Surface ozone measurements in the southwest of the Iberian Peninsula (Huelva,Spain)

Introduction  

Photochemical ozone pollution of the lower troposphere (LT) is a very complex process involving meteorological, topographic emissions and chemical parameters. Ozone is considered the most important air pollutant in rural, suburban and industrial areas of many sites in the world since it strongly affects human health, vegetation and forest ecosystems, and its increase during the last decades has been significant. In addition, ozone is a greenhouse gas that contributes to climate change. For these reasons, it is necessary to carry out investigations that determine the behaviour of ozone at different locations. The aim of this work is to understand the levels and temporal variations of surface ozone in an industrial-urban region of the Southwest Iberian Peninsula.     

Relative proportions of polycyclic aromatic hydrocarbons differ between accumulation bioassays and chemical methods to predict bioavailability

Chemical methods to predict the bioavailable fraction of organic contaminants are usually validated in the literature by comparison with established bioassays. A soil spiked with polycyclic aromatic hydrocarbons (PAHs) was aged over six months and subjected to butanol, cyclodextrin and tenax extractions as well as an exhaustive extraction to determine total PAH concentrations at several time points. Earthworm (Eisenia fetida) and rye grass root (Lolium multiflorum) accumulation bioassays were conducted in parallel. Butanol extractions gave the best relationship with earthworm accumulation (r² ≤ 0.54, p ≤ 0.01); cyclodextrin, butanol and acetone-hexane extractions all gave good predictions of accumulation in rye grass roots (r² ≤ 0.86, p ≤ 0.01). However, the profile of the PAHs extracted by the different chemical methods was significantly different (p < 0.01) to that accumulated in the organisms. Biota accumulated a higher proportion of the heavier 4-ringed PAHs. It is concluded that bioaccumulation is a complex process that cannot be predicted by measuring the bioavailable fraction alone.     

Acid mine drainage in the Iberian Pyrite Belt: 1. Hydrochemical characteristics and pollutant load of the Tinto and Odiel rivers

Acid mine drainage in the Iberian Pyrite Belt is probably the worst case in the world of surface water pollution associated with mining of sulphide mineral deposits. The Iberian Pyrite Belt is located in SW Iberian Peninsula, and it has been mined during the last 4,500 years. The central and eastern part of the Iberian Pyrite Belt is drained by the Tinto and Odiel rivers, which receive most of the acidic leachates from the mining areas. As a result, the main channels of the Tinto and Odiel rivers are very rich in metals and highly acidic until reaching the Atlantic Ocean. A significant amount of the pollutant load transported by these two rivers is delivered during the rainy season, as is usual in rivers of Mediterranean climate regions. Therefore, in order to have an accurate estimation of the pollutant loads transported by the Tinto and Odiel rivers, a systematic sampling on a weekly basis and a high temporal resolution sampling of floods events were both performed. Results obtained show that metal fluxes are strongly dependent on the study period, highlighting the importance of inter-annual studies involving dry and wet years.     

Vapor-phase concentrations of PAHs and their derivatives determined in a large city: Correlations with their atmospheric aerosol concentrations

Thirteen PAHs, five nitro-PAHs and two hydroxy-PAHs were determined in 55 vapor-phase samples collected in a suburban area of a large city (Madrid, Spain), from January 2008 to February 2009. The data obtained revealed correlations between the concentrations of these compounds and a series of meteorological factors (e.g., temperature, atmospheric pressure) and physical–chemical factors (e.g., nitrogen and sulfur oxides). As a consequence, seasonal trends were observed in the atmospheric pollutants. A “mean sample” for the 14-month period would contain a total PAH concentration of 13 835 ± 1625 pg m⁻³ and 122 ± 17 pg m⁻³ of nitro-PAHs. When the data were stratified by season, it emerged that a representative sample of the coldest months would contain 18 900 ± 2140 pg m⁻³ of PAHs and 150 ± 97 pg m⁻³ of nitro-PAHs, while in an average sample collected in the warmest months, these values drop to 9293 ± 1178 pg m⁻³ for the PAHs and to 97 ± 13 pg m⁻³ for the nitro-PAHs. Total vapor phase concentrations of PAHs were one order of magnitude higher than concentrations detected in atmospheric aerosol samples collected on the same dates. Total nitro-PAH concentrations were comparable to their aerosol concentrations whereas vapor phase OH-PAHs were below their limits of the detection, indicating these were trapped in airborne particles.     

Ozone Decay Rates in Residences

ABSTRACT

In urban and suburban settings, indoor ozone exposures can represent a significant fraction of an individual's total exposure. The decay rate, one of the factors determining indoor ozone concentrations, is inadequately understood in residences. Decay rates were calculated by introducing outdoor air containing 80-160 parts per billion ozone into 43 residences and monitoring the reduction in indoor concentration as a function of time. The mean decay rate measured in the living rooms of 43 Southern California homes was 2.80 + 1.30 hr^-1, with an average ozone deposition velocity of 0.049 + 0.017 cm/sec. The experimental protocol was evaluated for precision by repeating measurements in one residence on five different days, collecting 44 same-day replicate measurements, and by simultaneous measurements at two locations in six homes. Measured decay rates were significantly correlated with house type and the number of bedrooms. The observed decay rates were higher in multiple-family homes and homes with fewer than three bedrooms. Homes with higher surface-area-to-volume ratios had higher decay rates. The ratio of indoor-to-outdoor ozone concentrations in homes not using air conditioning and open windows was 68 + 18%, while the ratio of indoor-to-outdoor ozone was less than 10% for the homes with air conditioning in use.     

