Determination of specific activity of (226)Ra, (232)Th and (40)K for assessment of radiation hazards from Turkish pumice samples

The specific activity of (226)Ra, (232)Th and (40)K in 52 Turkish pumice samples collected from 11 geographical areas located in Central Anatolia, Eastern Anatolia, Mediterranean and Aegean regions was determined by gamma-ray spectrometry with a high-purity germanium (HPGe) detector. The specific activity of (226)Ra, (232)Th and (40)K ranged from 12.7+/-0.5 to 256.2+/-9.1Bqkg(-1) with a mean of 89.1+/-65.2Bqkg(-1), 12.3+/-1.0 to 237.9+/-12.2Bqkg(-1) with a mean of 87.0+/-61.4Bqkg(-1) and 300.1+/-5.5 to 1899.0+/-30.8Bqkg(-1) with a mean of 1211.9+/-419.8Bqkg(-1), respectively. Elemental concentrations were determined for U (from 1.0 to 20.7ppm with a mean of 7.2+/-5.3ppm), Th (from 3.0 to 58.6ppm with a mean of 21.4+/-15.1ppm) and K (from 1.0 to 6.1% with a mean of 3.9+/-1.3%). The radium equivalent activity (Ra(eq)), the activity index, the emanation coefficient, the (222)Rn mass exhalation rate, the indoor absorbed dose rate and the effective dose rate were estimated for the radiation hazard of the natural radioactivity in all samples. The calculated mean Ra(eq) value was 306.6+/-177.7Bqkg(-1) (54.6+/-5.5 to 737.6+/-49.0Bqkg(-1)) for all pumice samples. This value is lower than the recommended limit value of 370Bqkg(-1) for building raws and products. The emanation coefficient and the (222)Rn mass exhalation rate of all samples ranged from 29.4 to 42.9% with a mean of 36.2% and from 11.0 to 196.4muBqkg(-1)s(-1) with a mean of 73.5muBqkg(-1)s(-1), respectively. The mean indoor absorbed dose rate and the corresponding mean effective dose rate were 274.6+/-153.6nGyh(-1) (50.4-644.6nGyh(-1)) and 1.35+/-0.75mSvy(-1) (0.24-3.16mSvy(-1)), respectively. For all pumice samples the mean indoor absorbed dose rate is about three times higher than the population-weighted average of 84nGyh(-1), while the mean effective dose rate values except for PUM 05, PUM 06, PUM 10 and PUM 15 exceed the dose criterion of 1mSvy(-1).     

Characterization of municipal solid waste combustion in a grate furnace

The objective of this paper is to evaluate the combustion process of municipal solid waste combustion in a grate furnace both experimentally and numerically by using data of a reference experiment with over-stoichiometric primary air supply. Measurements were carried out inside the combustion chamber of a pilot plant by monitoring temperatures and sampling gaseous combustion products along the bed surface. The data were assessed using elemental and energy balances. Experimental data of the axial temperature profiles of the flue gas, the fuel bed and the grate bars, as well as local gas flows and the flue gas composition measured above the fuel bed along the grate were used to describe the conversion process, including drying and carbon burnout. These data served as input to model the thermo- and fluid dynamic processes of the gas phase above the bed inside the combustion chamber. For this purpose the commercial code FLUENT was employed to carry out the simulations. Thus, the turbulent temperature, flow and species distributions in the combustion chamber of the pilot waste incinerator TAMARA were predicted. The results of the FLUENT modeling showed that under the prevailing conditions the flue gas burnout is almost completed before entering the first flue due to high temperatures, effective mixing and sufficient residence times of the flue gas inside the combustion chamber. This agrees well with the experimental results inside the first flue. On the basis of the above mentioned results, design and parametric studies can be carried out in a more efficient way by saving cost and time.     

