Influence of boundary conditions on CMAQ simulations over the Iberian Peninsula

The influence of chemical boundary conditions (BC) on the response of the Community Multiscale Air Quality (CMAQ) model over the Iberian Peninsula was investigated in this study. Three strategies to supply boundary conditions in the context of the Integrated Assessment Modelling System for the Iberian Peninsula (SIMCA) were tested. Alternative methods consist in providing BC from (1) fixed, time-independent, concentration profiles, (2) concentrations predicted in a CMAQ mother domain (48 km, 1 h resolution) and (3) concentration values from the GEOS-Chem chemical-transport global model (2 × 2.5°, 3 h resolution). High resolution (3 km) simulated concentrations of the main pollutants (NO₂, NO, SO₂, O₃, PM₁₀ and PM_2.5) were compared through a comprehensive statistical analysis including observational data from 165 monitoring stations all over the Iberian Peninsula. It was found that model sensitivity to BC for nitrogen and sulphur oxides was limited, being restricted to the vicinity of model boundaries. However, significant domain-wide differences were found when modelling ozone and PM depending on the BC provided to run the tests. Although model performance was affected by spatial and seasonal factors, the results indicate that model-derived, dynamic BC improved CMAQ predictions when compared to those based on static concentrations prescribed in the boundaries. Aggregated statistics suggest that the GEOS-Chem produced the best results for O₃ and PM_2.5 while NO₂ and PM₁₀ were slightly better predicted under the CMAQ nesting approach. Besides the statistical evaluation some other relevant issues in the context of Integrated Assessment Modelling (IAM) are discussed to gain a better insight into the suitability of the methods analyzed and limitations of downscaling methods. Despite being useful to get a better understanding of the role of BC in SIMCA, this study contributed to highlight model deficiencies and therefore to point out future research needs to improve IAM activities in the Iberian Peninsula.     

Assessment of the uncertainty of using an inverse-dispersion technique to measure methane emissions from animals in a barn and in a small pen

Dispersion techniques are useful for assessing the effectiveness of management practices in mitigating methane (CH₄) emissions from animal operations. In this paper, the accuracy of an inverse-dispersion technique was examined for two common situations: 1) emissions from animals in a barn and 2) emissions from animals in a pen. For both situations, the accuracy of emission estimates generally increased with increasing fetch (scaled to barn height, h, or to pen width, X_s) between the source and the concentration measurement. The gas recovery ratio increased from 0.66 at 5 h to 0.93–1.03 at 10 h–25 h for the barn, and decreased from 1.59 at 0 X_s to 0.99 at 5 X_s and from 1.54 at 0 X_s to 1.09 at 5 X_s for the two small pen scenarios, due to the declining sensitivity of the dispersion model to errors in wind complexity and errors in the assumed source configuration. However, the relative uncertainty of the measured concentration increased with fetch due to the decreasing gas concentrations. Hence, improving the accuracy of emission estimates is a compromise between the source configuration sensitivity and the concentration measurement sensitivity. Fetches of about twice the size of the pen and about 10 times the height of the barn are suggested.     

Estimation and characterization of children’s ambient generated exposure to PM2.5 using sulphate and elemental carbon as tracers

