Selection and application of a rainbow trout toxicity testing procedure for screening Sacramento River Watershed, California samples

A number of procedures have been developed to assess toxic effects on the early life stages of salmonid fish. In this study 13 rainbow trout embryo development relatively short-term (7 to 90 day) procedures were reviewed. Three 7-day methods from the published literature and three modifications developed at AQUA-Science (A-S) were evaluated in the laboratory. Based on that evaluation, A-S methods were selected for screening surface water samples (A-S 1) collected in the Sacramento River watershed (California) and for conducting toxicity identification evaluations (TIE) to identify cause(s) of toxicity. Test control performance, test sensitivity, and reference toxicant response variability in the A-S 1 were superior to those in commonly used freshwater toxicity testing methods. The incidence of Sacramento River watershed samples resulting in a notable decrease in embryo development was very low. Of 260 samples screened only 16 (6%) resulted in statistically significant inhibition of embryo development. Of the 16 toxic samples, nine caused minimal (less than 20% abnormal development) and four marginal (less than 30%) toxicity. Samples collected from the agriculture-dominated Colusa Basin Drain and rangeland/forest-dominated Battle Creek on June 16, 2005 caused significant toxicity. TIE procedures indicated that cationic chemicals were the primary cause of toxicity. Metals analysis did not reveal concentrations sufficient to inhibit embryo development, so the most probable cause of toxicity in the two samples was cationic chemicals (perhaps surfactants?) or metals that were not included in the analytical screening.     

Risk assessment of trihalomethanes from tap water in Fortaleza, Brazil

The cancer risks (CR) by oral ingestion, dermal absorption, and inhalation exposure of trihalomethanes (THM) from tap water of ten districts in Fortaleza, Brazil were estimated. The mean levels of THM compounds were obtained in Fortaleza tap water as follow: 63.9 microg L(-1) for chloroform (CHCl(3)), 40.0 microg L(-1) for bromodichloromethane (CHBrCl(2)), and 15.6 microg L(-1) for dibromochloromethane (CHBr(2)Cl). Bromoform (CHBr(3)) was not detected. The mean CR for THMs in tap water is 3.96 x 10(-4). The results indicate that Fortaleza residents have a higher CR by inhalation than dermal absorption and oral ingestion. The CR for CHCl(3) contributes with 68% as compared with the total CR, followed by CHBrCl(2) (21%), and CHBr(2)Cl (11%). The hazard index (HI) is about ten times lower than unity, not indicating non-cancer effects.     

Organic speciation of atmospheric particles in Alvão Natural Park (Portugal)

PM₁₀ continental rural background aerosols were collected during a summer field campaign (August–September 2006) at Lamas de Ôlo in the upper zone of the Alvão Natural Park, a mountain region of northern Portugal. In addition to the determination of the carbonaceous content by a thermal–optical method, the organic speciation of aerosols was performed by gas chromatography–mass spectrometry in an effort to evaluate photo-oxidation products of biogenic volatile organic compounds and other markers for source characterization. The detailed analysis revealed relatively high concentrations of polyols and short-chain dicarboxylic, tricarboxylic, hydroxycarboxylic, and oxocarboxylic acids, many of which are thought to be indicators of secondary aerosol formation, accounting for about 70% of global chromatographically resolved mass. Major photo-oxidation products of α- and β-pinene have been detected. The tracers for the photo-oxidation of isoprene comprise two diastereoisomeric 2-methyltetrols, C₅-alkene triols, and 2-methylglyceric acid, which have only recently been elucidated. In addition, the occurrence of levoglucosan and other biomass combustion tracers indicates that the site was affected by wildfires. This source contributed to more than 80% of the organic carbon mass during a period of strong forest fire influence.     

Flow injection spectrophotometric determination of methamidophos using online hydrolysis

A new protocol for the online spectrophotometric determination of methamidophos has been developed. The method is based on online hydrolysis of methamidophos, and the resulting hydrolyzed product is reacted with sodium nitroproside to form a colored complex. The calibration curve is linear over the concentration range of 0.5–20 μgml^?–?1, with a molar absorptivity of 2.5×10⁴ L mol^?1 cm^?1. The method is fast and reproducible with a sample throughput of 90 samples/h. The method is successfully applied to formulations and real samples.     

