Bioretention column studies of phosphorus removal from urban stormwater runoff.

This study investigated the effectiveness of bioretention as a stormwater management practice using repetitive bioretention columns for phosphorus removal. Bioretention media, with a higher short-term phosphorus sorption capacity, retained more phosphorus from infiltrating runoff after 3 mg/L phosphorus loading. A surface mulch layer prevented clogging after repetitive total suspended solids input. Evidence suggests that long-term phosphorus reactions will regenerate active short-term phosphorus adsorption sites. A high hydraulic conductivity media overlaying one with low hydraulic conductivity resulted in a higher runoff infiltration rate, from 0.51 to 0.16 cm/min at a fixed 15-cm head, and was more efficient in phosphorus removal (85% mass removal) than a profile with low conductivity media over high (63% mass removal). Media extractions suggest that most of the retained phosphorus in the media layers is available for vegetative uptake and that environmental risk thresholds were not exceeded.     

Evaluation of Locations for Small Wind Turbines in Costal Urban Areas Based on a Wind Energy Potential Map

The purpose of the study was to evaluate potential locations for the installation of small wind turbines in urban areas. Four study sites in An-Ping, Tainan were chosen for measurement in this empirical study. The measurement data were used to verify the computational fluid dynamics (CFD) model. The weather information was gathered in order to understand the overall wind environment in the studied area. CFD software was used to simulate the wind environment in the study area from 16 directions. The distribution of wind environment was first presented, and then the distribution of exceedance probability in each grid, which was based on an exceedance probability assessment, was obtained. In addition to the installation heights of the turbines, the influence of surrounding buildings was taken into consideration. Finally, a wind energy potential map indicating the potential regions and non-potential regions for installing small wind turbines was illustrated by the ArcGIS system. A wind energy potential map, superimposed with locations of buildings of different floor heights, was used to evaluate the possible sites for the installment of small wind turbines at heights of 10, 20, and 30 m. The results proved that installing micro wind turbines in open spaces and on the roofs of three-, four-, and five-story buildings at a height of 20 m is relatively beneficial for coastal urban areas.     

Exposure of arc-furnace-plant workers to polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs)

This study aimed to evaluate serum polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) levels in electric-arc-furnace workers according to their corresponding occupational exposure. In addition, the ambient PCDD/Fs of the work environment were measured to provide additional support for the exposure and accumulation inside the electric arc furnace. The ambient PCDD/F concentrations inside the electric arc furnace were 1.557-1.917 pg-TEQ/Nm(3), 5-24 folds higher than those outside (0.080-0.385 pg-TEQ/N m(3)). In addition, higher average serum levels were measured in the workers with high occupational dioxin exposure (24.0 pg WHO-TEQ/g lipid) than in those with lower occupational dioxin exposure (13.8 pg WHO-TEQ/g lipid). Higher PCDFs/PCDDs ratios were found in serum samples from high-exposure groups than in low-exposure groups. The higher ratio of PCDFs/PCDDs was also found in ambient samples consistent with other metallurgical processes reported previously. Our results suggest that PCDD/Fs exposure exits in the smelting process of electric arc furnace, and the occupational hygiene should be taken more seriously concern in that workplace.     

Relationship between carbonaceous materials and polychlorinated biphenyls (PCBs) in the sediments of the Danshui River and adjacent coastal areas, Taiwan