Children’s exposures to ambient and non-ambient fine particulate matter (PM_2.5) were determined using the sulphate and elemental carbon components of the PM_2.5 mixture as tracers of the ambient contribution during a 6-week winter period in Prince George, British Columbia, Canada. Personal exposures to PM_2.5 were measured in children at 5 elementary schools located throughout the city and ambient samples were collected on school rooftops. Average ambient levels and personal exposures during this time period were 13.8 μg m^?3 and 16.4 μg m^?3 respectively. From the data pooled across individuals, use of the two different tracers indicated identical estimates of median exposure to ambient PM_2.5 (7.5 μg m^?3) and similar estimates of non-ambient generated exposure (6.4 and 5.0 μg m^?3) and infiltration (0.49 and 0.52) for the sulphate and elemental carbon approach, respectively. The median fraction of the ambient concentration resulting in exposure or exposure factors were 0.54 and 0.55 respectively, however lower values of 0.46 and 0.42 were determined from regression analysis. A strong association was found between exposure to ambient PM_2.5 and measured ambient concentrations at both the closest school monitor (median r = 0.92) and a central site (median r = 0.88) demonstrating that the central site monitor was suitable for assessing longitudinal ambient generated exposure throughout the city. These results support the use of elemental carbon as a tracer of ambient generated exposure and the use of ambient data as estimates of longitudinal changes in children’s exposure in this setting. The importance of both ambient and non-ambient sources of PM_2.5 is emphasized by their almost equal contribution to total personal exposures. Comparison with other studies suggests a limited influence of climate and the cold season in Prince George on exposure levels and found similar mean non-ambient generated exposures despite large variability across and within subjects in any given location.     

Chemical mass balance source apportionment for combined PM2.5 measurements from U.S. non-urban and urban long-term networks

The Minnesota Particulate Matter 2.5 (PM_2.5) Source Apportionment Study was undertaken to explore the utility of PM_2.5 mass, element, ion, and carbon measurements from long-term speciation networks for pollution source attribution. Ambient monitoring data at eight sites across the state were retrieved from the archives of the Interagency Monitoring of Protected Visual Environments (IMPROVE) and the Speciation Trends Network (STN; part of the Chemical Speciation Network [CSN]) and analyzed by an Effective Variance – Chemical Mass Balance (EV-CMB) receptor model with region-specific geological source profiles developed in this study. PM_2.5 was apportioned into contributions of fugitive soil dust, calcium-rich dust, taconite (low grade iron ore) dust, road salt, motor vehicle exhaust, biomass burning, coal-fired utility, and secondary aerosol. Secondary sulfate and nitrate contributed strongly (49–71% of PM_2.5) across all sites and was dominant (≥60%) at IMPROVE sites. Vehicle exhausts accounted for 20–70% of the primary PM_2.5 contribution, largely exceeding the proportion in the primary PM_2.5 emission inventory. The diesel exhaust contribution was separable from the gasoline engine exhaust contribution at the STN sites. Higher detection limits for several marker elements in the STN resulted in non-detectable coal-fired boiler contributions which were detected in the IMPROVE data. Despite the different measured variables, analytical methods, and detection limits, EV-CMB results from a nearby IMPROVE-STN non-urban/urban sites showed similar contributions from regional sources – including fugitive dust and secondary aerosol. Seasonal variations of source contributions were examined and extreme PM_2.5 episodes were explained by both local and regional pollution events.     

Distribution of radionuclides in the guano sediments of Xisha Islands, South China Sea and its implication

Several natural and anthropogenic radionuclides (²¹⁰Pb, ²²⁶Ra and ¹³⁷Cs) in guano-phosphatic coral sediments and pure guano particles collected from Ganquan, Guangjin, Jinqing and Jinyin Islands of the Xisha archipelago, South China Sea, were analyzed. The Constant Initial Concentration (CIC) model and the Constant Rate of Supply (CRS) model were applied for age calculation. The average supply rate of ²¹⁰Pb was 126 Bq m⁻² a⁻¹, very close to the flux of northern hemisphere average (125 Bq m⁻² a⁻¹). The activities of anthropogenic radionuclides in the sediments were very low, indicating that human nuclear tests did not notably impact this region. The main source of radionuclides in the sediments was from atmospheric precipitation, and the organic matter derived from plant and produced by nutrient-rich guano could further enhance them.     

