather-prediction data from the global model of the European Centre for Medium-range Weather Forecast (ECMWF) as well as higher-resolution data from two versions of the High Resolution Limited Area Model (HIRLAM), which are operational at the Danish Meteorological Institute (DMI), the sensitivity of DERMA to the resolution of meteorological data is analysed by comparing DERMA results with concentration measurements. Furthermore, the sensitivity to boundary-layer height and diffusion parameters is studied. These parameters include the critical bulk Richardson number, which is used to estimate the atmospheric boundary-layer height, the horizontal eddy diffusivity and the Lagrangian turbulence time scale. The parameters, which provide the best performance of DERMA, are 0.25 for the critical bulk Richardson number, 6×10³ m² s^-1 for the horizontal eddy diffusivity, and 3 h for the Lagrangian time scale. DERMA is much more sensitive to boundary-layer parameters when using high-resolution DMI-HIRLAM data than when using data of lower resolution from the ECMWF. Finally, the bulk Richardson number method of boundary-layer height calculation applied to DMI-HIRLAM data is verified directly against routine radiosondes released under the tracer gas plume. The boundary-layer height estimates based on analysed NWP model data agree well with observations, and the agreement deteriorates as a function of forecast length.     

Integration of Remote Sensed and In-situ Data in an Analysis of the Air Pollution Effects on Terrestrial Ecosystems in the Border Areas between Norway and Russia

Transboundary air pollution from industries in Nikel and Zapolyarnij has caused severe damage to the environment in Southern-Varanger in Norway and in Pechenga municipality in Russia. The work presented in this paper focuses on the integration of in-situ air pollution data with remote sensing based land cover maps. Land cover maps have been utilised to detect changes in the major land cover types within the area. The major change in the environment was the decrease of the sensitive lichen-dominated land cover types, and the increase of bilberry-dominated land cover types and finally the increase of the land cover types with the greatest air pollution stress (industrial barren, barren, and partly damaged vegetation, defoliated forests, lichen removal). A GIS based method for assessing the relationship of the remotely sensed land cover maps with the environmental condition parameters was developed and applied. By comparing the results from this analysis we observed that the land cover types with the greatest stress had the largest concentrations of SO₂ in the ground air layer, while the land cover types with minor damage (the remaining lichen-dominated vegetation) had rather low concentrations of sulphur dioxide in the ground air layer. The area of the land cover types with the greatest stress (industrial barren, barren and partly damaged vegetation) has increased in the period 1973–1988, and the degradation is carried out in a such manner that sensitive mountain and lichen vegetation formations have been transformed into a more barren-like environment. The increase in the emissions has also transferred the natural barrens which also consisted of some sparse vegetation into a complete barren with little vegetation left. Also the epilitic lichens and mosses on bare rocks and stones were also removed by the high concentrations of SO₂. The land cover types with minor damage (with the remaining lichen-dominated vegetation) had rather low concentrations of the contaminants (SO₂, Ni and S), while the partly damaged and damaged land cover types had the highest concentrations of the contaminants. An exception was the Ni and S concentrations found in class 11 Industrial barrens which were lower than expected. Associations between the degradation and the SO₂ concentration in the air were also documented. The conclusion from this analysis is that the in-situ data support the observations of damaged vegetation and industrial barrens imaged by the Landsat satellites, especially in the surroundings of Nikel and Zapolyarnij.     

Phthalate levels in Norwegian indoor air related to particle size fraction

Phthalates are found in numerous consumer products, including interior materials like polyvinyl chloride (PVC). Several studies have identified phthalates in indoor air. A recent case-control study demonstrated associations between allergic symptoms in children and the concentration of phthalates in dust collected from their homes. Here we have analyzed the content of selected phthalates in particulate matter (PM): PM(10) and PM(2.5) filter samples collected in 14 different indoor environments. The results showed the presence of the phthalates di-n-butyl phthalate (DBP), butyl benzyl phthalate (BBP), dicyclohexyl phthalate (DCHP) and diethyl hexyl phthalate (DEHP) in the samples. The dominating phthalate in both PM(10) and PM(2.5) samples from all locations was DBP. More than a 10-fold variation in the mean concentration of total phthalates between sampling sites was observed. The highest levels of total phthalates were detected in one children's room, one kindergarten, in two primary schools, and in a computer room. The relative contribution of total phthalates in PM(10) and PM(2.5) was 1.1 +/- 0.3% for both size fractions. The contribution of total phthalates in PM(2.5) to total phthalates in PM(10) ranged from 23-81%, suggesting different sources. Of the phthalates that were analyzed in the PM material, DBP was found to be the major phthalate in rubber from car tyres. However, our analyses indicate that tyre wear was of minor importance for indoor levels of both DBP as well as total phthalates. Overall, these results support the notion that inhalation of indoor PM contributes to the total phthalate exposure.     

