Chlorination of dibenzofuran and dibenzo-p-dioxin vapor by copper (II) chloride

Dibenzofuran (DF) is formed from phenol and benzene in combustion gas exhaust streams prior to particle collection equipment. Subsequent chlorination at lower temperatures on particle surfaces is a potential source of chlorinated dibenzofuran (CDF). Gas streams containing 8% O₂ and approximately 0.1% DF vapor were passed through particle beds containing copper (II) chloride (0.5% Cu, mass) at temperatures ranging from 200 to 400 °C to investigate the potential for CDF formation during particle collection. Experiment duration was sufficient to provide an excess amount of DF (DF/Cu=3). The efficiency of DF chlorination by CuCl₂ and the distribution of CDF products were measured, with effects of temperature, gas velocity, and experiment duration assessed. Results of a more limited investigation of dibenzo-p-dioxin (DD) chlorination by CuCl₂ to form chlorinated DD (CDD) products are also presented.

The efficiency of DF/DD chlorination by CuCl₂ was high, both in terms of CuCl₂ utilization and DF/DD conversion. Total yields of Cl on CDF/CDD products of up to 0.5 mole Cl per mole CuCl₂ were observed between 200 and 300 °C; this suggests that nearly 100% CuCl₂ was utilized, assuming a conversion of two moles of CuCl₂ to CuCl per mole Cl added to DD/DF. In a short duration experiment (DF/Cu=0.3), nearly 100% DF adsorption and conversion to CDF was achieved. The degree of CDF chlorination was strongly dependent on gas velocity. At high gas velocity, corresponding to a gas–particle contact time of 0.3 s, mono-CDF (MCDF) yield was largest, with yields decreasing with increasing CDF chlorination. At low gas velocity, corresponding to a gas–particle contact time of 5 s, octa-CDF yield was largest. DF/DD chlorination was strongly favored at lateral sites, with the predominant CDF/CDD isomers within each homologue group those containing Cl substituents at only the 2,3,7,8 positions. At the higher temperatures and lower gas velocities studied, however, broader isomer distributions, particularly of the less CDD/CDF products, were observed, likely due to preferential destruction of the 2,3,7,8 congeners.     

微氧膜生物反应器同时去除有机物和氮的研究

采用微氧颗粒污泥膜生物反应器处理生活污水,进行同时去除有机物和氮的研究。结果表明,膜出水COD不受水力停留时间变化的影响一直稳定在较低值,为15~35mg/L,去除率在94%以上。氮通过发生同时硝化反硝化反应而去除。在水力停留时间为16h以上时, 系统总氮去除率为65% ~92%,平均去除率为77%。     

The degradation of endocrine disruptor di-n-butyl phthalate by UV irradiation: a photolysis and product study

The direct photolysis of an important endocrine disruptor compound, di-n-butyl phthalate (DBP), has been investigated under monochromatic UV irradiation at 254 nm over a wide pH range (3-11). The investigation was carried out under idealized conditions and has considered both reaction kinetics and the degradation mechanism. It was found that more than 90% of DBP can be degraded within an hour of irradiation in water. A simple model has been developed and used to predict the initial DBP photolysis rate constant at different pH values and initial DBP concentrations. The major decomposition mechanism of DBP is believed to involve the hydrolytic photolysis of the carbon in the alpha and/or beta-position of the ester chain with the production of aromatic carboxylic derivatives. Additionally, multi-degradation pathways are proposed for acid-catalyzed hydrolytic photolysis (pH 3-5), which was found to be useful in explaining the photo-degradation of DBP under acidic conditions. The use of 254 nm UV to photo-degrade DBP was found to be a relatively fast and clean process, especially in neutral to basic conditions.     

等离子体协同光催化去除模拟烟气中SO2的实验研究

近年来,低温等离子体技术以及纳米TiO₂光催化技术在烟气脱硫中的应用越来越引起人们的关注。利用填充床反应器将这2种技术有机地结合起来，进行了大量脱硫实验研究。研究结果表明，等离子体协同光催化去除烟气中的SO₂与单独采用等离子体技术相比，其SO₂的去除率可提高5%～20%。同时，探讨了等离子体协同TiO₂光催化剂的脱硫机理，分别研究了外加电压、气体流量和SO₂初始浓度等因素对脱硫效率的影响。实验结果表明，当SO₂初始浓度为800 mg/m³，输入电压为17.5 kV，气体流量为0.2 m³/h时，SO₂脱除率可以达到77.6%。     

一种新型国产高效除尘滤筒在船厂分段涂装车间的应用

国产除尘滤材是将聚酯纤维热轧成型 ,再涂敷高分子发泡制成。滤材硬挺、耐压、抗撕裂 ,内部结构稳定 ,粉尘过滤精度高 ,实现表面过滤 ,易清灰再生 ,使用寿命长 ,耐水、酸、碱 ,可广泛用于各工业领域的气体净化和粉尘处理。大连新船重工集团把国产除尘滤材制成的滤筒配置到厂内原有的除尘系统中 ,通过 1年多的使用 ,获得非常满意的除尘效果。从而证明国产滤料性能已达到国际先进水平。     