Concentration and characterization of plutonium in soils of Hubei in central China

To study the Pu concentration and isotope ratio distributions present in China, the ^239+240Pu total activities and ²⁴⁰Pu/²³⁹Pu atom ratios in core soil samples from Hubei Province in central China were investigated using Accelerator Mass Spectrometry (AMS). The activities ranged from 0.019 to 0.502 mBq g⁻¹ and the ^239+240Pu inventories of 45 and ∼55 Bq m⁻² agree well with that expected from global fallout. The ²⁴⁰Pu/²³⁹Pu atom ratios in the soil ranged from 0.172 to 0.220. The ratios are similar to typical global fallout values. Hence, any close-in fallout contribution from the Chinese nuclear weapons tests, mainly conducted in the 1970s, must have either been negligible or had a similar ²⁴⁰Pu/²³⁹Pu ratio to that of global fallout. The top 10 cm layer of the soil contributes ∼90% of the total inventory and the maximum concentrations appeared in the 2-4 cm or 4-6 cm layers. It is suggested that climatic conditions and organic content are the two main factors that affect the vertical migration of plutonium in soil.     

Patagonian Fjord Ecosystems in Southern Chile as a Highly Vulnerable Region: Problems and Needs

Southern Chile encompasses one of the most extensive fjord regions of the world, the Patagonia, currently exposed to natural and anthropogenic perturbations. These fjord ecosystems provide important services to humans, which have not been adequately measured and valued. As a consequence, ecosystem services are commonly ignored in public policy design and in the evaluation of development projects. Here we tackle questions that are highly relevant for the nation’s development, namely (1) understanding fjord functioning, and (2) developing management strategies based on ecosystem services, in order to secure simultaneous and adequate use of these ecosystems which area influenced by ecological (e.g., biogeochemical) and productive (e.g., aquaculture, fisheries) processes. We also seek to strengthen the analysis of fjord ecosystem value from the economical (including coastal zoning), socio-cultural, institutional, and governmental points of view. In addition, the investigation of current and future effects of climate change on this large region offers a unique opportunity to understand the social and economic consequences of a global phenomenon at local to regional scales. Biogeochemical and socio-economic models will be used to simulate future scenarios under a gamut of management options.     

Localization of hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) and 2,4,6-trinitrotoluene (TNT) in poplar and switchgrass plants using phosphor imager autoradiography

Phosphor imager autoradiography is a technique for rapid, sensitive analysis of the localization of xenobiotics in plant tissues. Use of this technique is relatively new to research in the field of plant science, and the potential for enhancing visualization and understanding of plant uptake and transport of xenobiotics remains largely untapped. Phosphor imager autoradiography is used to investigate the uptake and translocation of the explosives 1,3,5-trinitro-1,3,5-triazine (RDX) and 2,4,6-trinitrotoluene within Populus deltoides × nigra DN34 (poplar) and Panicum vigratum Alamo (switchgrass). In both plant types, TNT and/or TNT-metabolites remain predominantly in root tissues while RDX and/or RDX-metabolites are readily translocated to leaf tissues. Phosphor imager autoradiography is further investigated for use in semi-quantitative analysis of uptake of TNT by switchgrass.     

Deposition of reactive nitrogen during the Rocky Mountain Airborne Nitrogen and Sulfur (RoMANS) study

Increases in reactive nitrogen deposition are a growing concern in the U.S. Rocky Mountain west. The Rocky Mountain Airborne Nitrogen and Sulfur (RoMANS) study was designed to improve understanding of the species and pathways that contribute to nitrogen deposition in Rocky Mountain National Park (RMNP). During two 5-week field campaigns in spring and summer of 2006, the largest contributor to reactive nitrogen deposition in RMNP was found to be wet deposition of ammonium (34% spring and summer), followed by wet deposition of nitrate (24% spring, 28% summer). The third and fourth most important reactive nitrogen deposition pathways were found to be wet deposition of organic nitrogen (17%, 12%) and dry deposition of ammonia (14%, 16%), neither of which is routinely measured by air quality/deposition networks operating in the region. Total reactive nitrogen deposition during the spring campaign was determined to be 0.45 kg ha⁻¹ and more than doubled to 0.95 kg ha⁻¹ during the summer campaign.