在线树脂富集流动注射法测定水中痕量酚

研究了用流动注射分析中的流体动力学注入技术与在线树脂富集相结合的方式，富集水中痕量苯酚，以４－氨基安替比林比色法测定的方法。结果表明，当进样频率为２４个样品每小时时，方法的检出限为０．０５ｍｇ／Ｌ，线性范围为０．０５～７ｍｇ／Ｌ；对水中苯酚重复测定１０次，相对标准偏差小于２％；回收率为９９％～１０５％。     

The epidemic characteristics of Kaschin-Beck disease (KBD) in different eco-environments

Epidemiological survey of 573 families, clinical examination of 2593 persons, and X-ray examination of 1136 persons (in 16 typical endemic villages) were conducted, based on the classification of endemiology for KBD disease areas, i.e, mountain type, loess plateau type, plateau type, and flatlands type. It was revealed that the KBD disease areas exhibited the regular pattern of corming-into-being, development and passing-away and the characteristics of growth and decline. Further, it was found clinically that the disease areas may be divided into 4 types, i.e., recent onset, developing, stable, and historical. This division is simple and easy, practical, scientific, and reliable and can be applied by medical personnel at different levels.     

Ecological assessment of cities-procedure and a case study

This paper discusses the scientific background and content of the ecological assessment of cities, and takes Boda, a new town in Xinjiang province, China, as a case study.     

Protozoa of Lough Neagh,Northern Ireland,UK

ＰｒｏｔｏｚｏａｏｆＬｏｕｇｈＮｅａｇｈ，ＮｏｒｔｈｅｒｎＩｒｅｌａｎｄ，ＵＫ￥ＸｕＭｕｑｉ（ＩｎｓｔｉｔｕｔｅｏｆＺｏｏｌｏｇｙ，ＣｈｉｎｅｓｅＡｃａｄｅｍｙｏｆＳｃｉｅｎｃｅｓ，Ｂｅｉｊｉｎｇ１０００８０，Ｃｈｉｎａ）ＢｒｉａｎＷｏｏｄ（Ｆｒｅｓ...     

量纲分析对污水近区初始稀释度变化规律的探讨

在上海合流污水二期工程白龙港排放口水力模型试验基础上，根据模型实验的大量数据，采用量纲分析方法对近区初始稀释度的变化规律进行了探讨，得出了描述该区域初始稀释度变化规律的半理论半经验公式，可为实际排海工程的设计提供依据。     

模拟酸雨对浙东北红壤中盐基离子和铝的淋失影响研究

通过对浙江省东北部杭州至宁波地区两个红壤剖面的模拟酸雨淋溶实验研究表明，随着时间的延续，盐基离子的淋失浓度会在某一时期出现一个峰值。该峰值的出现与酸雨的ｐＨ值并不简单相关，Ａｌ＾３＋的淋失浓度只是在酸雨ｐＨ值＝２．５左右才显增高并在淋出液ｐＨ＝４．０时有一个阈值，经ｐＨ＝２．５－３．０模拟酸雨１０余年降水量的淋溶，红壤中淋出液的ｐＨ值下降不超过０．８。     

回灌法处理城市垃圾填埋场渗沥液

在调研了国内外文献和模拟试验的基础上,阐述了用回灌法处理城市垃圾填埋场渗沥液的依据、工艺流程和技术参数,提出了应注意的问题。     

Hydrogen storage and distribution systems

Hydrogen storage and transportation or distribution is closely linked together. Hydrogen can be distributed continuously in pipelines or batch wise by ships, trucks, railway or airplanes. All batch transportation requires a storage system but also pipelines can be used as pressure storage system. Hydrogen exhibits the highest heating value per weight of all chemical fuels. Furthermore, hydrogen is regenerative and environment friendly. There are two reasons why hydrogen is not the major fuel of toady’s energy consumption: First of all, hydrogen is just an energy carrier. And, although it is the most abundant element in the universe, it has to be produced, since on earth it only occurs in the form of water. This implies that we have to pay for this energy, which results in a difficult economic task, because since the industrialization we are used to consuming energy for free. The second difficulty with hydrogen as an energy carrier is the low critical temperature of 33 K, i.e. hydrogen is a gas at room temperature. For mobile and in many cases also for stationary applications the volumetric and gravimetric density of hydrogen in a storage system is crucial. Hydrogen can be stored by six different methods and phenomena: high pressure gas cylinders (up to 800 bar), liquid hydrogen in cryogenic tanks (at 21 K), adsorbed hydrogen on materials with a large specific surface area (at T < 100 K), absorbed on interstitial sites in a host metal (at ambient pressure and temperature), chemically bond in covalent and ionic compounds (at ambient pressure), oxidation of reactive metals e.g. Li, Na, Mg, Al, Zn with water. These metals easily react with water to the corresponding hydroxide and liberate the hydrogen from the water. Finally, the metal hydroxides can be thermally reduced to the metals in a solar furnace.     

气态甲醛致小白鼠肝脏DNA-DNA交联的研究

为了探讨气态甲醛致生物体内DNA-DNA交联效应,进一步评价甲醛的遗传毒性作用,以昆明纯系小鼠为实验材料,进行了72 h动态吸入式连续染毒,采用荧光检测法检测甲醛染毒后小鼠肝细胞DNA-DNA交联形成的效应.实验结果表明,0.5 mg·m-3的气态甲醛能引起明显的DNA-DNA交联(p＜0.05),较高浓度的甲醛(1.0mg·m-3、3.0 mg·m-3,p＜0.01)可以产生极为明显的DNA-DNA交联作用.以上实验结果显示了0.5mg·m-3的气态甲醛就能致生物体内DNA-DNA交联效应,且随着浓度的升高DNA-DNA交联率越高.     

广东省危险废物处置设施与管理现状及对策

文章对广东省危险废物的产生与流向、处置设施建设、工艺技术、污染防治以及管理等现状及存在问题进行调查分析，针对所存在的问题，并结合规划要求，从管理、技术发展、处理处置设施建设和运营等方面提出较为系统的危险废物污染防治对策。