Persistent organic pollutants, POPs (e.g., polychlorinated biphenyls) can seriously and deleteriously affect environmental quality and human health. These organic pollutants are exhibiting high affinities to solid phases and thus, quickly end up in sediments. To better understand the role of carbonaceous materials in the transport and distributions of POPs in terrestrial and near-shore environments, concentrations of PCBs and carbonaceous materials (including total organic carbon, black carbon and total carbohydrates), were determined in surface sediments of the Danshui River and nearby coastal areas, Taiwan. Total concentrations of PCBs in the sediments ranged from non-detectable to 83.9 ngg(-1), dry weight, with the maximum value detected near the discharge point of the marine outfall from the Pali Sewage Treatment Plant. These results suggest that the sewage treatment plant has discharged PCBs in the past and the concentrations are still high due to their persistence; alternatively, PCBs are still being discharged in the estuarine and near-shore environment of the Danshui River. Organic carbon and black carbon concentrations correlated well with those of total PCBs in the sediments, suggesting that both organic carbon and black carbon significantly affect the distribution of trace organic pollutants through either post-depositional adsorption, or by co-transport of similar source materials. The field results demonstrate that black carbon and plays an important role in the general distribution of PCBs, while concentrations of some specific PCBs are affected by both black carbon and organic carbon concentrations.     

Effect of humic substance on thermal treatment of chromium(VI)-containing latosol soil

Latosol soils contaminated with chromium(VI) [Cr(VI)], which is hazardous, can be recycled as raw materials for porcelain and construction sectors if a proper thermal stabilization process is implemented. This study investigates how thermal treatment affects Cr behavior during the sintering of latosol and deorganic latosol samples; both samples are artificially contaminated with CrO3. Approaches including X-ray absorption spectroscopy, scanning electron microscopy, N2-based Brunauer Emmett Teller surface analyzer, thermogravimetric analyzer/differential scanning calorimeter, and the toxicity characteristic leaching procedure promulgated by Taiwan Environmental Protection Administration are used in this study. After drying the Cr(VI)-contaminated latosol (i.e., containing 37,120 mg of Cr/kg sample) at 105 degrees C, approximately 80% of the doped CrO3 is chemically reduced to Cr(OH)3 by a humic substance naturally existing in the soil. In contrast, in the organics-free CrO3-contaminated latosol dried at 105 degrees C, only 9% of the doped CrO3 is reduced to Cr(OH)3. Heating the samples at 500 and 1100 degrees C transforms hazardous Cr(VI) into Cr(III) that is negligibly toxic; Cr2O3, which is insoluble, is detected as the most abundant Cr species. Moreover, formation of Cr2SiOs, which is suggested to relate to low Cr leaching, is only detected in the sample heated at 1100 degrees C. Surface morphology, surface area, and thermogravimetric analyzer/differential scanning calorimeter results demonstrate that thermal treatment at 1100 degrees C can incur considerable soil sintering/ melting if the humic substance in the soil has been heated off previously. Finally, Cr concentrations in the toxicity characteristic leaching procedure leachates collected from the samples thermally treated at 1100 degrees C for 4 hr are < or =0.21 mg of Cr L(-1) that are much less than the Taiwan Environmental Protection Administration regulatory limit (<5 mg of Cr L(-1)); consequently, these two samples are nonhazardous, and they have the potential for resource recycling. Conversely, Cr concentrations in the leachates from all 500 degrees C and 105 degrees C samples are in the 25.6-1279 mg L(-1) range.     

Evaluation of PCR-based quantification techniques to estimate the abundance of atrazine chlorohydrolase gene atzA in rhizosphere soils

There are many challenges in the accurate quantification of bacterial genes, such as the atrazine-degrading enzyme antA from Pseudomonas sp. strain ADP, from soil samples. We compared four quantitative methods for enumeration of atrazine-degrading bacteria in rhizosphere environments and utilized the optimal probe-based real-time polymerase chain reaction (PCR)-based method in an ongoing bioremediation experiment to monitor atzA copy number over time. We compared three quantitative PCR (qPCR) based methods--quantitative competitive PCR and two real-time qPCR methods--to traditional dilution-plate counting techniques. The optimal real-time qPCR assay was then used to monitor atzA copy number over time in the robust atrazine-degrading Pseudomonas sp. strain ADP-spiked rhizosphere environment. The use of sensitive and reliable probe-based real-time qPCRs for the enumeration of bacterial catabolic genes allows for their detection from soil samples and monitoring of potential degradative populations over time. The addition of arrazine-biodegrading bacteria into arrazine-contaminated sites to remove entrapped atrazine is a promising approach for mitigating atrazine pollution and its metabolites. The methodology contained herein will allow for optimal monitoring of atzA in rhizosphere soil with or without the addition of biodegradative Pseudomonas sp. strain ADP of bacteria.     