Chemical investigations of aquifers affected by pyrite oxidation in the Bitterfeld lignite district

In a large area around the former open-pit lignite mines near Bitterfeld, Germany, groundwater taken from wells was analyzed for the major cations, anions, and trace elements. Quaternary and Tertiary sediments were collected from aquifers exposed on the sides of the pits and from boreholes outside the mines and analyzed for major and trace elements, as well as for carbonate, pyritic sulfur and total organic carbon. The pH and electrical conductivity of the sediments in suspension were measured. Significant differences were determined between the Tertiary sediments of the aquifers that were exposed to atmospheric oxygen during the lowering of the groundwater table and those outside the cone of depression. The greatest differences were found in the pyrite content, the pH values, and the electrical conductivity. In order to map the degree to which the mining of the lignite has affected the quality of the groundwater in the study area, the water samples were divided into six classes on the basis of their sulfate content. The neutralization potential was calculated to estimate the potential for acidification. Prediction of future groundwater quality is based on both (i) the present composition of the groundwater, surface water, and Quaternary and Tertiary aquifer sediments and (ii) the present and future groundwater flow directions. These studies have shown which parameters are important for future groundwater monitoring.     

The impact of COVID-19 pandemic in medical waste amounts: a case study from a high-populated city of Turkey

Journal of Material Cycles and Waste Management - In this study, the amount of medical waste generated in a high-populated city in Turkey between January 2018 and August 2021 was evaluated, and the...     

Chitosan-graft-poly(N‑tert‑butylacrylamide) Copolymer: Synthesis,Characterization and Optimization of Tetracycline Removal Using RSM

Journal of Polymers and the Environment - In the present study, a graft copolymer was synthesized in accordance with the free radical method using N-tertiary butylacrylamide monomer on chitosan,...     

Ecotoxicological risk assessment for sediments of Çavuşlu stream in Giresun,Turkey: association between garbage disposal facility and metallic accumulation

Environmental Science and Pollution Research - The objective of this paper was to stress the possible potential toxic element (PTE) accumulation in the surface sediments of the Çavu?lu...     

The impact of human capital and bio-capacity on the environmental quality: evidence from G20 countries

Environmental Science and Pollution Research - This study investigates the effects of human capital, bio-capacity, energy use, and economic growth on the ecological footprint of G20 countries for...     

Pesticide and agro-ecological transition: assessing the environmental and human impacts of pesticides and limiting their use

Environmental Science and Pollution Research -     

湿地植物对污水中氮、磷去除效果的试验研究

采用室内试验和现场试验考察了黄花鸢尾、水葱和梭鱼草3种挺水植物对类污水处理厂二级出水中氮、磷的吸收速率、吸收容量和吸收贡献。结果表明:短期内,各种湿地植物污水中氮、磷的吸收速率比较稳定,但在整个生长周期内,各种植物对氮、磷的吸收速率却有较大变化,4月份,水葱对氮、磷的吸收速率最大,8月份,梭鱼草对氮、磷的吸收速率最大。在整个生长期内,黄花鸢尾对氮、磷的吸收容量一直保持最大,在10月下旬分别达到21.5和4.16 g/m2,因此其对二级出水中氮、磷去除的吸收贡献也最大,分别为30%和73%。这表明湿地植物的选择不仅要考查其对污染物的吸收速率,更要关注其对污染物的吸收容量,并且湿地植物的吸收作用对类二级出水中氮、磷的去除具有更加重要的意义。     

Dry Deposition Monitoring in Europe

Between 1993 and 1999 two EU funded projects wereexecuted aimed at (i) the development of drydeposition monitoring methods for core sites andlarge scale application, (ii) the installation andrunning of three core sites in Europe and (iii) the improvement and validation of models used forregional application. This article provides anoverview of the development of depositionmonitoring stations and the main results of thethree core sites, which were operated between1995 and 1998. Furthermore, the results of thedevelopment of a low cost monitoring system arepresented. Continuous measurements were made ofboth wet and dry deposition of sulphur andnitrogen components and base cations. The 4 yearsof data show a decrease in sulphur loads and notrend for the other components. It is shown thatthe surface affinities for sulphur depositionalso changed during the years, underpinning theneed for dry deposition monitoring. A conditionaltime average gradient system was successfullydeveloped and tested and provides a good meansfor low cost monitoring of dry deposition fluxes.The costs can be reduced by a factor of 3–4 without losing the accuracy of the annual average gas fluxes.