四氯化钛精制除钒废弃物的综合利用

对四氯化钛铜丝除钒精制过程中产生的废弃物,采用酸碱联合法回收其中的铜和钒。考察了关键的碱处理及盐酸沉钒过程的影响因素。实验结果为：在碱处理溶液pH12．0—13．0,碱处理温度60℃,碱处理时间1h,沉钒溶液pH1．0～1．5,沉钒温度60℃,沉钒时间1h的条件下,铜和钒的回收率分别达到90％和75％以匕,获得的阴极铜和五氧化二钒的产品质量均达到国家标准。     

膜生物反应器中溶解性微生物产物特性的研究进展

溶解性微生物产物是制约生物处理出水达标和回用的主要污染物,处理工艺和操作条件的不同可能造成其特性差异。阐述了溶解性微生物产物的定义和产生机制,对膜生物反应器中溶解性微生物产物的组成、分子质量分布、亲水／疏水性、螯合性和毒性进行了概述,分析了影响其产生、特性和去除的因素。由于膜的截留作用使溶解性微生物产物在膜生物反应器中积累,容易引起膜污染。可以通过优化操作条件,减少溶解性微生物产物的产生,提高出水水质,有效地抑制膜污染。     

The Effect of Masterbatch Addition on the Mechanical, Thermal, Optical and Surface Properties of Poly(lactic acid)

There has been considerable interest in the use of the biodegradable polymer poly(lactic acid) (PLA) as a replacement for petroleum derived polymers due to ease of processability and its high mechanical strength. Other material properties have however limited its wider application. These include its brittle properties, low impact strength and yellow tint. In an attempt to overcome these drawbacks, PLA was blended with four commercially available additives, commonly known as masterbatches. The effect of the addition of 1.5 wt% of the four masterbatches on the mechanical, thermal, optical and surface properties of the polymer was evaluated. All four masterbatches had a slight negative effect on the tensile strength of PLA (3–5% reduction). There was a four fold increase in impact resistance however with the addition of one of the masterbatches. Differential scanning calorimetry demonstrated that this increase corresponded to a decrease in the polymer crystallinity. However there was an associated increase in polymer haze with the addition of this masterbatch. The clarity of PLA was improved through the addition of an optical brightener masterbatch, but the impact resistance remained low. The glass transition and melting temperatures of PLA were not affected by the addition of the masterbatches, and no change was observed in surface energy. Some delay in PLA degradation, in a PBS degradation medium at 50 °C, was observed due to blending with these masterbatches.     

Seat Belt Use in States and Territories with Primary and Secondary Laws -- United States, 2006

Problem

Motor-vehicle crashes are a leading cause of death in the United States. In the event of a crash, seat belts are highly effective in preventing serious injury and death.

Methods

Data from the 2006 Behavioral Risk Factor Surveillance System were used to calculate prevalence of seat belt use by state and territory and by type of state seat belt law (primary vs. secondary enforcement).

Results

In 2006, seat belt use among adults ranged from 58.3% to 91.9% in the states and territories. Seat belt use was 86.0% in states and territories with primary enforcement laws and 75.9% in states with secondary enforcement laws.

Discussion

Seat belt use continues to increase in the United States. Primary enforcement laws remain a more effective strategy than secondary enforcement laws in getting motor-vehicle occupants to wear their seat belts.     

自动喷水灭火系统喷水强度概率分布特性及其控火性能研究

喷水强度是体现自动喷水灭火系统控火能力的重要参数,具有不均匀性和不确定性.传统的喷水强度设计主要考虑喷头的流量和保护面积,没有考虑其分布特性,对系统控火性能的影响.因此本文将喷水强度分布特性引入自动喷水灭火系统的控火性能研究.以公称口径为15 mm的传统下垂型玻璃球洒水喷头的喷水强度分布实验为基础,建立了包含径向距离和喷头工作压力等参数的喷水强度分布模型,采用蒙特卡罗方法获得了喷水强度的概率分布特性.参照不同危险等级场控火所需的喷水强度参数和不同喷头开启个数下的有效控火百分比,分析了喷水强度概率分布特性对控火性能的影响.研究结果表明,喷水强度概率分布特性对控火性能有重要影响,随径向距离的增加,喷水强度出现较小值的概率增大,控火性能下降,在某些危险较大的场所不能达到控火作用.对于同一危险等级场所,控火性能随着喷头安装间距减小而增强.研究方法可为合理评估喷头适用范围、优化喷头布置提供参考.     