Combined phytoremediation of metal-working fluids with maize plants inoculated with different microorganisms and toxicity assessment of the phytoremediated waste

The aim of this study was to validate the effectiveness of a phytoremediation procedure for metal-working fluids (MWFs) with maize plants growing in hydroponic culture in which the roots grow on esparto fibre and further improve bioremediation potential of the system with root beneficial bacteria, seeking a synergistic effect of the plant–microorganism combination. Chemical oxygen demand (COD), pH, total and type of hydrocarbons measured after phytoremediation indicated that the process with maize plants was successful, as demonstrated by the significant decrease in the parameters measured. This effect was mainly due to the plant although inoculated microorganisms had a relevant effect on the type of remaining hydrocarbons. The success of the phytoremediation process was further confirmed by two toxicity tests, one of them based on chlorophyll fluorescence measurements on maize plants and another one based on cyanobacteria, using a bioluminescent toxicity bioassay; both tests demonstrated that the phytoremediated waste was significantly less toxic than the initial non-phytoremediated MWFs.     

多种聚氧乙烯牛脂胺混合物MON 0818的水生环境危害评估：实验室急性暴露实验基础上的物种敏感度分布

本实验利用标准短期(48- 96 h)实验室测试测定了包括初级生产者,底栖无脊椎动物,水蚤类动物,软体动物和鱼类在内的15种水生生物对于MON 0818的敏感性。MON 0818是一种商业表面活性剂,由多种聚氧乙烯牛脂胺混合而成。此外本实验使用模糊网纹蚤(Ceriodaphnia dubia)潜在的长期(8 d)毒性,确定了暴露浓度。长期毒性测试中未在任何终端指标中发现显著效果。利用得出的数据和文献记载得到物种敏感度在4种暴露条件下的分布,通过对比物种敏感度分布进行了tier-1危害评估。评估显示在本研究规划下(以综述为原型,研究林业除草剂;12 L标准每公顷,等于4.27 kg每公顷) 最差的情况(无意中以最大标签使用速率直接过量喷洒到15 cm深的水体中)会造成中等危害(43.1%的物种处于暴露中,高于中位有效浓度水平)。在更多以最大使用速率使用的典型情况下,受到损害的物种降至20.9%(6 L标准每公顷,相当于2.14 kg每公顷),在更频繁的雇佣施用速率(2.5 L标准每公顷,相当于0.89 kg每公顷)下,受损物种比例降至6.9%。通过草甘膦在环境中的最大测定浓度计算得到MON 0818的浓度,最终受损物种比例(3.8%)则小于此浓度下受损物种比例(5%)。
精选自Jose L. Rodriguez-Gil, Ryan Prosser, David Poirier, Linda Lissemore, Dean Thompson, Mark Hanson, Keith R. Solomon. Aquatic hazard assessment of MON 0818, a commercial mixture of alkylamine ethoxylates commonly used in glyphosate-containing herbicide formulations. Part 1: Species sensitivity distribution from laboratory acute exposures. Environmental Toxicology and Chemistry: Volume 36, Issue 2, pages 501–511, July 2017. DOI: 10.1002/etc.3559
详情请见http://onlinelibrary.wiley.com/wol1/doi/10.1002/etc.3559/full
     

A safety culture maturity model for petrochemical companies in Brazil

A framework to measure safety culture maturity in the Brazilian oil and gas companies was formulated based on the model of Hudson (2001). Following a review of the safety culture literature, a questionnaire was designed to measure five aspects of organisational safety indicative of five levels of cultural maturity. The questionnaire was completed by the safety managers of 23 petrochemical companies based in Camacari, Bahia, Brazil and they were interviewed one month later. The reliability of the questionnaire was tested by asking the same questions in an interview and comparing the results (alternate forms reliability). The correlation coefficients between the questionnaire and interview scores on each dimension ranged from r = 0.7 to 0.9, demonstrating good reliability of the measures used. The research findings demonstrated that the 23 companies studied showed characteristics of different levels of safety culture maturity. Most scores were at the level of proactive. The model of Hudson (2001) and the revised framework and questionnaire were found to be practical to use, making it possible to identify levels of safety culture maturity in the context of the Brazilian petrochemical industry.     

Assessment of Ball Milling as a Compounding Technique to Develop Nanocomposites of Poly(3-Hydroxybutyrate-co-3-Hydroxyvalerate) and Bacterial Cellulose Nanowhiskers

The aim of this study was the assessment of high energy ball milling technique to develop poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) nanocomposites containing bacterial cellulose nanowhiskers (BCNW). Crystallization behaviour of PHBV/BCNW nanocomposites was studied under non-isothermal and isothermal conditions using differential scanning calorimetry. The changes in PHBV crystalline structure were also studied using X-ray diffraction. The results confirmed that BCNW acted as nucleating agents and, hence, favored the crystallization of the PHBV. The oxygen permeability of the nanocomposites was reduced by ~22 % when compared to that of the neat PHBV. This work provides a new insight into the development of polyhydroxyalkanoate composites by means of the high energy ball milling technique.