Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.     

Emissions from Slash Burning and the Influence of Flame Retardant Chemicals

Pollutants sampled during the burning of 30 lb ponderosa pine fuel beds yielded emission factors for CO, hydrocarbon gases, and par-ticulate matter of 146, 8.4, and 9.1 lb/ton of fuel, respectively. When similar beds were treated with diammonium phosphate flame retardant, these factors increased to 166, 11.7, and 19.3 lb/ton of fuel, respectively.

Gas chromatographic analysis of hydrocarbon gases showed that 15-40% of this material was composed of methane and eth-ylene. Ethane and acetylene were the next most abundant materials, with photochemically important materials constituting minor portions of this gaseous component. Fuel beds treated with flame retardant produced more oiefins, and this production lasted throughout the smoldering phase of burning.

These tests showed that the smoldering phase of combustion is of major importance to air pollutant production during slash burning. The initial 80% of the fuel burned accounted for only 20-30% of HC and CO emissions. This suggests that a rapid mop-up of slash burns could substantially reduce air pollutant production.     

Some Heavy-Metal Pollutants in the Air of Naples

ABSTRACT

In this paper, assumptions regarding future land use as a key uncertainty is considered and its impact on risk analysis for contaminated sites is assessed. Risks are assessed for two land use scenarios (current-use industrial and future-use residential) using probabilistic models that incorporate uncertainty and variability in the exposure parameters. Residual risks are calculated for both industrial and residential cleanup standards. A Superfund site in northern California is considered.

In general, for the unremediated case, the future-use residential scenarios produce larger risks (1 to 3 orders of magnitude) than current- (continued) use industrial scenarios. For the Superfund site studied, the residual risks calculated for the remedy selected was not sufficiently protective of future-use residents in that it did not meet .S. Environmental Protection Agency (EPA) risk goals, but was protective of current-use workers, even though the cleanup criteria were based on residential use. Alternative risk management practices, such as deed restrictions, can be used in such cases.     

Atmospheric Deposition and Ionic Input in Adirondack Forests

Major mechanisms for input of ions to forest ecosystems in the central Adirondack Mountains of New York State were studied. Precipitation and throughfall in adjacent northern hardwood and lake margin coniferous forests were continuously sampled from May 2, 1979 to May 7, 1980. Important mechanisms for transport of ions from atmosphere to forest floor were identified using regression analyses and the assumption that deciduous and coniferous forests capture particulates and aerosols with differing efficiencies. Sodium was delivered in precipitation and dry-fall and interacted little with the forest canopies. Hydrogen, potassium, and magnesium were also deposited primarily by bulk precipitation but hydrogen was retained by foliage while additional quantities of potassium and magnesium were leached from tree canopies. Impaction of suspended particulates and/or aerosols on forest vegetation was an important source of additional sulfate and nitrate, and these ions contributed to the leaching of calcium from foliage.     

Experimental Characterization of Atmospheric Diffusion in Complex Terrain with Land-Sea Interactions

The body of information presented in this paper is directed to scientists working in atmospheric dispersion research and model development. Two years of field measurements in the coastal area of Bilbao in northern Spain show that the diffusion behavior in this complex terrain can be classified into several well defined patterns, which correspond to certain meteorological conditions. The approach taken has been the systematic use of SO₂ remote sensors (COSPEC) and ground level monitors in moving platforms which are used to follow and document the flow of the air mass. Results to date show that complex reentry cycles can occur and that synoptically different flows may be indistinguishable by wind sensors at ground level (affected by channeling), and yet result in totally different observed pollution levels by a fixed monitoring network (affected by topographical effects). These results are being used to parameterize the cause-effect relationships and guide the modeling efforts in this area of complex terrain.     

Salting-out phenomenon and 1-octanol/water partition coefficient of metalaxyl pesticide

In this paper, we present the effect of inorganic cations such as Na⁺, K⁺, Ca²⁺, Mg²⁺ on the salting-out phenomenon of metalaxyl from pure water to aqueous salt solutions. Moreover the 1-octanol/water partition coefficient in pure water is presented. To accomplish this, aqueous solubility of metalaxyl was determined in pure water, in different salt solution (NaCl, KCl, CaCl₂ and MgCl₂), and at different concentration level ranging from 0.01 to 1.5 M. The 1-octanol/water partition coefficient was determined using the static shake-flask method. Solubility was determined using dynamic saturation method for pure water in the range of 298.15-325.15 K and at 298.15 K for different salt solutions. The solubility value in pure water for studied interval was found constant (m = 3.118 × 10⁻² mol kg⁻¹).Solubility values were used to calculate the standard molar Gibbs free energy of dissolution (Δ_solG°) and transfer (Δ_trG°) at 298.15 K. The values of Δ_trG° from pure to all studied aqueous salt solutions did not exceed 2 kJ mol⁻¹, the value of Δ_solG° of dissolution is 18.5 ±0.72 kJ mol⁻¹. The 1-octanol/water partition coefficient in pure water log K_o/w is equal to 1.69. The obtained results confirm the classification of the neutral metalaxyl as a slightly hydrophobic molecule.     

Temporal and geographical genetic variation in the amphipod Melita plumulosa (Crustacea: Melitidae): Link of a localized change in haplotype frequencies to a chemical spill

Anthropogenic effects such as contamination affect the genetic structure of populations. This study examined the temporal and geographical patterns of genetic diversity among populations of the benthic crustacean amphipod Melita plumulosa in the Parramatta River (Sydney, Australia), following an industrial chemical spill. The spill of an acrylate/methacrylate co-polymer in naphtha solvent occurred in July 2006. M. plumulosa were sampled temporally between December 2006 and November 2009 and spatially in November 2009. Genetic variation was examined at the mitochondrial cytochrome c oxidase subunit I locus. Notably, nucleotide diversity was low and Tajima’s D was significantly negative amongst amphipods collected immediately downstream from the spill for 10 months. We hypothesize that the spill had a significant localized effect on the genetic diversity of M. plumulosa. Alternate explanations include an alternate and unknown toxicant or a localized sampling bias. Future proposed studies will dissect these alternatives.     

Experimental investigation of outdoor and indoor mean concentrations and concentration fluctuations of pollutants

Tracer gas was released upwind of a two-compartment complex shaped building under unstable atmospheric conditions. The mean wind direction was normal to or at 45° to the long face of the building. The general patterns of concentration distribution on the building external walls and inside the building were analysed and the influence of natural and mechanical ventilation on indoor concentration distributions was discussed. Mean concentration levels, as well as the concentration fluctuation intensity, were higher on the windward walls of the building, although concentration levels varied along each wall. Concentration fluctuations measured inside the building were lower than those measured outside. Inside the two compartments of the building, the time series of concentrations had a similar general behaviour; however, gas concentrations took approximately 1.5 times longer to reach the mean maximum concentration value at the downwind compartment 02 while they also decreased more rapidly in the upwind compartment 01 after the source was turned off. The highest indoor concentration and concentration fluctuation values were observed at the detectors located close to the windward walls, especially when the building windows were open. Experiments with and without natural ventilation suggested that infiltration and exfiltration of contaminants is much faster when the building windows are open, resulting to higher indoor concentration levels. Furthermore, mechanical ventilation tends to homogenize concentrations and suppress concentration fluctuations, leading to lower maximum concentration values.