Soil and vegetation carbon stocks in Brazilian Western Amazonia: relationships and ecological implications for natural landscapes

The relationships between soils attributes, soil carbon stocks and vegetation carbon stocks are poorly know in Amazonia, even at regional scale. In this paper, we used the large and reliable soil database from Western Amazonia obtained from the RADAMBRASIL project and recent estimates of vegetation biomass to investigate some environmental relationships, quantifying C stocks of intact ecosystem in Western Amazonia. The results allowed separating the western Amazonia into 6 sectors, called pedo-zones: Roraima, Rio Negro Basin, Tertiary Plateaux of the Amazon, Javari-Juruá-Purus lowland, Acre Basin and Rondonia uplands. The highest C stock for the whole soil is observed in the Acre and in the Rio Negro sectors. In the former, this is due to the high nutrient status and high clay activity, whereas in the latter, it is attributed to a downward carbon movement attributed to widespread podzolization and arenization, forming spodic horizons. The youthful nature of shallow soils of the Javari-Juruá-Purus lowlands, associated with high Al, results in a high phytomass C/soil C ratio. A similar trend was observed for the shallow soils from the Roraima and Rondonia highlands. A consistent east–west decline in biomass carbon in the Rio Negro Basin sector is associated with increasing rainfall and higher sand amounts. It is related to lesser C protection and greater C loss of sandy soils, subjected to active chemical leaching and widespread podzolization. Also, these soils possess lower cation exchangeable capacity and lower water retention capacity. Zones where deeply weathered Latosols dominate have a overall pattern of high C sequestration, and greater than the shallower soils from the upper Amazon, west of Madeira and Negro rivers. This was attributed to deeper incorporation of carbon in these clayey and highly pedo-bioturbated soils. The results highlight the urgent need for refining soil data at an appropriate scale for C stocks calculations purposes in Amazonia. There is a risk of misinterpreting C stocks in Amazonia when such great pedological variability is not taken into account.     

Is PM10 mass measurement a reliable index for air quality assessment? An environmental study in a geographical area of north-eastern Italy

The aim of this study was to measure the concentration of some metals (Cd, Cr, Cu, Fe, Mn, Ni, Pb, and Ti) in PM(10) samples collected in one urban and one industrial site and to assess that PM(10) total mass measurement may be not sufficient as air quality index due to its complex composition. Metals were determined by inductively coupled plasma-atomic emission spectroscopy (ICP-AES) and differential pulsed anodic stripping voltammetry (DPASV). The measured concentrations were used to calculate the content of metals in the PM(10) total mass, and to estimate the enrichment factors and the correlations between PM(10), metal concentrations and meteorological data for the two sites. The mean PM10 concentration during the sampling period in the urban site exceeded the annual European Union (EU) standard (40 microg/m(3)) and, for some sampling days, the daily EU standard (50 microg/m(3)) was also exceeded. In opposite, both EU standards were never exceeded in the industrial site. The overall metal content was nearly double in the industrial site compared to the urban one, and the mean Ni concentration exceeded the EU annual limit value (10 ng/m(3)). The metals with the highest enrichment factor were Cd, Cu, Ni and Pb for both sites, suggesting a dominant anthropogenic source for these metals. Metal concentrations were very low and typical of rural background during Christmas holidays, when factories were closed. PM(10) total mass measurement is not a sufficient air quality index since the metal content of PM(10) is not related to its total mass, especially in sites with industrial activities. This measurement should be associated with the analysis of toxic metals.     

Responses of Physical, Chemical, and Biological Indicators of Water Quality to a Gradient of Agricultural Land Use in the Yakima River Basin, Washington

The condition of 25 stream sites in the Yakima River Basin, Washington, were assessed by the U.S. Geological Survey's National Water-Quality Assessment Program. Multimetric condition indices were developed and used to rank sites on the basis of physical, chemical, and biological characteristics. These indices showed that sites in the Cascades and Eastern Cascades ecoregions were largely unimpaired. In contrast, all but two sites in the Columbia Basin ecoregion were impaired, some severely. Agriculture (nutrients and pesticides) was the primary factor associated with impairment and all impaired sites were characterized by multiple indicators of impairment. All indices of biological condition (fish, invertebrates, and algae) declined as agricultural intensity increased. The response exhibited by invertebrates and algae suggested a threshold response with conditions declining precipitously at relatively low levels of agricultural intensity and little response at moderate to high levels of agricultural intensity. This pattern of response suggests that the success of mitigation will vary depending upon where on the response curve the mitigation is undertaken. Because the form of the community condition response is critical to effective water-quality management, the National Water-Quality Assessment Program is conducting studies to examine the response of biota to gradients of land-use intensity and the relevance of these responses to water-quality management. These land-use gradient pilot studies will be conducted in several urban areas starting in 1999.     

Migratory crustaceans as biomonitors of metal pollution in their nursery areas. The Lesina lagoon (SE Italy) as a case study

Lichens collected in an unpolluted forest (background) in November 2004, transplanted at 41 sampling sites along the Madina-Tetteh Quarshie road, retrieved in February 2005 and analysed were found to contain higher concentrations of Manganese (Mn), Vanadium (V), lead, Cadmium (Cd), Chromium (Cr) and Nickel (Ni) than in the background area. Observations showed that of all the heavy metals studied, Manganese concentrations were highest at all sampling points with maximum values around a traffic light, an intersection and car fitting/mechanic workshops. Significant correlations were found between Ni and Mn, Mn and Cr and Mn and V. Statistical analysis also revealed a relatively even dispersion of the studied elements on the eastern side of the road than on the western side.