Closed cycle construction: an integrated process for the separation and reuse of C&D waste

In The Netherlands, construction and demolition (C&D) waste is already to a large extent being reused, especially the stony fraction, which is crushed and reused as a road base material. In order to increase the percentage of reuse of the total C&D waste flow to even higher levels, a new concept has been developed. In this concept, called 'Closed Cycle Construction', the processed materials are being reused at a higher quality level and the quantity of waste that has to be disposed of is minimised. For concrete and masonry, the new concept implies that the material cycle will be completely closed, and the original constituents (clay bricks, gravel, sand, cement stone) are recovered in thermal processes. The mixed C&D waste streams are separated and decontaminated. For this purpose several dry separation techniques are being developed. The quality of the stony fraction is improved so much, that this fraction can be reused as an aggregate in concrete. The new concept has several benefits from a sustainability point of view, namely less energy consumption, less carbon dioxide emission, less waste production and less land use (for excavation and disposal sites). One of the most remarkable benefits of the new concept is that the thermal process steps are fuelled with the combustible fraction of the C&D waste itself. Economically the new process is more or less comparable with the current way of processing C&D waste. On the basis of the positive results of a feasibility study, currently a pilot and demonstration project is being carried out. The aim is to optimise the different process steps of the Closed Cycle Construction process on a laboratory scale, and then to verify them on a large scale. The results of the project are promising, so far.     

Microbial degradation and impact of Bracken toxin ptaquiloside on microbial communities in soil

The carcinogenic and toxic ptaquiloside (PTA) is a major secondary metabolite in Bracken fern (Pteridium aquilinum (L.) Kuhn) and was hypothesized to influence microbial communities in soil below Bracken stands. Soil and Bracken tissue were sampled at field sites in Denmark (DK) and New Zealand (NZ). PTA contents of 2.1 +/- 0.5 mg g(-1) and 37.0 +/- 8.7 mg g(-1) tissue were measured in Bracken fronds from DK and NZ, respectively. In the two soils the PTA levels were similar (0-5 microg g(-1) soil); a decrease with depth could be discerned in the deeper B and C horizons of the DK soil (weak acid sandy Spodosol), but not in the NZ soil (weak acid loamy Entisol). In the DK soil PTA turnover was predominantly due to microbial degradation (biodegradation); chemical hydrolysis was occurring mainly in the uppermost A horizon where pH was very low (3.4). Microbial activity (basal respiration) and growth ([3H]leucine incorporation assay) increased after PTA exposure, indicating that the Bracken toxin served as a C substrate for the organotrophic microorganisms. On the other hand, there was no apparent impact of PTA on community size as measured by substrate-induced respiration or composition as indicated by community-level physiological profiles. Our results demonstrate that PTA stimulates microbial activity and that microorganisms play a predominant role for rapid PTA degradation in Bracken-impacted soils.     

Comparison of organochlorine compound concentrations in colostrum and mature milk

Human breast milk represents the best choice for the nutrition of infants. It is often used for monitoring human exposures to environmental chemicals. Uniquely suited to meet human biological needs, breast milk composition, especially fat content, changes significantly with time from delivery. With the aim to compare the concentration of organochlorine compounds (OCs) in colostrum versus mature milk, we obtained samples of fourth-fifth day postpartum milk (colostrum) and day-14 postpartum milk (mature milk) from 12 women enrolled in the project "Early Childhood Development and PCB Exposure in Slovakia". The concentrations of selected organochlorine pesticides and congeners of polychlorinated biphenyls (PCBs) were measured using gas chromatography with electron capture detection and reported on lipid adjusted basis. No significant differences were found between organochlorine levels in colostrum and those in mature milk samples. A very close correlation was found between the concentrations of organochlorine compounds in colostrum and mature milk (Spearman correlation coefficient r=0.94-0.98 for PCBs, and r=0.85-0.99 for organochlorine pesticides, p<0.001 for all compounds). The present study concludes that the use of colostrum samples provides a close estimate of the child's exposure to OCs in the early neonatal period and demonstrates that, despite the lower fat content, colostrum specimens are adequate to conduct OC analyses.     