Mixture risk assessment due to ingestion of arsenic,copper, and zinc from milkfish farmed in contaminated coastal areas

Human health risks associated with the consumption of metal-contaminated fish over extended periods have become a concern particularly in Taiwan, where fish is consumed on a large scale. This study applied the interaction-based hazard index (HI) to assess the mixture health risks for fishers and non-fishers who consume the arsenic (As), copper (Cu), and zinc (Zn) contaminated milkfish from As-contaminated coastal areas in Taiwan, taking into account joint toxic actions and potential toxic interactions. We showed that the interactions of As–Zn and Cu–Zn were antagonistic, whereas As–Cu interaction was additive. We found that HI estimates without interactions considered were 1.3–1.6 times higher than interactive HIs. Probability distributions of HI estimates for non-fishers were less than 1, whereas all 97.5%-tile HI estimates for fishers were >1. Analytical results revealed that the level of inorganic As in milkfish was the main contributor to HIs, indicating a health risk posed to consumers of fish farmed in As-contaminated areas. However, we found that Zn supplementation could significantly decrease As-induced risk of hematological effect by activating a Zn-dependent enzyme. In order to improve the accuracy of health risk due to exposure to multiple metals, further toxicological data, regular environmental monitoring, dietary survey, and refinement approaches for interactive risk assessment are warranted.     

Effects of controller-pilot communication medium,flight phase and the role in the cockpit on pilots’ workload and situation awareness

This study explores the effects of communication medium, flight phase, and the role in the cockpit on pilots’ workload and situation awareness. Eight pilots with the experience of Controller-Pilot Data Link Communications (CPDLCs) participated in this simulated experiment. Two types of communication medium (voice and datalink), three types of flight phase (departure, cruise, and arrival), and two types of role (pilot flying and pilot non-flying) were investigated in the experiment. The results indicated that flight phase is a significant factor and cruise is the most suitable phase for datalink use on pilots’ acceptance, workload, and situation awareness performance. Both medium and role were not the significant factors. Since there is no significant difference on medium when no extra tasks and interferences involved in a normal flight, that the use of CPDLC can be justified during all phases of a no-event flight. In addition, the results of usability indicated that the simulated CPDLC with command selection functions proposed in this study provides good utility for the participants. In order to use the CPDLC for all phases of flight in the future, adding more command selection functions in place of typing messages by pilots and accommodating appropriate interfaces for different phases are recommended to enhance the usability of the CPDLC unit.     

RELATIONSHIPS BETWEEN FLOOD FREQUENCIES AND RIPARIAN PLANT COMMUNITIES IN THE UPPER KLAMATH BASIN,OREGON1

ABSTRACT: This study was conducted in the Klamath Basin of southwestern Oregon to evaluate the dependency of riparian plant communities upon infrequent flooding. Plant communities were sampled with 1 m² quadrats along established cross‐sections. Data collected for purposes of hydraulic modeling included channel and floodplain elevations (i.e., cross‐sectional profiles) and water surface elevations associated with specific discharges. The elevational distribution of hydrophytic plant communities relative to modeled return periods provided the basis for establishing relationships between these variables for nine sites. Results indicate that, on average, a peak flow frequency of 4.6 years (range of 3.1 to 7.6 years) was needed to sustain riparian plant communities at seven of nine sites. At two sites, results indicated return periods of more than 25 years were needed; these results possibly were influenced by local geomorphic conditions (a narrow steep channel in one case and an incised channel in the other). Overall, these results tend to confirm a strong dependency of riparian plant communities on overbank flows.