Experimental determination of efficiency of capping materials during consolidation of metal-contaminated dredged material

Capping has received considerable attention as a method to reduce contaminant transport from contaminated sediments and sub-aqueous disposed dredged materials. Consolidation of dredged material after capping can result in a substantial advection of pore water, into or through the capping layer. The effect of two different capping materials (crushed limestone and gneiss) on the transport of heavy metals and phosphorus during consolidation was studied with a novel experimental design. Capped dredged material was placed in a consolidation cell and pore water expelled during the consolidation was collected for chemical analysis. To support interpretation of the results from this test, interactions between the capping material and the dredged material were also studied in batch tests. The study revealed large differences in the capping efficiency (CE) between the two materials. Both materials were efficient caps for Fe and P (CE>99% with 2cm cap), while limestone also was efficient for Mn (CE>92% with 2cm cap). Contrary to what was expected, capping of dredged material with crushed gneiss increased the release of Ca, Mn, Co, Ni, Cd, and Cu, resulting in negative CE. The batch tests showed that leaching from the crushed gneiss was the source of the observed release of metals. The results also show that the high concentrations of heavy metals in the dredged material were immobilised, probably by sulphides. Protection against re-suspension and oxidation will therefore in many cases be the most important effect of the cap.     

Effect of amino acids on the swimming activity of newly hatched turbot larvae (Scophthalmus maximus)

The swimming behaviour of newly hatched turbot (Scophthalmus maximus L.) larvae was observed in artificial seawater (ASW) and in solutions of 21 l-amino acids at a concentration of 10⁻⁵  M. The behaviour of 20 larvae was analysed in each solution. Each larva was observed for 1 min. Individual movements were recorded on video and analysed using a computer-assisted program. The larvae swam in convoluted, randomised three-dimensional paths, rested and started swimming again. There were large variations in the swimming behaviour of turbot larvae during ontogeny. In ASW the mean frequency of trajectories longer than a body length of 4 mm larva⁻¹ min⁻¹ increased from 1.2 at Day 1, to 10 at Day 4. Analysing the data (Dunnett's method) revealed that the frequency of swimming trajectories increased in the presence of glycine, histidine and glutamine, and decreased in the presence of proline. The total distance swum increased for glycine but decreased for proline. The threshold concentration for glycine detected by turbot larvae was 10⁻⁵  M. The straightness index did not change in the presence of the amino acids. The possible role of these changes in behaviour is discussed. Received: 12 June 1997 / Accepted: 13 January 1998     

Enabling Sustainable Agro-Food Futures: Exploring Fault Lines and Synergies Between the Integrated Territorial Paradigm,Rural Eco-Economy and Circular Economy

What kind of futures does agro-food imaginaries enable and who can get involved in the making of agro-food futures? In this respect, what can the increasingly influential idea of circular economy potentially offer in terms of enabling more sustainable agrofood futures? We approach this task by first outlining the interconnected challenges that the agro-food system is facing related to environmental degradation, economic crises and social problems. Then we consider the way these challenges are being addressed in agro-food studies. We argue that agro-food research in recent years has seen important contributions in relation to studies of alternative food networks and the “quality” turn. These research agendas have challenged the current logic of the food system in terms of offering alternative visions of future development. We highlight two examples from the literature—the eco-economy and the integrated territorial agri-food paradigm—that develop broader frameworks for rethinking the future of the agro-food system and which have distinguished themselves in contrast to the industrialized and globalized conventional food system. We find that with respect to reorienting and reconfiguring economic structures and relations all three approaches share a common goal, but circular economy stands out in relation to the actors that are included by, for example, emphasizing collaborations and partnerships with extant agro-food businesses. Also with regards to scalar politics, it would be prudent to consider the potentials offered by the increasingly influential ideas around circular economy.