Polychlorinated biphenyls and DDT in swordfish (Xiphias gladius) and blue shark (Prionace glauca) from Brazilian coast

The polychlorinated biphenyls (PCBs) and DDT may bioaccumulate in the aquatic food web and have been of great concern due to their toxic effects on wildlife and human health. There is evidence showing that fish in the human diet contributes at a significant proportion to the total intake of PCBs and other organochlorine compounds, particularly fish with higher fat levels. This study investigated the concentration of PCBs and DDTs in muscle tissues of samples of the blue shark (Prionace glauca) and a swordfish (Xiphias gladius) from east Brazilian coast and estimate the human exposure to total DDTs through the consumption of both the species. Samples of the each species were caught between August and September 2001. The mean concentration for summation operator PCBs in P. glauca was 3.15 ng/g w.w. and the summation operator DDTs was 0.93 ng/g w.w. The mean concentration of summation operator PCBs in X. gladius was 6.50 ng/g and the mean of summation operator DDTs was 2.47 ng/g. The estimated daily intake of summation operator DDT through X. gladius or P. glauca consumption can be considered safe since it contributes to less than 0.1% of the limit of acceptable daily intake (ADI) of summation operator DDT proposed by WHO.     

Investigations of chemical fraction of Co and Ni in industrial fly ash and mobility of metals in environmental conditions

The quantitative evaluation of chemical fraction of Co and Ni in the industrial fly ash by methods of five step sequential extraction was carried out in order to characterize metal mobility in environmental conditions. The research involved (i) water-soluble (pH=7), (ii) acid-soluble (pH=5), (iii) oxide, (iv) sulfide and (v) residue metal fractions. It was discovered, that the total extraction of the studied metals from fly ash to solutions take place in the following quantities Co - 35.5 and Ni - 153.0mgkg(-1). The investigations of chemical fractions proved that the subject metals occur mainly in fly ash as: oxide (Co - 7.0, Ni - 28.5mgkg(-1)) and residue (Co - 11.5, Ni - 42.5mgkg(-1)) as well as sulfide (Co - 8.5, Ni - 46.5mgkg(-1)). Low concentrations of metals for water-soluble fraction (Co - 0.7, Ni - 1.2mgkg(-1)) and acid-soluble fraction (Co - 4.5, Ni - 23.5mgkg(-1)) were observed. The fractions of Co and Ni leachable from the ash in environmental conditions contain: 24.0% (Co) and 23.3% (Ni) of metal total amount in the industrial fly ash. The obtained mobility parameter of Co and Ni can be applied to estimate the concentration increase of mobile and hardly mobile forms of these metals in soil polluted with the ash.     

Persistent organic pollutants in atmospheric deposition and biomonitoring with Tillandsia usneoides (L.) in an industrialized area in Rio de Janeiro state, southeast Brazil--Part II: PCB and PAH

Monitoring of immission of persistent organic pollutants in the industrialized area of Volta Redonda (V.R.) and in the National Park of Itatiaia (PNI) in southeast Brazil was performed using an endemic bromeliad species as biomonitor and measuring bulk deposition rates of polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH). For the sum of PCB, overall deposition rates were between 17 and 314 ng/(m2 day) in winter and between 43 and 81 ng/(m2 day) in summer, respectively. Deposition rates of dioxin-like PCBs ranged from 0.14 to 2.8 pg WHO-TEQ/(m2 day) in winter and from 0.90 to 4.3 pg WHO-TEQ/(m2 day) in summer. PCB deposition rates (total PCB and WHO-TEQ) were in the same range in winter in V.R. and PNI. In summer, contamination levels in V.R. were 6-10-folds higher than in PNI. PCB concentrations in biomonitor samples from V.R. and PNI were in the same range in summer and in winter. Concentrations of total PCB ranged from 14 to 95 microg/kg dry matter (d.m.) in winter and from 18 to 27 microg/kg d.m. in summer, respectively. The TEQ values were between 1.7 and 4.1 ng WHO-TEQ/kg d.m. in winter and between 1.9 and 2.9 ng WHO-TEQ/kg d.m. in summer. PCB concentrations of di-ortho PCB but not of non-ortho PCB were a factor of 2-4 lower in summer in both areas. PCB congener profiles resembled those from technical formulations. The profiles shifted to the higher chlorinated congeners in summer, probable due to revolatilisation of the lighter components at higher temperatures. PCB profiles in biomonitor resembled those from deposition samples and the shift to the heavier congeners in summer was even more pronounced. PAH deposition rates were in a similar range in both areas (131-2415 ng/(m2 day)). PAH levels in biomonitor samples from V.R. were about one order of magnitude higher than in samples from PNI indicating the impact of local sources. PAH profiles revealed stationary thermal processes as main source of contamination in V.R. whereas in PNI, biomass burning seems to be the main contamination source.