Modeling the quantum yields of herbicide 2,4-D decay in UV/H2O2 process

The photodecay of herbicide 2,4-D in a hydrogen peroxide-aided photolysis process was studied and modeled. The decay rate of 2,4-D was known to be low in the natural environment, but rate improvement was achieved in an H2O2/UV system. The 2,4-D decay quantum yields under ultraviolet (UV) light at 253.7 nm increased from 4.86 x 10(-6) to 1.30 x 10(-4) as the ratio of [H2O2]/[2,4-D] increased from 0.05 to 12.5. Apparently, in the presence of UV light, the decay rate of 2,4-D could be greatly improved as the concentration of hydrogen peroxide increased. However, the efficiency of 2,4-D photodecay was retarded if the concentration of H2O2 was overdosed, because the excess hydrogen peroxide consumes the hydroxyl radicals (HO*) in the solution, resulting in a much weaker oxidant HO2*. The decay of 2,4-D was also pH dependent. A ranking of acid (highest), base (middle) and neutral (lowest) was observed owing to the property change of reactants and the shifting of dominant mechanisms among photolysis, photohydrolysis and chemical oxidation. Two mathematical models were proposed to predict the quantum yield for various [H2O2]/[2,4-D] ratios and initial pH levels, in which very good correlation was found for the ranges of regular application.     

Toxicological assessment of chlorinated diphenyl ethers in the rat

Chlorinated diphenyl ethers are environmental contaminants that have been found in Great Lakes fish and birds. Because of their presence in the food chain, and potential for human exposure, the present short-term study was conducted to assess their toxicity. Groups of 10 male and 10 female rats were each given by gavage 2,2',4,4'6-pentachlorodiphenyl ether (CDE1), 2,2',4,4',5,6-hexachlorodiphenyl ether (CDE2) or 2,2',3,3',4,6'-hexachlorodiphenyl ether (CDE3) at dose levels of 0.04, 0.4, 4.0 or 40 mg/kg b.w./day for a period of 28 days. The control group received an equivalent volume of corn oil only (0.5 ml/100 g b.w.). Treatment with the three CDE congeners did not result in suppression of growth rate or food consumption. Increased liver weights were seen in the animals of both sexes fed 40 mg/kg CDE2, in males treated with 40 mg/kg CDE1, and in females with 40 mg/kg CDE3. Hepatic microsomal aminopyrine demethylase activity was significantly higher in the male rats administered 40 mg/kg CDE2, and aniline hydroxylase activity was elevated in the females following the same treatment. Serum glucose, calcium, protein and urea nitrogen of CDE1-treated males were higher than the control. Levels of uric acid, potassium and LDH of CDE3-treated females were also elevated. No hematological changes were observed. Histological examination revealed that the liver and thyroid were the target organs affected by CDE treatment but the morphological changes were mild even at the highest dose level. Changes in the liver consisted of nuclear vesiculation and increased cytoplasmic volume. Alterations in the thyroid were characterized by increased epithelial height and follicular collapse. Based on the data presented above, the 3 CDE congeners can only be considered moderately toxic in the rat.     

Degradation pathways of PCBs upon UV irradiation in hexane.

The photodegradations of eight individual PCB congeners (5, 31, 52, 77, 87, 126, 138, 169) in hexane have been investigated employing a mercury lamp. All degradation reactions of the above mentioned PCB congeners are of the pseudo first order. The principal products of PCB decomposition are the less chlorinated biphenyls, and no PCB-solvent adducts are found. Symmetrical and coplanar PCB congeners show lower photoreactivities. The reactivities of the chlorine atoms at various positions of PCB rings are generally in the order: ortho > meta > para. Photodechlorinations occur mainly on the more substituted rings, when the numbers of chlorine atoms on the two phenyl rings are unequal. During photodegradation, some coplanar PCB congeners are formed, which make the TEQ of solutions to decrease slowly or even to increase.     

A two-dimensional inviscid model of the gravity-current head by Lagrangian block simulation

A two-dimensional inviscid model of the gravity-current head produced by the release of a relatively small volume of dense fluid from behind a tall lock gate is constructed by Lagrangian block simulation. Three numerical experiments are conducted for the lock’s height-to-length aspect ratios H/L _o  = 8, 4 and 2. The front speeds obtained by the simulations agree with the laboratory observation for a similar range of aspect ratios. The floor velocity in the wake behind these heads is found to be greater than their front speed. The high floor velocity is caused by the impingement of the coherent wake vortex on the floor. It is a condition that permits these gravity-current heads to maintain their structural integrity so that the fine sediments can travel with the head over long distances on the ocean floor. The structural coherence of the current head depends on the lock aspect ratio. The gravity-current head produced by the release from the lock with the highest aspect ratio of H/L _o  = 8 is most coherent and relatively has the greatest floor velocity and the least trailing current behind the head.     

进口废塑料环境保护管理研究

随着塑料资源的大量消耗,废塑料的利用引起了社会的高度重视。工艺简单,投入成本少,入行门槛低导致部分废塑料加工利用企业技术水平低、管理模式差、环境污染重。为规范进口废塑料行业,通过调研统计、实验分析、咨询论证和研究了进口废塑料环境保护管理规定,对进口废塑料企业的规模、设备、人员和管理等方面提出了要求,为进一步规范提升进口废塑料行业提供技术支撑。